• The Korean Journal of Physiology
• /
• v.1 no.1
• /
• pp.57-66
• /
• 1967

Cold $(0^{\circ}C)$ or warm $(25^{\circ}C)$ fresh and sea water were flooded into the lungs of rabbits through tracheal canule. Respiratory arrest ensued in 19.5 minutes in the warm fresh water flooded rabbits and was the longest survival time among the experimental groups. The survival times in the other groups were: 2.32 minutes in cold fresh water group, 2.75 minutes in .warm sea water group, and 4.57 minutes in cold sea water group. Cardiac output was measured by means of T-1824 dilution technique after 2 or 3 minutes of flooding in 27 rabbits. Blood pressure was observed by mercury manometer throughout the survival time in 40 rabbits. The following results were obtained. 1. Cardiac output in the warm fresh water flooded and sea water flooded animal was smaller than that of control rabbits. In the cold fresh water flooded animal cardiac output was greater than that of the control animal. 2. Time constants of T-1824 dilution curve of experimental group were elongated than the normal curve. 3. Central blood volume showed an increase in the fresh water group, a decrease in cold sea water group and no change in warm sea water group. 4. In all of the experimental groups arterial blood Pressure showed an abrupt and great variations after flooding of lungs and lasted about 30 seconds. Thereafter, arterial pressure remained at a plateau level until the sudden fall to zero and this was almost coincided with the time of respiratory arrest. The Plateau level of arterial Pressure in fresh water group was about 10 mmHg higher than the control value, and it was lower than the control value in warm sea water group. In cold sea water group the plateau was made up by fluctuations around the control value. 5. Osmosis of water through the lung alveolar membrane occured in all animals. Fresh water caused hemodilution and sea water caused hemoconcentration. 6. In sea water flooded animal more volume of water was recovered through the tracheal canule than the volume injected into trachea. This was interpreted as the consequence of the shift of water from plasma to alveolar sac. 7. Relative freight of lung was greater in fresh water group than sea water group. In all animal lung edema ensued. 8. The mechanisms of cardiac output variations were discussed.

• Korea-Australia Rheology Journal
• /
• v.20 no.4
• /
• pp.253-260
• /
• 2008

A method based on transient shear flow dynamics of red cell aggregates was developed to investigate reversible re-aggregation processes with decreasing shear flow. In the microchannel-flow aggregometry, the aggregated red blood cells that are subjected to continuously decreasing shear stress in microchannel flow were measured with the use of a laser-scattering technique. Both the laser-backscattered intensity and pressure were simultaneously measured with respect to time, resulting in shear stress ranging from $0{\sim}35\;Pa$ for a time period of less than 30 seconds. The time dependent recording of the backscattered light intensity (syllectogram) yielded an upward convex curve with a peak point, which reflected the transition threshold of aggregation in the RBC suspensions. Critical-time and critical-shear stress corresponding to the peak point were examined by varying the initial pressure-differential and the micro channel depth, and these results showed good potential for being used as new aggregation indices. In the present study, these newly proposed indices were also validated by differentiating the effect of fibrinogen on RBC aggregation and then these indices were compared to the conventional indices that were measured by a rotational aggregometer.

• Proceedings of the KIEE Conference
• /
• 1994.07b
• /
• pp.1559-1561
• /
• 1994

At present, the principle of puffer action in high current interruption is adopted in almost of the EHV(Extra High Voltage) and UHV(Ultra High Voltage) GCB(Gas Circuit Breakers). The thermal interruption capability of these GCBs critically depends on the pressure rise in the puffer cylinder at current zero. The pressure rise in the puffer cylinder depends on the puffer cylinder volume, flow passage and leakage area in the interrupter, stroke curve etc. Recently commercial CFD(Computational Fluid Dynamics ) packages have been widely adopted to calculate the pressure distribution in the interrupter. However, there are still several problems with it, e.g. very expensive price, moving boundary problem, computation time, difficulty in using the package etc. Thus, the calculation of the puffer cylinder pressure in simple and relatively correct method is essential in early stage of GCB design. In these paper, the model ing technique and computed results for EHV class GCB (HICO, 145kV 40kA and 362kV 40kA GCB) are presented and compared with available measured results.

