• 한국재료학회지
• /
• 제17권5호
• /
• pp.289-292
• /
• 2007

Although piezoelectric bimorph that is using as the sensor in medical and industrial measurement has large displacement, it has problems including efficiency in generating force, energy convergence, and response. Its application is being limited based on the change in resonance frequency with temperature. In this study, to overcome the disadvantages, PZT piezoelectric ceramics was prepared and produced a parallel type piezoelectric bimorphs. In addition, by using the finite element method. the configuration of piezoelectric bimorph was designed and the displacement of the bimorph based on applied electric pressure and the wave pattern were measured. By analyzing the resonance characteristics of the bimorph in the temperature range of $-60{\sim}80^{\circ}C$, an attempt was made to study the operational characteristics and temperature reliability of vortex flowmeter sensor. As a result, the resonance frequency of the bimorph was gradually increased with the temperature from $-60{\sim}80^{\circ}C$. The deflection of the bimorph was found to strongly depend on both the applied electric field waveform and the environmental temperature.

• 한국음향학회지
• /
• 제25권5호
• /
• pp.222-228
• /
• 2006

본 연구에서는 마이크로스피커에 사용되는 진동판의 재질에 따른 음향특성을 연구하였다. 진동판의 재료가 달라지면 영률과 밀도가 바뀌게 되고, 그로 인하여 재질에 따라서 음속과 스티프니스 값이 변하게 된다. 그 결과로써, 공명진동 수는 PEl, PPS, PET, PEN의 순서로 점차 높게 나타났으며, 이는 이론적으로 예측된 결과와 정확히 일치하였다. 진동판의 재질은 저음으로부터 최저공명진동수 ($f_s$)까지 음압이 증가하는 변화율이나 최고한계공명진동수 ($f_h$)에는 영향을 주지 않았다. 그러나 임피던스 특성에서 얻어진 공명진동수가 낮은 재질의 순서대로 저음영역이 강하게 나타났다.

• International Journal of Fluid Machinery and Systems
• /
• 제8권3호
• /
• pp.202-208
• /
• 2015

For a prototype turbine operating under part load conditions, the turbine output is fluctuating strongly, leading to the power station incapable of connecting to the grid. The field test of the prototype turbine shows that the main reason is the resonance between the draft tube vortex frequency and the generator natural vibration frequency. In order to reduce the fluctuation of power output, different measures including the air admission, water admission and adding flow deflectors in the draft tube are put forward. CFD method is adopted to simulate the three-dimensional unsteady flow in the Francis turbine, to calculate pressure fluctuations in draft tube under three schemes and to compare with the field test result of the prototype turbine. Calculation results show that all the three measures can reduce the pressure pulsation amplitude in the draft tube. The method of water supply and adding flow deflector both can effectively change the frequency and avoid resonance, thus solving the output fluctuation problem. However, the method of air admission could not change the pressure fluctuation frequency.

• 한국전기전자재료학회논문지
• /
• 제21권12호
• /
• pp.1063-1070
• /
• 2008

The performance of an acoustic transducer is determined by the effects of many design variables, and mostly the influences of these design variables are not linearly independent of each other. To achieve the optimal performance of an acoustic transducer, we must consider the cross-coupled effects of the design variables. In this study, the variation of the performances of underwater acoustic transducer in relation to its structural variables was analyzed. In addition, the new optimal design scheme of an acoustic transducer that could reflect not only individual but also all the cross-coupled effects of multiple structural variables, and could determine the detailed geometry of the transducer with great efficiency and rapidity was developed. The validation of the new optimal design scheme was verified by applying the optimal structure design of a flextensional transducer which are the most common use for high power underwater acoustic transducer. With the finite element analysis(FEA), we analyzed the variation of the resonance frequency, sound pressure, and working depth of a flextensional transducer in relation to its design variables. Through statistical multiple regression analysis of the results, we derived functional forms of the resonance frequency, sound pressure, and working depth in terms of the design variables. By applying the constrained optimization technique, Sequential Quadratic Programming Method of Phenichny and Danilin(SQP-PD), to the derived function, we designed and verified the optimal structure of the Class IV flextensional transducer that could provide the highest sound pressure level and highest working depth at a given operation frequency of 1 kHz.

• 동력기계공학회지
• /
• 제3권3호
• /
• pp.60-69
• /
• 1999

The noise and vibration sources of rotary compressor for room air-conditioner are pressure pulsation of compression process, cavity resonance of inner space, structural radiation noise of shell and impact noise of discharge valve. Among them, pressure pulsation is very important noise and vibration source. Because it transferred various kinds of noise and vibration like as mentioned above. In this reason, muffler and resonator are used in order to absorb and remove these noises. But an analytical prediction using acoustic analysis does not coincident with the experimental result. The difference between analysis and actual state is due to the assumption of analysis. This paper covered with new concept of muffler design based on the turbulence kinetic energy of flow by using CFD. From this analysis, it is possible to decide the best position of discharge port of muffler. Therefore $2{\sim}3dB$ noise reduction effect is acquired in rotary compressor of 5000 BTU grade. Also new approach of resonator design is suggested. From this study, the characteristics of resonator and surge hole (a kind of resonator without pipe length) are identified. The former is useful for pure tone noise (narrow frequency band), and the latter is effective for broad frequency band. This paper shows that it is very available to use 3 dimensional analysis of resonator in order to predict more exact tuning frequency. The result is proved by a lot of experiments. From combination of fluid analysis and acoustic analysis, up stream position is effective location of resonator concerning turbulence motion of fluid.

