• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.49 no.3
• /
• pp.47-52
• /
• 2012

This paper is in regard to design and experiment about the radar's circular polarization antenna operating in the Ku band. By using the Post to manufacture the circular polarization antenna using the linear antenna, it could reduce the structural size of an antenna. 3 Posts were used in order to broaden the Axial ration Bandwidth of the circular polarization antenna. The distance and length between Posts and Post were appropriately selected for the axial ratio optimization and applied in the design. It was verified that the designed antenna has the impedence bandwidth of 12.7%, axial ratio performance less than 2dB and gain of 7.8dBi.

• Korean Journal of Optics and Photonics
• /
• v.14 no.6
• /
• pp.657-662
• /
• 2003

Optimum Hamming apodized acousto-optic 2${\times}$2 add/drop multiplexers, using SiO$_2$ film loaded acoustic waveguide with angular offset to the Ti:LiNbO$_3$ waveguide, were fabricated. The four-port device consists of two input waveguides, a polarization beam splitter (PBS), two polarization conversion/acoustooptic tuning waveguide sections, a second PBS and two output waveguides. Insertion loss <7.1 ㏈ has been obtained and side-lobe of -19 ㏈ for -32 ㎽ RF driving power has been realized. Add/drop performance has been confirmed and a linear tuning rate of 8.1 nm/MHz and a 3 ㏈ spectral width of -1.5 nm were demonstrated.

• Proceedings of the Optical Society of Korea Conference
• /
• 2004.02a
• /
• pp.298-299
• /
• 2004

We propose and theoretically analyze multi-functional integrated optical device based on figure-eight shaped birefringent Sagnac loops. Our analysis shows that the propose device exhibit many unique features which allows it to operate as a tunable high-Q comb filter with a good channel isolation, and the intensity transmission of the filter can be varied from zero to 100 percent.

• Proceedings of the IEEK Conference
• /
• 1999.11a
• /
• pp.191-194
• /
• 1999

Switching behaviour of the ferroelectric thin film and device characteristics of the MFSFET (Metal-Ferroelectric-Semiconductor FET) are simulated with taking into account the accumulation of oxygen vacancies near interface between the ferroelectric thin film and the bottom electrode caused by the progress of fatigue. We show net switching current decreases due fatigue in the switching model. It indicates that oxygen vacancy strongly suppresses polarization reversal. The difference of saturation drain current of the device before fatigue is shown by the dual threshold voltages in I$_{D}$-V$_{D}$ curve as 6㎃/$\textrm{cm}^2$ and decreases as much as 50% after fatigue. Our simulation model is expected to play an important role in estimation of the behavior of MFSFET device with various ferroelectric thin films.lms.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.58-61
• /
• 2001

Metal-insulator-semiconductor (MIS) C-V properties with high dielectric AIN thin films showed no hysteresis and good interface properties. The dielectric constant of the AIN film calculated from the capacitance at the accumulation region in the capacitance-voltage(C-V) characteristics was about 8. The C-V characteristics of MFIS capacitor showed a hysteresis loop due to the ferroelectric nature of the LiNbO$_3$ thin films. Typical dielectric constant value of LiNbO$_3$ film of MFIS device was about 23. The memory window width was about 1.2V at the gate voltage of $\pm$5 V ranges. Typical gate leakage current density of the MFIS structure was the order of 10$^{-9}$ A/cm$^2$ at the range of within $\pm$500 kV/cm. The ferroelectric capacitors showed no polarization degradation up to about 10$^{11}$ switching cycles when subjected to symmetric bipolar voltage pulse(peak-to-peak 8V, 50% duty cycle) in the 500kHz.

