• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.23 no.2
• /
• pp.76-90
• /
• 2018

To determine the distribution of mercury (Hg) in the coastal surface sediments around the Korean peninsula, the baseline concentration of Hg was estimated, the extent of contamination was assessed, and the factors controlling the distribution were discussed. The concentrations of Hg in surface sediments were significantly high in Jinhae-Masan Bay in the South Sea, Ulsan-Onsan Bay and Yeongil Bay in the East Sea, but Hg in other sediments showed a similar distribution to Cs and relatively very low concentration between 0.21 and $39.5{\mu}g/kg$ ($13.6{\pm}7.80{\mu}g/kg$). Compared to the sediment quality guidelines in Korea, 8 % of the surface sediments (n=282) analyzed in this study exceeded the values of the threshold effects level (TEL), and six sediments collected around Onsan Port were higher than the value of the probable effects level (PEL). The contamination levels of Hg were assessed by the enrichment factors using the baseline concentration (2.06Cs+1.75) based on the residual analysis from the linear regression line for Cs, and further, factors controlling the distribution of Hg were discussed by the comparison with geochemical substances depending upon the Hg enrichment level. Hg concentrations were correlated well with Cs concentration in the range of less than 1.69 of EF implying grain size control, while in the range of 1.69 and 4.03 Hg concentrations were correlated well with Fe oxyhyroxide and organic carbon contents, which indicates Hg was enriched by superior sorption capability. On the meanwhile, samples with higher EFs (4.03 to 74.9) showed fairly positive correlations with other metals (Cu, Zn, Pb) rather than geochemical substances. For samples in Youngil Bay and Ulsan-Onsan Bay (n=30), Hg concentrations were correlated only with other metals rather than geochemical substances implying simultaneous supply of metal particles from metal refineries. But samples at Gosung, Sokcho and Uljin coast were correlated well with organic carbon even though they had high EFs. In addition, samples in Jinhae-Masan Bay with high contents of S were enriched by relatively high sulfide formation.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.30 no.1
• /
• pp.61-74
• /
• 2002

The purpose of this study is to propose vegetation management devices through analyzing the actual vegetation, flora, plant community structure and soil chemical concentrations in Weolmi urban nature park, Incheon. The actual vegetation of Weolmi Park in various areas is composed of urbanization area(2 types, 25.9%), landscape planting area(4 types, 16.1%), grass and marsh area(5 types, 7.6%) and mountain forest areal(14 types, 50.4%). The flora is composed of 295 taxa with 80 families, 253 species, 35 varieties and 7 formas, and among them there are 16 naturalized plant families, 39 species, 3 varieties. In reflection of size, the number of the species seems high but most of the them are under influence of human disturbance. Nine survey plots of plant community structure are classified into two groups. One is the semi-natural plant community(Prunus sargentii-Acer palmatum, Quercus accutissma-Prunus sargentii, Quercus serrata-Quercus accutissma-Prunus sargentii, Prunus sargentii, and Zelkova serrata-Prunus sargentii) that migrated finn the planting forest to the natural forest and the other is planting forest(Pinus koraienssis-Pinus thunbergii-Abies holophylla-Chamaectparis obtusa, Prunus sargentii, Pinus thunbergii-Alnus firma, Zelkova serrata). The average pH is 4.65 which means the soil acidity is quite high. The concentration of K, Ca, Mg and base saturation is very low. It seems that the environmental pollutants from Incheon Port and industrial plants near by survey site and long-distance transport of air pollutants from China made the soil condition worse. On the basis of the results above, six vegetation management devices are suggested: 1) removing the hazard plants(Pueraia thunbergiana and Humulus japonica), 2) natural landscape management of the middle and long term, 3) increasing species diversity, 4) Robinia pseudoacacia management, 5) keeping the naturalized plants from being distributed any further inside the mountain forest, 6) improving soil acidification.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.20 no.3
• /
• pp.88-97
• /
• 2012

