• Proceedings of the KIEE Conference
• /
• 2000.07b
• /
• pp.663-665
• /
• 2000

We fabricated resistive superconducting fault current limiters (SFCL) based on YBCO thin films grown on 2-inch diameter saphire substrates Two SFCLs with nearly identical properties were connected in series to investigate the simultaneous quench. There was a slight difference in the rate of voltage increase between two SFCL units when they were operated independently. This difference. however, resulted in significantly unbalanced power dissipation between the units. This imbalance was removed by connecting a shunt resistor to an SFCL in parallel. The appropriate values of the shunt resistances were $80{\Omega}$ at $75 V_{rms}$. $100{\Omega}$ at $100 V_{rms}$ and $110{\Omega}$ at $120 V_{rms}$, respectively. Increased power input at high voltages also reduced the initial imbalance in power dissipation. but with increase in film temperature to higher than 200 K.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.39 no.4
• /
• pp.359-370
• /
• 2015

The present study aims to numerically investigate the behavior of liquid droplet driven by capillarity force imbalance on horizontal surfaces ranging from hydrophilic to hydrophobic, under various conditions. The droplet behavior has been simulated using an in-house solution code(PowerCFD), which employs an unstructured cell-centered method based on a conservative pressure-based finite-volume method with interface capturing method(CICSAM) in a volume of fluid(VOF) scheme for phase interface capturing. The detailed droplet behavior was obtained under various conditions for droplets with different initial shapes, contact angles and surface tension forces(or Bond number). The mechanism of droplet transport was examined using the numerical results on the droplet shapes.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.2
• /
• pp.110-120
• /
• 2010

In this paper, we propose a tunable SIW(Substrate Integrated Waveguide) using dielectric screws for eliminating the phase imbalance of large size power distribution networks(PDN). Alumina screws partially inserted into several through holes of the tunable SIW section effectively change the phase shift without S-parameter degradation. ${\pm}33.9^{\circ}$ measured phase imbalance of a large conventional 9 GHz SIW-PDN of $370\;mm{\times}195\;mm$ size has been greatly reduced to ${\pm}4.65^{\circ}$. We expect that the proposed tunable SIW plays an important role for a light-weight, high performance substrate integrated phased array system(Si-PAS) and large size SIW circuit applications.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.8
• /
• pp.2055-2062
• /
• 1996

This paper presents a method of compensating for the gain and phase imbalance of quadrature modulator and demodulator. The gain and phase imbalance are compensated using the received power after the compensation pattern was transmitted at tranceiver. The proposed method is less vulnerable to changes in the transmission channel than the conventional method because compensation is made possible within the tranceiver system, and even the change in phase mblance in accordance with frequency can be compensated utilizing the adaptive algorithm. According to numerical results, a normalized eye opening and a bit error rate are improved by 1.8dB and 3.8dB, respectively.

• Safety and Health at Work
• /
• v.13 no.4
• /
• pp.469-474
• /
• 2022

Background: Nowadays, counter-productive work behaviors (CWBs) have turned into a common and costly position for many organizations and especially health centers. Therefore, the study was carried out to examine and compare the demand-control-support (DCS) and effort-reward imbalance (ERI) models as predictors of CWBs. Methods: The study was cross-sectional. The population was all nurses working in public hospitals in Hamadan, Iran of whom 320 were selected as the sample based on simple random sampling method. The instruments used were Job Content Questionnaire, Effort-Reward Imbalance Questionnaire, and Counterproductivity Work Behavior Questionnaire. Data were analyzed using correlation and regression analysis in SPSS18. Results: The findings indicated that both ERI and DCS models could predict CWB (p ≤ 0.05); however, the DCS model variables can explain the variance of CWB-I and CWB-O approximately 8% more than the ERI model variables and have more power in predicting these behaviors in the nursing community. Conclusion: According to the results, job stress is a key factor in the incidence of CWBs among nurses. Considering the importance and impact of each component of ERI and DCS models in the occurrence of CWBs, corrective actions can be taken to reduce their incidence in nurses.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.7
• /
• pp.1160-1164
• /
• 2008

