• Proceedings of the KSME Conference
• /
• 2003.04a
• /
• pp.893-898
• /
• 2003

Coulomb friction is an important factor for precise position tracking control systems. The control systems with friction causes the steady state error because of being sensitive to the change of system condition and highly nonlinear characteristics. To overcome these problems, we use an estimation scheme of Coulomb friction to experiment for it's compensating. The estimated factor for Coulomb friction is used as a feed-forward compensator to improve the tracking performance of ball-screw systems. The tracking performance was improved by compensating the estimated friction torque in the feed-forward term. And, the sliding mode control which is derived from the Lyapunov stability theorem is applied for robust stability and reducing chattering. The experimental results show that the sliding mode controller with adaptive friction compensator has a good tracking performance compared with the friction uncompensated controller.

• Proceedings of the KIEE Conference
• /
• 2002.07b
• /
• pp.1146-1148
• /
• 2002

Highly precise position control is essentially required in stead/transient state in liner motor. The overall performance of position control system is depend on the accuracy of the position information and the performance of the speed controller in low speed range. In this paper, When Load is changed that the simulation results confirm the validity of the proposed estimation and control scheme, and Dynamic characteristics of the designed Transverse Flux Linear Motor are simulated and estimated using Matlab/simlunk.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.14 no.3
• /
• pp.208-213
• /
• 2004

This paper is concerned with the theoretical estimation of the single-input single-output(SISO) positive position feedback(PPF) controller and the derivation of the stability conditions for the multi-input multi-output (MIMO) PPF controller. Although the stability condition for the SISO PPF controller was derived in the earlier works, the question regarding the performance estimation of the SISO PPF controller has never been studied theoretically. Hence, the SISO PPF controller for the single degree-of-freedom system was first investigated and then control parameters including gain, the filter frequency, and the damping factor of the PPF controller were analyzed in detail thus providing the design methodology for the SISO PPF controller. In the case of real structure. there are infinite number of natural modes so that some modes are to be controlled by a limited number of actuator and sensor. Based on the theoretical results on the SISO PPF controller, the stability condition for the multi-input multi-output PPF controller was derived when only the few number of modes are to be controlled. The control spillover problem is also discussed in detail.

• Journal of Institute of Control, Robotics and Systems
• /
• v.20 no.11
• /
• pp.1136-1141
• /
• 2014

This paper proposes a new contact type ball tracking sensor to improve the control performance of a low cost ball-and-beam system. It is well-known that the impulsive measurement noise contained in ball position measurement is one of the factors which severely degrades the ball-and-beam control performance. The impulsive ball position measurement noises often appear under the sporadical ball floating on the beam. This fact motivates us to devise a simple analog preprocessing circuit to determine whether the ball loses the contact or not. Once the abnormal ball position measurement is detected, the design problem of the ball tracking sensor can be cast into the typical state estimation problem with missing data. In order to tackle the real-time implementation issue, a steady-state Kalman filter is applied to the problem. Through the experimental results, the usefulness of the proposed scheme is demonstrated.

• Journal of Power Electronics
• /
• v.5 no.3
• /
• pp.173-179
• /
• 2005

In this paper, a very low cost and robust sensing method for the rotor position of a TSRM(Toroidal Switched Reluctance Motors) is described. Position information of the rotor is essential for SRM drives. The rotor position sensor such as an opto-interrupter or high performance encoder is generally used for the estimation of rotor position. However, these discrete position sensors not only add complexity and cost to the system but also tend to reduce the reliability of the drive system. In order to solve these problems, in the proposed method, rotor position detection is achieved using voltage waveforms induced by the time varying flux linkage in the search coils, and then the appropriate phases are excited to drive the SRM. But the search coil's EMF is generated only when the motor rotates. Therefore the rotor position sensing method using squared Euclidean distance at a standstill is also examined. The simulation and experimental results are presented to verify the performance of the proposed method in this paper.

