• Resources Recycling
• /
• v.24 no.5
• /
• pp.3-14
• /
• 2015

This study investigated that status of domestic and international furnace desulfurization and desulfurization characteristics of limestone for fluidized bed use depending on the technology for CFBC one of the CCPs. Limestone-based desulfurizing agent is one of the superior elements which are optimal at around $850-950^{\circ}C$ on high temperature desulfurization. And effectiveness of desulfurization process can be determined by the desulfurization experiment method such as diffusion reaction of the diaphragm of the absorber surface, the size of the particles, the pores of the quantity, size and structure. And, desulfurization efficiency depending on geological and crystallographic properties and calcination process of limestone needs additional research in the future.

• Resources Recycling
• /
• v.18 no.5
• /
• pp.44-51
• /
• 2009

Fundamental study has been made on the recovery of copper from the electronic scrap by hydrometallurgical process. Nitric acid was used as a leaching agent to dissolve the metals such as Cu, Sn, Pb, Fe etc. from the crushed electronic scraps. TBP was employed to extract nitric acid from the strong nitric acid leaching solutions and to reclaim nitric acid. From the experimental results, Cu was effectively leached by 3.0-4.0 M nitric acid. And 95% of nitric acid in the leaching solution was extracted by 60% TBP, and 98% of nitric acid was stripped from the loaded organic phase by distilled water and it was possible to reuse as a leaching agent.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.13 no.4
• /
• pp.107-117
• /
• 2005

The objective of this study was to investigate the proper operation conditions of fenton oxidation such as initial pH, $H_2O_2/Fe^{2+}$ ratio, $H_2O_2/Fe^{2+}$ dosage amount, and neutralizing agent for pretreatment of the livestock wastewater. Fenton oxidation reagents were reacted with the livestock wastewater for 2 hours at 120 rpm and the settling was performed for 2 hours using jar-tester apparatus under the different experimental conditions. And then the supernatant was sampled and measured for the residual $H_2O_2$, $COD_{Cr}$, and SS. The results are as follows; optimum initial pH=4, optimum $H_2O_2/Fe^{2+}$ ratio=10:1, optimum $H_2O_2/Fe^{2+}$ dosage amount=5,000/500 mg/L and $Ca(OH)_2$ as proper neutralizing agent. The removal efficiency of $COD_{Cr}$ and SS were 43% and 84% under those optimal fenton oxidation conditions.

• Resources Recycling
• /
• v.10 no.6
• /
• pp.9-14
• /
• 2001

A sulfuric acid leaching of $LiCoO_2$as cathodic active materials of lithium ion secondary batteries was investigated in terms of reaction variables. In the absence of a reducing agent, the extraction of cobalt was less than 40% in 2 M sulfuric acid at $75^{\circ}C$ instead of that of lithium could be almost 100% in the same conditions. To improve the Co extraction, hydrogen peroxide was used as a reducing agent in the range 2~20 vol%. When over 10vo1% hydrogen peroxide was added, the extractions of both metals were improved to about 95%. It seems to be due to the reduction of Co(III) to Co(II) that can be readily dissolved. The extractions of Co and Li were increased with increasing $H_2$$SO_4$concentration and temperature, and amount of hydrogen peroxide and with decreasing of pulp density. The optimum leaching conditions were determined at $2 M H_2$$SO_4$concentration, $75^{\circ}C$ operating temperature, 100 g/L. initial pulp density, 20 vol% $H_2$$O_2$addition and 30 min.

• Resources Recycling
• /
• v.16 no.6
• /
• pp.28-33
• /
• 2007

Coal is the most abundant energy source and deposited in every area of world. Combustion process with lower efficiency has been mainly used. Therefore, implementation of more efficient technologies, involving gasification, combined cycles and fuel cells, would be a key issue in the plans for more efficient power generation. In these technologies, gasification has been studied for decades. However, coal gasification to high value combustible gas such as hydrogen and carbon monoxide is focused again due to high oil price. The gaseous product, called syngas, can be effectively utilized in a variety of ways ranging from electricity production to chemical industry (as feedstock). In this study, coal gasification with ultra high temperature steam has been performed. The effect of steam/carbon ratio on the produced gas concentrations, gasification rate and additional products like tar, ammonia and cyan compounds has been determined.

• Resources Recycling
• /
• v.20 no.2
• /
• pp.67-73
• /
• 2011

In this study, for recovery of renewable noble metal from used stack of fuel cell, synthesis of platinum nano particle is established through effect of platinum solution concentration, pH value, reducing agent and dispersing agent at a volume ratio of 1 mM $H_2PtCl_6$:10 mM $NaBH_4$:8 mM Cl4TABr = 1:0.4:0.4(vol.%), pH4, $50^{\circ}C$, 160 rpm and 10min. Less than 5 nm platinum particles were synthesized using Pt leaching solution from used MEA of stack under same condition of method using simulated Pt solution. The characteristics of synthesized nano particles was illustrated by XPS analysis as the reduction of platinum ions into platinum metals(zero-valent).

