• The Journal of the Acoustical Society of Korea
• /
• v.41 no.4
• /
• pp.446-460
• /
• 2022

In this paper, we propose an algorithm to improve target detection rate degradation due to direct blast in a bi-static sonar systems with high duty cycle using an adaptive filters. It is very important to suppress the direct blast in the aforementioned sonar systems because it has a fatal effect on the actual system operation. In this paper, the performance was evaluated by applying the Normalized Least Mean Square (NLMS) and Recursive Least Square (RLS) algorithms to the simulation and sea experimental data. The beam signals of the target and direct blast bearings were used as the input and desired signals, respectively. By optimizing the difference between the two signals, the direct blast is removed and only the target signal is remained. As a result of evaluating the results of the matched filter in the simulation, it was confirmed that the direct blast was removed to the noise level in both Linear Frequency Modultated (LFM) and Generalized Sinusoidal Frequency Modulated (GSFM), and in the case of GSFM, the target sidelobe decreased by more than 20 dB, thereby improving performance. In the sea experiment, it was confirmed that the LFM reduced the level of the transmitted direct wave by 10 dB, the GSFM reduced the level of the transmitted direct wave by about 4 dB, and the side lobe of the target decreased by about 4 dB, thereby improving the performance.

• The Journal of the Acoustical Society of Korea
• /
• v.29 no.5
• /
• pp.303-313
• /
• 2010

This paper describes an acoustic communication receiver structure, which is designed for QPSK (Quadrature Phase Shift Keying) signal with 25 kHz carrier frequency and 5 kHz symbol rate, and takes samples from received signal at 100 kHz sampling rate. Based on the described receiver structure, optimum design parameters, such as number of taps of FF (Feed-Forward) and FB (Feed-Back) filters and forgetting factor of RLS (Recursive Least-Square) algorithm, of joint equalizer are determined to minimize the BER (Bit Error Rate) performance of the joint equalizer output symbols when the acquisition data in shallow water using implemented acoustic transducers is decimated at a rate of 2:1 and then enforced to the input of receiver. The transmission distances are 1.4 km, 2.9 km, and 4.7 km. Analysis results show that the optimum number of taps of FF and FB filters are different according to the distance between source and destination, but the optimum or near optimum value of forgetting factor is 0.997. Therefore, we can reach a conclusion that the proper receiver structure could change the number of taps of FF and FB filters with the fixed forgetting factor 0.997 according to the transmission distance. Another analysis result is that there are an acceptable performance degradation when the 16-tap-length simple filter is used as a low-pass filter of receiver instead of 161-tap-length matched filter.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.22 no.2
• /
• pp.253-260
• /
• 2018

The acoustic communication channel in shallow underwater is typically shown as time-varying multipath fading channel characteristics. The received signal through channel transmission cause inter-symbol interference (ISI) owing to multiple components of different time delay and amplitude. To compensate for this, several techniques have been used, and one of them is acoustic equalizer. In this study, we used four equalizers - feed forward equalizer (FFE), decision directed equalizer (DDE), decision feedback equalizer (DFE) and combination DDE with DFE to compensate ISI. And we applied two adaptive algorithms to adjust coefficient of equalizers - normalized least mean square algorithm and recursive least square algorithm. As result, we found that it has a significant performance improvement over 6 dB on SNR in nonlinear equalizer. By combination of DFE and DDE has almost best performance in any case.

• Journal of the Korean Institute of Telematics and Electronics T
• /
• v.35T no.2
• /
• pp.48-55
• /
• 1998

The main drawback of filtered-X LMS(FXLMS) algorithm for the ANC of broadband noises is its low convergence speed when the filtered reference signals are strongly correlated, producing a large eigenvalue ratio in correlation matrix. This correlation can be caused either by autocorrelation of the signals of the reference sensors, or by coupling between the error path which introduces intercorrelation in the filtered reference signals. In this paper, we introduce a transform domain FXLMS(TD-FXLMS) algorithm that has a high convergence speed by orthogonal transform's decorrelation properties.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.35 no.3
• /
• pp.299-308
• /
• 2011

In this study, we develop a pressure observer to measure the cylinder length of a harbor-construction robot. For the robot control, sensors are required to measure the length of a hydraulic cylinder. The cylinder-position sensor is relatively expensive when the operating environment prohibits external approaches for the measurement of the cylinder position. LVDT or linear scales are usually mounted on the outside of the cylinder, which causes poor durability on a construction site. We use a pressure sensor to indirectly estimate the length of the cylinder. The pressure sensor is mounted inside a hydraulic valve box so that it is protected by the box and easy to waterproof for an underwater robot. By treating oil as a compressible fluid, we derive the nonlinear pressure dynamics as a function of the cylinder position, velocity, and pressure. The recursive least squares (RLS) algorithm is applied to identify the dynamic parameters, and the pressure observer estimates the cylinder position through the pressure acting on the head and the rod of the hydraulic cylinder. The position accuracy is relatively low, but it is acceptable for a construction robot that handles large armor stones.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.11A
• /
• pp.1244-1252
• /
• 2004

In this paper, we derive some properties of linear detectors (zero forcing or minimum mean square error) at spatial multiplexing systems with alamouti's space-time block code. Based on the derived properies, this paper proposes low-complexity receivers. Implementing MMSE detector adaptively, the number of weight vectors to be calculated and updated is greatly reduced with the derived properties compared to the conventional methods. In the case of recursive least square algorithm, with the proposed approach computational complexity is reduced to less than the half. We also identify that sorted QR decomposition detector, which reduces the complexity of V-Blast detector, has the same properties for unitary matrix Q and upper triangular matrix R. A complexity reduction of about 50%, for sorted QR decomposition detector, can be achieved by using those properties without the loss of performance.

• Journal of Power Electronics
• /
• v.18 no.2
• /
• pp.558-572
• /
• 2018

In addition to its modular nature, a Hybrid Modular Multilevel Converter (HMMC) assembled from half-bridge and full-bridge sub-modules, is able to block DC faults with a minimum number of switching devices, which makes it attractive for high power applications. This paper introduces a control strategy based on the Root-Least Square (RLS) algorithm to estimate the capacitor voltages instead of using direct measurements. This action eliminates the need for voltage transducers in the HMMC sub-modules and the associated communication link with the central controller. In addition to capacitor voltage balancing and suppression of circulating currents, a fault tolerant control unit (FTCU) is integrated into the proposed strategy to modify the parameters of the HMMC controller. On advantage of the proposed FTCU is that it does not need extra components. Furthermore, a fault detection unit is adapted by utilizing a hybrid estimation scheme to detect sub-module faults. The behavior of the suggested technique is assessed using PSCAD offline simulations. In addition, it is validated using a real-time digital simulator connected to a real time controller under various normal and fault conditions. The proposed strategy shows robust performance in terms of accuracy and time response since it succeeds in stabilizing the HMMC under faults.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.35C no.6
• /
• pp.99-108
• /
• 1998

In this paper, we proposed a multi-layer neural network for direct control method of nonlinear system. The proposed control method uses neural network as the controller to learn inverse model of plant. The neural network used consists of two parts; one part is for identification of linear part, and the other is for identification of nonlinear part of inverse system. The neural network has to be learned the liner part with RLS algorithm and the nonlinear part with error of plant. From the simulation and experiment of tracking control to use one link manipulator as plant, we proved usefulness of the proposed control method to comparing to conventional direct neural network control method. By comparing the two methods, from simulation and experiment, we were convinced that the proposed control method is more simple and accuracy than the conventional method. Moreover, number of weight and bias to be controller parameter are small, and it has smaller steady state error than conventional method.