• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.8
• /
• pp.678-686
• /
• 2002

This paper presents the effects of accumulation of surface charges on hydrophobic level and the changes of surface potential decay with various artificial environment treatments on high temperature vulcanized (HTV) silicone rubber used for outdoor insulating material. For this study, the charging apparatus by corona discharge, in which grid electrode was installed between the main corona and ground electrode, was used. From this study, it was found that the accumulation of surface charges above a critical surface potential on silicone insulating materials could lead to the temporary loss of surface hydrophobicity. In addition, corona stress and water absorption stress increase the decay rate of surface charges of HTV silicone rubber, while ultraviolet (UV) stress causes longer decay time. We could conclude that the effects of surface charges on hydrophobicity level and the changes of surface state by various artificial treatments were found through a trend of surface potential decay.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.59 no.12
• /
• pp.2230-2234
• /
• 2010

This paper deals with the change of surface potential decay, surface resistivity, contact angle and XPS of ultraviolet-treated PET films. From the experimental results on the surface potential decay of UV degraded-samples, it was found that the accumulation of charge is decreased and the surface potential decay time is shortened. Also, from the result of XPS, it was found that the changes affected by the surface degradation of PET film were caused by the generation of carboxyl groups through the chain decomposition and recombination with oxygen molecules in the air.

• Korean journal of applied entomology
• /
• v.23 no.4 s.61
• /
• pp.242-246
• /
• 1984

Results obtained from the experiment conducted to find out e relationships between tuber decay, and water potential and bruising in or on the tubers, are summerized as follows ; 1) When potato tubers were bruised or injected with bacterial inoculum, the tubers with high water potential rotted more easily than the tubers with low potential. A big difference in the development of decay between high and low water potential tubers was found. 2) In tubers injected with different levels of inoculum. high water potential tubers were more susceptible to soft rot than low water potential tubers. 3) $ED_{50}$ of inoculum concentration was 8.5(log) at high water potential tubers and 9.8(log) at low water potential. A small difference between low and high water potential was detected. The results of this experiment show that potatoes should be handled carefully and must be dried after harvest to reduce decay development in shipment and storage.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.05e
• /
• pp.1-5
• /
• 2003

This paper presented the effects of accumulation of surface charges on hydrophobicity level and the surface states of silicone polymer used for outdoor insulator treated by ultraviolet irradiation and corona discharge through measuring surface voltage decay of a corona-charged specimen were investigated. The surface resistivity by the method of the surface potential decay was compared with the value by the three electrodes methods. From this study, it was found that the accumulation of surface charges above a critical surface voltage on silicone insulating materials could lead to the temporary loss of surface hydrophobicity. In addtion, uv stress lead to a longer decay time of surface charges. We could conclude that the effects of surface charges on hydrophocity level and the changes of surface state by various artificial treatments were understood through a trend of surface potential decay.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.49 no.10
• /
• pp.553-558
• /
• 2000

This paper deals with change of contact angle, surface potential decay, surface resistivity and XPS of water-treated epoxy insulator. From the experimental results on the contact angle was reduced from $74^{\circ}$to $24^{\circ}$ due to the formation of polar hydroxyl groups on surface which was associated with intermolecular reaction between epoxy chains of three-dimensional network structure and water molecules. From the experimental results in the surface potential decay of water treated-samples, it was found that the accumulation of charge is decreased and the surface potential decay time is shortened by the interaction of polar hydroxyl groups induced on the treated surface as the increment of treatment time. The positive charging on the treated surface compared with negative charging is relatively lowered by the induction of polar hydroxyl groups. The surface resistivity was changed from $10^{15}[{\Omega}/cm^2$] to $10^{12}[{\Omega}/cm^2$] caused by water treatment. From XPS, it was found that the changes affected by the surface degradation of epoxy were caused by the generation of carboxyl groups through the chain decomposition and recombination with oxygen molecules in the air.

