• 전자공학회논문지D
• /
• 제34D권9호
• /
• pp.1-6
• /
• 1997

A transmission type phase shift attenuator has a poor reflection characteristics at an output port. And that is controlled by the current, its dynamic rnage decreases due to the current limitation. In this paper, to avoid such disadvantages, a reflection type low phase shift attenuator has been designed and measured. As a result, at a center frequency (1855MHz), the sreflection type low pahse shift attenuator has an attenuation of 30dB, within the limit of 3 phase shift and less than -17dB reflection characteristics at both input and output ports. And it demonstrates the peformance of the reflection type low phase shift attenuator is better than the transmission type phase shift attenuator with the same measurement specifications.

• 한국자동차공학회논문집
• /
• 제4권4호
• /
• pp.80-86
• /
• 1996

In order to decrease fuel comsumption rate and emissions, lean burn engine which has equipped swirl control valve, is investigated experimentally on the test bench. Single cylinder engine was used to test the combustion and emission performance with 4 kinds of swirl valve. Decrease in the carbon monoxide, hyerocarbon and specific fuel consumption was shown at the lean condition, which means that a good choice of swirl valve on the given intake port geometry can be used to increase the combustion efficiency and lean limit.

• 한국자동차공학회논문집
• /
• 제10권2호
• /
• pp.73-79
• /
• 2002

The NO emissions at the exhaust manifo1d were investigated with a fast NO analyzer to investigate the cycle-by-cycle variations on NO emissions level and the dependence of NO emissions on combustion. The measurement was performed with a part load condition with respect to the mixture ratios and the changes in loads at 1800rpm. The averaged values were obtained during 200 cycles. We found that there is characteristic pattern in 70 emissions from exhaust port and it was possible to set a representative value with the data sampled during specific period. As the load increased, the characteristics of NO emissions were more dependent on combustion pressures. It was also analyzed that the correlation between combustion pressures and NO emissions for different equivalence ratios tends to increase as the mixture goes leaner, Furthermore, this correlation for the lean mixture near the lean limit seemed to be kept.

• 한국항해학회지
• /
• 제17권4호
• /
• pp.73-87
• /
• 1993

As a result of accepting the '71 FUND Convention and enforcing the Oil Pollution Compensation Act 1992, we observed some benefits and costa. This paper analyses those benefits and costs and suggests se-veral key policy recommendations for the estasblishment of an effective oil pollution compensation regime in Korea. This paper identifies the said benefits and costs as follows : First, by establishing the oil pollu-tion compensation system as same as the international level, most of small and medium size of oil pollution damage which are caused by coastal tankers will be compensated by FUND. Second, most of oil pollution damage which are not covered by '69 CLC will be compensated by FUND. Third, some parts of FUND Contribution Fee and CRISTAL Contribution Fee to be charged by major oil companies will be doubled. However the limit of international oil pollution compensation system and the loophole outside the Oil Pol-lution Compensation Act 1992 suggest followings : 1) Radical risk management and insurance manage-ment of ocean going tanker owners, 2) Establishment of oil pollution claim settlement system, 3) Enforce-ment of crew and ship management for coastal tanker and 4) Establishment of Korean P & I Club.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2004년도 추계학술대회 논문집
• /
• pp.1384-1389
• /
• 2004

The primary objective of this paper is to examine the capacity of electrical transmission in electric railway feeding system. Although supply capacity of railway substation are sufficient and there is no accident, due to the electrical transmission limit of feeding line the voltage breakdown may occur when large capacity of electric load at feeding line exist. So, using multi-port analysis model, we draw P-V curve due to the length of feeding line, load, location and power factor of electric locomotive. And through case study, compare measurement result and simulation result

• 한국가스학회지
• /
• 제11권4호
• /
• pp.59-63
• /
• 2007

The purpose of this paper is to find optimum vent port of the booth for gas explosion experiment. Also, it is to understand the safety of the booth for explosion experiment which is installed to let the trainees for legal education which is managed by IGTT(Institute of gas technology training) blow the riskiness of explosion. Since the booth for gas explosion experiment is a confined space, we used the exhaust model for indoor explosion. As the result, it was safety calculated when the amount of leaking gas was close to the maximum of explosion limit on the explosion experiment.

• 수산해양교육연구
• /
• 제29권2호
• /
• pp.415-421
• /
• 2017

This study is aiming to find one of working conditions for loading and unloading a large ship at game port. Firstly, for dynamic analysis of the moored ships, the motion characteristics of ship according to loading condition are figured out. The motion characteristics of ship is related to environmental factors such as current, wind, mooring line, fender and etc. As a result, it is ascertained through numerical simulation using the AQUA MARINE developed by ANSYS INC. This study might contribute to make a new method of mooring stability of target ship.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 제38회 하계학술대회
• /
• pp.1169-1170
• /
• 2007

The primary objective of this paper is to examine the capacity of electrical transmission in electric railway according to the type of feeding system. Although supply capacity of railway substation are sufficient and there is no accident, due to the electrical transmission limit of feeding line the voltage breakdown may occur when large capacity of electric load at feeding line exist. So, using multi-port analysis model, we draw P-V curve due to feeding method, load, location and power factor of electric locomotive.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 추계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.291-295
• /
• 2005

This paper presents the modeling of grounding system on Korean electric railway system. The system model is composed of the catenary system, the grounding-system, the sub-sectioning post, the fault point, the sectioning post, the autotransformer in the substation, and the electric vehicle. The increment of rail-ground voltage may be thought as an amplifier of danger on human body of equipment insulation. The rail-ground voltage on steady state and on fault condition should be under standard limit voltage. To analyze grounding system for steady state and fault condition on Korean railway, modeling for each railway system is performed by 10-port network model. Modeling and analysis of present grounding-system are important to protect human and electronic equipments. The examinations for systematic grounding-system are investigated.

• 한국항해항만학회지
• /
• 제26권3호
• /
• pp.289-294
• /
• 2002

본 논문에서는 디지털 TV 중계기용 고출력 광대역의 3-Way 전력결합기를 설계.제작하였다. 대역폭 증가와 고출력을 동시에 이루기 위하여 Wilkinson 형태의 전력분배기를 채택하였다. 우선 Wilkinson 전력분배기를 균등(1 : 1) 및 비균등(2 : 1) 분배시켜, 동위상 4 포트 전력결합기를 시뮬레이션 하였다. 시뮬레이션 결과에 따라서 두께 120 mil인 유전체 기판을 사용하여 제작된 전력결합기는 디지털 TV 중계기 주파수 470~806 MHz 대역에서 삽입손실 -6.53dB 이하, 반사계수 -13dB 이하, 포트 간 분리도 -15 dB 이하, 출력 포트 간 위상차가 13$^{\circ}$이하의 특성을 보였다. 새롭게 만든 전력결합기는 회로에서의 고 임피던스로 인한 마이크로스트립 선로 폭의 한계와 고출력의 경우 선로간의 상호작용으로 인한 전력의 손실 및 협대역의 문제를 동시에 개선이 가능함을 알 수 있었다. 나아가서, 제작된 3-Way 결합기의 삽입손실, 반사계수, 포트간의 분리도 및 위상차가 디지털 TV 중계주파수 470~806 MHz에서 양호한 특성을 나타내는 것을 확인함으로써 고출력 및 광대역화가 실현가능하다는 것을 알 수 있었다.