• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.33 no.5
• /
• pp.1907-1914
• /
• 2013

Textile-type heat exchangers installed on the tunnel walls for facilitating ground source heat pump systems, so called "energy textile", was installed in an abandoned railroad tunnel around Seocheon, South Korea. To evaluate thermal performance of the energy textile, a series of long-term monitoring was performed by artificially applying daily intermittent cooling and heating loads on the energy textile. In the course of the experimental measurement, the inlet and outlet fluid temperatures of the energy textile, pumping rate, temperature distribution in the ground, and air temperature inside the tunnel were continuously measured. From the long-term monitoring, the heat exchange rate was recorded as in the range of 57.6~143.5 W per one unit of the energy textile during heating operation and 362.3~558.4 W per one unit during cooling operation. In addition, the heat exchange rate of energy textile was highly sensitive to a change in air temperature inside the tunnel. The field measurements were verified by a 3D computational fluid dynamics analysis (FLUENT) with the consideration of air temperature variation inside the tunnel. The verified numerical model was used to evaluate parametrically the effect of drainage layer in the energy textile.

• Journal of Korean Society for Atmospheric Environment
• /
• v.26 no.6
• /
• pp.633-648
• /
• 2010

The study was performed to elucidate the characteristics of VOCs at distinct monitoring sites in urban atmosphere; one is at a roadside in downtown inland city of Jeonju, and the other is at an industrial site in Gunsan near coastal area. The ambient samples were collected for 24 hours in two-bed adsorbent tubes by using MTS-32 sequential tube sampler equipped with Flex air pump every 16 days in a roadside and a industrial complex from February to November in 2009. VOCs were determined by thermal desorption coupled with GC/MSD. Major individual VOCs in roadside samples were shown as following order in magnitude: toluene>m,p-xylene>ethyl benzene>decanal; and those in the industrial complex samples were as follows: toluene>ethanol>ethyl acetate>decanal>m,pxylene. High benzene concentration in the roadside was more frequently occurred than in the industrial complex. However ambient level of toluene in the industrial complex was higher than that in the road side. Results from roadside sample analysis showed that nonane and 1,2,4-trimethylbenzene were very frequently observed with higher concentrations than those in the industrial complex. It seems that nonane and 1,2,4-trimethylbenzene could be the source characteristics for the roadside air. From the diurnal variation, it was found that concentrations of benzene, ethylbenzene, xylene, nonane and 1,2,4-trimethylbenznene in the roadside were higher during rush hours; but those in the industrial complex were higher from 10 to 16 LST when the industrial activities were animated. On weekly base, the concentration of benzene, toluene, ethylbenzene and m,p-xylene in the roadside were higher specifically on Wednesday, but those in the industrial complex were higher on Sunday. It was found that the general trends of VOCs levels at both sites significantly influence on seasonal changes. The results of factor analysis showed that the VOCs in the roadside were mainly affected by the emission of vehicles and the evaporation of diesel fuel, meanwhile those in the industrial complex were influenced by the evaporation of solvents and vehicular emission.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.27 no.7
• /
• pp.369-374
• /
• 2015

This study analyzed analyzes the energy performance of six houses in Daejeon completed which were built in 2011. Observed The observed houses, which were all designed and constructed inof the same size and structure, are were highly insulated with triple Low-E coating windows; the insulation level of the walls is was $0.13W/m^2K$ and that of the roof is was $0.10W/m^2K$. As electric houses, all of the energy supplied to the houses, including for cooking, is was supplied by electricity. A and 3~4 kWp of photovoltaic system and a 3~5 kW of ground source heat pump (GSHP) were installed in each house tofor providing provide space heating/and cooling and hot water are installed. We constructed a Web-based remote monitoring system in order to understand energy consumption and the dynamic behavior of the energy system. T, and the results of our metering data analysis of 2013 are as follows. First, the annual residential energy consumption is was 4,400 kWh (${\sigma}=1,209$) and GSHP energy consumption is was 5,182 kWh (${\sigma}=1,164$). Second, residential energy consumption ranked highest in average energy usage, with at 45% of the total, followed by heating with at 30%, hot water supply with at 17% and cooling with at 6%. Third, the average energy independence rate is was 51.8%, the GFA (Gross gross floor area) criteria average energy consumption unit is was $48.7kWh/m^2yr$ (${\sigma}=10.1$), and the net energy consumption unit (except the energy yield of the PV systems) is was $24.7kWh/m^2yr$ (${\sigma}=8.8$).

