• Journal of Power Electronics
• /
• v.11 no.4
• /
• pp.424-429
• /
• 2011

In this paper, the simulator of an on-line monitoring system for the range extender electric vehicle has been developed. The messages from the four control modules, the air pressure and fuel level sensors data, and the on/off switching states of 31 indicator lamps can be received through the control area network (CAN), and displayed on the graphic panel. The simulator was designed using the four DSP boards, variable resistors, and toggle switches instead of the four control modules, sensors, and switching state of indicator lamps on an actual series hybrid electric vehicle (SHEV) bus, respectively. The performance of the monitoring technologies was verified with the simulator at the laboratory, and then it was tested on an actual SHEV bus. The simulator is very useful at the initial development of the monitoring system at the hybrid-type or electrical vehicles.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.5
• /
• pp.2075-2080
• /
• 2013

A Coolant core for Range Extender engine has been developed using CFD technique. Coolant by-pass has been added to the improved model to reduce temperature near and between exhaust valve. Due to the increased coolant flow-rate both around the second cylinder block and between exhaust valves, improved model shows no significant stagnant flow compared with base model. Finally, the improved model shows improved heat transfer coefficients near exhaust valves, and 5% reduced pressure-drop through the coolant core. Reduced pressure-drop may increase the fuel efficiency by reducing the load of a coolant pump.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.6
• /
• pp.2575-2580
• /
• 2013

An intake port for Range Extender engine has been developed using CFD technique. Three dimensional intake port model has been built and computational analysis has been performed. Computed non-dimensional flow coefficient, swirl ratio and swirl number have been compared with the experimental result. Convex and concave curvature of the intake port have been optimized to reduce recirculation flow and flow resistance. Finally, the mean flow coefficient is 0.383 and the mean swirl number is 1.544. The intake port shows relatively excellent performance compared with those of general 2 valve engine system intake ports.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.11
• /
• pp.529-535
• /
• 2018

The range extender vehicle runs on a mechanism that allows the small power generation engine to start in the most efficient specific operating range to charge the battery and extend the mileage. In this study, we developed a step motor type intake air supply system that replaces existing throttle body system to develop a simple low cost control logic system. The system was applied to the existing base engine, and in order to improve the performance by increasing the amount of intake air, the effect of changing the length of the intake and exhaust manifold was experimentally examined. As a result, the Type B intake air control actuator operated by one step motor showed higher performance than the Type A in all the operation region, but the performance was lower than that of the base engine due to the increase of flow resistance. To improve this, it was confirmed that the engine performance was improved at both speeds of 2200rpm and 4300rpm when the 140mm adapter was installed in the intake manifold and when the newly designed 70mm exhaust manifold was applied. Through this process, high - precision operation control was realized by connecting the generator load to the optimized engine for the range extender electric vehicle. Experimental results showed that the speed change rate was within ${\pm}2.5%$ at 2200rpm in 1st stage and 4300rpm in 2nd stage and the speed follow-up result of 610 rpm/s was obtained when the speed was increased from 2200rpm to 4300rpm.

• Polymer(Korea)
• /
• v.29 no.1
• /
• pp.81-86
• /
• 2005

In this study, waterborne polyurethanes were synthesized with poly(tetramethylene glycol) (PTMG), polycarprolactone PCL), dimethylol propionic acid (DMPA) and different molar ratio of chain extender. Particle size, polydispersity, thermal and mechanical properties of waterborne polyurethane were investigated. The particle size of waterborne polyurethane was in the range of 5∼200 nm and decreased with increasing the amounts of PCL and chain extender. Glass transition temperatures ($T_g$) were in the range of -70∼-45 ${\circ}C$ and increased with as PCL and chian extender (ED) contents increased. The $T_g$ of polyurethane prepared from the mixture showed similar trends as compared with those of in the same values of synthetic polyurethane using PTMG or PCL, respectively. Also, mechanical properties of mixed polyols (PTMG and PCL) were lower than those of PTMG and PCL, respectively.

• Asian-Australasian Journal of Animal Sciences
• /
• v.19 no.12
• /
• pp.1716-1721
• /
• 2006

The present study was conducted to observe the effect of osmolality of glycerolated TEST-yolk glycerol extenders on post-thawing sperm kinematics of ram spermatozoa of the native Malpura breed maintained in a semi-arid tropical environment. Good quality semen obtained from adult rams was pooled, split and diluted to 1,000 million spermatozoa per ml in complete TEST-yolk-glycerol extenders of 900, 1,200, 1,500 and 1,800 mOsm/kg osmolality. Diluted semen samples were loaded in 0.25 ml straws and cooled down to $-125^{\circ}C$ freezing temperature at the rate of $-25^{\circ}C$ per minute under controlled conditions before plunging into liquid nitrogen for storage. The thawing of straws was performed at $50^{\circ}C$ in a water bath for 10 seconds and sperm kinematics of the frozen-thawed spermatozoa were assessed by a computer-assisted sperm analysis technique. Osmolality of diluent had no significant effect on post-thawing % motility, % rapid, % medium and % slow moving frozen-thawed spermatozoa but significantly (p< 0.05) affected the % linearity and % straightness. The post-thawing % motility and % rapid motile spermatozoa were highest in samples extended in diluent of 1,500 mOsm/kg osmolality and lowest in 900 mOsm/kg. The curvilinear velocity of spermatozoa was significantly (p<0.05) higher for samples extended in 1,800 mOsm/kg, compared to those in 900 and 1,200 mOsm/kg, but the effect was not significantly different to those extended in diluent of 1,500 mOsm/kg osmolality. The study indicated that ram spermatozoa could tolerate a wide osmolality range for dilution in the complete TEST-yolk-glycerol extender for their cryosurvival. The highest recovery of motile spermatozoa following thawing was achieved in samples extended in the TEST-yolk-glycerol diluent of 1,500 mOsm/kg osmolality.

