• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.2
• /
• pp.233-238
• /
• 2018

This paper proposes a seamless MPPT operation mode transfer method of photovoltaic system. The photovoltaic system consists of a DC-DC boost converter, a DC-Link, and a 3-level neutral point clamp (NPC) type inverter. The PV voltage fluctuates due to the output characteristics of the solar pane1 depending on the irradiation amount and the temperature. The photovoltaic system requires seamless MPPT mode transfer method that the discontinuity does not occur in order to supply the stable power to system without affecting the fluctuation of the PV voltage. MPPT operation is divided into two modes by the voltage reference. Under the condition that the PV voltage is below 650V, the DC-DC boost converter performs MPPT through duty control based on perturb & observe (P&O) method, and the inverter conducts DC-link voltage and grid current controls in synchronous reference frame. On the other hand, when the PV voltage exceeds above 650V, inverter performs MPPT in accordance with the variation of DC-link voltage control while the converter stops operating. Two MPPT operation modes is smoothly transferred through the proposed method that DC-link voltage or grid current commands are appropriately adjusted from the certain criteria. The feasibility of the MPPT operation mode transfer method is verified using a 10kW solar photovoltaic system, experimental results have good performances that the fluctuation of PV current is reduced to 100%.

• Ocean and Polar Research
• /
• v.35 no.1
• /
• pp.15-26
• /
• 2013

The toxic, Harmful Algal Blooms (HABs) caused by the Cochlodinium polykrikoides have a serious impact on the coastal waters of Korea. In this study, the acoustic detection system was developed for rapid HABs detection, based on the acoustic backscattering properties of the C. polykrikoides. The developed system was mainly composed of a pulser-receiver board, a signal processor board, a control board, a network board, a power board, ultrasonic sensors (3.5 and 5.0 MHz), an environmental sensor, GPS, and a land-based control unit. To evaluate the performance of the system, a trail was done at a laboratory, and two in situ trials were conducted: (1) when there was no red tide, and (2) when there was red tide. In the laboratory evaluation, the system performed well in accordance with the number of C. polykrikoides in the received level. Second, under the condition when there was no red tide in the field, there was a good correlation between the acoustic data and sampling data. Finally, under the condition when there was red tide in the field, the system successfully worked at various densities in accordance with the number of C. polykrikoides, and the results corresponded with the sampling data and monitoring result of NFRDI (National Fisheries Research & Development Institute). From the laboratory and field evaluations, the developed acoustic detection system for early detecting HABs has demonstrated that it could be a significant system to monitor the occurrence of HABs in coastal regions.

• Nutrition Research and Practice
• /
• v.11 no.1
• /
• pp.25-32
• /
• 2017

BACKGROUND/OBJECTIVES: Stress-induced cognitive impairment is related to the suppression of hippocampal neurogenesis that results from an increase of oxidative stress. Therefore, the aim of this study was to investigate the effects of administration of a blueberry drink, having a high antioxidant power, on the cognitive performance of adult rats exposed to chronic mild stress. MATERIALS/METHODS: Twelve-week-old male Sprague-Dawley rats (n = 48) were randomly divided into four groups: control (CO), stress (ST), control + 5% blueberry drink (CO + B), and stress + 5% blueberry drink (ST + B). After eight weeks, the cognitive performance was assessed using a multiple T-maze water test. Levels of superoxide dismutase (SOD), catalase (CAT), glutathione peroxidase (GPx), and ascorbic acid were measured in the brain, and catecholamine concentrations were measured in plasma. RESULTS: The brain weights of the rats from the ST and ST + B groups were significantly lower than those of the rats from the CO and CO + B groups. The cognitive performance of the ST group was impaired when compared to that of the CO group. This impairment was significantly improved by the blueberry drink supplementation (P < 0.05). The brain SOD and CAT concentrations were not influenced by the stress or by the blueberry drink. However, the brain levels of GPx and ascorbic acid were significantly lower in the ST group than those in the CO group and were increased by the blueberry drink supplementation. The plasma catecholamine concentrations were affected by chronic mild stress and by the blueberry drink. The plasma norepinephrine and dopamine concentrations were decreased by the chronic stress and improved by the blueberry drink supplementation. The plasma epinephrine level was only influenced by the stress. CONCLUSION: These findings suggest that the blueberry drink may protect against the cognitive impairment induced by chronic mild stress.

• Smart Structures and Systems
• /
• v.19 no.6
• /
• pp.665-678
• /
• 2017

In this paper the tuned mass-damper-inerter (TMDI) is considered for passive vibration control and energy harvesting in harmonically excited structures. The TMDI couples the classical tuned mass-damper (TMD) with a grounded inerter: a two-terminal linear device resisting the relative acceleration of its terminals by a constant of proportionality termed inertance. In this manner, the TMD is endowed with additional inertia, beyond the one offered by the attached mass, without any substantial increase to the overall weight. Closed-form analytical expressions for optimal TMDI parameters, stiffness and damping, given attached mass and inertance are derived by application of Den Hartog's tuning approach to suppress the response amplitude of force and base-acceleration excited single-degree-of-freedom structures. It is analytically shown that the TMDI is more effective from a same mass/weight TMD to suppress vibrations close to the natural frequency of the uncontrolled structure, while it is more robust to detuning effects. Moreover, it is shown that the mass amplification effect of the inerter achieves significant weight reduction for a target/predefined level of vibration suppression in a performance-based oriented design approach compared to the classical TMD. Lastly, the potential of using the TMDI for energy harvesting is explored by substituting the dissipative damper with an electromagnetic motor and assuming that the inertance can vary through the use of a flywheel-based inerter device. It is analytically shown that by reducing the inertance, treated as a mass/inertia-related design parameter not considered in conventional TMD-based energy harvesters, the available power for electric generation increases for fixed attached mass/weight, electromechanical damping, and stiffness properties.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.7
• /
• pp.292-299
• /
• 2013

