• Journal of the Korea Institute of Military Science and Technology
• /
• v.9 no.3
• /
• pp.109-115
• /
• 2006

The investigation of the polarization cross-coupling in fiber coils was made using white light Michelson interferometer. The white light interferometer has a light source of about 13nm spectral bandwidth and measurement resolution of less than -80dB. The measurement found that the 200m fiber coil has a polarization cross-coupling of about -64dB in average and -46dB in maximum.

• Journal of information and communication convergence engineering
• /
• v.19 no.3
• /
• pp.131-135
• /
• 2021

The interference between closely placed co-coverage satellites was analyzed. In general, a satellite network may use different orthogonal polarizations and frequencies to increase the throughput of a satellite. However, when orthogonal linear polarization (horizontal polarization and vertical polarization) or orthogonal circular polarization (left-handed circular polarization and right-handed circular polarization) is used, the signal from one polarization sense to another may be coupled, resulting in cross-polarization interference. This signal-coupling arises due to the finite value of the cross-polarization discrimination of the earth station. In this study, field equations were used to analyze the interference between adjacent satellites using co-frequency. The level of interference was compared to that when two adjacent satellites used the same polarization. The simulation results show that the interference mainly depends on the off-axis co-polar pattern and the cross-polar pattern of the earth station antenna.

• Journal of electromagnetic engineering and science
• /
• v.1 no.1
• /
• pp.30-36
• /
• 2001

Whereas it is well known that microwave propagation around corners of urban area is estimated well by the uniform geometrical theory of diffraction (UTD), it is not clear how much depolarization occurs at a given receiver position and how much transmission through walls affects to total path loss. This paper presents the results of the ray tracing simulation to answer these questions. Simulations of microwave propagation around corners were performed for various line-of-sight (LOS) and out-of-sight(OOS) positions of a receiver, by summing the electrical fields of reflected, diffracted and transmitted rays coherently. Since height difference between transmitter and receiver, as well as ground plane, causes depolarization, the ray tracing simulation estimates the cross-polarization coupling. It was found that the cross-polarization coupling decreases as receiver moves away from transmitter. Another part of the study focused on the signal transmitted through building walls of the corner. It was found that the transmitted field is dominant at OOS region when the conductivity of the walls is low (for example, lower than 0.0l S/m). The simulation results of the ray tracing technique in this study agreed well with an experimental measurement around corners.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.6 no.6
• /
• pp.897-903
• /
• 2002

In this paper, a modified feeding structure for microstrip patch antenna is suggested for improving the performances. The proposed antenna has a gap between the transmission line and the recessed part of the radiating patch which makes a capacitive coupling. It shows higher 511(-l4dB) and lower cross polarization level(-2OdB) compare with the conventional inset ftd patch antenna while having a similar characteristics in another evaluating items. Experimental results are examined and considered to apply to the S-Band application, and the effectiveness has been confirmed by FDTD simulation and measurement simultaneously.

• Journal of the Optical Society of Korea
• /
• v.13 no.4
• /
• pp.439-444
• /
• 2009

Accurate evaluation of polarization characteristics in the integrated optic chip (IOC) for interferometric fiber optic gyroscope was performed. Spatial distribution of optical wavetrains caused by the polarization parameters such as local polarization cross-coupling and polarization rejection coefficient of the IOC were measured utilizing the path-matched optical coherence domain polarimetry (PM-OCDP). With the analytic model deduced from Jones matrix representation, we could accurately identify the polarization characteristics of the IOC. Both degree of measurement error due to the imperfect equipment conditions in PM-OCDP and birefringence of IOC chip were also characterized.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.4
• /
• pp.894-900
• /
• 2004