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.139.2-139.2
• /
• 2016

Electrons and phonons in chalcogenide-based materials play are important factors in the performance of an optical data storage media and thermoelectric devices. However, the fundamental kinetics of carriers in chalcogenide materials remains controversial, and active debate continues over the mechanism responsible for carrier relaxation. In this study, we investigated ultrafast carrier dynamics in an multilayered $\{Sb(3{\AA})/Te(9{\AA})\}n$ thin film during the transition from the amorphous to the crystalline phase using optical pump terahertz probe spectroscopy (OPTP), which permits the relationship between structural phase transition and optical property transitions to be examined. Using THz-TDS, we demonstrated that optical conductance and carrier concentration change as a function of annealing temperature with a contact-free optical technique. Moreover, we observed that the topological surface state (TSS) affects the degree of enhancement of carrier lifetime, which is closely related to the degree of spin-orbit coupling (SOC). The combination of an optical technique and a proposed carrier relaxation mechanism provides a powerful tool for monitoring TSS and SOC. Consequently, the response of the amorphous phase is dominated by an electron-phonon coupling effect, while that of the crystalline structure is controlled by a Dirac surface state and SOC effects. These results are important for understanding the fundamental physics of phase change materials and for optimizing and designing materials with better performance in optoelectronic devices.

• Fire Science and Engineering
• /
• v.31 no.1
• /
• pp.58-62
• /
• 2017

There is a growing need for seismic resistance design. But it is controversial that standards of sway brace device in non-structural elements for buildings like pump waterway is vary widely. Therefore, in this study to get a valid range of sway brace device in seismic resistance design, using load test of sway brace device. As a result, load of safe range from 0 to 18.5 kN and under 29.4 kN, no structural fault of sway brace device. And using internet of things get a data of seismic resistance design from sensor node like accelerometer, GPS, tilt sensor and temperature sensor through steps of sampling and prediction. These results will be acceptable for monitoring system for seismic resistance in non-structural elements.

• Journal of Advanced Marine Engineering and Technology
• /
• v.29 no.7
• /
• pp.713-721
• /
• 2005

A marine diesel engine should realize optimal operation efficiency while reducing NOx, PM (Particulate Matters) and other emissions. Fuel injection systems that use electronic control can become an effective means of achieving that objective. However. it still needs some accurate and instant information in order to bring its ability into full potential while sailing on the sea. The important information of them are a shaft torque and continuous combustion pressures of all cylinders. The shaft torque and the propeller thrust described in this paper are measured at an intermediate shaft by using a unique principle that one of two electromagnet coils oscillates a vibrating strip which the length changes with force and the other coil picks up the change of the frequency of the vibrating strip. For further reference, the shaft power meter multiplied the torque by the shaft revolution has already had about 750 sets of sales performance. The research presented in this paper started about ten years ago and is concerned with the development of a combustion pressure sensor that uses the same principle. Recently, the pressure sensor which bears continuous operation has been developed after a hard struggle, that is, the system that consists of a shaft horsepower meter, a propeller thrust meter and a combustion pressure sensor has been completed and has been shown to be reliable. This paper describes the configuration of this system, the material of the combustion pressure sensor, the principle of that, and the improving point of the sensor, and, we finally consider the use of this system.

