• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.131-131
• /
• 2010

We compared the electrical, optical, structural, and interface properties of indium zinc oxide (IZO)-Ag-IZO and IZO-Au-IZO multilayer electrodes deposited by linear facing target sputtering system at room temperature for organic photovoltaics. The IZO-Ag-IZO and IZO-Au-IZO multilayer electrodes show a significant reduction in their sheet resistance (4.15 and 5.49 Ohm/square) and resistivity ($3.9{\times}10^{-5}$ and $5.5{\times}10^{-5}$Ohm-cm) with increasing thickness of the Ag and Au layers, respectively. In spite of its similar electrical properties, the optical transmittance of the IZO-Ag-IZO electrode is much higher than that of the IZO-Au-IZO electrode, due to the more effective antireflection effect of Ag than Au in the visible region. In addition, the Auger electron spectroscopy depth profile results for the IZO/Ag/IZO and IZO/Au/IZO multilayer electrodes showed no interfacial reaction between the IZO layer and Ag or Au layer, due to the low preparation temperature. To investigate in detail the Ag and Au structures on the bottom IZO electrode with increasing thickness, a synchrotron x-ray scattering examination was employed. Moreover, the OSC fabricated on the IZO-Ag-IZO electrode shows a higher power conversion efficiency (3.05%) than the OSC prepared on the IZO-Au-IZO electrode (2.66%), due to its high optical transmittance in the wavelength range of 400-600 nm, which is the absorption wavelength of the P3HT:PCBM active layer.

• Journal of the Korean Society for Geothermal and Hydrothermal Energy
• /
• v.19 no.1
• /
• pp.1-13
• /
• 2023

Many government in the world have conducted building energy performance certification program to reduce building energy consumption. In this study, a reference building and its HVAC system was modeled, and the energy load and consumption were estimated by the ECO2 program. The software is a simple building energy simulation program based on monthly calculated method. The building energy efficiency rating the the reference building was 1+ under baseline condition. The simulation results showed that the insulation performance slightly affected building energy load and consumption, but light density had a significant effect on them. The application of geothermal heat pumps gave improvement of building energy efficiency rating but it could not make it possible to get zero energy building(ZEB) certification. The ZEB 5 certification could be achieved by using photovoltaics, however getting better grade was difficult. The simulation results showed that the ZEB 4 certification, one grade higher than ZEB 5, could be attained by using more than one renewable energy source such as geothermal and solar energy in this study.

• 한국신재생에너지학회:학술대회논문집
• /
• 2005.06a
• /
• pp.142-146
• /
• 2005

Standards are increasing of importance for photovoltaics. The rapid growth of production is one reason for this but standards are equally important in ensuring the quality and reliability of installed PV systems. which have a propound impact on acceptance of the technology in the expanding marketplace. Korea government (Korean Agency for Technology and Standards. KATS)make and implement a five year plans for promotion of international standardization of this field from 2004. Through these works and harmonization of PV Korea standards with international standards(international electrotechnical commission. IEC). KATS leads the technology innovations and eventually increases the international Competitiveness. Strategic collaboration with other countries is also strengthened through Korea's participation in IECEE(IEC system for conformity and certification of electrical equipment) on standards and conformity assessment. One of the major goals of the Plan is to facilitate trade between Korea and its trading partners by emphasizing harmonization of its national conformity assessment system with international norms

• The Journal of Information Technology
• /
• v.12 no.4
• /
• pp.19-24
• /
• 2009

Recently, for the efforts of low-carbon deduction and to solve the problems of global warming, many industrial nations in world have been strengthening positively their competitive power into the research, development and industrialization of new renewable sources of energy and clean energy. In the most promising source of photovoltaic, it is essential that the government take an initiative role to develop and industrialize the materials, ingot or wafer, solar cell, power conditioning system and photovoltaic system, and need to establish both short-term and long-term technical development of goal setting and forward plan in the direction of the technical development strategy and forward industrialization for the strengthening of world market. This paper analyze new technology, policies and the market trend of photovoltaic field which are currently strategically and actively enhancing the research, development and practical-industralization by Korea and other nations.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.3
• /
• pp.538-543
• /
• 2011

In this paper, design and control of an interleaved boost converter for multi-string PV Inverter are discussed. Interleaved Boost converter can reduce current ripples at input and output side by cancelling an each phase of inductor currents. Therefore, it contributes to increase efficiency and downsize the whole system volume, cost. One of the advantages of the multi-string system is easy to expand power capacity by connecting the converter modules in parallel. In order to reduce current ripples, the inductor currents on each phase are controlled independently in the converter module, and communication between the converter modules is required for further ripple current reduction. Current control algorithm for the balance of the each phase ripple currents and synchronization of the converter modules based on communication are proposed and implemented in the DSP programming. 10kW prototype of the multi-string converter module is assembled and experimental results are presented to verify the proposed ripple current reduction methods.

