• 전기학회논문지
• /
• 제63권11호
• /
• pp.1564-1570
• /
• 2014

An electric vehicle (EV) not only receives electric power from the electric vehicle supply equipment (EVSE), but it also exchanges the information regarding charging process with the power gird through the EVSE. However, the EV and EVSE communicate using the ISO/IEC 15118 standard while the EVSE and power grid communicate using the IEC 61850 standard. Therefore, the EVSE should support both the ISO/IEC 15118 and IEC 61850 standards, and provide a data mapping function between the two communication protocols so that the EV and power grid, which support different protocols, can communicate with each other throughout the charging process. In this paper, we propose a mapping method of the EVSE, which converts the ISO/IEC 15118 data to IEC 61850 and vice versa, based on the XML schema of each protocol. The proposed method converts the data using the XSL (eXtensible Stylesheet Language) method, which defines the data mapping between two XML schemas. Our approach is more flexible and easier to maintain against changes in charging scenarios and the standards than other existing approaches such as one-to-one data mapping methods.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 B
• /
• pp.663-665
• /
• 2000

We fabricated resistive superconducting fault current limiters (SFCL) based on YBCO thin films grown on 2-inch diameter saphire substrates Two SFCLs with nearly identical properties were connected in series to investigate the simultaneous quench. There was a slight difference in the rate of voltage increase between two SFCL units when they were operated independently. This difference. however, resulted in significantly unbalanced power dissipation between the units. This imbalance was removed by connecting a shunt resistor to an SFCL in parallel. The appropriate values of the shunt resistances were $80{\Omega}$ at $75 V_{rms}$. $100{\Omega}$ at $100 V_{rms}$ and $110{\Omega}$ at $120 V_{rms}$, respectively. Increased power input at high voltages also reduced the initial imbalance in power dissipation. but with increase in film temperature to higher than 200 K.

• 한국초전도ㆍ저온공학회논문지
• /
• 제11권3호
• /
• pp.46-49
• /
• 2009

A 3-phase 100m long, 22.9kV class HTS power transmission cable system was developed by Korea Electrotechnology Research Institute (KERI) and LS cable Ltd. those are participated in the 21st Century Frontier project R&D Program of Korea. It is important to test the DC critical current related with its power capacity before applying to the real power grid. In 1995, several international standards organizations including International Electrotechnical Commission (IEC), decided to unify the use of statistical terms related with 'accuracy' or 'precision' in their standards. It was decided to use the word 'uncertainty' for all quantitative (associated with a number) statistical expressions. In this paper, we measured DC critical current of 22.9kV/50MVA superconducting power cable with several voltage tap and analyzed the uncertainty with these results.

• 전기학회논문지
• /
• 제67권3호
• /
• pp.479-484
• /
• 2018

This paper describes domestic technical standard of Photovoltaic(PV) PCS(Power Conditioning Systems)-Characteristics of the utility interface. This standard tests utility compatibility and personnel safety and equipment protection of PV inverter performance functions. Especially utility compatibility part includes test items of 1)voltage, current and frequency, 2)normal voltage operating range, 3)DC injection, 4)normal frequency operating range, 5)harmonics and 6)waveform distortion, 7)power factor of PV inverter. Therefore in this paper each test item of domestic technical standard is studied and analyzed and finally full tested by PV inverter performance function.

• 전기학회논문지
• /
• 제61권10호
• /
• pp.1524-1528
• /
• 2012

According to the Article 4(Confirmity Assessment)of the Electrotechnical Regulation, Confirmity Assessment for the Electrotechnical Regulation decides confirmity of Electrotechnical Regulation; whether to satisfy performances and requirements(determined from Electrotechnical Regulation). It evaluates technical requirements, new technology and standards. However, it does not evaluate technical content stated from Electrotechnical Regulation & Conformity Criteria. From Confirmity Assessment, the technology will be decided whether to fulfill performances and technical requirements. Which is predetermined by contents related to Electrotechnical Regulation. Test standards and test conditions will be overlooked to determine its performances and technical requirements for safety. This paper will show that, studies have been done to determine the guideline for Confirmity Assessment, which is evaluated from performances and technical requirements associated with Confirmity Assessment of electrical installation for new technology of wireless power transfer.

• 한국IT서비스학회지
• /
• 제19권3호
• /
• pp.89-100
• /
• 2020

The wireless power transmission market is growing at an average annual rate of 51.5% from $ 16.4 billion in 2015 to $ 131.1 billion in 2020. However, there are limitations to commercialization due to the development of standards and technologies. Thus, this study identified trends in standards and regulations by market and by country. The research collected and filtered a total of 69,488 worldwide wireless power transfer patents by June 2019 and extracted a total of 28,555 patents. Based on this, technology development status was analyzed and predicted. In this study, long-distance and short-range technology development with high technology development difficulty and low technology development ratio could lead to growth of the entire wireless charging market. It is analyzed that investment and policy preparation are necessary to secure source technology for long-distance / near technology development than China, Japan and Europe.

• 한국초전도학회:학술대회논문집
• /
• 한국초전도학회 2000년도 High Temperature Superconductivity Vol.X
• /
• pp.252-256
• /
• 2000

We investigated resistance development in Au/YBCO thin film meander lines during quench. The meander lines were fabricated by coating YBCO films insitu with a gold layer and patterning them by photolithography. The center stripe quenched fastest even though the flux flow resistance that appeared upon the current passing the critical current was uniform. Quench started at an area of the center stripe and propagate both through the gold layer and the sapphire substrate. Quench propagation speed was uniform and 60 cm/s at 30 V$_{rms}$.

• Journal of Electrical Engineering and information Science
• /
• 제2권5호
• /
• pp.60-64
• /
• 1997

The design process and construction method of a strip line is described for measuring radiated susceptibility of vehicular components having electrical cables more than 2 min length. he characteristic impedance of the trip line was determined 90$\Omega$ to obtain the field uniformity of $\leq$${\pm}$3 dB in the frequency range from 100 kHz to 500 MHz. Tapered coaxial lines were used instead of the traditional lumped circuit element for the impedence matching units, therefore, the strip line has high power capability. Using these techniques, the field uniformity and power capability of a strip line could be considerably improved.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 추계학술대회 논문집 전기설비전문위원
• /
• pp.53-55
• /
• 2005

Because of the continuous growth of energy consumption and also the tendency to site power lines and pipelines along the same route, the close proximity of power lines and buried metallic pipelines has become more and more frequent. The lightning strokes collected by an electric substation or power line tower might cause arcing through the soil to an adjacent gas pipeline. This paper gives the review of the breakdown mechanism and the standards of separation distance between lower and pipelines.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2006년도 춘계학술대회
• /
• pp.343-346
• /
• 2006

Although renewable energy sources are more environmentally friendly than fossil energy sources, it is far more costly, considering current technological standards. It would not present many competitive advantages in the power market. If the renewable electricity is viable in the market, the government should take 'visible' actions to compensate production costs. Popular policies, such as Feed-In-Tariff and Renewable Portfolio Standards, can help to attract investors into generators of renewable electricity. But presently, they are mainly financed through a undifferentiated increase of electricity bills and occasionally confronted with the opposition of the electricity consumers. And most policies tend to focus on increasing the supply of renewable electricity with little consideration toward elevating the motivation of consumers. This study evaluates the potential of environmentally friendly energy consumption and examines the 'green pricing' program which realize the potential.