• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.34C no.2
• /
• pp.1-11
• /
• 1997

We developed a base station modulator ASIC for CDMA digital cellular system. In CDMA digital cellular system, the modulation is performed by convolutional encoding and QPSK with spread spectrum. The function blocks of base station modulator are CRC, convolutional encoder, interleaver pseudo-moise scrambler, power control bit puncturing, walsh cover, QPSK, gain controller, combiner and multiplexer. Each function block was designed by the logic synthesis of VHDL codes. The VHDL code was described at register transfer level and the size of code is about 8,000 lines. The circuit simulation and logic simulation were performed by COMPASS tools. The chip (ES-C2212B CMB) contains 25,205 gates and 3 Kbit SRAM, and its chip size is 5.25 mm * 5,45 mm in 0.8 mm CMOS cell-based design technology. It is packaged in 68 pin PLCC and the power dissipation at 10MHz is 300 mW at 5V. The ASIC has been fully tested and successfully working on the CDMA base station system.

• The KIPS Transactions:PartC
• /
• v.13C no.3 s.106
• /
• pp.311-316
• /
• 2006

We propose the optical sensor network using optical CDMA with bipolar receiver and modified Pseudorandom Noise codes which are widely used in the wireless communication network. We numerically analyze the performances in the optical sensor network. In the proposed network, multiple access interferences between two sensors are suppressed by performing synchronization between the optical encoder and the optical decoder and adjusting the delay times of optical delay lines. Numerical simulations confirm that the performance can be acquired by suppressing the beat noise among optical signals as the number of sensors increases.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.10B
• /
• pp.1216-1221
• /
• 2011

We propose a multiplexed fiber Bragg grating (FBG) sensor network for vessel monitoring to measure the variation of strain and temperature by environmental perturbation based on code division multiple access (CDMA). The center wavelength of FBG was linearly changed by environmental perturbation such as strain and temperature variation so that we could be monitoring the state of sensors. A RSOA was used as optical broadband source and which was modulated by using pseudo random binary sequence (PRBS) signal. The correlation peak of reflected signal from sensor networks was measured. In this paper, we used the sliding correlation techniques for high speed response and dynamic rage of sensors.

• Geomechanics and Engineering
• /
• v.10 no.5
• /
• pp.657-676
• /
• 2016

In this paper, the active lateral earth pressure is evaluated using the stress characteristics or slip line method. The lateral earth pressure is expressed as the lateral earth pressure coefficients due to the surcharge, the unit weight and cohesion of the backfill soil. Seismic horizontal and vertical pseudo-static coefficients are used to consider the seismic effects. The equilibrium equations along the characteristics lines are solved by the finite difference method. The slope of the ground surface, the wall angle and the adhesion and friction angle of the soil-wall interface are also considered in the analysis. A computer code is provided for the analysis. The code is capable of solving the characteristics network, determining active lateral earth pressure distribution and calculating active lateral earth pressure coefficients. Closed-form solutions are provided for the lateral earth pressure coefficients due to the surcharge and cohesion. The results of this study have a good agreement with other reported results. The effects of the geometry of the retaining wall, the soil and soil-wall interface parameters are evaluated. Non-dimensional graphs are presented for the active lateral earth pressure coefficients.

• Journal of Communications and Networks
• /
• v.6 no.1
• /
• pp.9-18
• /
• 2004

Self-encoded multiple access (SEMA) is a unique realization of random spread spectrum. As the term implies, the spreading code is obtained from the random digital information source instead of the traditional pseudo noise (PN) code generators. The time-varying random codes can provide additional security in wireless communications. Multi-rate transmissions or multi-level grade of services are also easily implementable in SEMA. In this paper, we analyze the performance of SEMA in additive white Gaussian noise (AWGN) channels and Rayleigh fading channels. Differential encoding eliminates the BER effect of error propagations due to receiver detection errors. The performance of SEMA approaches the random spread spectrum discussed in literature at high signal to noise ratios. For performance improvement, we employ multiuser detection and Turbo coding. We consider a downlink synchronous system such as base station to mobile communication though the analysis can be extended to uplink communications.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.39 no.2
• /
• pp.69-80
• /
• 2002

In this paper, signed-rank based nonparametric detectors are used for direct sequence code division multiple access pseudo-noise code acquisition systems in frequency-selective Rician fading channels. We first derive the locally optimum rank detector, and then propose the locally suboptimum rank (LSR) and k-th order modified signed-rank (MSRk) detectors using approximate score functions. We compare the serial and hybrid parallel double-dwell schemes using the LSR and MSRk detectors with those using the conventional squared-sum (SS) using the cell averaging constant false alarm rate processor and modified sign detectors. From the simulation results, it is shown that the LSR and MSRk detectors perform better than the SS detector using the cell averaging constant false alarm rate processor.

