• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.6 no.9
• /
• pp.2266-2284
• /
• 2012

Recent studies have indicated that a significant improvement in wireless video throughput can be achieved by Cross Layer Design with Side-information (CLDS) protocols. In this paper, we derive the operational rate of a CLDS protocol operating over a realistic wireless channel. Then, a Rate-Distortion (R-D) empirical model for above-capacity Scalable Video Coding (SVC) is deduced to estimate the loss of video quality incurred under inaccurate rate estimation scenarios. Finally, we develop a novel Unequal Error Protection (UEP) scheme which leverages the characteristics of LDPC codes to reduce the distortion of video quality in case of typically-observed burst wireless errors. The efficacy of the proposed rate adaptation architecture over conventional protocols is demonstrated by realistic video simulations using actual IEEE 802.11b wireless traces.

• Proceedings of the IEEK Conference
• /
• 2002.06d
• /
• pp.29-32
• /
• 2002

In typical block-based video coding, the objective of RC(Rate Control) is to select the quantization parameters so that the encoder produces bits at the rate of the channel and the overall distortion is minimized. To reduce the huge amount of computations required for offline RC, there have been significant efforts to speed up the process of video encoders. Those efforts have been mainly focused on the modes for bit rate and distortion in types of coders, in terms of the quantization parameters. Because previous works related to model based online RC are based on statistics of previous frame, it occurs the problem such that allocates bits unequally without regard to current frame statistics. In this thesis, an equal bit allocation scheme using current frame statistics is proposed.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.12
• /
• pp.6052-6059
• /
• 2012

This paper deals with the Harmonics on the power lines in the computer room. The voltage and current at each phase of electric power from UPS to the load must be ensured less than 5% distortion rates according to the regulation terms from KEPC(Korea Electric Power Corporation) and the KSC4310 Uninterruptible Power Supply regulation. However, measurements show that the voltage distortion rate conforms those regulations but the current distortion rate exceeds much the limit. This current distortion is stabilized from 34.98% to 15.22% nearly half by an AC current filter.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.40 no.5
• /
• pp.417-425
• /
• 2003

H.264, which is the latest video coding standard of both ITU-T(International Telecommunication Union-Telecommunication standardization sector) and MPEG(Moving Picture Experts Group), adopts new video coding tools such as variable block size motion estimation, multiple reference frames, quarter-pel motion estimation/compensation(ME/MC), 4${\times}$4 Integer DCT(Discrete Cosine Transform), and Rate-Distortion Optimization, etc. These new video coding tools provide good coding of efficiency compared with existing video coding standards as H.263, MPEG-4, etc. However, these new coding tools require the increase of encoder complexity. Therefore, in order to apply H.264 to many real applications, fast algorithms are required for H.264 coding tools. In this paper, when encoder MacroBlock(MB) mode is decided by rate-distortion optimization tool, fast mode decision algorithm by skipping variable block size ME/MC and spatial-predictive coding, which occupies most encoder complexity, is proposed. In terms of computational complexity, the proposed method runs about 4 times as far as JM(Joint Model) 42 encoder of H.264, while the PSNR(peak signal-to-noise ratio)s of the decoded images are maintained.

• Journal of Communications and Networks
• /
• v.7 no.2
• /
• pp.144-156
• /
• 2005

Video streaming over wireless networks is challenging due to node mobility and high channel error rate. In this paper, we propose a multi-source video streaming (MUVIS) system to support high quality video streaming service over IEEE 802.1l-based wireless networks. We begin by collocating a streaming proxy with the wireless access point to help leverage both the media server and peers in the WLAN. By tracking the peer mobility patterns and performing content discovery among peers, we construct a multi-source sender group and stream video using a rate-distortion optimized scheme. We formulate such a multi-source streaming scenario as a combinatorial packet scheduling problem and introduce the concept of asynchronous clocks to decouple the problem into three steps. First, we decide the membership of the multisource sender group based on the mobility pattern tracking, available video content in each peer and the bandwidth each peer allocates to the multi-source streaming service. Then, we select one sender from the sender group in each optimization instance using asynchronous clocks. Finally, we apply the point-to-point rate-distortion optimization framework between the selected sender-receiver pair. In addition, we implement two different caching strategies, simple caching simple fetching (SCSF) and distortion minimized smart caching (DMSC), in the proxy to investigate the effect of caching on the streaming performance. To design more realistic simulation models, we use the empirical results from corporate wireless networks to generate node mobility. Simulation results show that our proposed multi-source streaming scheme has better performance than the traditional server-only streaming scheme and that proxy-based caching can potentially improve video streaming performance.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.4C
• /
• pp.321-329
• /
• 2008

