• 대한공간정보학회지
• /
• 제23권4호
• /
• pp.43-48
• /
• 2015

본 논문은 DGNSS(Differential GNSS) 위치정확도 향상을 위한 PRC(Pseudo-Range Correction) 보정정보 모델링에 관한 연구내용이다. PRC는 DGNSS 기법을 이용하여 측위정확도를 향상시키기 위해 사용되는 보정정보로써 사용자가 통신망을 통해 수신한 뒤 사용된다. 그러나 일시적인 통신두절이나 신호간섭 등으로 인해 위치정확도가 급격히 저하되는 일이 발생한다. 그래서 본 논문에서는 이러한 현상을 방지하기 위해 PRC 보정정보를 다항식 곡선접합 방정식을 이용하여 모델링하고 그 정확도를 평가하였다. 모델링 매개변수를 이용하여 계산한 PRC 추정값과 실제 기준국 수신기에서 생산되는 관측값간의 차이를 계산한 결과 GPS의 경우에는 평균 0.1m, RMSE는 1.3m로 나타났고 대부분의 위성들이 ${\pm}1.0m$ 이내의 편향오차와 3.0m 이내의 RMSE를 보였다. GLONASS의 경우에는 평균 0.2m이고 대부분 ${\pm}2.0m$ 이내에 분포하였다. RMSE는 2.6m로 나타났고 다수의 위성들이 3.0m 이내에 분포하였다. 이런 결과는 모델링을 통해 산출한 추정값이 사용자의 위치정확도를 유지하는데 유효하게 사용될 수 있음을 보였다. 그러나 고도각이 낮은 영역에서 두 값의 차이가 크게 나타나 이에 대한 연구를 추가적으로 수행할 필요성이 있다.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2002년도 ICCAS
• /
• pp.82.3-82
• /
• 2002

This paper designs an integrated navigation system that uses the signals from both GPS satellites and pseudolites. While GPS satellite clocks are synchronized, pseudolite clocks are not exactly synchronized even though pseudolite can use 1PPS signal from the GPS receiver. This can cause large range error and can be solved by transmitting the correction information. Assuming that the positions of pseudolites are known, it is possible to determine the true range between two pseudolites. Also, from the measurement of pseudolite signals, the pseudo range between two pseudolites can be calculated. Using the difference between the true range and the pseudo range, each pesudolite can produce correc...

• 한국항해항만학회지
• /
• 제34권7호
• /
• pp.511-516
• /
• 2010

GPS anomaly has increased according to the degradation of satellite performance, and many GPS users could be exposed to any kinds of error-included signals without any previous notice when unscheduled error occurred. RSIM (Reference Station Integrity Monitors) is a typical monitoring method to broadcast PRC (Pseudo Range Correction) for users. However, there were some cases that the receiver detected the anomalous satellite's signal even though it was unhealthy set, consequently it occurred a large range error. Then it is important to monitor the integrity of GPS signal and it is needed to devise the correction method of pseudorange by eliminating error-occurred PRN for notification to GPS users when it is monitored that the anomaly occurred. This paper proposes the basic concept of how to correct the pseudorange. The paper also shows the analysis results of PRN10 GPS anomaly occurred on day 39 in 2007 with corrected results by eliminating anomaly satellite (PRN10). The proposed correction method shows decreased pseudorange error range compared to the case when the anomaly satellite were used.

• 한국항행학회논문지
• /
• 제22권6호
• /
• pp.602-609
• /
• 2018

DGPS (differential GPS) 방식의 위치해 계산 방식은 기준국 수신기와 동적 수신기와의 의사거리 보정정보 (PRC; pseudo-range correction) 실시간 통신을 통해서 위치해를 계산하는 방식을 말한다. 실제 동적으로 움직이는 수신기에서는 기준국 수신기와의 통신이 단절되어 PRC 실시간 통신이 단절되는 상황이 발생한다. 논문에서는 DGPS 방식의 위치해 계산방식에서 PRC를 받는 실시간 상황 중간에서수신기에 의사거리보정 정보전송이 끊긴 상황을 가정하여, 수신기에서 기존에 수신했던 PRC 정보를 사용하여 가상의 PRC 모델을 기계학습 알고리즘을 통해 실시간 생성하는 predict DGPS를 제안한다. predict DGPS 방식을 검증하기 위해 고정되어있는 기준국의 수신기에서 실제 PRC와 본 논문에서 제안 한가상의 PRC를 적용하여 위치해를 비교, 분석하였다. 또한 실제 도로에서 PRC 통신이 단절된 시나리오를 가정하여, predict DGPS 방식을 적용한 위치해 계산 방식이 기존 방식의 위치해 계산과 비교하여 향상된 위치해를 보여 줄수 있음을 보였다.

• 한국구조물진단유지관리공학회 논문집
• /
• 제25권6호
• /
• pp.50-59
• /
• 2021

현재 공용중인 교량에 대한 재하시험으로 계측한 응답과 초기해석모델의 해석 응답을 비교하여 응답보정계수를 계산하고, 이 모델을 사용하여 내하율과 내하력을 평가하는 방법을 적용하고 있다. 그러나 이러한 응답보정계수는 계측 위치와 하중 조건에 따라 변동하는 값을 준다. 특히 초기해석모델이 교량의 거동에 합당하지 않은 경우, 그 변동 폭이 크며 보정된 모델에 의한 해석 응답이 계측된 응답과 동떨어진 결과를 줄 수 있다. 본 연구에서는 저속으로 주행하는 차량의 다양한 하중 조건에서 동적 성분을 제거한 정적 응답을 얻기 위해 의사정적재하시험법을 적용하였다. 두 개의 유사한 PSC-I 거더교에서 정적 응답을 계측하고, 두 교량 각각에 대한 변위와 변형률에 대한 응답보정계수를 계산하였다. 초기해석모델이 제대로 설정되어 있지 않다면, 평균적으로 구한 응답보정계수로 보정한 모델의 해석 응답이 계측 응답과 오차범위 내에 들어오는지 않음을 확인하였다.