• The Korean Journal of Food & Health Convergence
• /
• v.8 no.1
• /
• pp.21-30
• /
• 2022

This study proposed a multiple regression equation for predicting VO2max of elderly men and women using functional performance variables required to conduct daily activities. The subjects of this study were 58 elderly men (72.4±5.9 yrs) and 117 elderly women (73.4±4.5 yrs) aged 65-90 who belong to the senior welfare center. The maximal graded exercise test using a cycle ergometer and functional performance representing muscle strength, endurance, static and dynamic flexibility, mobility, and agility were measured. For statistical processing, multiple regression analysis was performed, and the statistical significance level was α = .05. As a result, the VO2max estimation formula for the elderly was 0.419 (standing up and sitting down a chair) + 0.199 (leg endurance against wall) + 5.383, and R2=0.406. In addition, the VO2max estimation formula for elderly women is - 0.737 (standing up from a supine position) - 0.144 (waking around two cones in a figure 8) - 0.135 (%body fat) + 0.042 (one leg balance with eyes open) + 29.395, R2=0.367 was calculated. The conclusion is that if the maximal graded exercise test is not available, it is considered that VO2max of the elderly can be predicted properly by using the estimation formula calculated based on the functional performance variable.

• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.12
• /
• pp.1294-1301
• /
• 2008

Under passive RFID environment, this paper presents a new localization of a mobile robot traversing over the floor covered with tags, which is superior to existing methods in terms of estimation performance and cost effectiveness. Basically, it is assumed that a mobile robot is traveling along a series of straight line segments, each segment at a certain constant velocity, and that the number of tags sensed by a mobile robot at each sampling instant is at most one. First, for a given line segment with known starting point, the velocity and position of a mobile robot is estimated using the spatial and temporal information acquired from the traversed tag. Some discussions are made on the validity of the basic assumptions and the localization for the initial segment with unknown starting point. Second, for a given tag distribution density, the optimal tag arrangement is considered to reduce the position estimation error as well as to make easy the tag attachment on the floor. After reviewing typical tag arrangements, the pseudorandom tag arrangement is devised inspired from the Sudoku puzzle, a number placement puzzle. Third, through experiments using our passive RFID localization system, the validity and performance of the mobile robot localization proposed in this paper is demonstrated.

• Proceedings of the KIEE Conference
• /
• 1989.11a
• /
• pp.268-272
• /
• 1989

To avoid the use of position sensor or flux sensor in a field oriented induction machine drive system, the terminal quantities are often used to estimate the rotor flux. Since the estimation involves the leakage inductance of the machine, the performance of such systems is sensitive to the variations of leakage. Since estimation of the stator flux is independent of the leakage, the steady state performance of the stator flux oriented system is insensitive to the leakage inductance. In this paper, the torque response of stator flux oriented system is compared to that of rotor flux oriented system by digital simulation. And induction motor sensor less speed control by stator flux oriented method is developed. The performance of the speed estimation is showed by digital simulation.

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.211-211
• /
• 2000

The multiple targets tracking problem has been one of main issues in the radar applications area in the last decade. Besides the standard Kalman filtering, various methods including the variable dimension filter, input estimation filter, interacting multiple model (IMM) filter, federated variable dimension filter with input estimation, probable data association (PDA) filter etc. have been proposed to address the tracking and sensor fusion issues. In this paper, two existing tracking algorithms, i.e. the IMMPDA filter and the variable dimension filter with input estimation (VDIE), are combined for the purpose of improving the tracking performance of maneuvering targets in clutter. To evaluate the tracking performance of the proposed algorithm, three typical maneuvering patterns i.e. Waver, Pop-Up, and High-Diver motions, are defined and are applied to the modified IMMPDA filter considered as well as the standard IMM filter. The smaller RMS tracking errors, in position and velocity, of the modified IMMPDA filter than the standard IMM filter are demonstrated through computer simulations.

• Journal of Korea Multimedia Society
• /
• v.12 no.4
• /
• pp.600-607
• /
• 2009

In order to obtain continuous navigation information at low cost, we demonstrate, in this work, a position system which is constructed by integrating accelerometers with GPS. The proposed system eliminates vibration and noise elements of accelerometers by using Kalman filter. Calculating continuous navigation information is executed by unifying GPS position data and accelerations of moving and centripetal directions which affect the vehicle. Through simulations and experiments, we show that the performance of GPS can be improved by employing accelerometers. Our proposed system can provide stable and seamless position information where the GPS signal is unavailable due to obstruction like tunnels, and high buildings. The designed system can be implemented at low cost of circuit design and production, and satisfy various installation conditions.