• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.2
• /
• pp.98-103
• /
• 2013

In this work, we investigated the enhanced performance of IZO-based TFTs with $HfSiO_x$ gate insulators. Four types of $HfSiO_x$ gate insulators using different diposition powers were deposited by co-sputtering $HfO_2$ and Si target. To simplify the processing sequences, all of the layers composing of TFTs were deposited by rf-magnetron sputtering method using patterned shadow-masks without any intentional heating of substrate and subsequent thermal annealing. The four different $HfSiO_x$ structural properties were investigated x-ray diffraction(XRD), atomic force microscopy(AFM) and also analyzed the electrical characteristics. There were some noticeable differences depending on the composition of the $HfO_2$ and Si combination. The TFT based on $HfSiO_x$ gate insulator with $HfO_2$(100W)-Si(100W) showed the best results with a field effect mobility of 2.0[$cm^2/V{\cdot}s$], a threshold voltage of -0.5[V], an on/off ratio of 5.89E+05 and RMS of 0.26[nm]. This show that the composition of the $HfO_2$ and Si is an important factor in an $HfSiO_x$ insulator. In addition, the effective bonding of $HfO_2$ and Si reduced the defects in the insulator bulk and also improved the interface quality between the channel and the gate insulator.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.7
• /
• pp.115-121
• /
• 2013

We fabricated thin film transistors (TFTs) using TiInZnO(TiIZO) thin films as active channel layer. The thin films of TiIZO were deposited at room temperature by RF-magnetron co-sputtering system from InZnO(IZO) and Ti targets. We examined the effects of titanium addition by X-ray diffraction, X-ray photoelectron spectroscopy and the electrical characteristics of the TFTs. The TiIZO TFTs were investigated according to the radio-frequency power applied to the Ti target. We found that the transistor on-off currents were greatly influenced by the composition of titanium addition, which suppressed the formation of oxygen vacancies, because of the stronger oxidation tendency of Ti relative to that of Zn or In. A optimized TiIZO TFT with rf power 40W of Ti target showed good performance with an on/off current ratio greater than $10^5$, a field-effect mobility of 2.09 [$cm^2/V{\cdot}s$], a threshold voltage of 2.2 [V] and a subthreshold swing of 0.492 [V/dec.].

• Industry Promotion Research
• /
• v.3 no.2
• /
• pp.9-20
• /
• 2018

The purpose of this study is to examine the influence of orgaizational capability(Organizational management capability, marketing capability, relationship formation capability, governance capability) of management perceived by the members of the social enterprise on performance of organization(both economic and social). For such goal, empirical analysis of research hypothesis 1 (organizational competence and economic performance) and research hypothesis 2 (organizational competence and social performance) was conducted using the statistical program of IBM SPSS 24.0 for the final 195 candidates who work in social enterprise. Both hypothesis 1 and 2 were adopted, as the result of the hypothesis 1 and 2, H1-1 H2-1 (organizational management competence and economic performance and social performance), H1-2 H2-2 (marketing competence and economic performance social performance), H1-3 H2-3 (relationship formation competence, economic performance, and social performance), and H1-4 H2-4 (governance capability and economic performance and social performance) all have a significant effect on economic and social performance. Therefore, the importance of organizational capability of management, executive body of social enterprises, was emphasized for the success and strive of social enterprise and sustainable management. Therefore, it is necessary to establish an education and training system to strategically develop and strengthen the organizational capability of the management, and provide a systematic and long-termed education system and training.

• Journal of the Microelectronics and Packaging Society
• /
• v.22 no.1
• /
• pp.15-19
• /
• 2015

We demonstrated an inspection system for detecting discoloration of PCB Cu ball pad with an OSP surface finish. Though the OSP surface finish has many advantages such as eco-friendly and low cost, however, it often shows a discoloration phenomenon due to a heating process. In this study, the discoloration was analyzed with device-independent CIELAB color space. First of all, the PCB samples were inspected with standard lamps and CCD camera. The measured data was processed with Labview program for detecting discoloration of Cu ball pad. From the original PCB sample image, the localized Cu ball pad image was selected to reduce the image size by the binarization and edge detection processes and it was also converted to device-independent CIELAB color space using $3{\times}3$ conversion matrix. Both acquisition time and false acceptance rate were significantly reduced with this proposed inspection system. In addition, $L^*$ and $b^*$ values of CIELAB color space were suitable for inspection of discoloration of Cu ball pad.

• Korean Journal of Ichthyology
• /
• v.30 no.1
• /
• pp.27-35
• /
• 2018

The activity period and feeding ecology of the Iksookimia yongdokensis were investigated to obtain baseline data for its ecological characteristics in the Chuksan Stream and Gokgang Stream, Gyeongsangbuk-do, Korea from 2015 to 2016. I. yongdokensis were active on cobble, pebble and sand bottom from March to November when the water temperature exceeded $10^{\circ}C$, but tended to overwinter in cobble and pebble during the winter months (December~February) when the water temperature was lower than $10^{\circ}C$. During the day from 9 am to 15 pm, individuals of I. yongdokensis were highly active with a high rate of food consumption. I. yongdokensis activley fed on the surface of stone, pebble and sand as a filter feeder. Their main food sources analyzed with an index of relative importance (IRI) include Chironomidae (54.7%), Branchiopoda (10.1%), Rotatoria (8.7%), Arcellidae (8.6%), Chlorophyceae (6.5%) and Bacillariophyceae (5.1%). Juveniles of I. yongdokensis (total length 20~39 mm) fed on small-sized preys such as Rotatoria, Branchiopoda and Arcellidae, but they exhibited a transition in their prey-size markedly dominated by large-sized preys such as Chironomidae and Ephemeroptera as they grow.

