• Resources Recycling
• /
• v.14 no.6 s.68
• /
• pp.21-27
• /
• 2005

As one of the hydrometallurgical processes available in the recycling of silver-bearing wastes, the preparation of Ag nano-powder was investigated by a reductive precipitation reaction in silver solution using sodium formaldehydesulfoxylate and ascorbic acid as a reducing agent. Silver solution was prepared by dissolving silver nitrate with distilled water, and Tamol NN8906, PVP, SDS and caprylic acid were also used respectively as the dispersant to avoid the agglomeration of particles during the reductive reaction. Ag particles obtained from the reduction reaction from silver solution were characterized using the particle size analyzer and TEM to determine the particle size distribution and morphology. It was found that about $40\%$ excess of sodium formaldehydesulfoxylate was required to reduce completely silver ions in the solution. It alto appeared that the particle size generated with sodium formaldehydesulfoxylate was much greater than that with ascorbic acid. As far as the effect of dispersant on the Ag particles was concerned, the particle size distribution showed typically bimodal distribution in case of Tamol/FVP while very broad distribution ranged from 0.01 to $100{\mu}m$ appeared in case of SDS/caprylic acid.

• Journal of Korean Society of Water and Wastewater
• /
• v.33 no.2
• /
• pp.95-101
• /
• 2019

High voltage impulse(HVI) has been gained attention as an alternate technique controlling $CaCO_3$ scale formation. Investigation of key operational parameters for HVI is important, however, those had not been reported yet. In this study, the effect of temperature and applied voltage of HVI on $Ca^{2+}$ concentration was studied. As the applied voltage from 0 to 15kV and the temperature increased from 20 to $60^{\circ}C$, the $Ca^{2+}$ concentration decreased, indicating that the aqueous $Ca^{2+}$ precipitated to $CaCO_3$. The $Ca^{2+}$ concentration decreased up to 81% under the condition of 15kV and $60^{\circ}C$. Rate constant for the precipitation reaction, k was determined under different temper1ature and voltage. The reaction rate constant under the 15kV and $60^{\circ}C$ condition was evaluated to $66{\times}10^{-3}L/(mmol{\cdot}hr)$, which was 5 times greater than the k of the reaction without HVI at same temperature. The increases in k by HVI at higher temperature region(40 to $60^{\circ}C$) was much greater than at lower temperature region(20 to $40^{\circ}C$), which implies temperature is more important parameter than voltage for reducing $Ca^{2+}$ concentration at high temperature region. These results show that the HVI induction accelerates the precipitation to $CaCO_3$, particularly much faster at higher temperature.

• Journal of the Korean Chemical Society
• /
• v.58 no.6
• /
• pp.580-589
• /
• 2014

The concepts used to explain specific phenomenon can be influenced by context or coherent regardless of context. The purpose of this study is to understand middle school students' concept of particles in particular context and to investigate the effects of context on concept of particles. A conceptual questionnaire was developed to find out how students represented particles in two contexts: solid and solution states of electrolytes, and ion precipitation reaction. The questionnaire was administered to $9^{th}$ grade students after classes of 'electrolyte and ions' unit. The responses of students were analyzed using framework developed for categorization of students' concepts. The results are as follows: First, it was found that students used various concepts on particles when they explained solid and solution state of electrolytes, respectively. Second, we identified students' concepts of particles used to explain ion precipitation reaction. In addition, we recognized that majority of students failed to write correct chemical symbols. Third, approximately 79% of students showed coherent responses for explanation of particles in solution state of both electrolytes and ion precipitation reaction. About 57% of students had scientific concepts. Some suggestions were made based on results for acquisition of scientific concepts on particles in different contexts.

• Journal of the Korean Electrochemical Society
• /
• v.10 no.1
• /
• pp.48-51
• /
• 2007

In order to investigate the effects of particle size and specific surface area(BET area) of spinel powder, $LiMn_2O_4$ were synthesized using metal oxide precursor by co-precipitation method(CoP) and solid state reaction (SSR) .X-ray diffraction(XRD) patterns revealed that the both prepared powder has a well developed spinel structure with Fd3m space group. The $LiMn_2O_4$ prepared by co-precipitation showed spherical morphology with narrow size distribution. However, the $LiMn_2O_4$ prepared by solid state reaction showed relatively smaller particles with irregular shape. The measured BET areas of the powers are $0.8m^2g^{-1}$ (CoP) and $3.6m^2g^{-1}$(SSR). The electrochemical performance of the Prepared $LiMn_2O_4$ powders was evaluated using coin type cells(CR2032) at elevated temperature ($55^{\circ}C$). The $LiMn_2O_4$ prepared by co-precipitation showed the better cycling performance(82.3%capacity retention at $50^{th}$ cycle) than that of the $LiMn_2O_4$(68.3%) prepared by solid state reaction at elevated temperature.

• Clean Technology
• /
• v.23 no.2
• /
• pp.196-204
• /
• 2017

CdZnS/ZnO composite was prepared through low-temperature precipitation and drying method. The property of CdZnS/ZnO as a recyclable photocatalyst for the degradation of rhodamine B (RhB) under visible light irradiation was examined. The sample was characterized by XRD, FE-SEM, XPS, UV-vis DRS and photoluminescence techniques before and after repeated reaction to investigate the change of properties during the photocatalytic reaction. During repeated reaction, the CdZnS/ZnO showed an improved photocatalytic activity and recycle stability. Among two feasible reaction pathways for photocatalytic degradation of RhB, the cleavage of conjugated chromophore was found to predominate over N-dealkylation of chromophore skeleton in the present work. The results indicate that the CdZnS/ZnO, prepared by a simple precipitation method, can be used as a visible-light driven photocatalyst with enhanced cycle stability and activity.

