• Food Science and Biotechnology
• /
• v.18 no.2
• /
• pp.565-569
• /
• 2009

This study was conducted to evaluate the effects of different preparation methods on the recovery and quantification of ginsenosides in raw Korean ginseng (Panax ginseng C.A. Meyer). Eight major ginsenosides ($Rb_1$, $Rb_2$, $Rb_3$, Rc, Rd, Re, Rf, and $Rg_1$) were analyzed by high performance liquid chromatography (HPLC), after which the recovery and repeatability of the extraction of those ginsenosides using 3 different preparation methods were compared [A. direct extraction (DE) method, hot MeOH extraction/evaporation/direct dissolution; B. solid phase extraction (SPE) method, hot MeOH extraction/evaporation/dissolution/$C_{18}$ cartridge adsorption/MeOH elution; C. liquid-liquid extraction (LLE) method, hot MeOH extraction/evaporation/dissolution/n-BuOH fractionation]. Use of the DE method resulted in a significantly higher recovery of total ginsenosides than other methods and a relatively clear peak resolution. Use of the SPE and LLE methods resulted in clearer peak resolution, but lower ginsenoside recovery than the DE method. The LLE method showed the lowest ginsenoside recovery and repeatability among the 3 methods. Given that the DE method employed only extraction, evaporation, and a dissolution step (avoiding complicate and time consuming purification), this technique may be an effective method for the preparation and quantification of ginsenosides from raw Korean ginseng.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.1
• /
• pp.35-42
• /
• 2009

Headspace micro solid phase extraction using mulberry paper bag (HS-MPB-$\mu$-SPE) has been developed and validated for the analysis of volatile flavor compounds from five spice by gas chromatography-mass spectrometry (GC/MS). HS-MPB-$\mu$-SPE was performed with adsorbent particles enclosed inside a mulberry paper bag. Four different kinds of adsorbents such as Tenax TA, Porapack Q, dimethylpolysiloxane and polyethylene glycol were tested. The extraction solvents compared were petroleum ether, methylene chloride, and chloroform. Better results were obtained when Tenax TA and petroleum ether were used. The limit of detection (LOD) and the limit of quantitation (LOQ) were in the range of 1.3 ng/mL and 4.3 ng/mL, respectively, for o-cymene as a model compound of monoterpene. Proposed method showed good reproducibility (3.3%, RSD) and good recoveries (94.0%). The HS-MPB- μ-SPE is very simple to use, inexpensive, rapid, requires small sample amounts and solvent consumption. Because the solvent for extraction is reduced to only a very small volume (0.6 mL), there is minimal waste or exposure to toxic organic solvent and no further concentration step. This method allows successful characterization of the headspace in contact with the five spice sample. Strong trans-anethole from star anise or fennel is a characteristic flavor of five spice powders. HS-MPB-$\mu$-SPE combined with GC/MS can be a promising technique for the broad spectrum measurement of volatile aroma compounds from solid spices.

• Bulletin of the Korean Chemical Society
• /
• v.25 no.8
• /
• pp.1133-1136
• /
• 2004

The need for highly reliable methods for the determination of trace metals is recognized in analytical chemistry and environmental science. A method based on the cloud-point extraction (CPE) technique for the trace analysis of Pb and Cu in water samples is described in this study. The analytes in the initial aqueous solution are complexed with pyrogallol, and 0.1%(w/v) Triton X-114 is added as surfactant. Following phase separation at $50^{\circ}C$, based on the cloud point of the mixture and dilution of the surfactant-rich phase with acidified methanolic solution, the enriched analytes are determined by flame atomic absorption spectrometry. After optimization of the complexation and extraction conditions, the enrichment factors of Pb and Cu were found to be 72 and 85, respectively. Under optimum conditions, the preconcentration of 60 mL of samples in the presence of 0.1%(w/v) Triton X-114 permitted the detection of 0.4 ${\mu}gL^{?1}$ of Pb and 0.05 ${\mu}gL^{?1}$ of Cu. The proposed method was applied successfully to the determination of Pb and Cu in water samples.

• Current Optics and Photonics
• /
• v.7 no.4
• /
• pp.387-397
• /
• 2023

Tooth surface shape error is an important parameter in gear accuracy evaluation. When tooth surface shape error is measured by laser interferometry, the gear interferogram is highly distorted and the gray level distribution is not uniform. Therefore, it is important for gear interferometry to extract the foreground region from the gear interference fringe image directly and accurately. This paper presents an approach for foreground extraction in gear interference images by leveraging the sinusoidal variation characteristics shown by the interference fringes. A gray level mask with an adaptive threshold is established to capture the relevant features, while a local variance evaluation function is employed to analyze the fluctuation state of the interference image and derive a repair mask. By combining these masks, the foreground region is directly extracted. Comparative evaluations using qualitative and quantitative assessment methods are performed to compare the proposed algorithm with both reference results and traditional approaches. The experimental findings reveal a remarkable degree of matching between the algorithm and the reference results. As a result, this method shows great potential for widespread application in the foreground extraction of gear interference images.

