• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1992.05a
• /
• pp.117-121
• /
• 1992

Zinc oxide thin films were obtained from zinc acetate-2-water and oxygen by photo-CVD method. (1) The formation of ZnO films sarts from 100[$^{\circ}C$] and the deposition rate increases with increasing substrate temperature. (2) The rate of deposition was also affected by flow rates of O$_2$(reaction gas) and N$_2$(Carrier gas). (3) The deposition rate decreases with increasing O$_2$mole rate. (4) The transmission of the films was independent of oxygen mole rate and it was largely affected substrate temperature. (5) The electric resistivity of th films was largely varied at oxygen mole rate 10[%] and above 20[%], a plateau was encountered. Also, it increases with increasing substrate temperature. As the results, at substrate temperature: 200[$^{\circ}C$]; O$_2$gas mole rate:10[%]; reation time:10[min] pressure: 10$\^$-2/[atm], deposition rate; transmittance; resistivity were 780[A$\^$0/; 94[%]; 7${\times}$10$\^$-2/[$\Omega$$.$cm] respectively.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.10 no.2
• /
• pp.208-214
• /
• 1986

To establish the evaluation of the fatigue crack growth behavior in 5083-O aluminum alloy, constant load-amplitude fatigue crack growth tests were carried out under the small scale yielding conditions. Crack length and closure of this material were measured by the compliance method using a clip-on gage. The main results obtained as follows: The fatigue crack growth rate against stress intensity factor range .DELTA.K exhibits the trilinear form with two transitions at the growth rate 5.5*10$^{-6}$ and 5.5*10$^{-5}$ mm/cycle, in the so-caled Region II. The trilinear form appears still in the plot of growth rate versus effective stress intensity factor range .DELTA. $K_{eff}$. Stress ratio R affects the relationship of crack growth rates versus .DELTA.K but does not affect the reation of crack growth rate versus .DELTA. $K_{eff}$. The experimental results indicate that the effective stress intensity range ratio U depends on the maximum stress intensity factor $K_{max}$, but not on the stress ratio R.o R.R.

• Journal of the Korean Applied Science and Technology
• /
• v.16 no.2
• /
• pp.135-141
• /
• 1999

A synthesis of Dimer acid was studied from a tall oil fatty acid. Catalytic activity measured as reactant conversion in a autoclave reactor increase in accordance with the acidity. The optimization of process conditions were tested by an experimental design method. Optimization synthetic conditions of dimer acid and were reaction of tall oil fatty acid during 2 hour at $250^{\circ}C$, used of 7.3 wt% active clay and $1.2{\sim}1.4wt%$ water, and found reation pressure $8{\sim}9Kg/cm^2$. The maximum conversion rate was researched $74{\sim}76%$.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.50 no.2
• /
• pp.27-34
• /
• 2008

Recently, owing to the development of industry and improvement of building techniques, concrete structures are becoming larger and higher. This study was performed to analyze hydration reation properties of concrete with binders and admixtures, such as OPC, low heat cement, belite rich cement, slag powder, lime powder and fly ash. To investigate effects of PC type superplasticizer on the hydration, experiments involving FT-IR, XRD, DSC, SEM were analyzed at the curing age 1day, 3days and 28days. The hydration reaction rate of OPC concrete slightly delayed at the curing age 1day, blast furnace slag powder and fly ash were more effective. BRC and LHC concretes can be used for concrete structures in winter season.

• Journal of the Korean Ceramic Society
• /
• v.33 no.5
• /
• pp.495-506
• /
• 1996

Monodispersed colloidaly yttria(Y2O3) can be used in a variety of applications such as phosphors. IR transparent materials and fine ceramics. For preparing monodispersed yttria homogeneous precipitation has been regarded as a fovorable method that is monodispersed yttria can be obtained through calcining monodispersed colloidal compound of yttrium (eg:Y(OH)CO3.nH2O)which can be prepared by homogeneous precipitation with urea. It is however still required to find out the quantitative effects of important variables of precipitation such as concentration of yttrium and urea reaction temperature and initial pH of reactant even though homogeneous precipitation of Y3+ with urea has been studied extensively. Among the effects of these variables we investiga-ted 1) the effect of yttrium concentration on the shape and size of precipitate and the reation rate 2) range of yttrium concentration required to make monodispersed colloidal particles 3) the reason for limited concentra-tion range of yttrium and 4) the effect of ultrasonic radiation on the limited concentration.

• Journal of the Korean Ceramic Society
• /
• v.24 no.6
• /
• pp.543-552
• /
• 1987

The effects of deposition variables on SnO2 CVD were investigated for SnCl4＋O2 reaction at 300∼700$^{\circ}C$, Psncl4=1${\times}$10-5∼1${\times}$10-3 atm, and Po2=5${\times}$10-4∼1 atm. A thermodynamic equilibrium study on Sn-Cl-O system has been performed with the computer calculation. The calculation indicates that major species participating the reaction in SnCl4 and not intermediate species, SnCl2. Good uniformity of the film thickness was obtained at the flow rate of 11cm/sec, which resulted from the stable gas flow in our cold wall reactor. The experimental results showed that apparent activation energy of the deposition was about 13.5Kcal/mole below the temperature of 500$^{\circ}C$ and the deposition mechanism was controlled by surface reation. The behavior of deposition rate on the reactant partial pressures could be explained with the Langmuri-Hinshelwood mechanism. X-ray study demonstrated that SnO2 film deposited at temperatures above 400$^{\circ}C$ were polycrystalline with tetragonal rutile structure and grew with (211) and (301) preferred orientations.

