• Transactions of the Society of Information Storage Systems
• /
• v.2 no.3
• /
• pp.184-188
• /
• 2006

In recent years the flying height of the head/slider has been decreasing in order to increase the recording density of hard disk drive (HDD). Accordingly, it was predicted that direct contact between slider and disk surface (slider slap) can cause defects on the disk such as scratch and particle generation. In this work, we theoretically demonstrate the effect of rounded-edge slider using Hertzian contact theory. Depth and width of scratch were predicted by plowing model. Furthermore, as we fabricated rounded-edge slider, rounded-edge slider was tested and compared with sharp-edge slider. The experimental results show rounded-edge was effective for reducing scratch depth.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.18 no.10
• /
• pp.2597-2605
• /
• 1994

The wear behavior of two types of $Si_3N_4$ exposed to high and low humidity was examined at various sliding speeds, using bearing steel as disk material under pin-on-disk type sliding conditions. Higher wear rates were obtained at a high humidity than at a low humidity. As the sliding speed was increased, the wear rates were decreased and the effect of humidity on the wear rates of $Si_3N_4$ was reduced. The result that the $Si_3N_4$ pin showed higher wear rate under the high humidity condition was explained by the decrease in microhardness of $Si_3N_4$ due to the chemisorbed moisture on the pin and plowing action by the hard particles of $Fe_2O_3$ from the disk. An increase in the sliding speed is supposed to reduce the effect of humidity on the wear rate of $Si_3N_4$ by raising the average temperature of the disk surface and the local temperature at pin-disk contact point.

• Korean Journal of Soil Science and Fertilizer
• /
• v.32 no.3
• /
• pp.254-260
• /
• 1999

This experiment was carried out to evaluate the effect of improvement of soil physical property such as deep plowing and chiseling and diagnostic application of N, P, K fetilizers. Latex Coated Urea(LCU), compost, sillicate for increasing yielding and enchancing N-use efficiency in puddled-soil drill seeding of Rice. The soil physical properties, such as bulk density, hardness and porosity were increased by deep plowing and chiseling, as well as chemical propeties were highly enhanced soil productivity due to increase the content of organic matter, available $P_2O_5$ and K as compare with control. The amount of $NH_4-N$ in soil was highly increased by diagnostic fertilization and chiseling, while recovery rate of V fertilizer was the highest at LCU 80% applied with chiseling. The rice yield increased by 23% under the diagnositic application of LCU 80% applied base with chiseling.

• Korean Journal of Medicinal Crop Science
• /
• v.16 no.2
• /
• pp.69-73
• /
• 2008

Fields experiments were conducted to investigate the effect of various tillage depth (TD) on productivity and quality of C. auriculatum Royle ex Wight from 2005 to 2006. The length of vine was elongated in lower TD treatments as 50 cm longer in 10 cm TD than 30 cm TD, and stem diameter and dry weight had increased in the lower TD. Length, width, and weight of leaves showed the quantitive growth in the lower TD treatments, but the chlorophyll content had increased in the deeper TD treatments. Root number and length had increased in the deeper TD treatments, but the root diameter and decomposed root was increased in the deeper TD. The total yield of root showed the increasing tendency in the deeper TD treatments as 6.2 ton/ha in 10 cm TD and increased as $7{\sim}9%$ in the 20 cm TD treatments.

• Tribology and Lubricants
• /
• v.21 no.5
• /
• pp.209-215
• /
• 2005

Nano/micro friction with the contact area was studied on Si-wafer (100) and diamond-like carbon (DLC) film. Borosilicate balls of radii $0.32{\mu}m,\;0.5{\mu}m,\;1.25{\mu}m\;and\;2.5{\mu}m$ mounted on the top of AFM tip (NPS) were used for nano-scale contact and Soda Lime glass balls of radii 0.25mm, 0.5mm, 1mm were used for micro-scale contact. At nano-scale, the friction between ball and surface was measured with the applied normal load using an atomic force microscope (AFM), and at micro scale it was measured using ball-on flat type micro-tribotester. All the experiments were conducted at controlled conditions of temperature $(24\pm1^{\circ}C)$ and humidity $(45\pm5\%)$. Friction was measured as a function of applied normal load in the range of 0-160nN at nano scale and in the range of $1000{\mu}N,\; 1500{\mu}N,\;3000{\mu}N\;and\;4800{\mu}N$ at micro scale. Results showed that the friction at nano scale increased with the applied normal load and ball size for both kinds of samples. Similar behavior of friction with the applied normal load and ball size was observed for Si-wafer at micro scale. However, for DLC friction decreased with the ball size. This difference of in behavior of friction in DLC nano- and microscale was attribute to the difference in the operating mechanisms. The evidence of the operating mechanisms at micro-scale were observed using scanning electron microscope (SEM). At micro-scale, solid-solid adhesion was dominant in Silicon-wafer, while plowing in DLC. Contrary to the nano scale that shows almost a wear-less situation, wear was prominent at micro-scale. At nano- and micro-scale, effect of contact area on the friction was discussed with the different applied normal load and ball size.