To measure the traffic pollutants with high temporal and spatial resolution under real conditions, a mobile emission laboratory (MEL) was designed. The equipment of the mini-van provides gas phase measurements of CO, NOx, CO2 and THC (Total hydrocarbon), and number density & size distribution measurements of fine and ultra-fine particles by a fast mobility particle sizer (FMPS) and a condensation particle counter (CPC). The inlet sampling port above the bumper enables the chasing of different type of vehicles. This paper introduces the technical details of the MEL and presents data from the experiment in which a MEL chases a city bus fuelled by diesel, DME and Bio-diesel. The dilution ratio was calculated by the ratio of ambient NOx and tail-pipe NOx. Most particles from the bus fuelled by diesel were counted under 300 nm and the peak concentration of the particles was located between 30 and 60 nm. However, most particles in the exhaust of the bus fuelled by DME were nano-particles (diameter: less than 50 nm). The bus fuelled by Bio-diesel shows less particle emissions compare to diesel bus due to the presence of the oxygen in the fuel.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.5 no.4
• /
• pp.93-99
• /
• 1997

The re quest to develop the engines that are able to run without air or with very little oxygen condition is raised with the interest of ocean science or the mines. This research had already be gun before the world war II, but had been stagnant owing to the appearance of nuclear power. Recycle diesel engines have ability to run under the above mentioned condition the recycle diesel engine recirculates exhaust gases into intake port and consumes additional oxygen supplied by oxygen tank. Carbon dioxide is controlled by the absorber. The combustion and emission characteristics of recycle diesel engines are quite different with conventional one because the working fluids of recycle diesel engines consist of Ar, $CO_2$ and $O_2$ as well as $N_2$. Recycle diesel engine is therefore different with general diesel engine from the viewpoint of intake air composition. It is required to investigate the effect of intake composition in the combustion and emission to know recycle diesel engine. In this study, NOx concentration, smoke and cylinder pressure are measured with the variation of Ar and $CO_2$ Reduces show that the addition of Ar reduces NOx but increases smoke. Otherwise $CO_2$ reduces smoke and NOX simultaneously. Only $CO_2$ increases the ignition delay and both gases increase fuel consumption Ar addition is superior to $CO_2$ addition for the performance of recycle diesel engine system but $CO_2$ has the avantage with respect to emission.

• Journal of Microbiology and Biotechnology
• /
• v.21 no.5
• /
• pp.519-524
• /
• 2011

The correlation between alcoholic fermentation rate, measured as carbon dioxide ($CO_2$) evolution, and the rate of hydrogen sulfide ($H_2S$) formation during wine production was investigated. Both rates and the resulting concentration peaks in fermentor headspace $H_2S$ were directly impacted by yeast assimilable nitrogenous compounds in the grape juice. A series of model fermentations was conducted in temperature-controlled and stirred fermentors using a complex model juice with defined concentrations of ammonium ions and/or amino acids. The fermentation rate was measured indirectly by noting the weight loss of the fermentor; $H_2S$ was quantitatively trapped in realtime using a pre-calibrated $H_2S$ detection tube which was inserted into a fermentor gas relief port. Evolution rates for $CO_2$ and $H_2S$ as well as the relative ratios between them were calculated. These fermentations confirmed that total sulfide formation was strongly yeast strain-dependent, and high concentrations of yeast assimilable nitrogen did not necessarily protect against elevated $H_2S$ formation. High initial concentrations of ammonium ions via addition of diammonium phosphate (DAP) caused a higher evolution of $H_2S$ when compared with a non-supplemented but nondeficient juice. It was observed that the excess availability of a certain yeast assimilable amino acid, arginine, could result in a more sustained $CO_2$ production rate throughout the wine fermentation. The contribution of yeast assimilable amino acids from conventional commercial yeast foods to lowering of the $H_2S$ formation was marginal.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.4
• /
• pp.279-285
• /
• 2017

In this paper, the resonator with a parallel plate capacitor is newly proposed around sub-microwave frequency band and applied to earlobe for non-invasive glucose monitoring the human biological tissue. The capacitor including the earlobe as dielectric material is connected to inductive slot in the ground plane of the microstrip line. Based on the simulation, one port resonator circuit is designed and fabricated as a prototype. Three step glucose concentration levels(0, 250, 500 mg/dL) was tested, and its reflection coefficients($S_{11}$) were measured. Owing to high Q resonator more than 100, resonant frequency shift of about 9 MHz per glucose level of 250 mg/dL has been successfully measured. This proves that the proposed sensor is applicable to a blood glucose sensor.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.19 no.5
• /
• pp.92-99
• /
• 2011

