• Proceedings of the Korean Society of Surveying, Geodesy, Photogrammetry, and Cartography Conference
• /
• 2007.04a
• /
• pp.201-205
• /
• 2007

In the post-Cold War era, acquisition technique of high-resolution satellite imagery (HRSI) has begun to commercialize. IKONOS-2 satellite imaging data is supplied for the first time in the 21st century. Many researchers testified mapping possibility of the HRSI data instead of aerial photography. It is easy to renew and automate a topographical map because HRSI not only can be more taken widely and periodically than aerial photography, but also can be directly supplied as digital image. In this study matching size of IKONOS Geo-level stereo image is presented lot production of digital elevation model (DEM). We applied area based matching method using correlation coefficient of pixel brightness value between the two images. After matching line (where "matching line" implies straight line that is approximated to complex non-linear epipolar geometry) is established by exterior orientation parameters (EOPs) to minimize search area, the matching is tarried out based on this line. The experiment on matching size is performed according to land cover property, which is divided off into four areas (water, urban land, forest land and agricultural land). In each of the test areas, window size for the highest correlation coefficient is selected as propel size for matching. As the results of experiment, the proper size was selected as $123{\times}123$ pixels window, $13{\times}13$ pixels window, $129{\times}129$ pixels window and $81{\times}81$ pixels window in the water area, urban land, forest land and agricultural land, respectively. Of course, determination of the matching size by the correlation coefficient may be not absolute appraisal method. Optimum matching size using the geometric accuracy therefore, will be presented by the further work.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.18 no.4
• /
• pp.1-7
• /
• 2004

As we know, topography of korea is composed of many mountains. Also, the volume of traffic is increasing more and more nowadays. So, many tunnels are being constructed to reduce cost of transport and time. Thus, tunnel illumination was considered as the most important thing to make safe traffic conditions. In the past, we installed luminaires on the wall in tunnel, but currently we are installing those on the ceiling. Wherever luminaires are installed on the ceiling, the electric designer may not have known the proper point to install luminaires. Therefore, we researched this project to resolve above problems with abundant experience and accurate data through simulation(Lightscape program). As a result of research, mounting luminaires on the ceiling are better than wall because uniformity is more regular and utilization factor is also higher and then brightness is adequate as well, whereby installation on the ceiling is economical. Therefore, it is suitable that luminaires are installed on the ceiling in tunnel than wall.

• Journal of Conservation Science
• /
• v.31 no.4
• /
• pp.457-476
• /
• 2015

This study is expected to present instructions and analysis of Modern Dancheong pigments by its physical characteristics. Search pigments currently used and experiments proper mixing ratio of Jangdanyuksaek(Incarnadine). Samples are made by based on presented a mixture ratio which is less exfoliation, cracks and color change. And put into accelerated weathering test and ultraviolet ray degradation test. As a result in case of Jidang($TiO_2$) Rutile type is superior in discoloration and durability. Rutile type makes color difference remarkably because of oil absorption difference while mixing with Jangdan. Water paints which are used as a alternative present yellowness which means water paints lack in durability. whiting should be taken carefully as it has high brightness after degradation.

• Culinary science and hospitality research
• /
• v.22 no.2
• /
• pp.66-77
• /
• 2016

This study aimed to develop eel dipping sauce adding bokbunja(Rub coreanus Miquel) vinegar and investigated the physicochemical and quality properties of eel dipping sauce for optimization. To accomplish the objective, eel dipping sauce was created by adding bokbunja vinegar. The findings are as follows. Among the composition, moisture and crude fiber content increased as more bokbunja vinegar was added. As for crude protein and crude ash, however, their content decreased as more bokbunja vinegar was added. In terms of crude fat, there was no difference between the control group and addition group. As for pH, the content decreased as more bokbunja vinegar was added. Also. the following properties declined as more bokbunja vinegar was added: titratable acidity; sugar content; salinity; viscosity. In terms of chromaticity, however, the brightness(L), redness(a), and yellowness(b) all increased. The overall acceptability was as follows: 0% < 5% < 10% < 20% < 15% Therefore, the proper content of bokbunja vinegar to add in eel dipping sauce is approximately 15~20%.