• Journal of Korean Society for Geospatial Information Science
• /
• v.22 no.1
• /
• pp.47-54
• /
• 2014

Precise Point Positioning (PPP) algorithms using GPS code pseudo-range measurements were developed and their accuracy was validated for the purpose of implementing them on a portable device. The group delay, relativistic effect, and satellite-antenna phase center offset models were applied as fundamental corrections for PPP. GPS satellite orbit and clock offsets were taken from the International GNSS Service official products which were interpolated using the best available algorithms. Tropospheric and ionospheric delays were obtained by applying mapping functions to the outputs from scientific GPS data processing software and Global Ionosphere Maps, respectively. When the developed algorithms were tested for four days of data, the horizontal and vertical positioning accuracies were 0.8-1.6 and 1.6-2.2 meters, respectively. This level of performance is comparable to that of Differential GPS, and further improvements and fine-tuning of this suite of PPP algorithms and its implementation at a portable device should be utilized in a variety of surveying and Location-Based Service applications.

• The Journal of the Acoustical Society of Korea
• /
• v.22 no.1E
• /
• pp.11-18
• /
• 2003

Non-singular boundary element method (BEM) codes are developed in acoustics application. The BEM code is then used to calculate unknown boundary surface normal displacements and surface pressures from known exterior near field pressures. And then the calculated surface normal displacements and surface pressures are again applied to the BEM in forward in order to calculate reconstructed field pressures. The initial exterior near field pressures are very well agreed with the later reconstructed field pressures. Only the same number of boundary surface nodes (1178) are used for the initial exterior pressures which are at first calculated by Finite Element Method (FEM) and BEM. Pseudo-inverse technique is, used for the calculation of the unknown boundary surface normal displacements. The structural object is a tuning fork with 128.4 ㎐ resonant. The boundary element is a quadratic hexahedral element (eight nodes per element).

• Proceedings of the Optical Society of Korea Conference
• /
• 2002.07a
• /
• pp.126-127
• /
• 2002

본 논문에서는 최근, 차세대 정보보호 기술로 많은 연구가 이루어지고 있는 디지털 정보은폐(Digital Information hiding) 기술과 광정보처리 기술을 상호 보완적으로 이용한 새로운 복합 광-디지털 다중 정보은폐 및 실시간 추출 시스템을 구현하였다. 즉, 디지털 기술을 이용한 다중 정보은폐에서는 확산코드간에 랜덤성과 직교성을 보장할 수 있는 새로운 코드로써 의사랜덤 코드(Pseudo random code)와 하다마드 행렬(Hadamard matrix)을 상호보완적으로 조합하여 만든 스테고 키(stego key)를 사용하였으며 이를 이용하여 임의의 커버영상(cover image)에 다중의 정보를 은폐시킬 수 있는 새로운 기법을 제시하였다. 이와 같은 방법으로 은폐된 정보는 정보 은폐시 사용된 스테고 키성분이 정확하게 일치될 경우에만 추출될 수 있으므로 불법 사용자가 무한히 발생시킬 수 있는 랜덤시퀀스를 정확하게 재생하는 것은 거의 불가능함으로 강한 비화성을 가지며, 하다마드 행렬의 직교성으로 서로 다른 확산코드간의 상관성이 발생하지 않기 때문에 에러 없는 은폐정보의 추출도 가능하다. (중략)

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2002.11b
• /
• pp.306-311
• /
• 2002

Non-singular boundary element method (BEM) codes are developed in acoustics application. The BEM code is then used to calculate unknown boundary surface normal displacements and surface pressures from known exterior near Held pressures. And then the calculated surface normal displacements and surface pressures are again applied to the BEM in forward in order to calculate reconstructed field pressures. The initial exterior near field pressures are very well agreed with the later reconstructed field pressures. Only the same number of boundary surface nodes (1178) are used far the initial exterior pressures which are initially calculated by Finite Element Method (FEM) and BEM. Pseudo-inverse technique is used for the calculation of the unknown boundary surface normal displacements. The structural object is a tuning fork with 128.4 Hz resonant. The boundary element is a quadratic hexahedral element (eight nodes per element).