• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.2
• /
• pp.111-116
• /
• 2001

Poly-Si TFT's(Polysilicon thin filmtransistors) have been actively studied due to their applications in active matrix liquid crystal displays and active pull-up devices of CMOS SRAM's. For such applications, the leakage current has to be in the range of sub-picoampere. However, poly-Si TFT's suffer from anomalous high leakage currents, which is attributed to the emission of the traps present at gain boundaries in the drain junction. The leakage current has been analyzed by the field emission via grain-boundary traps and thermionic field emission over potential barrier located at the grain boundary. We found that the models proposed before are not consistent with the experimental results at far as drain-offset poly-Si TFT's we fabricated concern. In this paper, leakage current of drain-offset poly-Si TFT's with different offset lengths was studied. A conduction model based on the thermionic emission of the tunneling electrons is developed to identify the leakage mechanism. It was found that the effective grain size of the drain-offset region is important factor in the leakage current. A good agreement between experimental and simulated results of the leakage current is obtained.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.20 no.11
• /
• pp.3433-3440
• /
• 1996

This paper was investigation of the stres corrosion cracking(SCC) mechanism and the properties of corrosion fracture surface of glass fiber reinforced plastics(GFRP) produced by hand lay up(HLU) method in synthetic sea water. Test material is GFRP, that was used vinylester type epoxy acrylate resin and an unsaturated polyester as the matrix and the chopped strand mat(CSM) type E-glss fiber as the reinforcement. The slow strain rate test(SSRT) was performed on dry, wet and saturated wet specimens in sea water. Here the pH concentration of synthetic sea water was 8.2 and the strain rate is 1 x $10^{-6}$($sec^{-1}$) and test temperature ranges varied from $-60^{\circ}C$ to $80^{\circ}C$. It could be confirmed the fact that wet specimens tested at a particular test temperature ranges were appeared the eviences of SCC such as con-planar, mirror and hackle zone. Moreover, SCC of GFRP in sea water was characterised by falt fracture surfaces with only small amounts of fiber pull-out, in partial.

• STI Policy Review
• /
• v.4 no.2
• /
• pp.55-73
• /
• 2013

Since the 1990s, the Japanese government has made considerable attempts at stimulating innovation with an aim to pull the country out of a possibly permanent economic decline. Several laws and policy initiatives were introduced to encourage better interaction between universities (and research institutions) and industry. The results of these efforts have been mixed. While the number of university-industry joint and commissioned research has increased, revenues from the licensing of university-owned patents have fluctuated year by year. Although the number of startups and spin-offs from universities rose, their long-term survival and contribution to the economy remain uncertain. The Japanese experience features both strengths and weaknesses. Strengths include the long-term commitment of policy makers, the ability to set specific targets, and the active engagement of several key economic ministries. Nevertheless, the effectiveness of these policy initiatives was hampered by limitations within the policies concerning the roles of universities and their mode of interaction with industry based on intellectual property rights, the inadequacy of demand-side innovation policies, the fragmentation of bureaucracy, and a lack of a credible evaluation system.

• 한국신재생에너지학회:학술대회논문집
• /
• 2007.11a
• /
• pp.597-599
• /
• 2007

Studies on the hydrocarbons in shallow sediments of the East Sea of Korea have been carried out by the Korea Institute of Geoscience and Mineral Resources (KIGAM) since 2000. 4946 L-km of 2D multichannel reflection seismic data, 3250 L-km of high-resolution Chirp profiles and 16 selected piston cores were analyzed to determine the presence of hydrocarbons in shallow sediments of the western deep-water Ulleung Basin. The seismic data show a number of blanking zones that probably reflect widespread fluid and gas venting. The blanking zones are often associated with velocity pull-up structures. These upwelling structures are interpreted to be the result of high-velocity natural gas hydrate. There are also several bottom-simulating reflectors that are associated with free gas and probably overlying gas hydrate. Numerous pockmarks were also observed in the Chirp profiles. They are seafloor depressions caused by the removal of near-seafloor soft sediments by escaping of fluid and gas. In piston cores, cracks generally oriented parallel to bedding suggest significant gas content some of which may have been contained in gas hydrate in situ.

• Advances in concrete construction
• /
• v.1 no.4
• /
• pp.273-288
• /
• 2013

The main objective of this research was to evaluate the potentials of self-compacting concrete (SCC) mixes to develop bond strength. The investigated mixes incorporated relatively high contents of dolomite powder replacing Portland cement. Either silica fume or fly ash was used along with the dolomite powder in some mixes. Seven mixes were proportioned and cast without vibration in long beams with 10 mm and 16 mm steel dowels fixed vertically along the flowing path. The beams were then broken into discrete test specimens. A push-put configuration was adopted for conducting the bond test. The variation of the ultimate bond strength along the flowing path for the different mixes was evaluated. The steel-concrete bond adequacy was evaluated based on normalized bond strength. The results showed that the bond strength was reduced due to Portland cement replacement with dolomite powder. The addition of either silica fume or fly ash positively hindered further degradation as the dolomite powder content increased. However, all SCC mixes containing up to 30% dolomite powder still yielded bond strengths that were adequate for design purpose. The test results demonstrated inconsistent normalized bond strength in the case of the larger diameter compared to the smaller one.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2003.10a
• /
• pp.908-911
• /
• 2003

In this study, the security system (Firewall and IDS) was installed in high speed information network and analyzed for a change in the speed of data transfer and the possibility of invasion. The selection of appropriate system, efficient detection and protection and surveillance method were suggested and analyzed. In order to do experiments, an experimental model was comprized to analyze the parameters that was affected by the detection and protection system in network. This will give a standard how much we can pull up the security system maintaining the network speed.

