• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.52 no.11
• /
• pp.508-511
• /
• 2003

In this paper, electrical characteristics of inductively coupled plasma in an electrodeless fluorescent lamp were investigated using a Langmuir probe with a variation of argon gas pressure. The RF output was applied in the range of 5 ∼ 50 (W) at 13.56 (MHz). The internal plasma voltage of the chamber and the probe current were measured while varying the supply voltage to the Langmuir probe in the range of -100 (V) ∼+100 (V). When the pressure of argon gas was increased, electric current was decreased. There was a significant electric current increase from l0W to 30 〔W〕. Also, when the RF power was increased, electron density was increase. This implies that this method can be used to find an optimal RF rower for efficient light illumination in an electrodeless fluorescent lamp.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.13 no.2
• /
• pp.229-235
• /
• 1989

The influence of monogalvanized layer to fatigue strength of two different mating metal specimens (HS*GA, HS*GAB) of high strength steels(HS) and of monogalvanized steel sheets(GA, GAB) were investigated under tensile-shear repeated load, and hardness test. Some of the results are; (1) The main cause of crack initiation and growth at high load range is plastic bending hinge. (2) In low load range, the cracks initiated near the nugget front where the hardness variation is steep.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.51 no.7
• /
• pp.322-327
• /
• 2002

Temperature-dependent current-voltage characteristics of organic light-emitting diodes(OLEDs) were studied in a device structure of ITO/TPD/Alq$_3$/Al to understand conduction mechanism. The current-voltage characteristics were measured in the temperature range of 8K ~ 300K. We analyzed an electrical conduction mechanism of the OLEDS using space-charge-limited current(SCLC) and Fowler-Nordheim tunneling. In the temperature range above 150k, the conduction mechanism could be explained by space charge limited current from the inversely proportional temperature dependence of exponent m. The characteristic trap energy is found to be about 0.15ev. At low temperatures below 150k, the Fowler-Nordheim tunneling conduction mechanism is dominant. We have obtained a zero field barrier height to be about 0.6~0.8eV.

• Journal of Magnetics
• /
• v.2 no.4
• /
• pp.135-137
• /
• 1997

We report the salient features of the magnetic properties of amorphous TM70Cr5Si10B15(TM=Fe, Co, Ni) alloys. The temperature dependence of magnetization for amorphous ribbons were measured by a SQUID and a VSM from 5 K to 700 K under an external field of 10 kOe. Except TM70Cr5Si10B15 that shows a paramagnetic behaviour, both Fe and Co based amorphous alloys show a typical ferromagnetic thermo-magnetization curves. For these two ferromagnetic alloys, the saturation magnetization in the temperature range from 5 K to about 0.4 Tc can be descrived by the Bloch relation, Ms (T)=Ms(0) [1-BT3/2-CT5/2]. The spin wave stiffness constants and the range of exchange interaction were analyzed from the magnetization behaviour. The variation of the magnetic properties are discussed and compared with the composition of the alloys.

• Korean Journal of Microbiology
• /
• v.10 no.1
• /
• pp.9-28
• /
• 1972

1. To get the suitable yeasts for the tratment of waste liquor from pulp and paper industries, the 162 yeasts were isolated from the waste liquor, decayed trees and sewage (1, 7, 8, 9, 1971). 17 species were chosen by its ability to assimilate the carbon compounds and indentified. 2. All of the strain was increased its growing ability by agitation. In particular, the strain 912, strain 613, strain 100, strain 732 showed excellent high productive ratio(A/$A_{0}$). 3. The optimum temperature of the strains rangel $27^{\circ}C$ and $30^{\circ}C$. 4. Most of the strain was grown actively in 10C/5N-composition and strain 113, strain 432, strain 735, strain 936, and strain 912 showed its optimum growing in 15C/5N-composition and 5C/5N-composition, respectively. 5. The optimum pH of the strains lay within range pH 4.5-6. Effect of the variation of pH on the growth was nearly negligible within this range. 6. The strain 912, strain 100, strain 613, strain 311, strain 235, and strain 732 were expected for the utilization to the treatment of the waste liquor from pulp and paper industries.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.66 no.2
• /
• pp.379-382
• /
• 2017

