• 한국군사과학기술학회지
• /
• 제21권3호
• /
• pp.306-314
• /
• 2018

In maritime environment, it is necessary to understand the characteristics of sunglint since it may degrade the target detection performance of the infrared sensor mounted weapons. In this paper, sunglint in LWIR band is modeled using the slope distribution of the sea surface, and is verified by comparing the radiance of a simulated result with that of the real world. According to the simulation, sunglint is critical when the solar zenith angle is over $60^{\circ}$. The peak radiance of sunglint grows as the solar zenith angle increases until it reaches $83^{\circ}$ and has a large difference depending on the solar zenith angle when the wind speed is small. Finally, seasonal and temporal characteristics of sunglint effects are analyzed. In summer, sunglint is dominant in the horizon near the solar azimuth right after sunrise and before sunset. However, in winter, the influence of sunglint lasts even during the daytime since the elevation of the sun is much lower than in summer.

• 한국태양에너지학회 논문집
• /
• 제34권5호
• /
• pp.101-108
• /
• 2014

The performance of the daylighting in buildings depends on building site and shape. As an energy saving design strategy, daylighting is a key issue in green building design. In this paper, the influence of the adjacent or obstructed building on daylighting performance of the office building in urban area was analyzed. A typical office building about 20 storeys with obstructed buildings has been modeled and simulated using Radiance. The parametric simulations have been performed to analyze the influence of the daylighting performance (illuminance, luminance) of the analyzed office. The results show that the possibility of the glare was decreased when the obstructed building is located in south, also the illuminance level was significantly decreased. When the obstructed building is located in north, the changes of the illuminance level and luminance possibility were somewhat small compared to the unobstructed condition. The daylighting performance of the analyzed building was most affected by the obstructed building in winter season.

• 한국군사과학기술학회지
• /
• 제19권2호
• /
• pp.185-194
• /
• 2016

It is essential for generating the synthetic image to test and evaluate a guided missile system in the hardware-in-the-loop simulation. In order to make the evaluation results to be more reliable, the extent of fidelity and rendering performance of the synthetic image cannot be left ignored. There are numerous challenges to simulate the LWIR sensor signature of sea surface depending on the incident angle, especially in the maritime environment. In this paper, we investigate the key factors in determining the apparent temperature of sea surface and propose the approximate formula consisting of optical characteristics of sea surface and sky radiance. We find that the greater the incident angle increases, the larger the reflectivity of sea surface, and the greater the water vapor concentration in atmosphere increases, the larger the amount of sky radiance. On the basis of this information, we generate the virtual maritime environment in LWIR region using the SE-WORKBENCH, physically based rendering software. The margin of error is under seven percentage points.

• 한국광학회지
• /
• 제27권1호
• /
• pp.18-24
• /
• 2016

섬광을 효율적으로 활용하고 그 효과를 예측하기 위해서는 섬광의 광 방출특성을 알아야 하는 것은 필수적이다. 본 논문에서는 섬광의 효과예측과 효율적 활용을 위한 섬광의 적외선 특성을 연구하였다. 세 종류의 섬광원에 대하여 중적외선과 원적외선영역에서 적외선 특성을 측정하고 이로부터 섬광의 복사휘도와 복사온도를 추출하여 섬광의 적외선 특성을 연구하였다. 세 종류의 섬광에 대해 중 원적외선 영역에서 적외선 스펙트럼 복사휘도를 추출한 결과는 섬광 A의 복사휘도가 상대적으로 제일 강하며 섬광 C, 섬광 B 순으로 분석되었다. 동일한 연소형 섬광인 섬광 A와 B의 복사휘도가 약 10배 이상 남을 알 수 있었으며, 이는 단지 화약량의 차이에 의해 나타나는 것이므로 화약량이 증가할수록 방출 적외선의 강도가 강해지는 것으로 해석된다. 또한 폭발형 섬광 C와 연소형 섬광 A, B를 비교해도 화약량에 따라 적외선 방출 강도가 달라지는 것을 알 수 있다. 두 적외선 영역에서 측정한 복사휘도로부터 복사온도를 추출하였다. 섬광 A의 복사온도는 3300 K, 섬광 B는 1120 K, 섬광 C는 1640 K로 추출되었다. 두 적외선 영역에서 측정한 적외선 복사휘도, 복사온도 그리고 섬광의 지속시간을 종합하여 볼 때, 연소형 섬광이 폭발형보다 더 많은 적외선 에너지를 방출하는 것으로 분석되며, 이는 적외선 관측장비에 미치는 영향은 폭발형보다는 연소형이 더 크게 됨을 의미한다. 이러한 측정된 자료를 바탕으로 분석을 통해 확보된 섬광의 스펙트럼 복사휘도와 복사온도는 섬광이 적외선 장비에 미치는 영향을 추정하는데 매우 중요한 역할을 할 수 있으며, 나아가 섬광효과의 M&S에 기반을 제공할 것으로 기대된다.