• Nuclear Engineering and Technology
• /
• v.52 no.10
• /
• pp.2183-2195
• /
• 2020

A mathematical model for the flowrate and rotation speed of RCP during idling was established. The numerical calculation method and dimensionless method were used to analyze the flow, head, torque and pressure and speed changes under idle conditions. Regularity, using the Q criterion vortex identification judgment method combined with surface flow spectrum morphology analysis to diagnose the vortex dynamic characteristics on RCP blade. On impeller blade, there is two oscillations in the pressure ratio on pressure surface in blade outlet region. The velocity on the suction surface is two times more oscillating than the inlet of blade, and there is an intersection with the velocity ratio curve on pressure surface. On blade of guide vane, the pressure ratio increases along the inlet to outlet direction, and the speed ratio decreases with the increase of idle time. There is a vortex that rotates counterclockwise on the suction surface, and the streamline on the suction surface of blade is subjected to the entrainment and blocking action of the vortex creates a large reverse flow in the main flow region. There are two vortices at the outlet of guide vane suction side and the vortices are in opposite directions.

• Journal of the Korean Geotechnical Society
• /
• v.28 no.5
• /
• pp.95-107
• /
• 2012

Even though the importance of predicting build-up of pore pressure under cyclic loading is recognized, effective stress analysis is rarely performed due to difficulties in selecting the parameters for the pore pressure model. In this paper, a new stress based numerical model for predicting pore pressure under cyclic loading is developed. The main strength of the model is that it is easy-to-use, requiring only the CSR-N curve in selecting the parameters. Another advantage of the model is that it can be used for any loading pattern and therefore can be implemented in an effective stress time-domain dynamic analysis code. The accuracy of the model is validated through its comparisons with measurements in literature and laboratory test data collected in Korea. Further comparisons with another stress based pore pressure model highlighted the superiority of the proposed model.

• Composites Research
• /
• v.30 no.3
• /
• pp.188-192
• /
• 2017

The mechanical properties of composites are significantly affected by external environment. It is essential to understand the degradation of material performance and judge the material's lifetime in advance. In the current research, changes in mechanical properties of glass fiber and unsaturated polyester composite materials (GFRP, Glass fiber reinforced plastic) were investigated under different bending stress and submerged in hot water at a temperature of $80^{\circ}C$. Loading time of 100 H (hours), 200 H, 400 H, 600 H, 800 H for testing under stresses equal to 0% (stress-free state), 30%, 50% and 70% of the ultimate strength was applied on the GFRP specimens. From the values of bending stress, obtained from three-point bending test, fracture energy, failure time, and life curve were analysed. Moreover, a normalized strength degradation model for this condition was also developed. It was observed that within 100 H, the decline rate of the bending strength was proportional to the pressure.

• International Journal of Naval Architecture and Ocean Engineering
• /
• v.11 no.1
• /
• pp.294-306
• /
• 2019

On the basis of the Computational Fluid Dynamics technique (CFD) combined with the overlap grid method, this paper establishes a numerical simulation method to study the problem of ice-propeller interaction in viscous flow and carries out a simulation forecast of the hydrodynamic performance of an ice-class propeller and flow characteristics when in the proximity of milling-shape ice (i.e., an ice block with a groove cut by a high-speed revolving propeller). We use a trimmed mesh in the entire calculation domain and use the overlap grid method to transfer information between the domains of propeller rotation calculation and ice-surface computing. The grid is refined in the narrow gap between the ice and propeller to ensure the accuracy of the flow field. Comparison with the results of the experiment reveals that the error of the hydrodynamic performance is within 5%. This confirms the feasibility of the calculation method. In this paper, we calculate the exciting force of the propeller, analyze the time domain of the exciting force, and obtain the curve of the frequency domain using a Fourier transform of the time-domain curve of the exciting force. The existence of milling-shape ice before the propeller can greatly disturb the wake flow field. Unlike in open water, the propeller bearing capacity shows a downward trend in three stages, and fluctuating pressure is more disordered near the ice.