This paper proposes a $4{\times}4$ broadband phased array antenna using a Left-Handed Transmission Line (LHTL) based phase shifter. The phased array is constructed with sixteen quasi-Yagi antenna elements and the phase shifters, as well as four power dividers. A key component of the system, the LHTL based phase shifter is able to control a phase delay of incident waves linearly and continuously. The fabricated phased array antenna operate for a frequency range of 800 MHz (1.6 GHz~2.4 GHz). The beam scanning range of the $4{\times}4$ array antenna is ${\pm}27^{\circ}$ horizontally and vertically while the antenna gain is maintained with a variation of ${\pm}1.4dBi$.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.25 no.11
• /
• pp.916-921
• /
• 2012

This research measured the dielectric properties of silicone rubber with various hardness in 100 Hz~3 MHz, $30{\sim}170^{\circ}C$ conditions. When the hardness increases from 65 degree to 75 degree, the dielectric loss increased within frequency range of 100 kHz~3 MHz and was a little change in dielectric loss within temperature range of $90^{\circ}C{\sim}170^{\circ}C$. Thermogravimetric Analysis (TGA) showed the weight change rate increased a little while heated until $800^{\circ}C$. Scanning Electron Microscope (SEM) measurement showed that Aluminium Trihydroxide($AlOH_3$) which acts as a reinforcement agent reduced the size of the particles as the hardness increased.

• Journal of Power Electronics
• /
• v.18 no.3
• /
• pp.714-722
• /
• 2018

This paper presents a wide-range speed control scheme of brushless DC (BLDC) motors based on a hall sensor with separated low- and normal-speed controllers. However, the use of the hall sensor signal is insufficient to detect motor speed in the low-speed region because of low sensor resolution and time delay. In the proposed method, a micro-stepping current control method according to the torque angle variation is presented. In this mode, the motor current frequency and rotating angle are determined by the reference speed without the actual speed fed by the hall sensor. The detected torque angle is used to adjust the current value in a limited band to control the current value in accordance with the load. The torque angle is detected exactly at the changing point of the hall sensor signal. The rotor can follow the rotating flux with the variable torque angle. In a normal speed range, the conventional vector control scheme is used to control the motor current with a PI speed controller using the hall sensor. The torque characteristics are analyzed on the basis of the back EMF and current shape. To adopt the vector control scheme, the continuous rotor position is estimated by the measured speed and hall sensor position. At the mode changing point between low and normal speed range, the proper initial current command and reference rotor position are calculated. The calculated current command can reduce the torque ripple during transient mode. The proposed method is simple but effective in extending the speed control range of a conventional BLDC motor with hall sensor without the need for a high-resolution encoder. The effectiveness of the proposed method is verified by various experiments on a practical BLDC motor.

• Journal of Biosystems Engineering
• /
• v.15 no.1
• /
• pp.33-43
• /
• 1990

Spectral reflectance of paddy, brown rice, milled rice, greenish grain, yellow grain and denatured grain were measured over the range of 340 to 820 nm with "Double Beam Spectrophotometer(Model UV-180)". Variation in the reflectance depending on milling degree of milled rice appeared greatest over the range of 420 to 500 nm, and that between white rice and other rice samples appeared greatest near 500 nm. On the basis of the above results, a whiteness meter to measure milling degree of rice was manufactured using tungsten lamp, photodiodes and amplifier, and its performance was compared with the existing whiteness meters (KETT and Z-II optical sensor). There were very high correlations among those whiteness meters.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.1
• /
• pp.146-154
• /
• 2015

This paper proposes a control method for maintaining the energy level for a supercapacitor energy storage system coupled with a wind generator to stabilize wind power output. Although wind power is green and clean energy source, disadvantage of the renewable energy output power is fluctuation. In order to mitigate the fluctuating output power, supercapacitor energy storage system (SCESS) and wind power simulator is developed. A remaining energy supercapacitor (RESC) control is introduced and analyzed to smooth for short-term fluctuating power and maintain the supercapacitor voltage within the designed operating range in the steady as well as transient state. When the average and fluctuating component of power increases instantaneously, the RESC compensates fluctuating power and the variation of fluctuating power is reduced 100% to 30% at 5kW power. Furthermore, supercapacitor voltage is maintained within the operating voltage range and near 50% of total energy. Feasibility of SCESS with RESC control is verified through simulation and experiment.