• KSTLE International Journal
• /
• v.4 no.1
• /
• pp.18-26
• /
• 2003

Recently, fluid dynamic bearings (EDBs) have important applications in miniature rotating machines such as those found in the computer information storage industry, due to their outstanding low acoustic noise and NRRO (Non-Repeatable Run Out) characteristics. This research investigates the dynamic behavior of fluid dynamic bearings composed of hydrodynamic herringbone groove journal and spiral groove thrust bearing. The five degrees of freedom of FDB are considered to describe the real motion of a general rotor bearing system. The Reynolds equation and five nonlinear equations of motion for the dynamic behavior are solved simultaneously, The incompressible Reynolds equation is solved by using the finite element method (FEM) in order to calculate the pressure distribution in a fluid film and the five equations of motion by using the Runge-Kutta method. The reaction forces and moments are obtained by integrating the pressure along the fluid film. Numerical results are validated by comparing with the previously published experimental and numerical results. As a result the dynamic behavior of FDB spindle such as orbit, floating height, and angular orbit is investigated by considering the conical motion under the static and dynamic load conditions.

• Journal of Biomedical Engineering Research
• /
• v.24 no.5
• /
• pp.435-442
• /
• 2003

In this paper, biomechanical aspects of dynamic대학교postural responses against forward perturbations were experimentally determined simultaneous measurements of joint angles, accelerations. EMG activations, center of pressure(CoP) movements and ground reaction forces(GRF), Thirteen young healthy volunteers, stood on a flat platform, were translated into the forward direction by an AC servo-motor at two separate velocities(0.1m and 0.2m/s). In order to recover postural balance against the forward perturbation, joint motions were observed in the sequence of the ankle dorsiflexion, the knee flexion and then the hip flexion during the later acceleration phase. Both acceleration patterns at the heel and the sacrum were shown the forward acceleration pattern during the later acceleration phase and early of constant velocity phase as increasing platform velocity, respectively. Tibialis anterior(TA) for the ankle dorsiflexion and biceps femoris(BF) for the knee flexion. the primary muscle to recover the forward perturbation, was activated during the half of acceleration phase. Ankle strategy was used for slow-velocity perturbation, but mixed strategy of both ankle and hip used for the fast-velocity perturbation. In addition, parameters of perturbation such as timing and magnitude influenced the postural response against the perturbation.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.25 no.2
• /
• pp.167-178
• /
• 2017

The steering wheel of a vehicle has a typical characteristic of automatically returning to its neutral state when the driver releases it. Steering returnability originated from the tire forces and kingpin moments. It is proportional to the reaction torque that is generated through the rack and column, which are dependent on suspension and steering geometry. It is also important to accurately predict and design it because steering returnability is related to steering performance. In this study, a detailed multibody dynamics model of a vehicle was designed by using ADAMS/Car and simulated for steering returnability. In addition, a tolerance analysis of the chassis system in terms of part dimension and properties has been performed in order to minimize the design parameters. The sensitivity of the selected design parameters was then analyzed via Design of Experiments(DOE). As a result, we were able to obtain the main parameters through a contribution analysis. It can be used to predict steering returnability and improve its performance, which is represented by the angle of restoration and laterality.

• Korean Journal of Applied Biomechanics
• /
• v.17 no.1
• /
• pp.69-79
• /
• 2007

The purpose of this study was to examine the characteristics of throwing motion in the elementary school students from the developmental point of view. For the purpose of this, total of nine subjects(each of three students in five, third, and first grades) were participated. They were asked to throw the ball as far as they can and the motions were videotaped with the 30frames/sec and 1/500 shutter speed. The successful motions for each subject were selected for three dimensional analysis. The collected data were analyzed using DV express 1.0 and Kwon3D 3.0 softwares. The results obtained from this study were as follows; 1. Total time for the throwing motion of the first grade was longer than that of the fifth and third grades. 2. The resultant displacement and velocity of COM for the fifth and third grades were greater than that of the frist grade. 3. The first grade tended to flex the trunk forward excessively during the throwing motion. 4. The fifth grade tended to place the upper arm close to the sagital plane and move the forearm and hand freely. 5. Looking at the greater variability of the angular velocity of the hand segment, the fifth grade seemed to have faster and more flexible movement of the wrist. 6. There were somewhat differences in the patterns and magnitudes of ground reaction forces among the different grades.

• Proceedings of the KIEE Conference
• /
• 1995.07b
• /
• pp.874-876
• /
• 1995

Force and compliance control has been used in the control of legged walking vehicles to achieve superior terrain adaptability on rough terrains. The compliance control requires distribution of the vehicle load over the supporting legs. However, the constraint equations for ground reaction forces of supporting legs are generally underdetermined, allowing an infinite number of solutions. Thus, it is possible to apply an optimization criteria in solving the force setpoint problem. It has been observed that the previous force setpoint optimization methods sometimes cause a system stability problem and/or the load distribution among supporting legs is not well balanced due to a memory effect on the solution trajectory, This paper presents an iterative force setpoint method to solve this problem using an interpolation technique. By simulation it was shown that an excessive load unbalance among supporting legs and the memory effect in the force trajectory are alleviated much with the proposed method.

