• Proceedings of the Korean Magnestics Society Conference
• /
• 2002.12a
• /
• pp.200-201
• /
• 2002

Recently, a countermeasure for the electromagnetic noise emission on RF integrated transmission line using the loss generation of ferromagnetic thin films is briefly suggested$\^$1,2/. Without the magnetic film, the noise harmonics of the signal pass through the transmission line with only a little attenuation. The ideal role of magnetic film is not to raise insertion losses in the pass-band and to give as large attenuation as possible to eliminate the noise harmonics at the stop-band, the frequency range higher than the meaningful signal as shown in Fig. 1. and Fig. 2. (omitted)

• International journal of advanced smart convergence
• /
• v.11 no.4
• /
• pp.41-46
• /
• 2022

This study is a Ku-band array antenna for the manufacture of low-orbit satellite communication terminals, designed to have miniaturization, high gain, and wide beam width. The transmission of low-orbit satellite communication has a right-rotating circularly polarized wave, and the reception has a left-rotating circularly polarized wave. The 4×8 array antenna was separated for transmission and reception, and it was combined with the RF circuit part of the transmitter and receiver, and was terminated in the form of a waveguide for RF signal impedance matching in the form of a transition from the microstrip line to the waveguide. The 30° beam width of the receiver maximum gain of 19 dBi and the 29° beam width of the transmitter maximum gain of 18 dBi are shown. Through this antenna configuration, the system was configured to suit the low-orbit satellite transmission/reception characteristics.

• Fashion & Textile Research Journal
• /
• v.20 no.5
• /
• pp.616-620
• /
• 2018

Recently, many researches have been conducted to improve the performance and wearability of smart wearables. In this study, we designed and fabricated the signal and power transmission textile cables for smart wearables which have excellent wearability, durability and reliability. For the signal transmission textile cables, conductive yarns for the signal line and the ground line were developed. Three types of signal transmission textile cables have been developed using the conductive yarns. Linear density, tensile properties, electrical resistance and RF characteristics were tested to characterize the physical and electrical properties of three signal transmission textile cables. The conductive yarns have the very low resistance of $0.05{\Omega}/cm$ and showed excellent uniformity of electric resistance. Therefore, the electrical resistance of the signal transmission fiber cable can be reduced by increasing the number of conductive yarns used in signal and ground lines. However, the radio frequency (RF) characteristics of the signal transmission textile cables were better as the number of strands of the conductive yarns used was smaller. This is because the smaller the number of strands of conductive yarn used in signal transmission textile cables, the narrower and more parallel the distance between the signal line and the ground line. It is expected that the signal and power transmission textile cable for signal and power transmission will be utilized in smart wearable products.

• Journal of Sensor Science and Technology
• /
• v.25 no.2
• /
• pp.131-137
• /
• 2016

In this study, a multilevel visible light communication (VLC) system based on resistor ladder circuit is designed to transmit medical data. VLC technology is being considered as an alternative wireless communication due to various advantages such as ubiquity, license free operation, low energy consumption, and no radio frequency (RF) radiation characteristics. With VLC even in places where traditional RF communication (e.g., Wi-Fi) is forbidden, significant bio-medical signal including the electrocardiography (ECG) and photoplethysmography (PPG) data can be transmitted. More lives could be saved anywhere by this potential advantage of VLC with a fast emergency response time. A multilevel transmission scheme is adopted to improve the data capacity with keeping simplicity, where data transmission rate can increase by log2m times (m is the number of voltage levels) than that of conventional VLC transmission based on on/off keying. In order to generate multi-amplitudes, resistor ladder circuit, which is a basic principle of digital to analog convertor, is employed, and information is transferred through LED (Light-Emitting Diode) with different voltage level. In the receiver side, multilevel signal is detected by optical receiver including a photo diode. Then, the collected data are analyzed to serve the necessary medical care to the concerned patient.