• Proceedings of the Optical Society of Korea Conference
• /
• 1997.08a
• /
• pp.82-82
• /
• 1997

• Journal of the Korean Chemical Society
• /
• v.37 no.6
• /
• pp.590-598
• /
• 1993

The simultaneous analysis of samples, 16 organic pesticides in water among 129 priority pollutants listed by EPA, was performed by GC-ECD (electron capture detector) and GC/MS-SIM (selected ion monitoring). Two extraction procedures, liquid-liquid extraction (LLE) and solid-phase extraction (SPE), were studied as an extraction and concentration method. Accuracy and precision of the methods were measured by the calculation of mean recovery and mean relative standard deviation. Finally, the detection limits, the experimental limitations, and prospects were discussed.

• Korean Journal of Materials Research
• /
• v.34 no.5
• /
• pp.247-253
• /
• 2024

The separation of zirconium and hafnium using tributyl phosphate (TBP)-Dodecane extractants in nitric acid medium was performed. Zirconium oxychloride, used as extraction feed, was obtained from the synthesis of Kalimantan zircon sand concentrate smelted using NaOH. The extraction process was carried out by dissolving chloride-based metals in nitric acid media in the presence of sodium nitrate using TBP-Dodecane as an extractant. Some of the extraction parameters carried out in this study include variations in organic phase and aqueous phase (O/A), variations in contact time, and variations in nitric acid concentration. Extraction was carried out using a mechanical shaker according to the parameter conditions. X-ray fluorescence (XRF) was used for elemental (Zr and Hf) composition analysis of the aqueous solution. The results showed that zirconium was separated from hafnium at optimum conditions with an organic/aqueous ratio of 1:5, contact time of 75 min, and an HNO₃ concentration of 7 M. The resulting separation factor of zirconium and hafnium using TBP-Dodecane was 14.4887.

• YAKHAK HOEJI
• /
• v.56 no.3
• /
• pp.145-151
• /
• 2012

To develop fundamental data of herbal materials with heat treatment, we studied analytical and extraction methods of benzopyrene in black ginseng and validated by HPLC analysis. Benzopyrene was successfully separated in mobile phase of acetonitrile:water (80 : 20) and detection of excitation 294 nm, emission 404 nm. The calibration curve of benzopyrene was linear over the concentration range of 1.17~37.50 ng/ml with correlation coefficient of above 0.999. The limit of detection (LOD) and quantitation (LOQ) of benzopyrene was 0.25 and 0.75 ng/ml, respectively. Hexane extraction method was used as a new extraction method for benzopyren and the efficient of extraction was over 95%. In conclusion, analytical method and extraction method were suitable for the determination of benzopyrene in the black ginseng and could be applied to fundamental study and guideline of herbal materials with heat treatment.

• Natural Product Sciences
• /
• v.19 no.3
• /
• pp.236-241
• /
• 2013

A high-performance liquid chromatography-diode array detector (HPLC-DAD) method was established for quantitative evaluation of nine constituents of Fraxinus rhynchophylla such as four coumarins, esculin (1), fraxin (2), esculetin (3), fraxetin (4), three lignans, syringaresinol 4,4'-O-${\beta}$-diglucoside (5), pinoresinol 4-O-${\beta}$-glucoside (6), pinoresinol (9), one secoiridoid, oleuropein (7), and one coumarinolignan, cleomiscosin C (8). The preferred chromatographic condition was obtained on Phenomenex Gemini-NX (3 ${\mu}m$, C18 110A, $150{\times}4.60$ mm) and the mobile phase was composed of water and acetonitrile using a gradient elution. The wavelength was set at 220 nm. Extraction condition of these constituents in F. rhynchophylla was also optimized through extraction time, extraction solvent and extraction method using established method. From this study, extraction at $70^{\circ}C$ with the mixture of ethanol and water for more than 12 h was suggested to be good extraction condition for these constituents. Quantitation of nine constituents in different F. rhynchophylla samples was also successfully accomplished with the newly established method.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.9 no.3
• /
• pp.213-221
• /
• 2004

In recent years, since more and more diode rectifiers with smoothing dc capacitor are used in electronic equipments, household appliances and ac drives, harmonics generated by these loads have become a major issue. In addition, 3-phase 4-wire system is widely employed in distributing electric energy to several office building and manufacturing plants. This systems show excessive currents in the neutral. These neutral currents are fundamentally third harmonic, and their presence is tied to wiring failure, elevating of neutral potentials, transformer overheating, etc. In response to the concerns, this paper proposes a series active power filter scheme based on direct compensating voltage extraction method and the advantage of this control algorithm is direct extraction of compensation voltage reference without multiplying gain. Therefore, the calculation of the compensation voltage reference will becom much simpler than other control algorithm. To verify the effectiveness of the proposed algorithm, a prototype active power filter is built and some experiments are carried out.