• Proceedings of the ESK Conference
• /
• 1993.04a
• /
• pp.1-9
• /
• 1993

A human gait study is required for the biomechanical design of running shoes. A tow-dimensional dynamic model was developed in order to analyze lower extremity kinematics and loadings at the right ankle, knee, and hip joints. The dynamic model consists of three segments, the upper leg, the lower leg, and the foot. Each segment was assumed to be a rigid body with one or two frictionless hinge joints. The lower extremity motion was assumed to be planar in the sagittal plane. A young male subject was involved in the gait test and his anthropometric data were measured for the calculation of segement mass and moment of inertia. The experimental data were obtained from three trials of walking at 1.2m/s. The foot-floor reaction data were measured from a Kistler force plate. The kinematic data were acquired using a three-dimensional motion measurement system (Expert Vision) with six markers, five of which were placed on the right lower extremity segments and the rest one was attached to the force plate. Based on the model and experimental data for the stance phase of the right foot, the calculated vertical forces reached up to 492, 540, and 561 N at the hip, knee, ankle joints, respectively. The flexion-extension moments reached up to 155, 119, and 33 Nm in magnitude at the corresponding joints.

• Journal of the Ergonomics Society of Korea
• /
• v.27 no.3
• /
• pp.93-101
• /
• 2008

Wedged soles and rocker soles are widespread shoe designs used to prevent the disorders and reduce the pain of the lower extremity caused by arthritis or diabetic feet. In this study, the effect of a shoe with a laterally wedged sole and a rocker sole simultaneously was analyzed on the kinematics and kinetics of the ankle joint during normal walking. Eight male participants without a history of lower extremity disorders were recruited. Each participant performed twenty walking cycles for each of three walking conditions: bare foot, wearing normal shoes and wearing shoes with laterally wedged rocker soles. The differences between the three walking conditions were statistically investigated including spatio-temporal variables, angular displacements, joint moments and ground reaction forces. The results showed that the laterally wedged rocker sole decreased the sagittal variation of angular displacements as well as the frontal/sagittal average moment on the ankle joints compared to the flat sole. In addition, the rate of angular displacements and loading decreased during the heel contact phase.

• Structural Engineering and Mechanics
• /
• v.55 no.5
• /
• pp.1015-1035
• /
• 2015

A three-dimensional (3D) numerical analysis for the train-bridge interaction (TBI) system is actively developed in this study in order to investigate the vibration characteristics of rigid-frame reinforced concrete (RC) viaducts in both vertical and lateral directions respectively induced by running high-speed trains. An analytical model of the TBI system is established, in which the high-speed train is described by multi-DOFs vibration system and the rigid-frame RC viaduct is modeled with 3D beam elements. The simulated track irregularities are taken as system excitations. The numerical analytical algorithm is established based on the coupled vibration equations of the TBI system and verified through the detailed comparative study between the computation and testing. The vibration responses of the viaducts such as accelerations, displacements, reaction forces of pier bottoms as well as their amplitudes with train speeds are calculated in detail for both vertical and lateral directions, respectively. The frequency characteristics are further clarified through Fourier spectral analysis and 1/3 octave band spectral analysis. This study is intended to provide not only a simulation approach and evaluation tool for the train-induced vibrations upon the rigid-frame RC viaducts, but also instructive information on the vibration mitigation of the high-speed railway.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.30 no.4
• /
• pp.155-163
• /
• 2007

Future war needs a lot of changes for military organization. Specially, concept of the "Speed" is raised importantly after Iraq war of U.S. Armed Forces. So, He is a lot of studying supply chain for logistical support speed improvement. Korea Marine Corps has made an efforts to improve supply chain. However it is real that is putting various techniques by prescription rather than fundamental change. These simplicity prescriptions are not only systematic but also insufficient for Marine Corps' survival. In addition, Korea marine corps in actuality is depending on many members in marine and navy in feed chain. Thus it is not establishing even tactical, decision-making plan of operation for support ability cultivation. Therefore, in this study, with Sense and Response concept that is United States Marine Corps' support strategy, presented theoretical background and basis frame that serve that Korea Marine Corps's supply chain changes to perception reaction formation.

• KDI Journal of Economic Policy
• /
• v.36 no.2
• /
• pp.1-64
• /
• 2014

This paper attempts to search the driving forces of the Korean economy after 2000 by analyzing an estimated DSGE model and observing the degree of implementation regarding non-systematic parts of both the monetary and fiscal policy during the global financial crisis. Two types of trends, various cyclical factors and frictions are introduced in the model for an empirical analysis in which historical decompositions of key macro variables are quantitatively assessed after 2000. While the monetary policy during the global financial crisis have reacted systematically in accordance with the estimated Taylor rule relatively, the fiscal policy which was aggressively expansionary is not fully explained by the estimated fiscal rule but more by the large magnitude of non-systematic reaction.