• KIEAE Journal
• /
• 제10권3호
• /
• pp.43-50
• /
• 2010

Natural lighting is directly connected with our mental and physical health. For working or learning effect, the proper natural lighting is required for improving our living conditions. School facilities, especially, are the place where includes students' ordinary activities with learning behaviors during the school years from elementary to high school. This study was carried out for the purpose introducing a basic database in that planning a school by researching on the actual in the natural lighting system of some schools' classroom, estimating, and analyzing through a simulation, which resulted in a method of improving the natural lighting system. As a result of measuring and analyzing Daylight Factor(DF) during the time from 9 am to 3 pm when students are activating in their classroom, generally DF range of the sides near to window and aisle seats zone are not distributed well. Besides, two out of four school which are researched would not reach the standards of the law for school sanitary while rest of the schools meet the standards; Average DF 5% and Minimum DF 2%. And the result of a simulation by RADIANCE program shows the most appropriate DF range when it is applied in variable numbers about an oriehows the- South-east 15, south-east 30, south-east 45, south-west 15, south-west 30, and south-west 45 degrees. When it is applied in the variable numbers about glass transmittance - 60%, 70%, and 80% in condition facing south of a classroom, the result shows that the DF range of 80% transmittance is relatively higher than other glasses in the classroom. Thus, when a school is built, plans for an orientation is necessary for improve of elementary schools' environment with the glass installation which is made for high transmittance and is regarded with the students' activities time.

• Journal of the Optical Society of Korea
• /
• 제20권4호
• /
• pp.500-509
• /
• 2016

Integrating spheres play a central role in the radiometric calibration of remote sensors. With the development of the wide field of view (FOV) remote sensors, aperture diameters of remote sensors are becoming larger and larger. To satisfy the radiometric calibration requirements of full FOV and full aperture, an 8000mm diameter large aperture integrating sphere uniform source with a variable exit port was designed and manufactured. This integrating sphere will be used for pre-launch test and radiometric calibration of remote satellites. In this paper, optical theories were used to design the output spectral radiance. The LightTools software based on ray-tracing simulation method was used to determine the best combination and distribution of inner light sources. A spectral experiment was made to verify the spectral radiance design. To reduce the influence of longtime power-on, a new characteristic measurement method was developed to obtain the radiation characteristic of the integrating sphere, which could greatly improve the measuring efficiency. This method could also be applied to measure other large aperture uniform sources. The obtained results indicate that the spatial uniformity is 98.35%, and the angular uniformity at center position is 98.78%.