• Proceedings of the Korea Technical Association of the Pulp and Paper Industry Conference
• /
• 2006.06a
• /
• pp.111-116
• /
• 2006

The microstickes control effects of some fixing agents, including an inorganic PAC, an organic polyamine (PA) and polydiallydimethyl ammonium chloride (Pdadmac), and a high cationic starch (HCS), were investigated, together with their effects on wet end performances and physical properties of handsheets. Despite that the HCS and Pdadmac had lower cationic charge densities than the PA and PAC (the HCS being even lower), they gave higher zeta potentials to fibers, and lower turbidities, cationic demands and residual COD contents to the pulp liquid phases than the PA and PAC did. In all cases, the HCS showed even better effects than the Pdadmac. In addition, drainage speed was also much higher by the HCS treatments although paper formation was worsened. All the phenomena showed that the HCS can fix more dissolved and colloidal substances to cellulose fibers, indicating that the HCS functioned mainly with flocculation and even hydrogen bonding mechanisms. Data on optical properties further indicated that the HCS interacted preferentially with colloidal substances, since it fixed more 'dirty' microstickes to fibers which decreased more sheet brightness while increasing more sheet opacity (with both higher light absorption and scattering coefficients). Interestingly, the organic fixing agents did not decrease tensile, tearing, and folding strengths of paper sheets made from 100% recycled newsprint pulp, except when they were dosed in high amounts. On the contrary, the inorganic PAC had more serious negative effects on the strength properties, especially on folding endurance. The study suggested that proper use of the HCS can lead to better microstickies control effects than traditional agents and methods.

• Proceedings of the Korea Technical Association of the Pulp and Paper Industry Conference
• /
• 2006.06a
• /
• pp.117-121
• /
• 2006

Virgin bleached kraft pulp, CPO (computer printout) and white ledgers are main raw materials used in tissue mills. The utilization rate of recycled fibers and virgin pulp in South Korea tissue industry are 90% and 10%, respectively. To improve brightness of printing grades the use of 'fluorescent whitening agents (FWAs)' or 'optical brightening agents (OBAs)' has been increased. When recycling these papers for tissue production, it is unavoidable that FWAs contained in recycled papers flow into tissue production lines and remain in the products. And this draws great attention from the public. This study was carried out to develop a technology for the removal of fluorescent whitening agents from recycled fibers. Enzymatic removal of FWAs was evaluated as a method to remove FWAs from the recycled fiber. The ${\alpha}-amylase$ that degrades starched used for surface sizing of fine papers and contained substantial condition is needed to prevent the re-adsorption of FWAs on fibers. The temperature of pulp suspension was another important factor affecting on FWA removal. The higher the temperature, the greater the efficiency of removing FWAs was obtained. Optimum pH and temperature for the effective removal of FWAs were suggested to be pH 8.5 and $65^{\circ}C$, respectively. The enzymatic removal of FWAs showed a great synergistic effect when proper control in pH and temperature was made.

• Journal of The Korean Association For Science Education
• /
• v.19 no.4
• /
• pp.570-584
• /
• 1999

The units about electricity in 5th and 6th science curriculum for elementary school was analyzed and the elementary students' understanding of related concepts was investigated. This study was to make connection between the research about alternative concepts and writing textbooks. It was found that students' response had following characteristics. They had strong belief that the + and - ends of battery should be connected. However this belief was not complete because students did not understand that the other circuit elements had to be connected properly. When the circuit involve more than one bulbs or batteries, they counted the number of batteries or bulbs only and paid little attention to the connection of them. In explaining circuits and the brightness of the bulbs in the circuits. students tried to explains the circuit using scientific terms but failed to used them properly. Although the concept of resistance was not dealt explicitly. student had reasonable qualitative understanding about resistance. According to response of students, several suggestions might be made for the curriculum. The structure and the circuit elements and the proper connection needs to be taught. Also more emphasis is necessary to pay attention to the connection in addition to the numbers of bulbs or batteries. Finally, it needs to be investigated carefully if it is better to introduce some qualitative model to explain the amount of current through bulb depending on the connection and the number of bulbs. It might also be better to introduce some terms, such as current and resistance with the model.

