• Journal of Advanced Navigation Technology
• /
• v.14 no.2
• /
• pp.213-219
• /
• 2010

Recently, a multi-core system is studied for single terminal's operations on various service networks for mobile systems. Therefore, it is expected that mobile systems capable of supporting WCDMA, MC-CDMA, CDMA and WiBro would be developed. Mobile systems for supporting various service networks is able to be implemented on a single chipset via SoC(System one Chip) technology, thus a noble modem design proper for SoC technology is necessary. For high speed data transmission of 4G mobile communication services, OFDM scheme has to be applied. But, an OFDM signal consists of a number of independently modulated subcarriers, and superposition of these subcarriers cause a problem that can give a large PAPR. In this paper, a noble modem design for 4G mobile communication services and PAPR reduction method for solving the PAPR problem are proposed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37A no.10
• /
• pp.865-875
• /
• 2012

In this paper, we optimize antenna locations for a distributed antenna system (DAS) with distributed antenna (DA) ports equipped with multiple antennas under per-DA port power constraint. Maximum ratio transmission and scaled zero-forcing beamforming are employed for single-user and multi-user DAS, respectively. Instead of maximizing the cell average ergodic sum rate, we focus on a lower bound of the expected signal-to-noise ratio (SNR) for the single-cell scenario and the expected signal-to-leakage ratio (SLR) for the two-cell scenario to determine antenna locations. For the single-cell case, optimization of the SNR criterion generates a closed form solution in comparison to conventional iterative algorithms. Also, a gradient ascent algorithm is proposed to solve the SLR criterion for the two-cell scenario. Simulation results show that DAS with antenna locations obtained from the proposed algorithms achieve capacity gains over traditional centralized antenna systems.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.3C
• /
• pp.224-231
• /
• 2003

In this paper we proposed system parameter values of ultra-wideband Impulse Radio systems for the frequency band(3.1~10.6GHz), which is allocated by Federal Communications Commission(FCC). We also analyzed performance of the proposed system in the multiple access interference environment. According to result, application of possible pulse duration($t_{n}$) is very limited by 0.04~0.0326 ns in permission frequency range that establish in FCC. In the case of the same pulse signal power, we could know that system performance was changed by pulse repetition number($N_{s}$ ) regardless of pulse duration. Thus, We could know that we have to need duration of monocycle pulse and setting of frame un it time(Τ$_{f}$ ) according to multi user numbers and design proper pulse repetition number by transfer rate in multiple access systems design. In the IR system that needs high speed transmission more than 50 Mbps in multiple access interference environment, we could know that very serious performance decrease by multiple access interference happens. Therefore, as the design of high speed multiple access IR system, it should be designed to additional improvement techniques that can remove multiple access interference at the same time.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.8A
• /
• pp.598-606
• /
• 2003

In this paper, we analyze the performance of the PCM cell search algorithm proposed for fast cell search of WCDMA systems. In order to improve both performance and complexity of the cell search algorithm standardized for WCDMA systems the PCM scheme uses a group of the polarization codes produced by a Gold code generator. The PCM scheme only uses one synchronization channel since the polarization codes modulated on P-SCH can replace the RS codes of S-SCH. Thus, the PCM reduces the BS's transmission power since only one synchronization channel can be used, and it can also reduce the complexity of receiver as compared with the conventional one. In this paper, by defining a numerical model, we analyze the performance of the PCM cell search algorithm in terms of detection probability and mean acquisition time. Consequently, we could demonstrate that the PCM cell search algorithm is superior to the standard WCDMA cell search algorithm.

• Journal of Broadcast Engineering
• /
• v.9 no.4 s.25
• /
• pp.371-383
• /
• 2004

In this paper we consider technological requirements to broadcast digital television signals using single frequency networks (SFN) in the Advanced Television Systems Committee (ATSC) transmission systems and propose equalization digital on-channel repeater (EDOCR) that overcomes the limitations of conventional digital on-channel repeaters (DOCRs). Since there are no forward error correction (FEC) decoder and encoder, the EDOCR does not have an ambiguity problem. In addition, since an adaptive equalizer in the EDOCR removes multi-path signals, additive white Gaussian noise (A WGN), and feedback signal due to low antenna isolation, the EDOCR may have good output signal quality with high power.

