• Applied Chemistry for Engineering
• /
• v.9 no.4
• /
• pp.542-547
• /
• 1998

Polyamine type polymer flocculants were synthesized and their characterization, viscosity and flocculation studies were conducted. In order to increase the molecular weight of polyamine flocculant which was prepared by polycondensation reaction from dimethylamine and epichlorohydrin, a small amount of 1,6-hexanediamine was employed. The incorporation of 1,6-hexanediamine up to 5.5 mole % replacing corresponding part of dimethylamine gave a branched type polyamine sample with increased intrinsic viscosity ([${\eta}$]=0.46 in 1 wt % aqueous NaCl solution). The amount of 1,6-hexanediamine above 5.5 mole %, however, resulted in gelation during polymerization. Utilizing raw water from Maegok potable water treatment plant, it was found that the addition of polyamine flocculant at a concentration of 1 mg/L level could reduce the amount of polyaluminum chloride (PAC) inorganic flocculant by half (15 mg/L). It was also observed that the incoporation of polyamine flocculant at 1 mg/L level was effective in the higher pH raw water, while PAC inorganic flocculating agent alone was not effective.

• Journal of Korean Society of Water and Wastewater
• /
• v.25 no.2
• /
• pp.231-240
• /
• 2011

The objectives of this research are to investigate coagulation efficiencies of two coagulants l.e., alum and polyaluminum chloride and to understand effects of the coagulants on membrane fouling in microfiltration. The turbidity of supernatant from alum coagulation was increased with increasing doses whereas the turbidity from PACl coagulation was maintained at the low values. The observed injection volume of PACl for the same removal was approximately 30 percent less than alum, which produced a low sludge volume. The settling velocity of PACl flocs was greater than alum flocs. The results corresponded well with floc size measurements. Flux decline from alum coagulation was significant due in part to small sizes of flocs. At the low dose, alum floc had less specific cake resistance than PACl floc. However, as the dosage was increased, the increases in specific cake resistances of alum was substantial. Alum coagulation pretreatment needs careful operation to reduce membrane fouling by flocs. In general, PACl coagulants were more effective than alum coagulants for pretreatment of membrane processes because PACl showed the better performance in coagulation and membrane fouling.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.35 no.2
• /
• pp.18-25
• /
• 2003

The adsorption of co-cationic dual polymer system was investigated as was the fiber dispersion stability of a paper stock suspension. Polyaluminum chloride(PAC) and polyamidoamine epichlorohy-drin(PAE) polymers were used as wet-end additives. The adsorbed amounts of PAE polymer in a wet stock were measured by using polyelectrolytic PCD titration. The sheet forming experiments were carried out in a standard handsheet machine. Fiber dispersion stability and relative retention were evaluated in terms of M/K non-uniformity index and sheet basis weight, respectively. The PAE polymer adsorption of Langmuir-isothermal type decreased with increasing PAC addition level. The combination of the two cationic polymers presumably exerts a site-blocking effect by the low molecular weight PAC which gives a partial charge neutralization at a minimum level of addition. From a thermodynamic view point of PAE adsorption, an increase in adsorption entropy and a decrease in train number suggests that the PAR polymer has an extended conformation structure that potentially leads to an enhancement of the fiber dispersion stability. This conclusion is supported by handsheet experiments that examined the PAC-PAE dual polymer effects on the sheet formation and retention.

• Korean Journal of Environmental Agriculture
• /
• v.28 no.2
• /
• pp.186-193
• /
• 2009