• 대한원격탐사학회지
• /
• 제37권1호
• /
• pp.123-137
• /
• 2021

In this study, we performed cross calibration of KOMPSAT-3 AEISS imaging sensor with reference to normalized pixels in the Landsat 8 OLI scenes of homogenous ROI recorded by both sensors between January 2014 and December 2019 at the Libya 4 PICS. Cross calibration is using images from a stable and well-calibrated satellite sensor as references to harmonize measurements from other sensors and/or characterize other sensors. But cross calibration has two problems; RSR and temporal difference. The RSR of KOMPSAT-3 and Landsat 8 are similar at the blue and green bands. But the red and NIR bands have a large difference. So we calculate SBAF of each sensor. We compared the SBAF estimated from the TOA Radiance simulation with KOMPSAT-3 and Landsat 8, the results displayed a difference of about 2.07~2.92% and 0.96~1.21% in the VIS and NIR bands. Before SBAF, Reflectance and Radiance difference was 0.42~23.23%. Case of difference temporal, we simulated by 6S and Landsat 8 for alignment the same acquisition time. The SBAF-corrected cross calibration coefficients using KOMPSAT-3, 6S and simulated Landsat 8 compared to the initial cross calibration without correction demonstrated a percentage difference in the spectral bands of about 0.866~1.192%. KOMPSAT-3 maximum uncertainty was estimated at 3.26~3.89%; errors due to atmospheric condition minimized to less than 1% (via 6S); Maximum deviation of KOMPSAT-3 DN was less than 1%. As the result, the results affirm that SBAF and 6s simulation enhanced cross-calibration accuracy.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2009년도 춘계학술대회 논문집
• /
• pp.117-120
• /
• 2009

New shading system, which is Grating Louver System into a pair glass, is proposed for integrated lighting system between Daylight Responsive Dimming Systems and shading system in this study. The optimized distance of louvers, which is to block direct sunlight into a space, is calculated. Grating Louver System was simulated using Desktop Radiance 2.0 of lighting simulation software for comparing daylight distribution and changes of control slope by distance from window to back wall with roller shading system controlled by sun profile angle.

• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 1999년도 Proceedings of International Symposium on Remote Sensing
• /
• pp.349-354
• /
• 1999

Electro-Optical Camera (EOC) is the main payload of the KOMPSAT-1 satellite to perform the mission of cartography that builds up a digital map of Korean territory including a digital terrain elevation map. This paper discusses the issues of the digital image simulation of EOC for the generation of EOC simulated scene as taken by EOC at 685km altitude on orbit. For the purpose, simulation work has been performed with the sensor models of EOC and the satellite platform motions models through image chain analysis from the illumination source (Sun) to a simulated image output in digital number. MODTRAN fur radiance calculation, MTF models of optics, detector and motions of EOC for system point spread function (PSF), and signal chain equations for digital number output are described. Several noise models of EOC are also considered. The final output is the EOC simulated image in digital number. The simulation technique can be used in several phase of a spaceborne electro-optical system development project, feasibility study phase, design, manufacturing, test phases, ground image processing phases, and so on.

• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 2007년도 Proceedings of ISRS 2007
• /
• pp.282-285
• /
• 2007

Satellite observed brightness temperature simulation using a radiative transfer model (here after, RTM) is useful for various fields, for example sensor design and channel selection by using theoretically calculated radiance data, development of satellite data processing algorithm and algorithm parameter determination before launch. This study is focused on elaborating the simulation procedure, and analyzing of difference between observed and modelled clear sky brightness temperatures. For the CMDPS (COMS Meteorological Data Processing System) development, the simulated clear sky brightness temperatures are used to determine whether the corresponding pixels are cloud-contaminated in cloud mask algorithm as a reference data. Also it provides important information for calibrating satellite observed radiances. Meanwhile, simulated brightness temperatures of COMS channels plan to be used for assessing the CMDPS performance test. For these applications, the RTM requires fast calculation and high accuracy. The simulated clear sky brightness temperatures are compared with those of MTSAT-1R observation to assess the model performance and the quality of the observation. The results show that there is good agreement in the ocean mostly, while in the land disagreement is partially found due to surface characteristics such as land surface temperature, surface vegetation, terrain effect, and so on.