This paper presents an wideband stripline balun. And, the proposed balun is composed of one power divider and two phase converters on stripline substrate. The target characteristics of the proposed balun is the combination loss of below -0.05 dB, an amplitude imbalance of ${\pm}0.5\;dB$ and a phase imbalance of $180{\pm}10$ degrees, with the reflection coefficient(S11) of below -10 dB over frequencies ranging from 500 to 1500 MHz. The fabricated balun occupies the area of $12(W){\times}220(L){\times}2.3(T)\;mm3$. Experimental measurement shows that the fabricated balun has an amplitude imbalance of ${\pm}0.7\;dB$, a phase imbalance of $180{\pm}8$ degrees and an insertion loss of about -2 dB with the reflection coefficient(S11) of below -10 dB over frequencies ranging from 500 to 1,500 MHz.

• Journal of IKEEE
• /
• v.23 no.1
• /
• pp.1-8
• /
• 2019

In this paper, the electrical characteristics with various C-rates are tested with a high power series battery pack comprised of 18650 cylindrical nickel cobalt aluminum(NCA) lithium-ion battery. The electrical characteristics of discharge capacity test with 14S1P battery pack and electric vehicle (EV) cycle test with 4S1P battery pack are compared and analyzed by the various of C-rates. Multiple linear regression is used to estimate voltage imbalance of 14S1P and 4S1P battery packs with various C-rates based on experimental data. The estimation accuracy is evaluated by root mean square error(RMSE) to validate multiple linear regression. The result of this paper is contributed that to use for estimating the voltage imbalance of discharge capacity test with 14S1P battery pack using multiple linear regression better than to use the voltage imbalance of EV cycle with 4S1P battery pack.

• Proceedings of the Korea Institute of Applied Superconductivity and Cryogenics Conference
• /
• 2000.02a
• /
• pp.91-94
• /
• 2000

We fabricated resistive super- conducting fault current limiters (SFCL) based on YBCO thin films grown on 2" diameter $Al_{2}O_{3}$ substrates. Two SFCLs with nearly identical properties. two SFCLs with nearly identical properties were connected in series to investigate simultaneous quenching. There was a difference of several half cycles in their quench starting time, although the difference was not more than 0.1 msec when they were operated separately. This imbalance was removed by connecting a shunt resistor to an SFCL in parallel. Increased power input at high voltages also reduced the initial imbalance in power dissipation. Further efforts on the simultaneous quench in SFCLs connected in series are on the way through methods such as the artificial control of quench speed.peed.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.63 no.6
• /
• pp.820-827
• /
• 2014

Since a microgrid has renewable energy sources, imbalance between power supply and power demand occurs in the islanded mode. In order to solve the imbalance, several energy storage systems (ESSs) such as bettary energy storage system (BESS), EDLC (electric double layer capacitor), flywheel, and SMES (superconducting magnetic energy storage) are generally used. Especially, their electrical characteristics are different. For efficient use of them, a coordinated control scheme is required. In this paper, a coordinated control scheme for using a Lead-acid BESS, a Lithium BESS, and a EDLC is designed to efficient frequency control for a microgrid in the islanded mode. The coordinated frequency control strategy is designed based on their electrical characteristics. The feasibility of the proposed coordinated frequency control strategy is verified through the simulation.

• Journal of Power Electronics
• /
• v.18 no.6
• /
• pp.1866-1878
• /
• 2018

This paper presents a neutral point deviation and ripple compensation control method for application to 3-level NPC converters. The neutral point deviation and its harmonic components are analyzed with a focus on the average current flowing through the neutral point of the dc-link. This paper also proposes a control scheme to compensate for the neutral point deviation and dominant harmonic components under generalized unbalanced grid operating conditions. The positive and negative sequence components of the pole voltages and ac input currents are employed to accurately explain the behavior of 3-level NPC converters. Simulation and experimental results are presented to verify the validity of the proposed method.