• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.43 no.5
• /
• pp.543-553
• /
• 2023

This study was conducted to propose a simple method to evaluate the load-carrying capacity of RC slab bridges, which have been most frequently constructed in Korea. A number of RC slab bridges have been considerably deteriorated associate with the long service year. However, since these bridges are not included in the 1st and 2nd class infrastructures due to their short span length, they have been relatively neglected compared to other bridge types in terms of safety management. In the previous theoretical study, a process (draft) was proposed for evaluating the damage of RC slab bridges using the relationship between the displacement response ratio and the stiffness reduction rate derived by the measured displacement and natural frequency. In this paper, to verify the validity of the proposed damage evaluation process (draft), the results to the actual bridges were compared with the safety grade and the Matsui's deterioration index. In addition, to enhance the practical applicability of the existing process (draft), an improved method approximately evaluating the load-carrying capacity using only the measured natural frequency was presented. If an error of 10% of the load-carrying capacity is allowed, it is judged that the proposed damage evaluation process can be appropriately used not only for evaluating the safety of RC slab bridges, but also for determining priorities for their maintenance.

• Journal of Practical Agriculture & Fisheries Research
• /
• v.10 no.1
• /
• pp.77-90
• /
• 2008

This study was conducted to investigate the influence of chilling temperature and duration at different seeding stages on yield, fruit characteristics and growth of cucumber in a greenhouse. When 20-day-old cucumber were exposed to 0 and 3℃ for 10 hours, 25 and 30% reduction in the main stem elongation rate and 34 and 37% reduction in total leaf area per plant were observed. The reduction in stem elongation and total leaf area was apparently associated with the increases in chilling duration. Exposure of seedlings to 6℃ failed to causes any significant differences in growth as compared to the unchilled plants. Repeated exposure of seedlings to 3℃ chilling for 10 hours per day increased the chilling injury significantly. The seedlings exposed to low temperature for 3 consecutive days exhibited severe injury as compared to the seedlings exposed to chilling treatment only once or twice. Fruit elongation rate was inhibited by approximately 10%, such as 0.59~2.26cm/day, with chilling of 15 hours at 0℃ as compare to 0.61~2.60cm/day in the non-chilled plants. Chilling treatment at 0~3℃ for 10 hours reduced the percentage of marketable fruits by 25~26%. while it increased the percentage of severely bent fruits significantly. Total fruits yield was reduced by 15~25% in cucumber plants when the chilling treatment was given to 20-day-old seedlings and by 22~37% in 30-day-old seedlings. This shows that, Larger seedlings were more sensitive to chilling. Total yield was also influenced by the duration of chilling. Definitely, at 0℃, 5-hour chilling treatment caused 18% of reduction, 10-hour caused 30%, and 15-hour caused 36%, respectively.

• Journal of Practical Agriculture & Fisheries Research
• /
• v.10 no.1
• /
• pp.67-75
• /
• 2008

Tartary buckwheat is one of specialized plants in Pyeongchang county, Korea and contains rutin much more than common buckwheat. Rutin is a kind of flavonoid (polyphenol compound) that has effects on blood vascular disease, strengthen capillary, and anti-inflammatory effect. This study was conducted to determine the possibility of development of beverage extracted from sugar-treated plants and sprouts of tartary buckwheat. By using two types of undiluted solution extracted from plant and sprouts of tartary buckwheat, we analyzed their nutrition components and did experiment on mice to find out pharmaceutical effects. In an experiment on mice, we administered various concentration of buckwheat to induced diabetic mellitus mice for 1 weeks. As a result, the buckwheat effected finely on lowering blood sugar and decreased LDL-cholesterol and total lipid level but increased HDL-cholesterol level.

• Therapeutic Science for Rehabilitation
• /
• v.12 no.1
• /
• pp.23-35
• /
• 2023

Objective : This study is to examine the practical use of clinical observational evaluation of sensory integration therapy and the difficulty and importance of measuring results for each sub-item, and through this, to confirm the usefulness of the application of Artificial Intelligence measurement technology in clinical observational measurement and the need for application. Methods : The questionnaire consisted of the actual use of the sensory integration evaluation tool, the difficulty of measurement for each detailed item of clinical observation, the usefulness of AI measurement technology, the importance of evaluation for each detailed item, and the need for developing AI measurement technology. Results : The detailed items that were difficult to measure during clinical observation were the Finger-to-Nose Test and Postural control (71.0%), followed by Eye movement and Protective Extension Test (67.7%). 83.9% of the study subjects answered that it would be useful to apply AI measurement technology when observing images. Postural control (on the ball) (90.3%) was the highest item that answered that AI measurement technology was needed, followed by Eye movement (83.9%), and Prone Extension and Protective Extension Test (77.4%). Conclusion : The results confirmed the desire of therapists that clinical observation is an important evaluation tool in the field of child occupational therapy in Korea.

• Journal of Practical Agriculture & Fisheries Research
• /
• v.25 no.1
• /
• pp.14-19
• /
• 2023

In summer, the natural ventilation performance for varying greenhouse width is very important in the glasshouses for year round cultivation. The effect of the side openings and greenhouse width on natural ventilation performance was analyzed by simulation. The necessary ventilation rate with different solar radiation transmittance increased significantly when the outside temperature grows higher. The necessary ventilation rate of 40% transmittance was about half of that of 90% transmittance. In consequence, shading effect on temperature control in greenhouse is significant in summer. When the total area of the openings for ventilation is constant, the maximum ventilation rate happens when the area of roof openings is equal to the area of side openings. This maximum ventilation rate is about 3 times of that of the greenhouse with roof openings and without side openings. Therefore, the side openings are advantageous to improve the natural ventilation in greenhouses. As the greenhouse width increases, the influence of side openings on the ventilation rate is becoming smaller. If the natural ventilation rate of the greenhouse with roof and side openings is to become double of that of the roof openings only, the width should be narrower than 38.4m for the Venlo type and 64m for Wide span type.