H.264/AVC video coding standard enables a considerably higher improvement in coding efficiency compared with previous standards such as MPEG-2, H.263 and MPEG-4. To achieve this, for each macro-block in H.264/AVC, Rate-Distortion Optimization (RDO) technique is employed to select the best motion vector, reference frame, and macro-block mode. As a result, computational complexity is increased significantly whereas RDO achieve higher improvement. This paper presents fast intra mode selection algorithm based on constraints of frequency characteristics which are derived from intra coding modes of H.264/AVC. First of all, we observe the features of each intra mode through the frequency analysis of image. And then proposed Frequency Error Costs (FECs) are calculated to select the best mode which has minimum cost. Computational complexity is considerably reduced because rate-distortion costs only calculate the candidate modes which are set of best mode and its neighbouring two modes. Experimental results show that proposed algorithm reduces the complexity dramatically maintaining the rate-distortion performance compared with H.264/AVC reference software.

• Imaging Science in Dentistry
• /
• v.48 no.4
• /
• pp.255-259
• /
• 2018

Purpose: This study proposes a new ball-type phantom for evaluation of the image layer of panoramic radiography. Materials and Methods: The arch shape of an acrylic resin phantom was derived from average data on the lower dental arch in Korean adult males. Metal balls with a 2-mm diameter were placed along the center line of the phantom at a 4-mm mesiodistal interval. Additional metal balls were placed along the 22 arch-shaped lines that ran parallel to the center line at 2-mm buccolingual intervals. The height of each ball in the horizontal plane was spaced by 2.5 mm, and consequently, the balls appeared oblique when viewed from the side. The resulting phantom was named the Panorama phantom. The distortion rate of the balls in the acquired image was measured by automatically calculating the difference between the vertical and horizontal length using $MATLAB^{(R)}$. Image layer boundaries were obtained by applying various distortion rate thresholds. Results: Most areas containing metal balls (91.5%) were included in the image layer with a 50% distortion rate threshold. When a 5% distortion rate threshold was applied, the image layer was formed with a small buccolingual width along the arch-shaped center line. However, it was medially located in the temporomandibular joint region. Conclusion: The Panorama phantom could be used to evaluate the image layer of panoramic radiography, including all mesiodistal areas with large buccolingual width.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.6
• /
• pp.131-137
• /
• 2013

The barrel distortion makes serious problems in a wide-angle camera employing a lens of a short focal length. This paper presents a low-complexity hardware architecture for a real-time barrel distortion corrector and its implementation. In the proposed barrel distortion corrector, the conventional algorithm is modified so that the correction is performed incrementally, which results in the reduction of the number of required hardware modules for the distortion correction. The proposed barrel distortion corrector has a pipelined architecture so as to achieve a high-throughput correction. The correction rate is 74.86 frames per sec at the operating frequency of 314MHz in a $0.11{\mu}m$ CMOS process, where the frame size is $2048{\times}2048$. The proposed barrel distortion corrector is implemented with 14.3K logic gates.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.29B no.8
• /
• pp.66-73
• /
• 1992

This paper proposes a new motion estimation algorithm which takes into account the rate-distortion relation in encoding motion compensated error images. The proposed algorithm is based on a new block-matching criterion which is the function of not only the mean squared block-matching error but also the code length for the entropy coded motion vector. The proposed algorithm optimizes the trade-off between the bit rate for motion compensated error images and the bit rate for the motion vectors. Simulation results show that in the motion compensated image coding the proposed motion estimator improves the overall performance by 0.5 dB when compared to the motion estimator which uses MSE only.

• Proceedings of the Korea Society of Information Technology Applications Conference
• /
• 2002.11a
• /
• pp.66-71
• /
• 2002

In Generally, a imbedding and extracting is good as watermark using a random dot image. In this paper, when the autostreogram which has some randomness is used watermark image, distortion rate is low and extraction rate is high. Using this quality, when any logo image is transformed to same image domain randomly, distortion rate is low and extraction rate is high, more over the robustness is good in spite of hard clipping.