To measure the traffic pollutants with high temporal and spatial resolution under real conditions, a mobile emission laboratory (MEL) was designed. The equipment of the mini-van provides gas phase measurements of CO, NOx, $CO_2$, THC (Total hydrocarbon) and number density & size distribution measurements of fine and ultra-fine particles by a fast mobility particle sizer (FMPS) and a condensation particle counter (CPC). The inlet sampling port above the bumper enables the chasing of different type of vehicles. This paper introduces the technical details of the MEL and presents data from the car chasing experiment of diesel bus equipped with aftertreatment system. The dilution ratio was calculated by the ratio of ambient NOx and tail-pipe NOx. Most particles from the diesel bus were counted under 300 nm and the peak concentration of the particles was located between 30 and 60 nm. The total PM number emission from diesel bus equipped with DPF was 10 orders of magnitude lower compared to those emitted from base diesel bus. And the total PM number emission from diesel bus equipped with SCR was comparable to the particle emission from base diesel bus.

• Journal of the Society of Naval Architects of Korea
• /
• v.51 no.2
• /
• pp.107-113
• /
• 2014

The icebreaking research vessel, ARAON had her second ice trial in the Arctic Sea from 16th July to 12th August 2010. During the voyage, the local ice loads acting on the bow of port side were measured from 14 strain gauges. The measurements were also carried out in ice waters with various ice concentration ratio as well as the icebreaking performance tests. In this study, the ice loads measured during the 'general' operation in ice waters were analyzed. As a first step, the relationship between the location of strain gauges and the ice loads were investigated, and then the possibility for observation of higher ice loads was estimated based on the probability density function. The relationship between the ship speed and the ice load was also investigated. 718 peak stresses data higher than 20 MPa obtained from strain gauges array attached in longitudinally and vertically was analyzed. In general, the ice load increases as the ship speed increases in the low ship speed range, and ice load decreases as the ship speed is greater than a certain speed.

• Journal of Korean Society for Atmospheric Environment
• /
• v.12 no.4
• /
• pp.495-504
• /
• 1996

The concentrations of dimethylsulfide (DMS) were determined from both seawater and the overlying atmosphere from a station located in the Masan Bay area during a ten-day field campaign period of January 1996. The resulting data were also used to derive saturation ratios (SR) as well as sea-to-air fluxes of DMS. The concentrations and fluxes of DMS for both reservoirs varied extensively over two to three orders of magnitude: DMS in air and seawater were measured at 9 to 4,300 pptv (mean: 600 $\pm$ 1, 170, N=18) and at 0.24 to 10 nM (4.0 $\pm$ 3.4, N=13), respectively, while its fluxes were found from 0.02 to 23 mol $m^{-2} day^{-1} (3.1 \pm 6.8, N=11)$. A comparative analysis between our data and previously reported ones indicate that its atmospheric concentrations are abnormalously high, but its seawater counterparts are slightly lower than expected. In light of high pollution levels of organic-rich materials in and the associated high biological productivity of the study area, the sea-to-air-fluxes derived are notably low relative to those values typically reported from the coastal areas. These complicated features of DMS distributions/fluxes in the study site indicate that the near-by port- based anthropogenic activities from various industrial plants strongly interfere with natural processes leading to the production and release of DMS. It was however striking to find out relatively strong signals of diel cycle in its saturation ratios, concentration gradients between seawater and atmosphere, and the associated fluxes. Although it is yet difficult to provide meaningful explanations for the observed phenomena, the existence of clear diel cycle in some DMS-related parameters suggests that the natural processes may nonetheless exert important controls on the regional cycling of atmospheric sulfur species, of particular DMS.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.1065-1068
• /
• 2008

Marine bridges are readily deteriorated due to the exposure to marine environment. The concrete deterioration occurred by corrosion of steel in concrete is mainly relevant to chloride in seawater. Chloride ions penetrate through porous concrete, and then reach to the reinforcing steel, and finally corroded them. The corrosion by-products(rusts) increase the volume as much as 6 to 10 times of origin steel. this creates expanding pressure and tensile stress, which cause the structures cracking and spalling. Sometimes the rebar corrosion is accelerated, and then collapsed catastrophically. In order to prevent corrosion damage, it is important to understand well regarding the reason of concrete corrosion, the quantification of its damage, and protection method/system to stop or to mitigate the corrosion. In this study, slab specimens were fabricated to evaluate the effect of cathodic protection which was simulated to marine bridges, and/or port structures. Zn-mesh sacrificial anode has been applied as a chathodic protection system and accelerated test conditions, i.e. temperature and salt concentration have been used in this study.