The removal efficiency of herbicide glyphosate in a drinking water treatment system was investigated. Four major processes of a drinking water treatment system were selected and experiments were performed separately including; treatments by sodium hypochlorite (NaOCl), a sedimentation process by PAC (polyaluminum chloride), ozonation and a GAC (granular activated carbon) treatment. In the sodium hypochlorite experiment, about 50% of the glyphosate was removed by 2 mg/L of hypochlorite and more than 90% was eliminated when 5 mg/L of NaOCl was applied. Also, AMPA, the main metabolite of glyphosate, was treated with hypochlorite. More than 30% of the AMPA was removed by 2 mg/L of hypochlorite and 50% by 5 mg/L. In the PAC experiment, it was determined that more than 60% could be removed. Further experiments were performed and the results indicated that the removed amount was dependent upon the amount of soil and upon the properties of the soil especially that of clay minerals. Ozonation could oxidize glyphosate to its byproducts at about a level of 50%. In contrast, when 1 mg/L of glyphosate was treated with GAC, the amount removed was negligible. The results of this experiment were conclusive. We confirmed that drinking water, which has been contaminated with water polluted with glyphosate can be effectively purified by the application of the drinking water treatment processes currently used.

• Journal of Marine Bioscience and Biotechnology
• /
• v.6 no.1
• /
• pp.17-25
• /
• 2014

Periodically, harmful algal blooms (HABs) have occurred, with impacts on various areas including public health, tourism, and aquatic ecosystems, especially aquacultured and caged fisheries. To prevent or manage invasions of HABs into fish farms on an emergency basis, many methods have been proposed. Frequently over the past 30 years in coastal countries, treatments of clay and clay mixed with polyaluminum chloride (PAC) and chitosan have been tested for HAB-removal effectiveness in both the laboratory and the field. In Korea, yellow loess clay (hwangto) has been dispersed using electrolytic clay dispensers, both to decrease the amount of yellow loess clay's usage in containers and enhance HAB-removal efficiency. However, this emergency method has limitations, among which is the requirement for more effective controlling agents for field applications. Thus, in this paper, we review technologies for clay-based red tides prevention and control and their limitations, and, further, introduce next-generation algicidal technologies for the emergency protection of fish farms.

• Journal of Environmental Science International
• /
• v.16 no.6
• /
• pp.699-706
• /
• 2007

Many lakes or irrigative reservoirs in Korea are rapidly contaminated due to the ever increasing pollutants. Although lots of treatment processes have been recommended and practiced, economical and technical improvement is currently needed. In this study, contaminated irrigation reservoir was treated using the proposed process which is consisted of fine air bubbles, coagulation and flotation. Fine bubbles, approximate diameter of 3 to $10{\mu}m$, were generated using cavitation in the pressurized tank and polyaluminum chloride was used as coagulants. This fine bubbles, coagulation and flotation effectively controlled the low density algae, for example, Chlorophyll-a was removed more than 97 %. Removal efficiency of COD, SS, T-N and T-P were 80.7%, 94.3%, 64.1 % and 92.4%, respectively. Pollutants released from the sediments was removed more than 80% of organics and 60-70 % of nutrients. Consequently, fine bubbles coagulation and flotation process could be effectively used as an alternative treatment method for the purpose of control of lake water quality.

• Journal of Korean Society of Environmental Engineers
• /
• v.32 no.8
• /
• pp.774-779
• /
• 2010

The experimental results for the analysis of aluminum hydrolysis species with PACls (polyaluminum chloride) prepared by different basicity (r value) showed that monomeric Al species were reduced while polymeric Al species were increased with an increase in basicity for PACls. The PACl with 2.2 of r value contained the highest amount of polymeric Al species. According to the experimental results for the phosphorus removal, the alum and PACl (r=0), which consisted of mainly monomeric Al species, were the most effective for phosphorus removal. Therefore, it was concluded that the Al coagulant containing higher amount of monomeric or lower molecular Al species would be more beneficial for phosphorus removal.