• Korean Journal of Human Ecology
• /
• v.24 no.6
• /
• pp.859-871
• /
• 2015

The purpose of this study is to examine the influence of the pigment characteristic and changes in dying conditions on the dying properties by extracting Chelidonium majus var. asiaticum using distilled water and ethanol as solvents. Changes in dying conditions include variations in dye concentrations, dyeing temperatures and time on dye uptake, and K/S Value was compared according to these changes. Additionally, color changes were observed through mordant. Ultraviolet-visible spectrum was used to investigate the pigment characteristic, and as a result, tannin was identified in distilled-water-extract, whereas berberine and chlorophyll were identified in ethanol-extract. In FT-IR analysis, tannin in distilled-water-extract was verified as hydrolyzable tannin. For ethanol extract, chlorophyll was verified through absorption band of C-H, which is aliphatic spectrum around $2920cm^{-1}$ and $2850cm^{-1}$. From GC/MS analysis, oil components as well as terpine compounds were detected in ethanol-extract, and this, in turn, brings expectation regarding functionality. When dying in silk, dye uptake increased as concentration of the extract increased, and the optimum dyeing temperature and time were $40^{\circ}C$ and 60 minutes respectively. Dyed fabrics' colors were all basically Y-series colors, and adjustment in brightness and revelation of khaki color were also available depending on the type of the mordant. Color fastness, except for washing fastness, was good in silk dyed with distilled-water-extract. Thus, it can be concluded that by selecting the right extracting method and by doing proper dyeing and mordant according to the needs, these dyed fabrics can be used as eco-friendly, functional clothing material.

• Korean Institute of Interior Design Journal
• /
• v.22 no.1
• /
• pp.47-54
• /
• 2013

For the office work environmental design, the importance of the design management is increased to improve operation efficiency as well as the aesthetic environmental implementation of the function today. Lighting is a required element ineffective operation environment. It has become more important for the aesthetic, economic, and practical reasons, to consider the luminous environment and the lighting of visual tasks separately. When the brightness is insufficient, productivity deteriorates, and the layout of the lighting located by mistake causes the fatigue of eyes. Productivity rises to office in a large number of studies so as satisfaction is low in general in the dark office, and to be bright. Therefore the purpose of this research is to suggest the right direction of lighting design of office building area. 11newly renovated office buildings are selected for this luminous environment research. We could conclusions as following through this research. First, it was planned brighter than the recommended lighting level in the most space. It shows that the accurate lighting design criteria is needed in order to achieve proper lighting environment. Second, the application of the LED lighting fixtures is continuously increased in the recent office lighting environment. It is explained that it is applied for reasons of the electrical energy reduction and the maintenance efficiency with the long life time. Third, the consideration of the lighting plan for the difference of working types is not enough. with various communication configuration through an independent plan, and the effective lighting plan that appropriateness preparation design and energy saving area vailable must be applied. Fourth, the lighting environment of the lobby needs a specialized lighting plan as are presentative space of the building.

• Textile Coloration and Finishing
• /
• v.18 no.1
• /
• pp.10-19
• /
• 2006

Despite several recent attempts to measure the concentration of individual catechins by HPLC, it has not been so easy to separate catechins accurately. The aim of the present work is to provide a proper condition for separating each component of catechins by HPLC analysis, and also to evaluate the experimental variables including color differences, and metal ion contents after dyeing and mordanting. Four kinds of Catechins, (-)-epicatechin(EC), (-)-epicatechin gallate(ECG), (-)-epigallocatechin(EgC), (-)-epigallocatechin gllate(EgCG) were isolated from the residues after dyeing. Catechins in Korean green tea leaves are richer when e tea leaves are younger. Higher concentration of catechins owes it to e way it is processed. The contents of catechins adsorbed in silk fabrics after dyeing were in order of EGCG>ECG>EGC>EC. We have found $68\%$ uptake of EGCG, and 116.8mg of EGCG in the silk fabrics after it was dyed with $1\%$ Korean green tea extracts. The absorbance intensity and K/S values of dyed silk fabrics were increased with dyeing temperature and time. Only the surface color of the silk fabric dyed with green tea extracts was yellowish red, but it changed from yellowish red to red with an increase in the mordant concentration. Post-mordanted silk fabrics with ferrous sulfate changed from yellowish red to red and purple color shade. In a practical evaluation, there is no significant change in color after twenty times of the continuous dry cleaning process. However, post-mordanted fabrics with ferrous sulfate faded the brightness of color after dry cleaning. Dyeing silk fabrics with a Korean tea extract reduced the metal ion contents in the silk fabrics when compared to the untreated silk fabrics. Metal contents in silk fabrics dyed and post-mordanted with $1\%$ each metal solution were 0.194 ppm for Aluminum, 1.601ppm for Copper, and 0.334 ppm for Iron. After the post-mordanting process, the heavy metal ion absorption increased, which was mainly attributed to the catechins and polyphenols in dyed silk fabrics.