• Journal of Drive and Control
• /
• v.17 no.4
• /
• pp.125-132
• /
• 2020

The objective of this study was to analyze the axle load of a rice transplanter when planting rice seedlings at different working load conditions to select a suitable gear stage and a constant planting depth for rice seedlings. In this study, there are four levels of planting distances (26, 35, 43, and 80 cm) and three planting depths (low, medium, and high) with two gear stages (1.3 and 1.7 m/s). Axle loads and required planting pressures were analyzed statistically. It was observed that axle torques were increased with increasing planting depths for both gear stages, meaning that axle torques were directly proportional to planting depths for both gear stages. It was also observed that required planting pressures had a significant difference between planting distances. Planting pressures also showed significant difference according to gear stage and planting depth. These results indicate that planting pressures were directly proportional to both gear stage and planting depth. Results revealed that the automatic depth control system of a rice transplanter could not guarantee a constant planting depth as supplied pressures were variable. This indicates that a control algorithm is needed to ensure a constant planting depth. In the future, a control algorithm will be developed for an automatic depth control system of a rice transplanter to improve its comprehensive performance and efficiency.

• Journal of Biosystems Engineering
• /
• v.41 no.4
• /
• pp.313-318
• /
• 2016

Purpose: This study measured and analyzed the PTO (power take off) torque of a transplanter according to the planting conditions during field operation. Methods: A torque measurement system was constructed with torque sensors to measure the torque of a PTO shaft, a measurement device to acquire sensor signals, and a power controller to provide power for a laptop computer. The field operation was conducted at four planting distances (26, 35, 43, and 80 cm) and two planting depths using the transplanter on a field with similar soil conditions. One-way ANOVA with planting distance and Duncan's multiple range test at a significance level of 0.05 were used to analyze the PTO torque. The torque ratio was calculated based on the minimum torque using the average PTO torque measured under each planting condition. Results: The average torques on the PTO shaft for planting distances of 26, 35, 43, and 80 cm at a low planting depth were 11.05, 9.07, 7.04, and 3.75 Nm, respectively; the same for planting distances of 26, 35, 43, and 80 cm at a middle planting depth were 12.20, 9.86, 7.94, and 4.32 Nm, respectively. When the planting distance decreased by 43, 35, and 26 cm, the torque ratio at a low planting depth increased by 88, 142, and 195%, respectively. When the planting distance decreased by 43, 35, and 26 cm, the torque ratio at the middle planting depth increased by 84, 128, and 182%, respectively. Conclusions: PTO torque fluctuated by planting distance and depth. Moreover, the PTO torque increased for short planting distances. Therefore, farmers should determine the planting conditions of the transplanter by considering the load and durability of the machine. The results of this study provide useful information pertaining to the optimum PTO design of the transplanter considering the field load.

• Journal of Bio-Environment Control
• /
• v.14 no.1
• /
• pp.46-51
• /
• 2005

This experiment was conducted to investigate planting depth, which applied the basic data for planting growth ability and mechanical planting of oriental melon. 'Gumssaragi-eunchun' variety was approach grafting to 'Shintozoa' and seedling was growing during 45 days in the 9cm pot and then planted on Jan. 16. The comparison of planting plots was carried out for four experimental plots, which were separated into 0cm, 4.5cm, 9cm, standard cultivation, and 12cm planting depth in soil. In the tunnel of vinyl house, the lowest and the highest temperature was $9.3^{\circ}C\;and\;41.2^{\circ}C$, respectively, and humidity was $59\~99\%$ during Jan. 18 and 19. The faster graft-take rate after planting was the deeper planting depth. The growth of 40 days after planting was not significant in each planting plot, except 0cm experimental plot. Fruit weight was the heaviest in 4.5cm planting depth of experimental plot but sugar content and flesh thickness were not significant in each planting depth. The more depth in planting meant the more increase in fermented fruit rate and decrease in marketable fruit rate. Marketable yield was 2,361kg per l0a in 9cm planting plot, which was $2\%\;and\;1\%$ lower than in 0cm and 4.5cm, respectively, and $11\%$ greater than in 12cm planting plot.