• Korean Journal of Environmental Agriculture
• /
• v.33 no.2
• /
• pp.144-147
• /
• 2014

BACKGROUND: It is essential to prioritize the exact and clear understanding of agricultural nonpoint source pollution (NPS) controls. The realistic policies and systems should also be developed based on this understanding. Therefore, this study aimed to present agricultural Best Management Practices (BMPs) applicable for the fields based on the Delphi survey result. METHODS AND RESULTS: This study deduced the evaluation items to assess each BMP for agricultural NPS control and conducted the surveying using the Delphi method based on agricultural BMP experts. In addition, its on-the-spot application were evaluated. Considering its importance, technical, social and economic proprieties showed that political support was ranked first and followed by cost investment, labor investment, reduction effect and resident participation. The survey findings by agricultural BMP experts showed the good performance of on-the-spot application can be achieved from fertilization by soil testing, residue and green manure application and contour plowing which are applicable within a field. Agricultural BMPs, highly applicable for the fields, were the countermeasures that farmers who are the principal bodies of agricultural NPS control could be participated directly. CONCLUSION: The active participation of farmers is essential for effective control of agricultural NPS. It is necessary to establish various incentive systems.

• Journal of Radiation Protection and Research
• /
• v.40 no.4
• /
• pp.231-243
• /
• 2015

Four different paddy soils collected around the Gyeongju nuclear site were treated with $^{99}TcO_4{^-}$ solution under the assumption of two contrasting contamination scenarios. Scenario I (SN-I) is for a pre-transplanting deposition of $^{99}Tc$ followed by plowing, whereas SN-II is for its deposition onto the water surface shortly after transplanting. Rice plants were grown in lysimeters in a greenhouse. Plant uptake of $^{99}Tc$ was quantified with the $TF_{area}$ ($m^2{\cdot}kg^{-1}-dry$). The SN-II $TF_{area}$ values for straws and brown rice, having been generally higher than the SN-I values, were within the ranges of $6.9{\times}10^{-3}{\sim}4.1{\times}10^{-2}$ and $5.2{\times}10^{-6}{\sim}7.3{\times}10^{-5}$, respectively. Sorption onto clay seems to have decreased $^{99}Tc$ uptake in SN-I, whereas it may have had an insignificant effect in SN-II. A phenomenon characteristic of submerged paddy soil, i.e., the development of a thin oxic surface layer may have greatly affected the rice uptake of SN-II $^{99}Tc$. The surface-water concentrations of $^{99}Tc$ were much higher in SN-II than in SN-I. For the percolating water, however, the opposite was generally true. At most 1.3% of the applied $^{99}Tc$ were leached through such percolation. The use of empirical deposition time-dependent $TF_{area}$ values was considered desirable in assessing the radiological impact of a growing-season deposition of $^{99}Tc$ onto paddy fields.

• Journal of Environmental Science International
• /
• v.21 no.2
• /
• pp.181-188
• /
• 2012

Salicornia europaea (glasswort) is succulent, annual, halophytic plant mainly distributed throughout reclaimed land or salt marsh. It has strong tolerance to salt so that it plays the part of the pioneer species in the first succession. According to domestic and foreign studies, S. europaea contains plenty of minerals and antioxidant in the body. Since people take note of an availableness of this plant as health diet, the natural growth sites are threatened. In addition to development of salt marsh and sea shore, imprudent harvest has a bad effect to S. europaea population maintenance. To seek ways to preserve the population of this plant, we carried out the continuity of seed germination and restoration test. Seokmo Island, Daebu Island, Youngjong Island and Sudokwon landfill in Korea are selected sites for research. Result of germination continuity shows that most S. europaea seeds germinate on March but no more after July. However the germination was occurred after that time in the greenhouse. So we concluded that no germination after July is a matter of environmental condition not the number of remaining seeds. Also germination was seldom occurred in the spot where seeds production was not happened. In result of continuity test of seed germination by soil depth, germination was occurred vigorously only in top soil. From these results, we note that most S. europaea germinate in the early spring, and germination is finished by July. And this rapid germination speed makes the number of seeds in soil seed bank rare. If a large number of S. europaea in some area are harvested after July, the number of this species will dramatically decrease in that area the following year. In Seokmo Island, we carried out reintroduction experiment by sowing S. europaea seeds. On the first year, a small number of S. europaea settled and they produced seeds successfully. On April 2010, the second year, we observed many S. europaea in seed sowing sites. And we found out that plowing is more efficient than treatment sea water for settlement of S. europaea.