• YAKHAK HOEJI
• /
• v.54 no.4
• /
• pp.252-257
• /
• 2010

The aim of this study was to investigate the effect of resveratrol on the pharmacokinetics of nifedipine in rats. The pharmacokinetic parameters of nifedipine were measured after the oral administration of nifenipine (6 mg/kg) in the presence or absence of resveratrol (0.5, 2.5 and 10 mg/kg, respectively). The effect of resveratrol on the P-glycoprotein (Pgp), CYP 3A4 activity was also evaluated. Resveratrol inhibited CYP3A4 enzyme activity in a concentration-dependent manner with 50% inhibition concentration ($IC_{50}$) of 0.94 ${\mu}M$. In addition, resveratrol significantly enhanced the cellular accumulation of rhodamine 123 in MCF-7/ADR cells overexpressing P-gp. Compared to the control groups, the presence of 2.5 mg/kg and 10 mg/kg of resveratrol significantly (p<0.05, p<0.01) increased the area under the plasma concentrationtime curve (AUC) of nifedipine by 49~75%, and the peak concentration ($C_{max}$) of nifedipine by 48~66%. The absolute bioavailability (AB%) of nifedipine was significantly (p<0.05) increased by 22.9-34.8% compared to the control (19.8%). The terminal half-life ($T_{1/2}$) of nifedipine was significantly (p<0.05) increased compared to the control. While there was no significant change in the time to reach the peak plasma concentration ($T_{max}$) of nifedipine in the presence of resveratrol. It might be suggested that resveratrol altered disposition of nifedipine by inhibition of both the CYP3A and P-glycoprotein efflux pump in the small intestine of rats. In conclusion, the presence of resveratrol significantly enhanced the oral bioavailability of nifedipine, suggesting that concurrent use of resveratrol or resveratrol-containing dietary supplenment with nifedipine should require close monitoring for potential drug interation.

• Journal of Environmental Health Sciences
• /
• v.44 no.4
• /
• pp.330-339
• /
• 2018

Objectives: The occurrence characteristics of BTEXS and phytoncides were investigated by type of urban forest. Methods: Four types of urban green space (Hongneung Forest, Mt. Chunjang, residential park, and traffic island) and Gwangneung Forest were selected. Monitoring of phytoncides and BTEXS was conducted considering the activity times of urban residents (five times per day) using a Tenax TA tube and suction pump in June 2017 (one day). Results: Phytoncide concentrations were ranked as Gwangneung Forest>Hongneung Forest>Mt. Cheonjang>traffic island>residential park. Relatively high concentrations of phytoncides were also identified in the urban forest. There was no significant difference between Gwangneung Forest and the urban forest. BTEXS concentrations were ranked as traffic island>residential park>Hongneung Forest>Gwangneung Forest>Mt. Cheonjang. Traffic island and residential park showed high levels of BTEXS depending on the inflow of vehicles. The difference in concentration by time was significant for the traffic island in particular. Pollutant levels in Hongneung Forest were as low as in Gwangneung Forest. Conclusion: The concentrations of phytoncides and BTEXS were different by types of urban green space, and the potential for health and hygiene of urban forests were able to be investigated. This study is expected to provide as basic data for the creation of urban forest spaces in the future.

• Clinical and Experimental Pediatrics
• /
• v.58 no.6
• /
• pp.234-237
• /
• 2015

Hepatic glycogenosis in type 1 diabetes mellitus (DM) can be caused by poor glycemic control due to insulin deficiency, excessive insulin treatment for diabetic ketoacidosis, or excessive glucose administration to control hypoglycemia. Mauriac syndrome, which is characterized by hepatomegaly due to hepatic glycogenosis, growth retardation, delayed puberty, and Cushingoid features, is a rare diabetic complication. We report a case of hepatic glycogenosis mimicking Mauriac syndrome. A 14-year-old girl with poorly controlled type 1 DM was admitted to The Catholic University of Korea, Seoul St. Mary's Hospital for abdominal pain and distension. Physical examination revealed hepatomegaly and a Cushingoid face. The growth rate of the patient had decreased, and she had not yet experienced menarche. Laboratory findings revealed elevated liver enzyme levels. A liver biopsy confirmed hepatic glycogenosis. Continuous glucose monitoring showed hyperglycemia after meals and frequent hypoglycemia before meals. To control hyperglycemia, we increased insulin dosage by using an insulin pump. In addition, we prescribed uncooked cornstarch to prevent hypoglycemia. After strict blood glucose control, the patient's liver functions and size normalized. The patient subsequently underwent menarche. Hepatic glycogenosis is a complication of type 1 DM that is reversible with appropriate glycemic control.

• The Journal of Engineering Geology
• /
• v.21 no.1
• /
• pp.35-43
• /
• 2011

Time series analysis was applied to groundwater level, water temperature, and electrical conductivity data obtained from monitoring wells around ground-source heat pumps at Sangji University of Wonju (standing column well type) and at Jungwon University of Goesan (closed loop type), from 21 May to 12 October 2010. We found large temporal variations in the characteristics of groundwater at Wonju, but only minor variations at Goesan. These results may improve our understanding of the effects of ground-source heat pumps on the characteristics of surrounding groundwater, according to the installation method for the pumps.