• Journal of the Society of Disaster Information
• /
• v.19 no.2
• /
• pp.280-291
• /
• 2023

Purpose: As fire accidents happen at the production and storage sites of superabsorbent polymers for convenience of daily life, an experimental study was conducted to secure basic data to establish practical preventive measures against them. Method: The sample container (20cm width × 20cm length) was made into a rectangular cuboid with the heights of 3cm, 5cm, 7cm, and 14cm, respectively, to allow access to the infinite flat plane. The front and back of the container were covered with a 300-mesh stainless steel mesh for one-dimensional heat transfer. The sample container was placed in the center of the thermostatic bath, which was heated to a predetermined temperature by setting the thermostat program in advance, and it was determined to be 'ignited' when the central temperature of the sample rose by more than 20℃ above the set temperature, and "unignited" when it was maintained at an approximate value of the set temperature. Result: The critical autoignition temperature was calculated to be 217.5℃ when the height of the sample container was 3 cm, 212.5℃ when it was 5 cm, 202.5℃ when it was 7cm, and 187.5℃ when it was 14cm. The ignition induction time to reach the maximum temperature was 34hours for 3cm, 76hours for 5cm, 143hours for 7cm, and 318hours for 14cm. Conclusion: ① As the size of the container increased, the autoignition temperature decreased and the induction time to reach the maximum temperature increased. ② An apparent activation energy was calculated to be 44.92kcal/mol, with a correlation of 96.93%.

• Journal of Practical Agriculture & Fisheries Research
• /
• v.20 no.2
• /
• pp.39-47
• /
• 2018

This study was carried out to investigate the applicability of alternating temperature control during night time in a nursery seedling production. Three groups of samples were exposed to three different environmental conditions for 6 days from 18:00 to 09:00; one was constantly 15 ℃, another was alternating between 15 ℃ for 2 hours and 11 ℃ for 2 hours, and the other was alternating between 15 ℃ for 2 hours and 11 ℃ for 4 hours. Leaf temperature and stem temperature was measured in real time. The influence of cold stress was analyzed by flavonoid content and growth of tomato seedling. The temperature of leaves and stem became equal to the ambient temperature over time, furthermore, there was no significant difference among the treatments. In conclusion, it is considered that heating costs can be saved considerably, as the alternating temperature has fewer effects on cold stress reaction by tomato seedling growth.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.4D
• /
• pp.545-551
• /
• 2008

The MOCT(Ministry of Construction & Transportation) gave a order named as "The guideline for computerization and application of geotechnical investigation result" to an affiliated organization in March 2007. Today, pilot project of construction of geotechnical information database is in process to be stable for its system after applying this guideline, and discipline how to input investigated data for related users. We have developed standard for geotechnical investigation result-format, metadata for distribution of geotechnical information and to coordinate based on world geodetic system. Also, We had a introduce to status with respect to use the input system, collect a statistics of input contents. At a result, improvement items of input system is proposed. It was analyzed that most users put to practical use easily as a result of education for making use of on the spot of the developed GIIS. But There were problems with the GIIS as well as complexity of metadata formation, such as error of moving part of information window, and a part of recognition error of install program in accordance with computer OS circumstances. Particularly, to improve some parts of GIIS is needed, because of use of or KNHC (Korea National Housing Corporation)-specific format and difference of input process followed by MOCT's guideline. In this study, it is planning to make up for occurred problems, and improvements when operating and managing the Geotechnical Information DB center in 2008.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.1A
• /
• pp.183-190
• /
• 2006

Minimizing the self weight of long-span deck slabs is one of the key factors for the practical and economic design of a composite two-girder bridge. In this paper, the minimum design thickness and rebar details of prestressed concrete deck slabs for composite two-girder bridges with girder span length from 4 m to 12 m are studied based on the safety and serviceability. The bridge deck slab with minimum thickness is designed as a one-way slab considering orthotropic behavior. Then fatigue safety of the deck slab is examined. Serviceability requirements for the deck slab such as deflection and crack width limits are also examined. The result shows that rebars with diameter less than 16 mm is recommended for the improved fatigue behavior, and, for the deck slab with span length longer than 8 m, the deflection limit governs the minimum design thickness. The result also shows that, for the deck slab with span length longer than 4 m, the distribution rebar requirement in the current Korea Highway Bridge Design Code is not sufficient to maintain the structural continuity in bridge axis as expected from the deck slab with span length shorter than 3 m.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.5D
• /
• pp.723-734
• /
• 2008

In this paper, the problems and betterment plan in operating district units plan are studied by selecting typal case locations based on the types of district units plan of the city of Busan. According to the types, 4 locations of 'type of maintaining preexisting district' and 3 of 'type of managing preexisting district' are selected as case locations, based on a scale and characteristics of each location.In systematical aspects of the case locations, indiscreet upward adjustment of the locations, insignificant participation of the citizens and patternization were recognized as problems. And setting accurate standards for target and range of alteration in line with usage plan of the locations would be necessarily urgent. So through the analysing process of the problems arisen from the case locations I would suggests necessary solutions to improve the effectiveness of the district units plan. And In planning aspects, the similarity between the basic directions and the object, batch-application of the density plan, inadequacy of the usage plan, allocations and patterns of structures, and color planning were recognized to have problematic points. Consequently distinguished specific operating-guidelines would be necessary to achieve the basic directions and the object of district units plan. Furthermore, the building-to-land ratio and floor space index are needed to be exactly calculated through providing accurate and logical standards for appropriate development density of structures.