• Korean Journal of Environmental Agriculture
• /
• v.42 no.1
• /
• pp.44-51
• /
• 2023

Nitrogen fertilizer is an essential macronutrient that requires repeated input for crop cultivation. Excessive use of nitrogen fertilizers can adversely affect the environment by discharging NH₃, NO, and N₂O into the air and leaching into surrounding water systems through rainfall runoff. Therefore, it is necessary to develop a technology that reduces the amount of nitrogen fertilizer used without compromising crop yields. Fertilizer deep placement could be a technology employed to increase the efficiency of nitrogen fertilizer use. In this study, a deep fertilization device that can be coupled to a tractor and used to inject fertilizer into the soil was developed. The deep fertilization device consisted of a tractor attachment part, fertilizer amount control and supply part, and an underground fertilizer input part. The fertilization depth was designed to be adjustable from the soil surface down to a depth of 40 cm in the soil. This device injected fertilizer at a speed of 2,000 m²/hr to a depth of 25 to 30 cm through an underground fertilizer injection pipe while being attached to and towed by a 62-horsepower agricultural tractor. Furthermore, it had no difficulty in employing various fertilizers currently utilized in agricultural fields, and it operated well. It could also perform fertilization and plowing work, thereby further simplifying agricultural labor. In this study, a newly developed device was used to investigate the effects of deep fertilizer placement (FDP) compared to those with urea surface broadcasting, in terms of rice and soybean grain yields. FDP increased the number of rice grains, resulting in an average improvement of 9% in rice yields across three regions. It also increased the number of soybean pods, resulting in an average increase of 23% in soybean yields across the three regions. The results of this study suggest that the newly developed deep fertilization device can efficiently and rapidly inject fertilizer into the soil at depths of 25 to 30 cm. This fertilizer deep placement strategy will be an effective fertilizer application method used to increase rice and soybean yields, in addition to reducing nitrogen fertilizer use, under conventional rice and soybean cultivation conditions.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.13 no.1
• /
• pp.2162-2176
• /
• 1971

From the ancient times our forefathers settled down in this peninsular and cultivated the hills and waste-lands into fields. Instead of fertilizing the lands they moved to find other fertile lands and lived a feudal life of agriculture and various machines played a main role in the land reclamation. The best method of land clearing, the time and efficiency in the operation and the effect of growing crops should sysematically analized prior to the time of 3rd Five-year Economic Development(1972-1976) in order to cultivated 210,000 ha of waste-land or the modernization of our country. The present study was investigated to find out a new working-system of mechanical land clearing and development of fertile soil. The results are as follows: 1) The land reclamation in natural slope is much more encourageable in land clearing and farming when the slope is below ten grades than bench terrace. 2) Weeds were mixed with soil in the land clearing work in order to supply organic materials and to make soil swollen instead of burning of just removing. 3) The equipments such as bulldozers, harrows, power tillers and so on should be prepared in order to do a systematic work in the land clearing. 4) The work of pulling-up roots is dependent upon the forms of roots spreading under the ground. The work of the pulling-up the straight roots was most difficult. 5) The land clearing work of the wrinkled style blocks was easy in pulling up roots and in the time of first plowing. The harrowing work could also be simply done. 6) The amount of soil carried was $240m^3/10a$, 15.6% increased amount from the standard block, while the required time of clearing work was 2 hours 15 minutes 45 seconds/10a, the one third of time required for the standard block. 7) The time disc harrowing work increased 50%, or 15 minutes/10a compared to the harrowing work required in the cultivated soil. 8) The time of rotary tilling increased 2.4 times or 1 hour 47 minutes 43 seconds/10a compared to the time required in the cultivated soil. 9) The reclamed land should be fertilized according to the soil quality, especially added fertilizer should be more than 1,200kg/10a, limes 20kg/10a. In order to produce added fertilizer grass fields should be needed. 10) The experiment of pasture growing is now progressing and therefore the effect of land clearing and the degree of developed soil will be investigated before long.