• Journal of the Korean Institute of Rural Architecture
• /
• v.16 no.1
• /
• pp.111-117
• /
• 2014

The aim of this study is to find out the pattern of Ger form, inner spatial composition of Mongolian Ger house, and to take a dig at the structural or symbolic elements of nomadic architecture of Ger. To the point of view of corresponding to living and space of housing, remarkable characteristics of Ger Architecture is able to pull down and recombine the structures of nomadic house. Even though urbanization of Mongolia has spreading rapidly in a whole nation, most of people preserves traditional housing pattern within Ger. The ways of survey are to study of traditional home of Mongolia, and then field work at residence or mountain area in Ulan Bator and Gorkhi Terelj National Park area. This survey contains the form, size, structure, spatial composition of living space, structure, and materials. There are three results as follows: First, the form of Ger house is like a pyramidal or crown roof style to approximate to the round shape of it. Usually they had lived in nomadic way of life, so the Ger had a movable and flexible structure. Second, the Ger is easy to build up and deconstruct to move or find a new pasture. Third, the Mongolian Ger structure is composed by mainly five elements that are Khana, Khaalga, Toono, Bagana, and Uni. It has a hierarchy of internal spaces which are classified to gender, orientation, and property.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2005.11a
• /
• pp.1141-1144
• /
• 2005

본 논문은 실내에서 홈 거주자의 위치를 인식하기 위해 근접성을 이용한 위치 추적 시스템 환경을 제안하고자 한다. 이를 위해 기존 실내의 고정된 위치에 있는 구조/시설물 및 가전제품의 ON/OFF 스위치를 이용하며 기타 추가적인 스위치 및 센서를 부착하여 개폐동작이 일어날 때 발생되는 신호를 검출하여 실제위치를 얻는다. 발생되는 신호는 Pull-up 저항을 이용한 신호 검출 방법으로 눌려진 스위치나 센서에서 발생된 아날로그 신호를 검출한다. 검출된 신호의 고유한 ID값은 Sensor TMO로 송신되어 수집된다. 수집된 센서ID는 소켓통신을 이용하여 홈서버인 실내위치추적시스템으로 보내질 뿐아니라 원격 모니터링 GUI를 통해 실내 거주자의 위치를 GUI의 가상공간 좌표와 매핑된 홈 거주자의 위치를 보인다. 본 논문에서 제안한 실내위치추적시스템은 홈 거주자의 위치를 주기적으로 모니터링하고 거주자의 이동 패턴과 활동 상황을 파악하여 헬스케어 정보로 활용할 예정이다.

• The Korean Journal of Nuclear Medicine
• /
• v.21 no.1
• /
• pp.39-46
• /
• 1987

The stress fracture is a disease caused by and abnormal stress to the normal bone with constant, repeated pull. Early detection of stress fracture plays an important role in treatment and prevention of its complication. Bone scintigraphy was performed to evaluate 18 patients with stress fracture of the lower extremities from May, 1985 to April, 1987, in the Department of Internal Medicine of National Police Hospital. The results were as follows: 1) Seventeen of the 18 cases showed positive bone scans at the initial study performed from 1 week to S months after the onset of symtom. 2) Ten of the 18 patients had findings of stress fracture at the initial X-ray film. Two out of 8 negative case revealed positive findings in the follow-up studies. 3) The bone scans in the 2 cases taken 5 months after the onset of symton; the one showed only slightly increased radiouptake, the other showed no abnormal findings. In conclusion, bone scanning is a more sensitive indicator of early stress fracture than radiologic study. The healing phase is characterized by a gradual decline in radioactivity at the fracture site in concordance with subsidence of symptom.

• Explosives and Blasting
• /
• v.17 no.4
• /
• pp.18-31
• /
• 1999

The explosive forming has been used for many year to expand tubes into tubesheets. this process has demonstrated ability to direct carefully the energy of an explosive to expand tubes into tubesheet holes without damaging the tubesheet and without causing the excessive cold work at the tube I.D. that is normally associated with mechanical expansion. The success of explosive tube expansion provided the background for the development of the explosive tube plug. The main results are as follows : (1) The optimum explosives and explosive qualities are PETN, RDX, HMS and about 18~31gr/ft of explosive plugging in nuclear steam generator. (2) Explosive plugging's thickness is 0.9~1.8mm. If groove of 0.4 mm formed in plug outside, For the hydraulic leakage is go up, explosive plugging of formed groove are applicate tube and tubrplate. (3) Sheath is designed on the polyethylene of low density, In thermal impact test of the $430^\circ{C}$, hydraulic leakage is $300kg/cm^2$. (4) About 10~60mm oxide inclusions are existed on the space of explosive plug and tube protect to the leakage.