• 한국군사과학기술학회지
• /
• 제4권1호
• /
• pp.177-187
• /
• 2001

It is important to test and evaluate the variation degree of ship-mounted antenna radiated power with respect to all directions in order to use more effectively antennas that installed on naval ships. The naval ship has various sensors for navigation, communication and electronic warfare, etc. And the performance of these sensors extremely depends on the various characteristics of antenna system to transmit and receive electromagnetic wave. The radiated power pattern of the antenna differs from all aspect angles of the ship because of complex superstructures. It is important to know the weak point(direction) of antenna radiation for appropriate operation. Therefore, the ARP(Antenna Radiation Pattern) of shipboard antennas is measured for the all aspect angles. The results of ARP measurement are utilized as reference for antenna arrangement of newly-built same class warship. This study also describes the development results for the ARP measurement technique, software design and test procedures to measure the radiation pattern of communication equipment antennas using the fixed test site.

• 한국항해학회지
• /
• 제4권2호
• /
• pp.1-6
• /
• 1980

Computer simulation results on the radiation pattern of an ultrasonic beam by the plurall arrangement of the transducers were reported by Sin (1979). This paper describes on the measurement of radiation pattern in case of one vibrox transducer and two vibrox transducers by varying the interval between the transducers. The measured results obtained are as follows; 1. Radiation wave of ultrasonic transducer is propagated to diffuse with spherical wave from center of transducer. 2. In case of one vibrox transducer, the greater the length of transducer, the sharper becomes the radiation pattern. 3. In case of two vibrox transducers, the maine lobe is revealed at the center of two transducers, it is shown difficult to make control freely of radiation pattern by varying merely the interval of transducers.

• 한국산학기술학회논문지
• /
• 제11권11호
• /
• pp.4537-4542
• /
• 2010

본 논문에서는 차량 내부에서 발생되는 안테나 방사패턴의 변화를 관찰하기 위해 모노폴 안테나를 사용하여 차량 내부에서 안테나의 방사패턴을 측정하였다. 다수의 반사파가 존재하는 좁은 공간에서는 안테나의 특성이 변해 무선 통신 환경에 영향을 끼칠 수 있다. 그러므로 실제 차량 내부에서 제공되는 무선 통신 서비스인 GPS 와 Wibro 동작 주파수 대역에서 안테나 방사패턴에 대한 모의실험과 측정실험을 수행하였다. 모의실험은 광선추적법을 기반으로 하였으며 측정실험은 각 동작 주파수 대역을 중심 주파수로 갖는 두 쌍의 모노폴 안테나를 제작하여 자유공간과 차량 내부에서 주파수에 따라 방사패턴을 측정하였다. 모의실험과 측정실험의 결과를 바탕으로 차량 내부와 자유공간에서의 안테나 방사패턴을 비교하였을 때 안테나의 전방향성 특성을 유지되며, 차량 내부에서 안테나의 수신전력이 자유공간에서의 결과보다 증가하는 것을 확인 할 수 있었다. 또한 주파수가 증가할수록 자유공간과 차량 내부에서의 수신전력 차이가 증가하는 것을 확인하였다.

• Journal of electromagnetic engineering and science
• /
• 제5권2호
• /
• pp.97-103
• /
• 2005

This paper describes the measured results of sonobuoy transmitting antenna system for anti-submarine warfare (ASW). Since radiation pattern and power density depend on impedance matching between transmitting RF part and antenna with termination resistance, design of matching circuit is very important for sonobuoy system performance. Matching circuit is designed by Smith chart using control of L and C. In standing wave ratio(SWR) measurement using Network Analyzer, SWR of antenna with matching circuit observed 1.5 below at the assigned VHF band. It shows very excellent performance comparison with conversional product that is used for the same object. The measured vertical and horizontal radiation patterns are also shown the satisfaction of military specifications. A drop out of sonobuoy system on the sea is happened when angle of elevation direction is over 10 degrees, and it is conformed that it takes less than I second return to original signal level. The required electric power density is $83\;mW/m^2$ in the military specification, and measured electric power density is observed over average $110\;mW/m^2$ at all frequency bands.

• 한국전자파학회논문지
• /
• 제11권4호
• /
• pp.627-633
• /
• 2000

본 논문에서는 후방 전방향 특성이 요구되는 비행체 탑재 안테나의 이상적인 방사패턴을 얻기 위해. 새 롭게 고안된 프린트형 역F안테나를 로케트 또는 미사일의 몸체 하단부에 있는 Fin측면상에 표연 장착하여 방사 패턴을 측정(중심주파수 : 1.81 GHz)하였으며, 그 결과 기존의 비행체 원통 몸체상에 장착된 역F안테나보다 비 행체의 후미 축상을 기준으로 대칭적인 방사패턴 특성을 얻었다. 또한 후미 방향으로 지향성을 높이기 위해 반 사기 역할을 하는 무급전 소자를 프린트형 역F안테나의 전방 방향 $\lambda$/8( $\lambda$ :파장, 10.5 em) 지점에 위치시켜 방 사패턴을 측정한 결과 전후비가 8dB 개선된 지향 특성을 얻었다.