• Journal of Industrial Convergence
• /
• v.20 no.1
• /
• pp.63-68
• /
• 2022

In schools and corporate buildings, public WiFi Access Points are installed on the ceilings of hallways. In the case of an architectural structure in which a WiFi signal enters through a steel door made of a material with high signal attenuation, Internet connection is frequently cut off or fails when the door is closed. To solve this problem, our research implements an economical and portable WiFi extender using a Raspberry Pi and an auxiliary battery. Commercially available WiFi extenders have limitations in the location where the power plug is located, and WiFi extension using the WiFi hotspot function of an Android smartphone is possible only in some high-end models. However, because the proposed device can be installed at the position where the Wi-Fi reception signal is the best inside the door, the WiFi range can be extended while minimizing the possibility of damage to the original signal. Experimental results show that it is possible to eliminate the shadows of radio waves and to provide Internet services in the office when the door is closed, to the extent that web browsing and real-time video streaming for 720p are possible.

• Reproductive and Developmental Biology
• /
• v.28 no.3
• /
• pp.155-159
• /
• 2004

This study was carried out to investigate the general characteristics and viability of sperm after freezing and thawing and the pregnancy rates after artificial insemination with thawed semen. The rates of viable sperm after slow and rapid freezing were 87.4±3.85% and 70.8±4.45%, respectively which were significantly lower than that of fresh semen control (91.7±3.45%). The mean concentration of epididymal sperm after dilution in 1.0 ml saline and. 3.0 ml extender in a various concentrations of cryoprotectants was 124.5±48.3 x 10/sup 6/ (range of 45 x 10/sup 6/ to 280 X 10/sup 6/ /ml). There was a significant difference not in the percentage of acrosome-reacted sperm, but in the percentage of capacitated sperm, between fresh and frozen-thawed epididymal semen. When frozen-thawed after diluting with tris-buffer extender containing glycerol, DMSO and ethylene glycol with concentration of 2 to 6%, the rates of epididymal sperm exposed to different cryoprotectants ranged from 14.4±4.7% to 20.7±5.8%, 17.8±5.2% to 36.5±4.9%, and 14.4±4.6% to 18.5±5.3%, respectively which were lower compare to fresh semen control. The pregnancy rate after artificial insemination with frozen semen was 70.6%, whereas that with fresh semen was 90.0% in dogs with naturally induced estrus.

• Korean Journal of Optics and Photonics
• /
• v.23 no.1
• /
• pp.6-11
• /
• 2012

A bidirectional TDM-PON link to support 2.5 Gb/s upstream signals of 256 ONUs was considered for an extended transmission distance of 50 km. The power budget of the link was 58 dB for the upstream signal and a SOA was applied as a link extender which had a 25 dB gain. Receiver sensitivity of the upstream signal was -25 dBm for -30 dBm input power to the SOA. When the input power was -10 dBm, pulse overshooting caused by gain transient of the SOA was maximum at 45% and the signal performance degradation gave a power penalty of 1.55 dB for $10^{-12}$ BER. However the penalties diminished rapidly and became negligible as the input power went below -15 dBm. So this input power dynamic range of up to -15 dBm means that it is not positively necessary to use gain control methods for the next generation TDM-PON systems.

• Korean Journal of Animal Reproduction
• /
• v.22 no.4
• /
• pp.405-410
• /
• 1998

Boar semen extender Kp (Hankook Life-Science, Korea) was newly formulated by authors. This study was carried out to investigate the optimal concentrations of EDTA, Tris and citrate buffers in the Kp extender (Basic Kp) on the pH change during storage. And then the motility of boar sperm with the Kp pH stabilized (Modified Kp) was compared with those of commercial products imported into Korea such as BTS (Mini-tube. Germany; BTSg), BTS (Tri-bio, USA; BTSa) and Modena (SGI, USA). The pH values of all extenders were increased gradually with the storage days. Especially, the initial pH of Basic Kp was higher than that of BTSg, BTSa and Modena, and also higher than physiological pH of boar sperm (6.8∼7.5). When Basic Kp was added with various concentrations of EDTA (0, 0.63, 1.25 ＆ 2.37g/L), Tris (0, 0.18, 0.35, 0.71 ＆ 1.42g/L) and Citrate (0, 0.75, 0.81, 1.00, 1.25 ＆ 1.50g/L) buffers for pH down-regulation and stabilization of pH, the group added with 1.25g EDTA, 1.42g Tris and 1.00g Citrate well maintained the neutral range of pH during storage (6.88 at day1 to 7.33 at day6 in Modified Kp), Especially, the concentrations of the buffers added in Modified Kp were lower, until 1/2∼1/4 ranges, than those in Modena and other extenders. The motility of frozen-thawed boar sperm diluted with Modified Kp was significantly higher than that of Basic Kp, BTSg, BTSa and Modena (87.0% vs. 55.0∼71.0% at day1; 13.3% vs. 0∼6.3% at day6), Conclusively, Modified Kp in this experiment was kept the favorable physiological conditions in spite of low concentrations of the buffers and motility of frozen-thawed boar sperm was obtained better than that of Basic Kp and other commercial products such as BTSg, BTSa and Modena.