• Current Research on Agriculture and Life Sciences
• /
• v.21
• /
• pp.31-37
• /
• 2003

The study aimed to identify leaf sheath through the investigation a characteristic of leaf by planting depth and leaf sheath function through the investigation of effect of leaf sheath removals on growth and flowering in forcing of Lilium cultivars. The number of leaf sheath of 'Jolanda', 'Dream Land', 'Casablanca' were 6, 5, 11 in 0cm planting depth and 6, 5, 14 in 6cm planting depth. The number of leaf sheath in 'Jolanda' and 'Dream Land' were little different in according to planting depth. The other hand, the number of leaf sheath in 'Casablanca' were increased 3 when it were planted in 6cm planting depth. As leaf sheath were removed, plant height and stem root growth were decreased in 'Le Reve' and 'Casablanca'. Whereas the growth of basal root and flower number varied among of Lillium and stem diameter, the days of flowering and flower size were little different.

• Journal of Bio-Environment Control
• /
• v.19 no.3
• /
• pp.153-158
• /
• 2010

To obtain the basic information for late-cultivation of sweet potato [Ipomoea hatalas (L.) Lam. cv. 'Jinhongmi'], vine growth and storage root yield were investigated in variously cutting sizes (10, 20, and 30 cm) and planting depths (1~4 nodes in 30 cm vine) using black-film vinyl mulching cultivation ($75{\times}25\;cm$ planting density, June 20). At 30 days after planting, main vine length, number of node, and vine fresh weight were significantly affected by the cutting length, and these were significantly different 10 and 30 cm at 120 days. The vine elongation affected by planting depths showed the best growth in 2-nodes planting depth and the lowest growth in 4-nodes planting depth at 30 days, but the vine growth was not significantly different among planting depths at 120 days. Number of storage root per plant, weight of storage root per plant, mean weight of storage root and yield of storage root were increased in longer cutting length, and those in 10 cm cutting length were significantly reduced compared to the 20 and 30 cm cutting length. Number of storage root per plant in the deeper planting was much increased, but mean weight of storage root was much decreased. Yield of storage root per 10a was highest in 3-nodes planting depth. Therefore, planting methods by cutting length over 20 cm and planting depth of 2~3 nodes in late-cultivation of sweet potato will be more efficient to improve the vine growth and storage root yield.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.34 no.1
• /
• pp.81-85
• /
• 1989

One of the most important cultural techniques of pearl millet (Pennisetum americanum (L.) Leeke) is to encourage rapid and uniform emergence of seedlings to establish good stand and to let them grow well. Thus the objectives of the study were to investigate the effects of pre-sowing seed soaking and planting depth on dormancy breaking, germination and emergence of the seedlings, and to estimate the optimum planting season of pearl millet in Suwon, Korea. The seeds with dormancy germinated 99 to 100 percent when soaked in the H$_2$O$_2$ 1％ solution for 24 hours and rinsed with pure water, but germinated only 38％ and 83％ when soaked in pure water for 24 hours just after harvest and drying, and one month later from the harvest time, respectively. The seeds of Australia inbred line did not germinate at the constant 10$^{\circ}C$, but germinated at the constant 11$^{\circ}C$. It also was possible to estimate the optimum planting season by applying minimum temperature 11$^{\circ}C$ for germination. The minimum air temperature reached from late April in Suwon, Korea in regular years but fluctuated from late April to early May in 1986 and 1987. Thus, the safe planting season was mid-May for rapid and uniform germination of pearl millet seed. The optimum depth of planting was 2∼4cm under the optimum soil moisture condition, and 4 to 6 cm under the drier soil moisture condition. Subcoleoptile internode(mesocotyle) length increased according to increased depth of planting. Seedling crown placement also became deeper due to deeper planting of the seeds. The subcoleoptile internode length and seedling crown depth were positively correlated with actual planting depth, indicating that deeper planting would be not good for appropriate adventitious root and tiller development.

