• Journal of Environmental Health Sciences
• /
• v.21 no.2
• /
• pp.68-74
• /
• 1995

The optimum conditions was synthesized for the formation of Magnetite ($Fe_3O_4$) by air bubbling with the suspensions obtained by mixing Ferrous sulfate ($FeSO_4\cdot 7H_2O$) and Sodium Hydroxide (NaOH) solution in various values equivalent ratio($R=2NaOH/FeSO_4$) were studied. The changes of the structure were measured with XRD, $EM and BET. Equivalent ratio R: 0.65 was synthesized Goethite ($\alpha$-FeOOH), which becomes Maghemite ($\gamma=Fe_2O_3$) by dehydration, reduction and oxidation process. At the equivalent ratio over 1 (R>1), Magnetite ($Fe_3O_4$) was synthesized directly. The oxygen-deficient Magnetite ($Fe_3O_{4-\delta}$), which is obtained by flowing $H_2$ gas(100 ml/min) through the synthesis Magnetite at 350$\circ$C for 4 hr. By using it, was researched the decomposition reaction of $CO_2$. $CO_2$ was decomposed nearly 100% in 45 minutes by the oxygen-deficient Magnetite.

• Journal of the Korean Ceramic Society
• /
• v.33 no.4
• /
• pp.441-447
• /
• 1996

Sb doped SnO2(ATO:Antinomy doped Tin Oxide) thin films were prepared by a DC magnetron spttuering method using oxide target and the deposition characteristics were investigated. The experimental conditions are as follows :Ar flow rate : 100 sccm oxygen flow rates ; 0-100 sccm deposition temperature ; 250 -40$0^{\circ}C$ DC sputter powder ; 150~550 W and sputtering pressure ; ; 2~7 mTorr. Deposition rate greatly depends not on the deposition temperature but on the reaction pressure oxygen flow rate and sputter power,. when the sputter powder is low ATO thin films with (110) preferred orientation are deposited. And when the sputter power is high (110) prefered orientation appeares with decreasing of oxygen flow rate and increasing of suputte-ring pressure.

• Nuclear Engineering and Technology
• /
• v.52 no.8
• /
• pp.1638-1649
• /
• 2020

In the case of a severe accident in a Light Water Reactor, the issue of late release of fission products, from the primary circuit surfaces is of particular concern due to the direct impact on the source term. CsI is the main iodine compound present in the primary circuit and can be deposited as particles or condensed species. Its chemistry can be affected by the presence of molybdenum, and can lead to the formation of gaseous iodine. The present work studied chemical reactions on the surfaces involving gaseous iodine release. CsI and MoO₃ were used to highlight the effects of carrier gas composition and oxygen partial pressure on the reactions. The results revealed a noticeable effect of the presence of molybdenum on the formation of gaseous iodine, mainly identified as molecular iodine. In addition, the oxygen partial pressure prevailing in the studied conditions was an influential parameter in the reaction.

• 한국생물공학회:학술대회논문집
• /
• 2005.10a
• /
• pp.730-734
• /
• 2005

Flow injection analysis (FIA) system was developed to monitor glucose concentrations in biotechnological processes. A fiber optic oxygen sensor was used to determine consumption of oxygen concentration by reaction of immobilized glucose oxidase (GOD). The GOD was immobilized on VA-Epoxy carrier and integrated into FIA system. A calibration curve for glucose was obtained in the range of 0.5 $g/L{\sim}3.0$ g/L.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.2
• /
• pp.95-100
• /
• 1998

A helical inductively coupled plasma asher, which produces low energy and high density plasma, has been built and investigated for photoresist stripping process. Oxygen ion density in the order of $10^{11}/cm^3$ is measured by Langmuir probe, and higher oxygen radical density is observed by Optical Emission Spectrometer. As RF source power is increased, the plasma density and thus photoresist stripping rate are increased. Independent RF bias power to the wafer stage provides a dc bias to the wafer and an ability to add the ion assisted reaction. At 1 KW of the source power, the coupling mechanism of the RF power to the plasma is changed from the inductive mode to the capacitive one at about 1 Torr. This change causes the plasma density and ashing rate decreases abruptly. The critical pressure of the mode change becomes larger with larger RF power.