• International Journal of Fluid Machinery and Systems
• /
• 제9권4호
• /
• pp.338-353
• /
• 2016

Information on the surge behaviors and stall stagnation boundaries for a nine-stage axial flow compressor are summarized on the basis of analytical data in comparison with those for a single-stage one, with attention to the pressure ratio effect. The general trends of the surge loop behaviors of the pressure-mass flow are similar for both compressors including the fact that the subharmonic surges tend to appear very near the stall stagnation boundaries. With respect to the nine-stage compressor, however, the mild loops in the subharmonic surges tend to be very small in size relative to the deep loops, and at the same time, insufficient surge recovery phenomenon, which is a kind of subharmonic surge, appears also far from the stagnation boundary for relatively short delivery flow-paths. The latter is found to be a rear-stage surge caused by unstalling and re-stalling of the rear stages with the front-stages kept in stall in the stalled condition of the whole compressor, which situation is caused by stage-wise mismatching in the bottom pressure levels of the in-stall multi-stage compressor. The fundamental information on the stall stagnation boundaries is given by a group of normalized geometrical parameters including relative delivery flow-path length, relative suction flow-path length, and sectional area-pressure ratio, and by another group of normalized frequency parameters including relative surge frequencies, modified reduced resonance frequencies, and modified reduced surge frequencies. Respective groups of the normalized parameters show very similar tendency of behaviors for the nine-stage compressor and the single-stage compressor. The modified reduced resonance frequency could be the more reasonable parameter suggesting the flow-induced oscillation nature of the surge phenomena. It could give the stall stagnation boundary in a more unified manner than the Greitzer's B parameter.

• 한국광학회지
• /
• 제1권1호
• /
• pp.7-11
• /
• 1990

수은 원자 증기에 강한 레이저 광$(10-120GW/\textrm{cm}^2)$을 조사하여 수은 원자의 공명 다광자 이온화 과정을 연구하였다. 파장 560.7nm의 광자 4개를 흡수할 때 공명준위는 $6d ^1D_2$이다. 수은 증기압(0.1-3.0 Torr)과 레이저 파장(559-569nm)을 변화시키면서 큰 강도의 광원과 원자가 상호작용하여 생기는 AC Stark 이동과 line broadening의 변화를 조사하였고, 원자 밀도의 증가에 따라 이온화율의 증가가 둔화되다가 감소되는 것도 관측되었다. 이동계수 $\alpha$=0.6cm-1/GW/$\textrm{cm}^2$로 측정되었다. 특히, 이온화율의 레이저 강도 의존성을 나타내는 비선형 차수를 공명파장에서 측정한 결과 k=3을 얻었으며, 이론적인 결과와 비교하였다.

• Journal of Platform Technology
• /
• 제9권3호
• /
• pp.36-43
• /
• 2021

뇌졸중 질환은 전세계적으로 가장 중요한 사망원인 중 하나이며, 특히 고령자에게 장애의 원인이 되는 가장 중요한 질환이다. 뇌졸중 질환이 발생하면 사망 또는 심각한 장애를 유발하기 때문에, 적극적인 일차 예방과 전조증상의 빠른 발견이 매우 중요하다. 특히, 일상생활에서의 뇌졸중 전조증상 발병을 감지 및 정확히 예측하여 전문가의 신속한 진단을 유도할 수 있어야 한다. 최근까지의 연구에서는 뇌졸중 환자의 전조증상을 예측하는 방법론으로 CT(Computed Tomography)나 MRI(Magnetic Resonance Imaging)와 같은 영상 분석이 대부분이었으나, 이러한 접근에는 오랜 검사 시간과 높은 검사 비용 등에 대한 한계점을 가지고 있다. 본 논문에서는 고령자의 뇌졸중 질환 발병이 보행 시 족압(Foot Pressure)에 어떤 영향을 미치는지 임상 데이터를 이용해 실험하였다. 실험 결과, 보행 중에 뇌졸중 고령자와 일반 고령자 간에 12개의 셀에서 * p < .05 인 유의미한 차가 있음을 분석 및 검증하였다. 결과적으로 고령의 뇌졸중 환자와 일반 고령자의 일상생활의 보행 패턴에 유의미한 차이를 발견했다는 것에 그 의미가 크다고 할 수 있다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2012년도 추계학술대회 논문집
• /
• pp.470-475
• /
• 2012

The downstream piping system of the water supply system in a supercritical power plant is affected by the fluctuation pressure waves induced by accessing to the acoustic modes of the piping systems with the rotation and impeller passing pulsations of the feed water pump. There are the phenomena amplified at the same time in the range of 415 ~ 455Hz, 830 ~ 910Hz, 1245 ~ 1365Hz and 1660 ~ 1820Hz on the spectrums of the vibration, the sound pressure, and the pressure fluctuation waves.

• Journal of Magnetics
• /
• 제18권2호
• /
• pp.168-172
• /
• 2013

We have developed a high-field and high-frequency ESR system using a commercially available magnetometer equipped with the superconducting quantum interference device (SQUID). This is magnetization detection type ESR and ESR is observed as a change of the magnetization at the resonance condition under irradiation of the electromagnetic wave. The frequency range is from 70 to 315 GHz and the maximum magnetic field is 5 T. The sensitivity is estimated to be $10^{13}$ spins/G. The advantage of this system is that the high-field ESR measurements can be made very easily and quantitatively. Moreover, this high-field ESR can be applied to the measurements under pressure by using a widely used piston-cylinder pressure cell.