There are many types of circularly polarized(CP) microstrip antenna elements, which are used as a good unit radiator. Since an advantage of CP antenna is no strict alignment requirements between Rx and Tx system, the printed antennas with circular polarization are very often used in numerous satellite and mobile radio systems. In order to realize the broad bandwidth of 3 dB axial ratio and impedance of CP microstrip antenna, complex feed structure and tri-plate patch element have been researched. This paper describes a design of wideband microstrip cross slot array antennas with circular polarization. The proposed antenna is composed of an open-ended microstrip feed line as a feeder and a cross slot as a radiator for circular polarization. To realize the wide bandwidth, tri-plate structure are considered and cross slot is electromagnetically coupled with feed line. Optimum parameters of 1-element cross slot antenna are analyzed and designed by method of moments. These parameters are also applied to may antennas design considered the mutual coupling between radiating elements. Right hand circular polarization(RHCP) and left hand circular polarization(LHCP) of the proposed antenna are easily controlled by asymmetrical cross slot structure and slot position. In 1-element and 15-element cross slot array antenna, the good axial ratio of 1 dB below and the broad bandwidth characteristics of antenna are obtained.

• Korean Journal of Optics and Photonics
• /
• v.15 no.6
• /
• pp.503-510
• /
• 2004

We propose a novel vertical directional coupler switch using a vertical directional coupler with polarization independent coupling lengths employing the doublesided deep-ridge waveguide structure. This switch is composed of a switching operation induced section with symmetric structures and an extinction ratio enhanced section with asymmetric structures. We present design methods and examples for this switch with very short lengths and very high extinction ratios larger than 30 dB for both TE and TM modes in cases of both cross and bar states.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.5
• /
• pp.492-501
• /
• 2013

In this paper, a multi polarization reconfigurable microstrip antenna that can be used selectively for four polarizations(vertical polarization, horizontal polarization, right hand circular polarization, left hand circular polarization) at the S-band is presented. The proposed antenna consists of four PIN diodes and a microstrip patch with a cross slot and a circular slot and is fed by utiliting electromagnetic coupling between the microstrip patch and the feed line. The proposed antenna has a DC bias network to supply DC voltage to each PIN diode and the polarization can be determined by controlling the ON /OFF states of four PIN diodes. The fabricated antenna has a VSWR below 2 in the vertical polarization(3.17~3.21 GHz), the horizontal polarization(3.16~3.20 GHz), the left hand circular polarization (3.08~3.19 GHz), and the right hand circular polarization(3.10~3.2 GHz) frequency bands. The designed antenna has the cross polarization level higher than 20 dB, a gain over 5 dBi for the linear polarization states, and 3 dB axial ratio bandwidth wider than 50 MHz in the circular polarization states.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.12
• /
• pp.171-176
• /
• 2005

This study designed and fabricated a multi-purpose planar antenna for base stations that are accessible to DCS, WiBro, and ISM. The proposed antenna was designed into an open loop form from the existing monopole structure. The capacitance of the multi-purpose antenna was increased by the coupling of open parts. This makes the use of MMIC and LTCC convenient and the antenna is smaller and has a larger gain than existing antennas. The resonance distance and bandwidth can be adjusted by changing the open gap and the height of the loop of the antenna. The bandwidth of the designed antenna satisfies DCS, IMT-2000, WiBro, Bluetooth, wireless LAN and ISM bands based on VSWR 2. The entire frequency bandwidth is $58.75\%$ of $1.575GHz\~2.985GHz(1.41GHz)$. Also, the radiation pattern of the antenna displayed co-polarization and cross-polarization characteristics at 1.6GHz, 2.3GHz and 2.8GHz.

• Polymer(Korea)
• /
• v.36 no.3
• /
• pp.372-379
• /
• 2012

In this study, we treated silica nanoparticles with bis[3-(trimethoxysilyl)propyl]amine (BTMA) silane coupling agent to modify their surfaces. We investigated the effects of BTMA hydrolysis time, BTMA concentration and BTMA treatment time on the degree of silanization reaction of silica nanoparticles. We used Fourier transform infrared spectroscopy (FTIR), elemental analysis (EA) and solid state cross-polarization magic angle spinning (CP/MAS) nuclear magnetic resonance spectroscopy (NMR) to obtain quantitative data. We found the decrease of isolated Si-OH peak intensity at 3747 $cm^{-1}$ and the increase of $-CH_2 $stretching and bending peaks with increasing hydrolysis time, concentration and treatment time of BTMA. EA analysis results also supported this trend. We found a strong effect of BTMA concentration on the degree of silanization of the silica particles, but weak effects of the hydrolysis time and the treatment time.