• Journal of Positioning, Navigation, and Timing
• /
• 제2권1호
• /
• pp.9-17
• /
• 2013

In this paper, a pseudorange correction regeneration algorithm was developed to improve the positioning accuracy of DGPS using multi-reference stations, and the optimal minimum number of reference sites was determined by trying out different numbers of reference. This research was conducted using from two to five sites, and positioning errors of less than 1 m were obtained when pseudorange corrections are collected from at least four reference stations and interpolated as the pseudorange correction at the rover. After determining the optimal minimum number of reference stations, the pseudorange correction regeneration algorithm developed was tested by comparison with the performance of other algorithms. Our approach was developed based on an exponential model. If pseudorange corrections are regenerated using an exponential model, the effect of a small difference in the baseline distance can be enlarged. Therefore, weights can be applied sensitively even when the baseline distance differs by a small amount. Also weights on the baseline distance were applied differently by assigning weights depending on the difference of the longest and shortest baselines. Through this method, the positioning accuracy improved by 19% compared to the result of previous studies.

• Journal of Power Electronics
• /
• 제16권3호
• /
• pp.872-882
• /
• 2016

A novel pseudo-continuous conduction mode (PCCM) voltage-fed single-stage power factor correction (PFC) full-bridge battery charger is proposed in this paper. By connecting a freewheeling transistor in parallel with an input inductor, the PFC cell can operate in the PCCM with a constant duty ratio. Thus, the dc/dc stage can be designed using this constant duty ratio and the restriction on the duty ratio of the PFC cell is eliminated. As a result, the input current distortion is less and the dc bus voltage becomes controllable over the wide output power range of the battery charger. Moreover, the operation principle of the dc/dc stage is designed to be similar to that of a conventional phase-shifted full-bridge converter. Therefore, it is easy to implement. In this paper, the operation of the new converter is explained, and the design considerations of the controller and key parameters are presented. Simulation and experimental results obtained from a 1 kW prototype are given to confirm the operation of the proposed converter.

• 전기학회논문지
• /
• 제59권10호
• /
• pp.1874-1881
• /
• 2010

A recursive linear stochastic error compensation algorithm is newly proposed for target localization in sensor network which provides range difference of arrival(RDOA) measurements. Target localization with RDOA is a well-known nonlinear estimation problem. Since it can not solve with a closed-form solution, the numerical methods sensitive to initial guess are often used before. As an alternative solution, a pseudo-linear estimation scheme has been used but the auto-correlation of measurement noise still causes unacceptable estimation errors under low SNR conditions. To overcome these problems, a stochastic error compensation method is applied for the target localization problem under the assumption that a priori stochastic information of RDOA measurement noise is available. Apart from the existing methods, the proposed linear target localization scheme can recursively compute the target position estimate which converges to true position in probability. In addition, it is remarked that the suggested algorithm has a structural reconciliation with the existing one such as linear correction least squares(LCLS) estimator. Through the computer simulations, it is demonstrated that the proposed method shows better performance than the LCLS method and guarantees fast and reliable convergence characteristic compared to the nonlinear method.

• 한국소음진동공학회논문집
• /
• 제24권7호
• /
• pp.537-548
• /
• 2014

In this paper, horn loudspeaker modeling was suggested, investigated and verified through comparison of test results and simulation ones based on input electrical impedance curves and acoustic sensitivity ones. First, Thiele Small parameters of horn driver were identified by using pseudo loudspeaker model concept and verified in case of both closed and open horndriver. Second, cone-shaped horn models were investigated and compared with input acoustic impedance curves for real horn(cone angle $6.6^{\circ}$) and short horn(cone angle $27.9^{\circ}$). It showed that Leach model for cone horn was well described to test results, which were electrical impedance and acoustic sensitivity, compared to Lemaitre one. To represent horn system model good approximation in wide frequency range, mass correction filter and lowpass filter were adopted and consequently showed good fitted to test results.

• Journal of Positioning, Navigation, and Timing
• /
• 제7권1호
• /
• pp.43-52
• /
• 2018

In recent years, the need of high accuracy navigation for vehicles has increased due to the development of autonomous driving vehicles and increase in land transportation convenience. This study is performed for vehicle users to achieve a performance of centimeter-level positioning accuracy by utilizing Compact Network Real-time Kinematic (RTK) that is applicable as a national-level infrastructure. To this end, medium-baseline RTK was implemented in real time to estimate accurate integer ambiguities between reference stations for reliable generation of Network RTK correction using the linear combination of carrier-phase observations and L1/L2 pseudo-range measurements. The residual tropospheric error was estimated in real time to improve the accuracy of double-differenced integer ambiguity resolution between network configuration reference stations that have at least 30 km or longer baseline distance. In addition, C++ based software was developed to enable real-time generation and broadcasting of Compact Network RTK correction information by utilizing an accurately estimated double-differenced integer ambiguity values. As a result, the horizontal and vertical 95% accuracy was 2.5cm and 5.2cm, respectively, without performance degradation due to user's position change within the network.