• Journal of the Optical Society of Korea
• /
• v.15 no.2
• /
• pp.132-139
• /
• 2011

We investigate theoretically the combined effect of fiber chromatic dispersion and self-phase modulation (SPM) on multi-channel subcarrier multiplexed (SCM) optical transmission systems in terms of the detected RF carrier power and SPM-induced power gain after transmission over single-mode fiber (SMF) links. According to the calculated power gain due to the SPM effect at the transmission distance of P3dB using the detected radio-frequency (RF) carrier power after photo-detection, the power gain is significantly degraded with large optical modulation index (OMI), small SCM channel spacing, and large fiber launching power because of the increased interaction between subcarrier channels. The nonlinear phase shift due to linear and nonlinear fiber characteristics is investigated to explain these results in detail. The numerical simulation results show that the OMI per SCM channel has to be smaller than 10 % for the fiber launching power of 10 dBm to guarantee prevention of SPM-induced power gain degradation below 0.5 dB for the SCM system with the channel spacing of 100 MHz. This result is expected to be utilized for the optical transmission systems using the SCM technology in future radio-over-fiber (RoF) networks.

• KEPCO Journal on Electric Power and Energy
• /
• v.1 no.1
• /
• pp.85-91
• /
• 2015

We investigated the structure of inductive coupler and its magnetic coupling to increase the transmission coefficient for power line communication. A Rogowski coil, which is an air-cored inductive coupler, and a magnetic cored coupler were fabricated to analyze the transmission coefficient for different coupler parameters. This paper proposes the impedance matching method using lumped elements and an impedance transformer to increase the transmission coefficient. In the experiment, the transmission coefficient of the proposed system was increased in both narrowband and broadband cases, and a trade-off between the transmission coefficient and the bandwidth was shown. This method will be useful for the further study of impedance matching with the load variation.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2019.11a
• /
• pp.96-97
• /
• 2019

본 논문에서는 다중 사용자 Rayleigh fading 채널 환경에서 RF 에너지하비스팅 네트워크의 에너지 효율 개선방안으로 DRF-EHN(Decoupled RF Energy Harvesting Network)을 제안한다. 시뮬레이션 결과를 통해 기존 RF-EHN 모델보다 에너지 효율이 31% 높아진 것을 확인하였다.

• Journal of IKEEE
• /
• v.22 no.2
• /
• pp.476-479
• /
• 2018

This paper proposes a method for reducing the amount of current consumption by the transceiver based remote control and the ZigBee RF4CE network layer step. We have studied how to improve power efficiency at short transition time through duty rate management. Also, comparing the measured current consumption before and after the improvement, we confirmed the correlation between the data transmission speed improvement and the current reduction.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.4
• /
• pp.331-341
• /
• 2002

It is expected that the SCM (Subcarrier Multiplexing) optical link system, in which a number of small scale base stations with only antenna and RF transceiver are connected to central station through optical fiber, is in demand. In order to analyze the performance of SCM optical link system fur RF signal transmission, MZ(Mach-Zehnder) modulator's transfer function is modelled as nonlinear form with the cube of input signal. And considering the multiple access interferences occurred In the demodulation of other users'CDMA signals with multipath components after passing through MZ modulator, the BER performance is analyzed.

• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.1507_1508
• /
• 2009

This study proposes a composite right/left-handed transmission line (CRLH-TL) that permits switching between the right-handed (RH) and left-handed (LH) modes using single crystalline silicon (SCS) RF MEMS switches. It is possible to change modes from the RH to LH mode, or vice versa, by controlling the admittance of capacitors and the impedance of inductors using switch operations. The proposed switchable CRLH-TL consists of SCS RF MEMS switches, metal-insulator-metal (MIM) capacitors and shunt inductors. At 8 GHz, the fabricated device shows a phase response of $87^{\circ}$ with an insertion loss of 2.7 dB in the LH mode, and a phase response of $-77^{\circ}$ with an insertion loss of 0.56 dB in the RH mode.