• Korean Journal of Optics and Photonics
• /
• v.14 no.1
• /
• pp.33-37
• /
• 2003

A low-power $1{\times}2$ polymeric thermo-optic switch with a trench structure is proposed and fabricated. The trench structure in the optimized region slows down the heat flow from the electrodes, which contributes to the reduction of power consumption. The temperature distribution in the polymer layers has been adjusted to increase the temperature gradient between the two arms of the Y-branch. For comparison, a $1{\times}2$ polymeric thermo-optic switch with no trench structure is fabricated together on the same substrate. In the device with a trench structure, the measured crosstalk is less than -17.0 dB for TE polarization.-15.0 dB for TM polarization. The power consumption is about 66 mW, which is 25% less than that of the device with no trench structure.

• Korean Journal of Optics and Photonics
• /
• v.15 no.6
• /
• pp.547-554
• /
• 2004

We investigated a LiNbO$_3$ based integrated-optic polarization controller with the Ti-indiffused waveguide along the z-axis utilizing the electro-optic effect. The device consists of a first quarter-wave (λ / 4) followed by a half-wave (λ / 2) and a second quarter-wave (λ / 4) wave-plate. We analyzed the amount of phase change and the transformation of the polarized mode as a function of the combination of wave-plates and of their applied voltages. The operation has been systematically measured utilizing a polarimeter and Poincare sphere. We confirmed that the fabricated device controls the transformations from any arbitrary input state of polarization (SOP) into any general output SOP.

• Korean Journal of Optics and Photonics
• /
• v.13 no.6
• /
• pp.467-472
• /
• 2002

In this paper, we propose a polarization-insensitive temperature sensor using a thermo-optic effect of the upper and (or) lower cladding of a planar waveguide in contact with a side-polished fiber. A microscope cover glass with thickness of a 170 ${\mu}{\textrm}{m}$ is adopted as an overlay waveguide because this waveguide opposes sudden temperature change and ensures polarization-insensitive responses. The measured polarization-dependence loss is less than 0.3 dB. The temperature can be detected as a result of the shift in coupling wavelength of the sensor. We investigate the shift in coupling wavelength as a function of the temperature variation with respect to the different thermo-optic coefficients of lower and upper claddings. We also show that the temperature sensitivity of the device can be easily controlled by the thermo-optic coefficients of lower and upper claddings of the overlay waveguide.

• Korean Journal of Optics and Photonics
• /
• v.8 no.6
• /
• pp.486-491
• /
• 1997

A division-of-amplitude type photopolarimeter has been constructed for the analysis of the dynamic optical characteristics of liquid crystal panels, one of the essential components of liquid crystal displays. In this instrument an incoming light ray, whose state of polarization is to be determined, is divided into three rays of nearly same intensities and of identical polarization state by using NPBS'(non-polarizing beam splitters). Each of the three rays is further divided into two components of orthogonal polarization states by using a PBS(polarizing cube beamsplitter) or by using a combination of a quater wave plate followed by a PBS. The intensity of each ray is measured by using a photodiode to produce a set of six photo-signals, which in turn are converted into four Stokes parameters describing the state of polarization of the incoming ray. Performance test of the insrument shows that its time resolution is 80 $mutextrm{s}$, accuracy $\pm$0.3 degrees when the state of polarization of the incoming ray is representated on the Poincare sphere.

• Korean Journal of Optics and Photonics
• /
• v.8 no.3
• /
• pp.223-229
• /
• 1997

A source code is developed on the basis of Berreman's 4$\times$4 matrix formalism for the analysis of polarization transmission characteristics of twisted nematic liquid crystal display. By using the program, the polarization transmission characteristics of liquid crystal cells and polarizers are analyzed. For a normally white twisted nematic liquid crystal cell, we obtained a family of iso-contrast contours which helps to understand the viewing angle characteristics of the liquid crystal display device by using the cell. The program also help us to understand the variation of the degree of polarization as well as the deviation of the state of polarization of the light transmitted through the polarizer commonly used in the LCD according to the change in incidence angle. This result suggests the contrast of the images appearing on the LCD can be limited by the characteristics of the polarizer in addition to the liquid crystal cell.