• Journal of the Korean Ceramic Society
• /
• v.33 no.12
• /
• pp.1380-1386
• /
• 1996

The effects of urea addition and reaction conditions were examined in the prepareation of zirconia coated SiC whiskers through surface precipitation taking place during high-temperature aging of Zr(SO4)2 solutions containing the whiskers. More dense zirconia-hydrate was precipitated on the surfaces of the whiskers in the presence of urea. The ratio of the concentration of Zr(SO4)2 to the amount of added whiskers was the most important factor to confine the precipitation of zirconia-hydrate only at the surfaces of the whiskers The from of the coating layers was unchanged after heat-treatment leading to the dehydration and crystallization of the layers.

• Journal of the Korean Ceramic Society
• /
• v.33 no.6
• /
• pp.693-699
• /
• 1996

YIG precursor powder was obtained by homogeneous precipitation in chloride salt solution by thermal decom-position of urea. It was found that ferric ions precipitated prior to yttrium ions. The precipitate was minute and spherical in shape. The precipitate formed consisted of the mixture of amorphous and ferric oxyhydroxide. Crystallization of YIG was proceeded by solid state reaction of intermediate YFeO3 and Fe2O3 in the temperature range of 85$0^{\circ}C$ to 140$0^{\circ}C$. Single phase of YIG was obtained by heat-treatment of the powder at 140$0^{\circ}C$ for 6 hrs in air. The powder calcined was molded into pellets and sintered in air. The maximum density of 4,92 g/cm3(95.1% of theoretical density) was obtainable for the pellet sintered at 145$0^{\circ}C$ using the powder calcined at 90$0^{\circ}C$.

• Journal of Pharmaceutical Investigation
• /
• v.6 no.2
• /
• pp.95-100
• /
• 1976

A study on the effect of the pH of precipitation on the acid consuming capacity, aging stability, physical and chemical properties of hydrous aluminum oxide prepared by the reaction of aluminum chloride and ammonium hydroxide solution was carried out by means of X-ray diffraction, IR spectra and differential thermal analysis. The results from these experiments are as follows: 1. Hydrous aluminum oxide precipitated at lower pH showed better acid consuming capacity, higher stability and more anion contained in the structure than that prepared at higher pH. 2. The hydrous aluminum oxide prepared at lower pH is amorphous and that prepared at higher pH is crystalline hydrated hydrous aluminum oxide, i.e., Bayerite and these results are conformed to Rhee's hypothesis. 3. The rate of loss of reactivity and the end-point reactivity are related to the pH of precipitation.

• Journal of the Mineralogical Society of Korea
• /
• v.9 no.2
• /
• pp.71-81
• /
• 1996

Dissolution experiments were conducted to understand chemical nature of weathering of anorthosite from the Hadong area. Anorthosite and plagioclase from it were reacted with HCl or KOH solutions under various conditions concerning such as grain size, initial pH of solutions, and shaking Average composition of plagioclase used in the experiment was Na0.32Ca0.71Al1.71Si2.28O8.Under acidic conditions, solution pH increases rapidly in the initial stage and then gradually to reach palteau. Shaking agitates the reaction rate in the initial stage but does not affect after the system reached steady state. Ca and si concentrations show rapid increase and then gradual increase. Al concentration increases rapidly in the early stage and then decreases. Later decrease was interpreted as the precipitation of an Al-bearing material. Different dissolution rates of different constituents of plagioclase together the with precipitation of al-bearing material might be responsible for the non-stoichiometric dissolution of plagioclase.X-ray diffraction analyses on anorthosite before and after dissolution experiment show dissolution rates differ with different lattice planes of plagioclase. It suggests the crystallographic control on dissolution reaction. X-ray photoelectron spectroscopic result shows that the average composition of plagioclase surface reacted with HCL of initial pH 1.97 for 2000 hours is Na0.20Ca0.26Al1.7Si2.3O8. It means that Na- and Ca-depleted H-feldspar is developed without Al-depleted layer on the surface of plagioclase by reaction with HCl and that dissolution reaction takes place sparsely on the surface of plagioclase. Al and Si are dissolved preferentially over Ca from anorthosite powder in KHO solution. Reaction of acid-reacted anorthosite with KOH solution shows the same Si dissolution behavior as in the fresh anorthosite. This indicates that the Al-depleted and Si-enriched layer does not build up on the acid-reacted surface.

• Applied Chemistry for Engineering
• /
• v.2 no.2
• /
• pp.119-126
• /
• 1991

This investigation was undertaken to study the synthesis of Boehmite by the hydrothermal homogeneous precipitation reaction of alum with urea. The reactions were carried out at a temperature of 100 to $250^{\circ}C$, 1 : 2 to 1 : 5 in a mole ratio of alum to urea and a reaction time of 0.5 to 20 hrs. The reaction precipitates were examined by X-ray diffraction analysis, scanning electron microscope, and chemical analysis. Under the condition of mole ratio 1 : 4 of alum to urea, the spherical and monodispersed amorphous aluminum sulfate hydrate was formed at $100^{\circ}C$, the mixture of spherical amorphous aluminum sulfate hydrate and Boehmite was formed at $150^{\circ}C$, Boehmite was formed at above $200^{\circ}C$, respectively. The reaction precipitates were dense, superior precipitable and filterable particle of average $2-4{\mu}m$.