• KIEAE Journal
• /
• v.17 no.1
• /
• pp.15-21
• /
• 2017

Purpose: This study was on the economic feasibility of BIPV system, focused on comparison with construction cost of BAPV system depend on roof finishing materials, and to suggest basic data on the construction cost. Method: Construction cost of BAPV system was calculated, by selecting asphalt single, flat type roof tile, color steel plate, titanium zinc plate as roof finishing material of residential building and by sum up each cost for roof finishing construction and cost for 3kWp-volumed PV module installation. Also, the economic feasibility was analysed quantitatively by comparing the cost for BIPV system construction, installing same volumed PV module instead of roof finishing materials. Result: 1. By installing BIPV system instead of the roof finishing material, the cost of construction falls ; about 19% in case of the titanium zinc plate, which is the most expensive, and about 11% in case of the color steel plate. 2. Reducing amount of the construction cost gets larger because of installing BIPV module instead of the roof finishing material, as the construction cost for roof finishing material gets higher ; therefore, it is more economical than BAPV system in terms of whole cost of construction.

• International Journal of Computer Science & Network Security
• /
• v.23 no.6
• /
• pp.49-58
• /
• 2023

Renewable energy is not a new terminology. One of the fastest growing renewable energies is solar energy. The implementation of solar energy provides several advantages including the reduction of some of the environmental risks of fossil fuel consumption. This research elaborated the importance of the adaption of solar energy by developing a spatial decision support system (SDSS), while the Residential Solar Energy Adoption (RSEA) is an instantiation artifact in the form of an SDSS. As a GIS web-based application, RSEA allows stakeholders (e.g., utility companies, policymakers, service providers homeowners, and researchers) to navigate through locations on a map interactively. The maps highlight locations with high and low solar energy adoption potential that enables decision-makers (e.g., policymakers, solar firms, utility companies, and nonprofit organizations) to make decisions. A combined qualitative and quantitative methodological approach was used to evaluate the application's usability and user experience, and results affirmed the ability of the factors of utility, usefulness, and a positive user experience of the residential solar energy adoption of spatial decision support system (RSEA-SDSS). RSEA-SDSS in improving the decision-making process for potential various stakeholders, in utility, solar installations, policy making, and non-profit renewable energy domains.

• Membrane and Water Treatment
• /
• v.2 no.4
• /
• pp.239-250
• /
• 2011

A photovoltaic powered ultrafiltration and reverse osmosis system was tested with a number of natural groundwaters in Australia. The objective of this study was to compare system performance at six remote field locations by assessing the impact of water composition and fluctuating energy on inorganic contaminant removal using a BW30-4040 membrane. Solar irradiance directly affected pressure and flow. Groundwater characteristics (including TDS, salts, heavy metals, and pH), impacted other performance parameters such as retention, specific energy consumption and flux. During continual system operation, retention of ions such as $Ca^{2+}$ and $Mg^{2+}$ was high (> 95%) with each groundwater which can be attributed to steric exclusion. The retention of smaller ions such as $NO_3{^-}$ was affected by weather conditions and groundwater composition, as convection/diffusion dominate retention. When solar irradiance was insufficient or fluctuations too great for system operation, performance deteriorated and retention dropped significantly (< 30% at Ti Tree). Groundwater pH affected flux and retention of smaller ions ($NO_3{^-}$ and $F^-$) because charge repulsion increases with pH. The results highlight variations in system performance (ion retention, flux, specific energy consumption) with real solar irradiance, groundwater composition, and pH conditions.

• Journal of the Korean Solar Energy Society
• /
• v.30 no.2
• /
• pp.1-9
• /
• 2010

This study has intended to analyze citizen's recognition on Photovoltaic (PV) System Supply Policy in Korea. To reach this goal, this study has employed a survey method and statistical analysis. We have asked 140 citizens knowing the policy to some degree to answer questionnaires including various contents related to PV supply policy driven by central government of Korea. The contents of questionnaires consist of three parts: 1) supply policies, 2) PV system and 3) expected effect from the policy. To verify any differences among the characteristics of respondents, ANOVA (Analysis of Variance) was carried out in 95% confidence level. This study has found the following results: 1) most citizens were positive about the 'Photovoltaic System Supply Policies'; 2) most citizens anticipated the policy would be helpful to cope with the environmental problems and energy crisis and 3) there exit subtle differences between residents according to the respondent's characteristics such as sex, age, occupation, and housing type.

• 한국태양에너지학회:학술대회논문집
• /
• 2008.04a
• /
• pp.86-91
• /
• 2008

Amid the booming research on new and renewable energy, the photovoltaic(PV) industry has been growing around the PV advanced countries such as Japan, Germany, Europe and USA. In recent years, China became a strong performer in the world PV market share, increasing solar cell production rapidly. Both world solar cell and module production and installation rose steadily in 2007 like recent bumper years. In 2007, the PV industry produced 4.28GW and the installations reached a record high of 2.83GW, representing growth of 60percent over the previous year.