In this paper, we developed a data transmission system over coaxial cable based on the IEEE 802.15.3 MAC and Ultra-Wideband(UWB) Physical Layer. This system is capable of operation in both wireless and wired medias. When operating on coax cable it is capable of Gigabit bi-directional data rate operation on in-home coax wiring and over Hybrid-Fiber-Coax(HFC) cable infrastructure. The developed system transceives command, control and data over a 75 ohm coax system in a home or office. This system operates at a center frequency of 4GHz with a total occupied bandwidth of 1.33Ghz centered on 4GHz. The system uses BPSK modulation and sends symbols at a maximum power level of +15dBm. It has been tested and works through up to three CATV RF splitters in a home environment.

• The Journal of Korean Association of Computer Education
• /
• v.15 no.3
• /
• pp.1-10
• /
• 2012

The flow of computer education in modern knowledge and information society contains the computer science courses to cultivate the higher-level thinking abilities such as logical thinking skills, creativity, and problem-solving ability of learners. The purpose of this study is to recognize the need to promote the algorithmic thinking power to improve the problem solving ability of learners, to design the algorithm class based on the anchored instruction strategy for elementary school students and to verify the effectiveness. Anchored instruction model and cases are added to the class. Elementary school students were subjects and divided into a control group in which the traditional algorithm teaching method was conducted and an experimental group in which algorithm class was conducted applying anchored instruction. As results, an experimental group has shown improvements on problem solving compared to a control group.

• Journal of Mushroom
• /
• v.9 no.1
• /
• pp.39-43
• /
• 2011

Soybean curd was mixed with mushroom powder to develop new healthful foods, and changes in quality characteristics were investigated. The yields of the soybean curds containing 3~12% powder of Pleurotus ostreatus(PPo), 3, 6% of powder of Pleurotus cornucopiae(PPc), Pleurotus salmoneostramineus(PPs), Agrocybe aegerita(PAa) were higher than those of the control. The hardness level was highest in the 3% of dried mushroom power, The addition of mushroom powder to curd evidenced a significantly lower L value(lightness) than was detected in the control. In particular, PPs added soybean curd observed the highest a value(redness). In terms of overall acceptability, the preferred soybean curd samples were the 6% PPo, 3% of PPc, PPs and, PAa.

• Fire Science and Engineering
• /
• v.20 no.1 s.61
• /
• pp.71-76
• /
• 2006

The major causes of electrical fire are classified to short circuit fault, overload fault, electric leakage and electric contact failure. The occurrence factor of the fire is electric arc or spark accompanied with electrical faults. Residual Current Protective Device(RCD) of high sensitivity type used at low voltage wiring cuts off earth leakage and overload, but the RCD can't cut off electric arc or spark to be a major factor of electrical fire. As the RCDs which are applied low voltage distribution panel are prescribed to rated breaking time about 30[ms](KS C 4613), the RCDs can't perceive to the periodic electric arc or spark of more short wavelength level. To be improved on such problem, this paper is proposed to a auxiliary control apparatus for RCD trip on electric arc or spark due to electrical fire. Some experimental results of the proposed apparatus is confirmed to the validity of the analytical results.

• Journal of Industrial Technology
• /
• v.40 no.1
• /
• pp.13-18
• /
• 2020

Lithium-ion batteries have a small volume, light weight and high energy density, maximizing the utilization of mobile devices. It is widely used for various purposes such as electric bicycles and scooters (e-Mobility), mass energy storage (ESS), and electric and hybrid vehicles. To date, lithium-ion batteries have grown to focus on increasing energy density and reducing production costs in line with the required capacity. However, the research and development level of lithium-ion batteries seems to have reached the limit in terms of energy density. In addition, the charging time is an important factor for using lithium-ion batteries. Therefore, it was urgent to develop a high-speed charger to shorten the charging time. In this thesis, a discharger was fabricated to evaluate the capacity and characteristics of Li-ion battery pack which can be used for e-mobility. To achieve this, a smart discharger is designed with a combination of active load, current sensor, and temperature sensor. To carry out this thesis, an active load switching using sensor control circuit, signal processing circuit, and FET was designed and manufactured as hardware with the characteristics of active discharger. And as software for controlling the hardware of the active discharger, a Raspberry Pi control device and a touch screen program were designed. The developed discharger is designed to change the 600W capacity battery in the form of active load.

• Clean Technology
• /
• v.23 no.3
• /
• pp.248-255
• /
• 2017

In dismantling factories for recycling, it is important to input actual working data to a personal computer (PC) in order to monitor the work results and related recycling rate of the inputs. This should be performed with a keyboard, a mouse, or other devices. But when a worker is working in the factory, it could be bothersome or time consuming to go to the PC. Especially, workers who works at dismantling factories have a generally low education level are scared to use a PC, which could be used as a pretext for not using the PC. In some cases, data input is performed by a worker after the day's job. In this case, it could take additional time, the worker can make more mistakes, and the data could be unreliable. In this study, we developed a man-machine interface (MMI) device using a safety helmet. A joystick-like device, pushbuttons, and a radio frequency (RF) device for wireless communication is equipped in a safety helmet. This MMI device has functions similar to a PC mouse, and it has a long communication distance. RF is used because it consumes less battery power than Bluetooth. With this MMI device, workers need not go to a PC to input data or to control the PC, and they can control the PC from a long distance. The efficiency of PCs in a factory could be increased by using the developed MMI system, and workers at the dismantling factories could have less reluctance in using the PC.