• Journal of the Korea Organic Resources Recycling Association
• /
• v.31 no.3
• /
• pp.93-102
• /
• 2023

This study investigated the possibility of treating heavy metal pollutants existing in the air in addition to simultaneously removing NOx and SOx by injecting oxidizing and reducing agents into a scrubber into a microbubble device to create an eco-friendly method that does not generate secondary pollutants. Lead compound (Pb) was selected as the heavy metal substance in the air to be treated with microbubbles, and the removal efficiency was confirmed. By treating microbubbles by connecting them to a scrubber, it was confirmed that not only NOx and SOx but also heavy metal substances in the air were reduced, cost was reduced, and secondary environmental pollutants were not generated. Through this study, it was possible to simultaneously remove NOx, SOx, and heavy metals at low cost by applying an eco-friendly method, rather than the existing high-cost treatment method such as SCR. If oxidizing agent, reducing agent, and microbubbles are used appropriately, economical and efficient air pollution can be achieved. Since material processing was possible, it is expected to be helpful in the technological development of environmental prevention facilities.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.5 no.1
• /
• pp.33-42
• /
• 1997

It is not long since treatment of food waste became a social problem. However, it is a fact that there have been a lot of debates on the treatment of food waste since several years ago. At present, two ways of disposing food waste are under great interest in Korea and Japan. One is drying of food waste at high temperature. The other is disappearance type, in which analysis by microorganism takes place with continuous supply of a bulking agent for a certain period of time that was stored in a reactor. In our laboratory, Disappearance type Food Waste Disposer is under interest, and experiments regarding condition establishment for efficient analysis of food waste were conducted. As preceding experimentation, experiments were done with regard to the selection of a substance to be used as a bulking agent, improvement by addition of a substance which maximizes initial growth of microorganism, and a concentration change in rank odors generated by reaction with deodorizer (absorbent). The results turned out to be satisfactory.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.20 no.3
• /
• pp.71-82
• /
• 2012

Common bulking agents in composting system include woody materials such as sawdust and woodchips. These bulking agents are mainly used for the purpose of the proper control of C/N ratio and moisture content in the composting. The topic for the effect on air permeability of bulking agents has far received relatively little attention in the composting field. This study investigated the effect of bulk density, moisture content, air-filled porosity, particle size and air flow rate on air permeability of several mixture ratios of sawdust and woodchip bulking agent. Increasing the moisture contents, the air-filled porosity was decreased and the particle size was increased for all kinds of bulking agent mixtures. Especially, with the increasing of mixing ratio of woodchip, these effects were sharply magnified. The air permeability respond to air-filled porosity was very similar to that for moisture content which was anticipated the linear relationship between air-filled porosity and moisture content. Above the region of moisture content 0.25 or 0.43(d.b.)(20 or 30% w.b.), the pressure drop decreased even though air-filled pore spaces were filling with water. Especially, to the particle size of 5 mm the pressure drop was decreased exponentially, so the air permeability was dramatically improved. By the water had the role of binding of the small particles, the macropores less resistances to air flow were created in the matrix. The effect of particle size on air permeability was much stronger than that of air-filled porosity or moisture content. And it is needed the preparing of initial particle size above 5 mm for efficient composting.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.11 no.2
• /
• pp.117-124
• /
• 2003

The purpose of this study was to investigate the optical conditions to satisfied the salt concentration of 1% below of compost produced by using the material of foodwaste and sawdust. We changed the mixing ratios of foodwaste : sawdust from 7:3 to 3:7 and the ratios of foodwaste : rice hull from 6.5:3.5 to 4:6. We analyzed C/N, pH, temperature, water content, volatile solid, salt, heavy metals to check the degree of composting. The running conditions of composting were $80{\sim}133{\ell}/min{\cdot}m^{3}$ of air flow rate, 1:4 of time interval(on:off) and 7days of turning interval. Running times were 28days. The optical mixing ratio of foodwaste : sawdust was 6:4 when we compared many factors. Especially when the mixing ratios of foodwaste : sawdust or foodwaste : sawdust were 7:3 or 6:4, the composting was not accomplished by the reason of low C/N. The concentrations of heavy metal were sufficiently low to satisfied the satandard of organic compost. The salt concentration was 0.43%-0.46% that was the half of initial concentration. The rice hull was the good in pore rate and 통기성, and so it can used alternative material.