• Journal of Environmental Health Sciences
• /
• v.38 no.2
• /
• pp.128-135
• /
• 2012

Objectives: This study was aimed at determining the optimum coagulation dosage in a high turbid kaolin water sample using streaming current detection (SCD) as an alternative to the jar test. Methods: SCD is able to optimize coagulant dosing by titration of negatively charged particles. Kaolin particles were used to mimic highly turbid water ranging from 50 to 600 NTU, and polyaluminum chloride (PAC, 17%) was applied as a titrant and coagulant. The coagulation consisted of rapid stirring (5 min at 140 rpm), reduced stirring (20 min at 70 rpm), and settling (60 min). To confirm the coagulation effect, a jar test was also compared with the SCD titration results. Results: SCD titration of kaolin water samples showed that the dose of PAC increased as the pH rose. However, supernatant turbidity less than 1 NTU after coagulation was not achieved for high turbid water by SCD titration. Instead, a conversion factor was used to calculate the optimum PAC dosage for high turbid water by correlating a jar test result with that from an SCD titration. Using this approach, we were able to successfully achieve less than 1 NTU in treated water. Conclusions: For high turbid water influent in a water treatment plant, particularly during summer, the application of SCD control by applying a conversion factor can be more useful than a jar test due to the rapid calculation of coagulation dosage. Also, the interpolation of converted PAC dose could successfully achieve turbidity in the treated water of less than 1 NTU. This result indicates that an SCD system can be effectively used in a water treatment plant even for high turbid water during the rainy season.

• Geomechanics and Engineering
• /
• v.12 no.5
• /
• pp.753-770
• /
• 2017

The coagulation or flocculation of cohesive clay suspensions is one of the most widely used treatment technologies for contaminated water. Flocculated clay can transport pollutants and nutrients in ground water. Coagulants are used to accelerate these mechanisms. However, existing coagulants (e.g., polyacrylamide, polyaluminum chloride) are known to have harmful effects in the environment and on human health. As an alternative, eco-friendly coagulant, this study suggests ${\varepsilon}-polylysine$, a cationic biopolymer fermented by Streptomyces. A series of sedimentation experiments for various ${\varepsilon}-polylysine$ concentrations were performed, and the efficiency of sedimentation with ${\varepsilon}-polylysine$ was estimated by microscopic observation and light absorbance measurements. Two types of sedimentation were observed in the experiments: accumulation sedimentation (at 0.15%, 0.20%, 0.25% ${\varepsilon}-polylysine$) and flocculation sedimentation (at 0%, 0.1%, 0.5%, 1.0%, 2.0% ${\varepsilon}-polylysine$). These sedimentation types occur as a result of the concentration of counter ions. Additionally, the performance of ${\varepsilon}-polylysine$ was compared with that of a previously used environmentally friendly coagulant, chitosan. The obtained results indicate that flocculation sedimentation is appropriate for contamination removal and that ${\varepsilon}-polylysine$ functions more efficiently for clay removal than chitosan. From the experiments and analysis, this paper finds that polylysine is an alternative eco-friendly coagulant for removing chemical contaminants in groundwater.

• Journal of Korean Society of Water and Wastewater
• /
• v.32 no.1
• /
• pp.47-53
• /
• 2018

This study investigated phosphorus removal from secondary treated effluent using coagulation-membrane separation hybrid treatment to satisfy strict regulation in wastewater treatment. The membrane separation process was used to remove suspended phosphorus particles after coagulation/settlement. Membrane separation with $0.2{\mu}m$ pore size of micro filtration membrane could reduce phosphorus concentration to 0.02 mg P/L after coagulation with 1 mg Al/L dose of polyaluminum chloride (PACl). Regardless of coagulant, the residual concentration of phosphorus decreased as the dose increased from 1.5 to 3.5 mg Al/L, while the target concentration of 0.05 mg P/L or less was achieved at 2.5 mg Al/L for the aluminum sulfate (Alum) and 3.5 mg Al/L for PACl. Moreover, alum showed better membrane flux as make bigger particles than PACl. Alum showed a 40% of flux decrease at 2.5 mg Al/L dose, while PACl indicated a 50% decrease of membrane flux even with a higher dose of 3.5 mg Al/L. Thus, alum was more effective coagulant than PACl considering phosphorus removal and membrane flux as well as its dose. Consequently, the coagulation-membrane separation hybrid treatment could be mitigate regulation on phosphorus removal as unsettleable phosphorus particles were effectively removed by membrane after coagulation.