• Journal of the Korean Society of Industry Convergence
• /
• v.25 no.6_3
• /
• pp.1239-1246
• /
• 2022

This paper introduces the effect of grease on the degradation characteristics of bearings used as key components of packaging equipment and automation systems. Bearings parts are installed to fix and support the rotating body of the system, and performance degradation of the bearings has a great effect on the life of the system too. When bearings are used in various devices and systems, the grease is applied to reduce friction and improve fatigue life. Determining the type of lubricant (grease) is important because it has a great influence on the operating environment and lifespan and ensures long lifespan of systems and facilities. However, studies that simultaneously compared and analyzed the change in mechanical degradation characteristics and the comparison of chemical degradation characteristics according to grease types under actual operating conditions are insufficient. In this paper, three types of small harmonic drive, high-load reducer, and low-load reducer grease used in power transmission joint modules are experimentally selected and finally injected into ball bearings with a load (19,500N) to improve bearing durability. Degradation characteristics were tested by attaching to test equipment. At this time, after the durability test under the same load conditions, the mechanical degradation characteristics, that is temperature, vibration according to the three greases types. In addition, the chemical degradation characteristics of the corresponding grease was compared to present the results of mutual correlation analysis.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.15 no.5
• /
• pp.981-986
• /
• 2020

The Internet of Things refers to a space-of-things connection network configured to allow things with built-in sensors and communication functions to interact with people and other things, regardless of the restriction of place or time.IoT is a network developed for the purpose of services for human convenience, but the scope of its use is expanding across industries such as power transmission, energy management, and factory automation. However, the communication protocol of IoT, MQTT, is a lightweight message transmission protocol based on the push technology and has a security vulnerability, and this suggests that there are risks such as personal information infringement or industrial information leakage. To solve this problem, we designed a synchronous MQTT security channel that creates a secure channel by using the characteristic that different chaotic dynamical systems are synchronized with arbitrary values in the lightweight message transmission MQTT protocol. The communication channel we designed is a method of transmitting information to the noise channel by using characteristics such as random number similarity of chaotic signals, sensitivity to initial value, and reproducibility of signals. The encryption method synchronized with the proposed key value is a method optimized for the lightweight message transmission protocol, and if applied to the MQTT of IoT, it is believed to be effective in creating a secure channel.

• Journal of Satellite, Information and Communications
• /
• v.6 no.1
• /
• pp.57-62
• /
• 2011

The VLC (visible light communication) system is communication technology using visible rays (RGB) that come out in LED device. It is energy curtailment effect and possible in ubiquitous network service applications. Also, VLC system has the above advantage about that the communication throughout the whole room is enabled by high power lighting and lighting equipment with white colored LED which are easy to install and have good outward appearance. However, the signal detection performance for the receiver near the network of transmitter boundary is severely degraded and the transmission efficiency decreased due to the influence of the interference signal from the adjacent networks. In this paper, we propose an interference mitigation method with optical beamforming in VLC systems, and evaluate the reception performance. For the system BER, the proposed optical beamforming transmission demonstrates the performance enhancement compared to the not using the optical beamforming scheme, and up to about 5~6dB SNR performance gain is achieved.

• Journal of Advanced Navigation Technology
• /
• v.11 no.1
• /
• pp.50-58
• /
• 2007

In this paper, the optimum position of optical phase conjugator (OPC) and the optimal dispersion coefficients of fiber sections in $16{\times}40$ Gbps WDM system with non zero - dispersion shifted fiber (NZ-DSF) of 1,000 km are induced, in order to expand the availability of mid-span spectral inversion (MSSI) technique in long-haul multi-channel transmission systems. It is confirmed that the compensation degrees of overall WDM channels are more improved by applying the induced optimal parameters into WDM system than those in WDM system with the conventional MSSI. So it is expected that the proposed optimal parameters should alternate with the forming method of the symmetrical distributions of optical power and local dispersion with respect to OPC, which generate a serious problem in the applying OPC into multi-channels WDM system if it is not formed. It will be possible to realize the flexible system design by applying the methods proposed in this paper into the real WDM system with OPC.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.20 no.2
• /
• pp.81-86
• /
• 2020

Ambient backscatter communication has a drawback in which the transmission power is limited because the data is transmitted using the ambient RF signal. In order to improve transmission efficiency between transceiver, a channel estimator capable of estimating channel state at a receiver is needed. In this paper, we consider the K-means algorithm to improve the performance of the channel estimator based on EM algorithm. The simulation uses MSE as a performance parameter to verify the performance of the proposed channel estimator. The initial value setting through K-means shows improved performance compared to the channel estimation method using the general EM algorithm.