• Proceedings of the KIEE Conference
• /
• 1989.07a
• /
• pp.323-328
• /
• 1989

In this paper, we studied the diagnostic method of insulation deterioration for 22.9kV CNCV cable using D.C potential decay component. At first, arbitrary D.C high voltage is appeied the CNCV cable for two minutes and switched off in vacuum. And then D.C potential decay components is measured for ten minutes. It is detecting source for cable insulation deterioration that its gradient is. Provisionally, we decided the criterion voltage and select the high voltage meter and S.W.

• Proceedings of the KIEE Conference
• /
• 2001.07c
• /
• pp.1457-1459
• /
• 2001

This paper deals with the change of surface Potential decay, surface resistivity, contact an91e and XPS of ultraviolet-treated PET films. From the experimental results on the surface Potential decay of UV degraded-samples, it was found that the accumulation of charge is decreased and the surface potential decay time is shortened. Also, from the result of XPS, it was found that the changes affected by the surface degradation of PET film were caused by the generation of carboxyl groups through the chain decomposition and recombination with oxygen molecules in the air.

• Korean Journal of Agricultural Science
• /
• v.38 no.4
• /
• pp.607-612
• /
• 2011

The occurrence of grape berry shattering and decay is influenced by the pre- and/or postharvest infection of decay organisms and pest. Postharvest infection is associated with physical damage due to rough handling. To control quality loss during storage of table grapes, the effects of slow releasing $SO^2$ pad on storability of 'Rosario Bianco' (Vitis vinifera) and 'Campbell Early' (Vitis labruscana) grapes were examined, respectively. The $SO^2$ concentration in package of tables grapes reached to at about 40 $ug{\cdot}L^{-1}$ after 40 days of treatment and remained more than 80 days above 15 $ug{\cdot}L^{-1}$. Decay was found in untreated 'Rosario Bianco' and 'Campbell Early' grapes at each for 44 and 85 days after storage, but not in $SO^2$ pad treated grapes. The storage potential of grape berries at $0^{\circ}C$ increased 2~3 times depending on cultivar by $SO^2$ pad treatment. The application of $SO^2$ pad is confirmed to be effective on the increase of market potential with minimizing quality loss such as berry shattering and decay.

• Journal of the Korean Graphic Arts Communication Society
• /
• v.11 no.1
• /
• pp.103-122
• /
• 1993

A cause and counterplan of the increase in dark decay rate of$\varepsilon$-CuPc/PVCz photoreceptor which is consist of the carrier generation layer (CGL) of$\varepsilon$type copper phthalocyanine ($\varepsilon$-CuPc) thin film by an aqueous coating method and the carrier transport layer (CTL) of polyvinylcarbazol (PVCz) by spin coating, are studied in this paper. Electrochemical deposition of CGL was accompanied by an increase in work function of the aluminium substrate during the processes and the enhanced work function 5.3 eV rose above the ionization potential 5.16 eV of $\varepsilon$-CuPc. This resulted in the increased injection of holes from substrate into CGL and a fast dark decay rate. Improved photoreceptor, an electron-transport $\varepsilon$-CuPc/TNF photoreceptor, led to lowing of dark decay rate and increasing of photosensitivity. The carrier generation efficiency (ηg), carrier injection efficiency (ηi) and xerographic gain (G) of the $\varepsilon$-CuPc/TNF photoreceptor were obtained by XTOF method and PIDC.

• 전자공학회논문지 IE
• /
• v.44 no.3
• /
• pp.6-11
• /
• 2007

In this study, which was performed to identify a degradation mechanism in macromolecular insulating material, the contact angle, surface potential decay, surface resistance rate and XPS analysis were compared after exposure of fibre-glass-reinforced polymer laminate to plasma discharge. In the case of chemical changes arising from plasma treatment, carboxyl radicals were generated mainly in the plasma-treated surface, which was rapidly changed to a hydrophilic surface. In the corona potential decay study to determine the electrical changes, leading to a negative surface for the untreated specimen. However, in the case of the hydrophilic surface, a lot of carboxy radicals(-COO) acting as positive polarity were generated, resulting in a positive surface. Owing to such a positive surface, the charges of applied negative polarity were decreased rapidly.