• Asian Journal of Atmospheric Environment
• /
• v.9 no.2
• /
• pp.158-164
• /
• 2015

The estimation of the concentration of hydroxyl radical (OH) in the atmosphere is essential to build atmospheric models and to understand the mechanisms of the reactions involved in OH. Although water vapor is one of the most abundant species in the troposphere, only a few studies have been performed for the reaction of OH and water vapor. Here I demonstrate an ab initio study on the complex forming reation of OH with $H_2O$ in the gas phase performed based on density functional theory to calculate the reaction rate and the energy states of the reactant and the OH-$H_2O$ complex. The structure of the complex, which belongs to the Cs point group, was optimized at global minima. The transition state was not found at the B3LYP and MP2 levels of theory. Rate constants of the forward and the reverse reactions were calculated as $1.1{\times}10^{-16}cm^3\;molecule^{-1}\;s^{-1}$ and $5.3{\times}10^9\;s^{-1}$, respectively. The extremely slow rates of complex forming reaction and the resulting hydrogen atom exchange reaction of OH and $H_2O$, which are consistent with experimentally determined values, imply a negligible possibility of a change in OH reactivity through the title reaction.

• Proceedings of the Korean Society for Applied Microbiology Conference
• /
• 2000.10a
• /
• pp.181-188
• /
• 2000

The electrocatalytic reduction of NAD$^{＋}$ using diaphorase was studied. methyl viologen (MV$^{2＋}$) mediator between an electrode and the enzyme. Steady-state currents could be obtained under the conditions of slow scan rate, low MV$^{2＋}$concentration, and high NAD$^{＋}$ concentration as the electrode reaction was converted to an electrochemical-catalytic (EC') reaction. The biomecular rate constant for the reaction of the reduced methyl viologen with the oxidized diaphorase was estimated as 7.5$\times$10$^3$M$^{-1}$ s$^{-1}$ from the slope of the current versus [MV$^{2＋}$] plot. And the optimal concentrations of diaphorase, MV$^{2＋}$ and NAD$^{＋}$ in the mediated electrocatalytic reduction of NAD$^{＋}$ were decided by applying the cyclic voltammetry. The optimal concentrations of the species were obtained by finding the conditions which gave the highest and steady-state current at a gold-amalgam electrode. The highest and steady-state catalytic current was achieved under the conditions of 1.5 U/ml diaphorase, 0.2 mM MV$^{2＋}$, and 4.8 mM NAD$^{＋}$ at the scan rate of 2 mV s$^{-1}$ , suggesting that the rate of the electrocatalytic reation is the higest under the former conditions. The electrochemical procedure under the conditions of 1.5 U/ml diaphorase,0.2 mM MV$^{2＋}$, and 4.8 mM NAD$^{＋}$ was used favorably to drive an enzymatic reduction of pyruvate to D-lactate.

• Journal of the Korean Chemical Society
• /
• v.46 no.2
• /
• pp.117-124
• /
• 2002

Counterflow oxidation was developed and evaluated for treatment of organics that adsorbed in/on granular activated carbon(GAC). This reaction is a method that destructs and removes organics adsorbed, at the same time, regenerates waste carbon, uti lizing a self-sustained flame which propagates itself ina direction counter to the oxygen flow. The results showed that the mass loss of carbon and flam temperature were strongly dependent on the flow rate of oxyen, adsorptive capability of regenerated carbon completely was recovered, as well as destrution and removal efficiency of thermally stable PCBs was achieved with the value of better than 99.99%.

• Proceedings of the SCSK Conference
• /
• 2003.09b
• /
• pp.479-479
• /
• 2003

We investigated the tyrosinase inhibitory effect using whitening materials such as arbutin, ethyl ascorbyl ether, glabridin, kojic acid, magnesium ascorbyl phosphate and ascorbic acid. Tyrosinase inhibition rate were determined varying the enzyme concentration, reaction time, reaction temperature and pH. The optimal conditions to measure the inhibitory efficacy were as follows. : enzyme concentration 1,500 or 2,000IU/mL, reaction time 15min(for the enzyme concentration 1,500 IU/mL) and l0min(for the enzyme concentration 2,000IU/mL), reation temperature 42$^{\circ}C$, pH 6.5. Under these conditions $IC_{50}$/ of arbutin, ethyl ascorbyl ether, glabridin, kojic acid, magnesium ascorbyl phosphate and ascorbic acid were calculated. In the case of magnesium ascorbyl phosphate, the inhibitory effect of tyrosinase was very low and the $IC_{50}$/ of magnesium ascorbyl phosphate could not be calculated. Other five materials showed good inhibitory effect of tyrosinase and can be used for the whitening materials.