• 한국전자파학회논문지
• /
• 제15권4호
• /
• pp.397-405
• /
• 2004

본 논문에서는PCS대역 안테나내장형 단말기의 성능에 관하여 살펴보았다. 안테나와 안테나 내장형 단말기의 방사패턴을 3차원 전산모의실험 프로그램인 HFSS(High Frequency Structure Simulator)와 SEMCAD(Simulator Platform for Electromagnetic Compatibility Antenna Design and Dosimetry)를 이용하여 전산모의실험하였다. 단말기에 장착된 LED(Light Emitting Bi여e) 회로와 접지판의 형태에 따른 방사패턴의 변화를 살펴보았으며, 외장형안테나 단말기와 내장형 안테나 단말기의 안테나 방사패턴을 원거리장 측정 시스템을 사용하여 전자파 무반사실에서 측정하였다. 측정결과 내장형 안테나는 전산모의실험 결과와 유사한 패턴을 보였다. 그리고 전자파 무반사실에서 Agilent E5515C를 사용하여 안테나 외장형 단말기와 안테나 내장형 단말기의 무선감도를 측정하여 비교하였다. 측정된 안테나내장형 단말기의 무선감도는 안테나 외장형 단말기의 무선감도와 비교해 유사한 성능을 보였으며 수평면상의 동일편파 무선감도 평균치의 경우 차이가 0.12 ㏈로 나타났다.

• 한국항해학회지
• /
• 제3권2호
• /
• pp.21-30
• /
• 1979

Echo sounder and Doppler sonar are to theultra-sonic transducers for measuring the depth and the ship's speed respectively. To measure the depth and speed with a single transducer, it is required to control the ultra-sonic beam to optional direction. In the past, the direction of the transducer itself is varied, but such a method provoked much problems in the mechanical design of the equipment. This paper deals with the method to control beam direciton by the phase control of the plural arrangement of transducers, and the results are studied by a computer simulation. The remarkable results of the study is condensed as follows; 1. The greater the interval of arrangement between transducers, the sharper the radiation pattern is, but in this case, the level of undesired sidelobe is also increased. 2. The control of radiation pattern up to 60 degree can be achieved by an adequate arrangement of more than 10 transducers. 3. It is shown that a simultaneous measurement of both depth and speed can be achieved by alternating directivity of the pulse by the method proposed in this paper.

• 한국전자파학회논문지
• /
• 제17권10호
• /
• pp.1007-1019
• /
• 2006

임의의 필드 분포를 갖는 단일 페치 안테나를 평면 배열하고 각 소자에 공급되는 급전 신호의 크기와 위상을 유전자 알고리즘으로 최적화하여, 여러 방향의 지향성과 널을 갖는 다중 빔 복사 패턴의 합성 방법을 제안하였다. 제안된 방법의 유효성을 확인하기 위해서, $2{\times}2$ 평면 배열 안테나를 제작하고 원거리 복사 패턴의 계산 결과와 측정 결과를 비교하여 동일한 특성을 확인하였으며, 다중 빔 복사 패턴의 합성은 $8{\times}8$ 배열 안테나 시스템을 이용하여, 시뮬레이션을 통해서 각 소자의 급전 신호의 크기와 위상을 최적화하였다.

• Journal of electromagnetic engineering and science
• /
• 제15권4호
• /
• pp.224-231
• /
• 2015

A comparison of the antenna parameters for R-band (1.7-2.6 GHz) and S-band (2.6-3.95 GHz) standard gain horn antennas has been performed by the Korea Research Institute of Standards and Science (KRISS), together with seven domestic participants from private companies and public institutions. Its purpose, as a proficiency test program of the 'Antenna Measurement Club' of KRISS, was to check equivalences in antenna parameter measurements between KRISS and the participants, particularly in the R-/S-band, to support antenna manufacturers and end users in Korea. The measurement parameters of this comparison are the power gain, radiation pattern, and reflection coefficient of the traveling standards for R-/S-band pyramidal standard gain horn antennas. The comparison used a gain comparison method and an extrapolation method to measure the power gain of the two traveling standards; the radiation patterns were measured in the far-field region of the transmitting and receiving antennas.

• Journal of Communications and Networks
• /
• 제1권3호
• /
• pp.166-181
• /
• 1999

The object of this paper is to investigate the influence of antenna pattern on indoor radio channel characteristics. Different from previous works where this analysis was carried out at a fixed frequency using different antennas, in the present paper (where measurements were taken in a wide frequency range) the variation of the radiation pattern was caused by two factors: the change of the radiation pattern when the same antenna was used at different frequenicies and the use of different type of antennas. To carry out this analysis, frequency domain measurements of the indoor radio channel at 1 GHz, 5.5 GHz, 10 GHz and 18 GHz were collected. Measurements were taken using a network analyzer. Serveral re-alizations of the channel transfer function were obtained varying, for each measurement, the positon of the transmitter and keep-ing the receiver fixed. Estimate of the channel impulse response was obtained from the Inverse Fourier Transform (IFT) of the fre-quency response. The measurements were performed in an office enviroment with mostly metallic walls and inner separations. The obtained data were elaborated to obtain the power versus distance relationship, the Cummulative Distribution Functions(CDFs) of rms Delay Spread(DS) and of the 3 dB frequency correlation band-width. Finally, the 3 dB width of the frequency correlation func-tion has been empirically related to the inverse of the rms DS of the impulse response.