• Proceedings of the KOSOMBE Conference
• /
• v.1998 no.11
• /
• pp.237-238
• /
• 1998

The kinetics of sulfite oxidation must be fast and the concentration of sulfite must be low to emulate oxygen uptake by blood. The kinetics were studied yielding a first order rate constant in sulfile, zero order in oxygen. Limitations of the technique were evaluated using the experimental rate constant and an adaptation of Lightfoot's approximation, while the reaction of hemoglobin is reversible and essentially instantaneous, that for sulfite is irreversible and finite. Thus if the approach to saturations not monotonic or if the mass transfer resistance is significantly lowered, e. g. when blood film thicknesses are thinner than a few hundred microns, deviations may occur.

• Journal of the Korean Chemical Society
• /
• v.23 no.6
• /
• pp.396-401
• /
• 1979

Measuring the reaction rate of bilirubin and oxodipyrromethenes with singlet oxygen, we have found oxodipyrromethenes to be better singlet oxygen trapping agents than diphenyl-isobenzofuran, the best such agent known so far. The photooxygenation rates of bilirubin and the model compounds, oxodipyrromethenes approached the diffusion control threshold. A new oxodipyrromethene is synthesized.

• Bulletin of the Korean Chemical Society
• /
• v.23 no.6
• /
• pp.799-803
• /
• 2002

Partial oxidation of methane has been conducted over $CeO_2$and it has been found that $CeO_2$has an extraordinary catalytic activity in the reaction. Its activity was strongly dependent on the $CH_4/CO_2$ ratio. Total combustion was dominant with stoichiometric feed ratio$(CH_4/O_2=$ 2.0) but partial oxidation was achieved between the $CH_4/O_2$ ration of 3.8 4.3 and the period depended upon the feed composition. The proposed raaction mechanism it that oxygen vacancies in raduced deria are supplied with oxygen molecules from the reactant, and then activate adsorbed oxygen, followed by releasing activated axygen species reacting with methane to produce $H_2$ and CO.

• Journal of Applied Biological Chemistry
• /
• v.42 no.3
• /
• pp.130-133
• /
• 1999

Lipoxygenase activities of three cultivars of black rice (Chindo, Suwon-415, Yongkeum-1) were determined using an oxygen polargraphic method to measure oxygen uptake. Studies at different pH levels revealed that the optimum pH was about pH 7.0 for Suwon-415 and pH 7.5 for Chindo and Yongkeum-1. The specific activities of Chindo, Suwon-415 and Yongkeum-1 at optimal pH were 41.0, 27.3, and 29.6 unit/mg-protein, respectively. In all the cultivars, there was an increase in the activity with increase in reaction temperature. Enzyme activity was tested at different concentrations of the substrate. The resulting $K_m$ and $V_{max}$ values of Chindo, Suwon-415, and Youngkeum-1 were 0.059, 0.050, and 0.066 mM and 2020, 2283, and 1616 unit/g-grain, respectively. Enzyme activity decreased at all storage temperatures(25, 4, and $-40^{\circ}C$).

• Journal of the Korean Society of Combustion
• /
• v.11 no.1
• /
• pp.11-18
• /
• 2006

In this work, $TiO_2$ nanoparticles were synthesized using $N_2-diluted$ and Oxygen-enriched coflow hydrogen diffusion flames. The effect of flame temperature on the characteristics of the formed $TiO_2$ nanoparticles was investigated. The measured maximum centerline temperature of the flame ranged from 2,103 K for oxygen-enriched flame to 1,339 K for $N_2-diluted$ flame. The visible flame length and the height of the main reaction zone were characterized by direct photographs. The characteristics of synthesized $TiO_2$ nanoparticles were analyzed by SEM and TEM images. From these images, it was evident that the formed nanoparticles were divided into two sorts. In the higher temperature region, over the 1,700 K, $TiO_2$ nanoparticles having spherical shapes with diameters about 60 nm were synthesized. In the lower temperature region, below the 1,600 K, the diameters of formed nanoparticles having unclear boundaries were ranged from 35 - 50 nm.