• Korean Journal of Medicinal Crop Science
• /
• v.3 no.1
• /
• pp.12-15
• /
• 1995

This experiment was carried out to elucidate the effect of planting depth on the Quality and yield in Rehmannia glutinosa. Planting depths were 3,6,9 and 12cm, and planted on April 18. Emergence rate was decreased in the order of 86% in 3cm, 67% in 6cm, 37% in 9cm and 21% in 12cm. Leaf length was longer about $0.3{\sim}0.8cm$ in planting depth 6-12cm than that of 15.6cm in planting depth 3cm. Yield of Rehmannia glutinosa were lower 5% in planting depth 6cm, 62% in 9cm and 68% in 12cm than that of l,154kg/10a in planting depth 3cm. And optimum planting depth was considered 6cm.

• Land and Housing Review
• /
• v.6 no.4
• /
• pp.221-229
• /
• 2015

Large trees in the apartment complex are playing an important role to decide the quality of external environment. They are planted with the object of utilizing themselves as a landmark of the complex and enhancing space symbolism. Since planting large trees would require high maintenance costs and generate defect, it would cause decline in quality of external environment. This study researches on large trees in artificial ground of the apartment complex. This study analyzes actual condition of planting and tries to provide improvement direction of planting. In order to conduct this research, three target areas (over R30) and 265 trees are selected. Based on the drawings and specifications this study researches on the plan of landscape design, changes of field design, actual condition of completion, present condition of planting, minimum soil depth of growth and development and types of extra action for soil depth. The result shows that 85% of drawings and specifications for large trees in the apartment complex are deep-rooted tree species. On average large trees with R 35 are planted in artificial ground and there is lack of on average 65cm minimum soil depth of growth and development. Reviewing changes of field design is conducted in such limited size as mainly R30 and R40 and there is no extra plan for lack of soil depth. The plan for securing additional soil depth is done by 85% of mounding. However, since there is only 10% of satisfaction, the inappropriateness in securing additional soil is pointed out. This research also points out that the size of large trees, root characteristics and location-allocation for planting are pivotal factors for securing minimum soil depth of growth and development. This research also provides improvement direction in case of planning planting.

• KIEAE Journal
• /
• v.13 no.3
• /
• pp.105-110
• /
• 2013

Green roof system is classified as intensive greening, extensive greening or mix of intensive-extensive greening. Recently, light-weigh green roof has been performed actively, because buildings have been considered loads, design and maintenance. This study was conducted to design soil depth for light-vegetation block with using bottom-ash. As a result, it was found that growth of plant had no direct effect on soil depth even it was less than 10cm. Soil depth having under 5cm could be integration of plant roots and vegetation blocks. It was also possible to grow organic vegetables through the experiment of planting. According to this experiment, as light-vegetation block with bottom-ash was used for planting, it makes design shallow soil depth. The results will help install green roof system conveniently not only new buildings but also used buildings.

• Journal of the Korean Society of Tobacco Science
• /
• v.19 no.1
• /
• pp.18-23
• /
• 1997

The study was carried out to clarify reasonable production of healthy seedling, optimal Pot depth, and appropriate transplanting time, which can be deduced from understanding of seedling quality. Seedling quality results from growth of root and shoot, morphology and distribution of root system under influence of Pot depth during seedling growing period. Stem height, shoot dry weight, leaf area and leaf number were increased in proportion to depth of pots. Growth of shoot and root during seedling growing period showed the most dramatic development between 20th and 25th day after temporary planting. Root number increased as pot depth decrease and total root length and dry weight increased as pot depth increase. In 5cm pot, relative multiplication rate was higher and mean extension rate was lower than other depth of Pot. The limitation of pot volume in which rhizosphere was located enhance the development of roots of second and third order. At 20th days after temporary Planting root distribution was relatively uniform in length and development of adventitious root on stem base was poor as Pot depth decreased.