• Korean Journal of Agricultural Science
• /
• v.42 no.1
• /
• pp.15-22
• /
• 2015

This study was conducted to evaluate the phytotoxicity of imazosulfuron+fentrazamide mixture in rice field. It is recommended that safe herbicide application was obtained at 3 cm of transplanting depth and in sandy loam or loam soil type. In the direct water seeding of rice, imazosulfuron+fentrazamide SC should be applied at least 10 days before sowing land ower than 25+100 g ai/ha. In case of imazosulfuron+fentrazamide SC application after sowing, If we use the herbicide 15 days after sowing, no herbicide symptoms will be detected even though the amounts of the herbicide increase. In the rice transplanting, it is recommended that imazosulfuron+fentrazamide GR is applied 5 days after transplanting. In case of sequential herbicide application, the imazosulfuron+fentrazamide SC application at 75+300 g ai/ha 15 or 20 days after transplanting after the application at 25+100 g ai/ha or 50+200 g ai/ha 3 days before sowing increases weed control efficacy and gives no phytotoxicity in the rice growth.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.23 no.2
• /
• pp.217-225
• /
• 2010

Most of the steel bridges in Korea are being currently designed by the allowable stress design method that uses the conventional deterministic factors of safety. However the limit state design based on the concept of probability, statistics and reliability engineering is becoming very popular as a global standard deign method, leading the rational and economic bridge design. As part of the fundamental research to establish the load and resistance factor design(LRFD) of steel bridges considering domestic environmental conditions and regional characteristics, an experimental design is conducted by applying AASHTO-LRFD specification especially to a steel closed-box girder, which occupies relatively a large portion of steel bridges in Korea. Throughout the experimental design according to various sectional changes, some of the issues to be considered in the LRFD design of a composite steel closed-box girder bridge are examined. In this process, an Excel-based design verification program is developed for easy computation and prevention of errors. Quantitative reliability levels of the bridge sections designed by LRFD are also estimated using a reliability analysis method, and compared with the target reliability indexes applied in the LRFD design to verify the validity of the procedure and methodology used in this study.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.26 no.4
• /
• pp.247-254
• /
• 2013

In this paper, dynamic response analysis of a heave compensation system is performed for offshore drilling operations based on multibody dynamics. With this simulation, the efficiency of the heave compensation system can be virtually confirmed before it is applied to drilling operations. The heave compensation system installed on a semi-submersible platform consists of a passive and an active heave compensator. The passive and active heave compensator are composed of several bodies that are connected to each other with various types of joints. Therefore, to carry out the dynamic response analysis, the dynamics kernel was developed based on mutibody dynamics. To construct the equations of motion of the multibody system and to determine the unknown accelerations and constraint forces, the recursive Newton-Euler formulation was adapted. Functions of the developed dynamics kernel were verified by comparing them with other commercial dynamics kernels. The hydrostatic force with nonlinear effects, the linearized hydrodynamic force, and the pneumatic and hydraulic control forces were considered as the external forces that act on the platform of the semi-submersible rig and the heave compensation system. The dynamic simulation of the heave compensation system of the semi-submersible rig, which is available for drilling operations with a 3,600m water depth, was carried out. From the results of the simulation, the efficiency of the heave compensation system were evaluated before they were applied to the offshore drilling operations. Moreover, the calculated constraint forces could serve as reference data for the design of the mechanical system.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.33 no.4
• /
• pp.263-270
• /
• 2020

This study evaluates the structural behavior of connected long-span beams applied for excavation in urban areas with a narrow street. Generally, the reliability of the connection is reduced owing to the defect of the upper flange in the connection. An improved connection part was developed to complement the defects in the connected long-span beam. A finite element analysis based on a commercial program, ABAQUS, was employed to evaluate the behavior of the improved connection part. A numerical analysis model was proposed to analyze the high-strength bolt connection and the composite behavior of steel and concrete applied to the improved connection. The suitability of the proposed numerical analysis was verified by comparing the experimental and numerical analysis results of the references. Using the proposed numerical analysis method, the improved and general connections were analyzed and compared with each other. The stress distribution and elastic-plastic behavior of the long-span beam were analyzed numerically. The analysis confirmed that 25% of the compressive stress was improved, resulting in the improvement of structural safety and performance.

• Management & Information Systems Review
• /
• v.28 no.1
• /
• pp.125-156
• /
• 2009

The primary purpose of this study is to identify the determinants of the users' satisfaction and commitment in personal media. For these purposes, we developed a research model based on the literature reviews of personal media, perceived risk and interactivity, satisfaction, and commitment. This study has identified four dimensions in the concept of perceived risk, such as privacy risk, social risk, time loss risk, and economic risk, and three dimensions in the concept of perceived interactivity, such as active control, two-way communication, and responsiveness. In survey, data were collected from 428 male and female who have an experience in personal media. Data was analyzed factor analysis, reliability analysis, measurement model analysis, and structural model analysis by utilizing SPSS 15.0 and AMOS 5.0 program. Analysis results of research model indicate the following. Firstly, privacy risk, active control, two-way communication, and responsiveness are significantly related satisfaction. Secondly, privacy risk, time loss risk, economic risk, active control, and two-way communication are significantly related commitment. Thirdly, users' satisfaction has positive relationship with commitment in personal media. Based on these results, theoretical implications for relevant researchers and managerial implications for personal media vitalization and marketing strategy are discussed. Finally, limitations for this study and further research issues are suggested.