• Journal of the Korean Society of Laryngology, Phoniatrics and Logopedics
• /
• v.14 no.2
• /
• pp.88-93
• /
• 2003

Whether respiratory muscle training is of benefit to the singing students is controversial. The purpose of the study is to investigate pulmonary function and the maximal inspiratory(MIP) and expiratory pressure(MET), and maximum phonation time in five female singing students before and after the specially programmed respiratory muscle training during 2 months. All singing students had average 4.8 years of formal classical voice training. Respiratory muscle training machine (Ultrabreath) was used to train respiratory muscle. Pulmonary function test data on simple pulmonary function, flow volume curve, static lung volumes are obtained from Vmax 6200. The MIP and MEP were measured using Spirovis, and the MPT were measured using hand-held stopwatch. Any pulmonary function test variables are not changed after respiratory muscle training. However, MIP and MEP were significantly increased between before and after respiratory muscle training. MPT increased significantly after training, compared to the pre-trained. MIP, MEP, and MPT after training in female singing students were 26%, 25% and 33% higher than those before training. The result indicated that the specially programmed respiratory muscle training is beneficial to improve respiratory muscle strength and vocal function without an increment in pulmonary function.

• Journal of Korean Critical Care Nursing
• /
• v.16 no.3
• /
• pp.24-33
• /
• 2023

Purpose : This study aims to establish an optimal cut-off score on the Braden scale for the assessment of pressure injury to detect pressure injury risks among inpatients in a South Korean tertiary hospital. Methods : This retrospective study used electronic medical records, from January to December 2022. A total of 654 patients were included in the study. Of these, 218 inpatients with pressure injuries and 436 without pressure injuries were classified and analyzed using 1:2 Propensity Score Matching (PSM), and the generalized estimating equation was performed using SPSS Version 26 and the R Machlt package program. Results : The cut-off value on the Braden scale for distinguishing pressure injury was 17 points, and the AUC (area under the ROC curve) was 0.531 (0.484-0.579). The sensitivity was 56.6% (45.5-67.7%) and the specificity was 69.7% (66.0-73.4%). With 17 points, the Braden scale cut-off distinguished those who had pressure injuries from those who did not at the time of admission (p < .03). In the pressure injury group, the Braden score on the day of the pressure injury was 14, with significant results in all subcategories except the moisture category. Conclusion : Our findings revealed that a cut-off value of 17 was optimal for predicting the risk of pressure injuries among tertiary hospital inpatients. Future studies should evaluate the optimal cut-off values in different clinical environments. Additionally, it is necessary to conduct multicenter large sample studies to verify the effectiveness of a 17 value in PI risk assessments.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.24 no.8
• /
• pp.126-132
• /
• 2010

This paper presents dielectric characteristics of $N_2$ gas under impulse voltages in a quasi-uniform electric field gap. The experiments were carried out at the test gap applied by the 1.2/50[${\mu}s$] lightning impulse voltage, 180/2500[${\mu}s$] switching impulse voltage, 500[ns]/1[MHz] very fast transient overvoltage(VFTO). The gap separation of sphere-to-plane electrodes was 14[mm] and the electric field utilization factor was about 71.2[%]. The gas pressure ranges from 0.2 to 0.6[MPa]. As a result, the electrical breakdowns are occurred by streamer discharge. Breakdown voltages are linearly increased with the gas pressure and the highest breakdown voltage is appeared under the VFTOs having fast rising time. Breakdown voltages under the positive impulse voltages were higher than those under the negative ones, and also the time to breakdown in the positive polarity is longer than that in the negative polarity.