• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.5
• /
• pp.82-87
• /
• 2008

This paper presents a new fast locking dual-slope phase-locked loop. The conventional dual-slope phase-locked loop consists of two charge pumps and two phase-frequency detectors. In this paper, the dual-slope phase-locked loop was achieved with a charge pump and a phase-frequency detector as adjusting a current of the charge pump according to the phase difference. The proposed circuit was verified by HSPICE simulation with a $0.35{\mu}m$ CMOS standard process parameter. The phase locking time of the proposed dual-slope phase-locked loop was $2.2{\mu}s$ and that of the single-slope phase-locke loop was $7{\mu}s$.

• Korean Journal of Applied Biomechanics
• /
• v.26 no.2
• /
• pp.161-166
• /
• 2016

Objective: The purpose of this study was to determine the knee and ankle joint kinematics and kinetics by comparing downhill walking with valley-shape combined slope walking. Method: Eighteen healthy men participated in this study. A three-dimensional motion capture system equipped with eight infrared cameras and a synchronized force plate, which was embedded in the sloped walkway, was used. Obtained kinematic and kinetic parameters were compared using paired two-tailed Student's t-tests at a significance level of 0.05. Results: The knee flexion angle after the mid-stance phase, the mean peak knee flexion angle in the early swing phase, and the ankle mean peak dorsiflexion angle were greater during downhill walking compared with valley-shape combined slope walking (p < 0.001). Both the mean peak vertical ground reaction force (GRF) in the early stance phase and late stance phase during downhill walking were smaller than those values during valley-shape combined slope walking. (p = 0.007 and p < 0.001, respectively). The mean peak anterior GRF, appearing right after toe-off during downhill walking, was also smaller than that of valley-shape combined slope walking (p = 0.002). The mean peak knee extension moment and ankle plantar flexion moment in late stance phase during downhill walking were significantly smaller than those of valley-shape combined slope walking (p = 0.002 and p = 0.015, respectively). Conclusion: These results suggest that gait strategy was modified during valley-shape combined slope walking when compared with continuous downhill walking in order to gain the propulsion for lifting the body up the incline for foot clearance.

• Journal of electromagnetic engineering and science
• /
• v.12 no.4
• /
• pp.280-286
• /
• 2012

The conventionally classified waves are reclassified in this paper, including the waves associated with metamaterial (MTM) transmission lines. Various types of guided waves in periodic structures are analyzed for 1D Composite Right/Left Handed (CRLH) transmission lines (TL). In addition, dispersion diagrams for 1D CRLH, RH, and LH TLs are presented in terms of radiation conditions. We have refined the design equations of the conventional 1D CRLH TL and proposed a condition to realize the desired phase shift and its slope per unit cell. This condition has been applied to the conventional Wilkinson power divider and realized into MTM added $90^{\circ}$ hybrid coupler. Based on the 10 dB return loss and the $90{\pm}10^{\circ}$ phase shift, the bandwidths of the MTM added $90^{\circ}$ hybrid coupler are 82.25% and 103.5% against the conventional 23% and 52.5%, respectively.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2006.10a
• /
• pp.95-104
• /
• 2006

A floating-type wave power pump is a device which sends air into water by using wave power. The floating-type wave power pump has the new configuration composed of a curved surface reflection board, a slope, and phase plates. As a result of a water-tank experiment it turned out that the floating-type wave power pump with a curved surface reflection board and a slope raised power and efficiency in the wide wavelength waves. The result of a marine experiment was also preferable. The floating-type wave power pump sends air into the sea by using wave power, so it can be used for the improvement of marine environment. In addition, the floating body constituted of a curved surface reflection board, a slope, and phase plates, is effective as a device to utilize the energy of a wave. Therefore, it can be widely used for a wave power generation, pumping up deep seawater.

• Journal of Power Electronics
• /
• v.13 no.2
• /
• pp.264-274
• /
• 2013

A new sensorless position estimation method for switched reluctance motor (SRM) drives is presented in this paper. This method uses the change of the slope of the phase inductance to detect the aligned position. Since the aligned positions for successive electrical cycle of each phase are apart by a fixed mechanical angle $45^{\circ}$ in the case of 12/8 SRM, the speed of the machine can be calculated to estimate the rotor position. Since no prior knowledge of motor parameters is required, the method is easy for implementation without adding any additional hardware or memory. In order to verify the validity of this technique, effects such as changes in the advanced angle and phase lacking faults are examined. In addition, an inductance threshold based sensorless starting scheme is also proposed. Experimental results demonstrate the validity of the proposed method.

• The Journal of Engineering Geology
• /
• v.16 no.2 s.48
• /
• pp.135-143
• /
• 2006

This study presents the results of a series of laboratory scale slope failure experiments aimed at clarifying the process and the condition leading to the initiation of rainfall-induced slope failures. For the evaluation of hydrologic response of the model slopes in relation the process of failure initiation, measurements were focused on the changes in volumetric water content during the initiation process. The process leading to failure initiation commences by the development of a seepage face. It appears reasonable to conclude that slope failures are a consequence of the instability of seepage area formed at the slope surface during rainfall period. Therefore, this demonstrates the importance of monitoring the development seepage area for useful prediction about the timing of a particular failure event. The hydrologic response of soil slopes leading to failure initiation is characterized by three phases (phase I, II and III) of significant increase in volumetric water content in association with the ingress of wetting front and the rise of groundwater level within the slope. The period of phase III increase in volumetric water content can be used to initiate advance warning towards a failure initiation event. Therefore, for the concept outlined above, direct and continuous monitoring of the change in volumetric water content is likely to provide the possibility for the development of a reliable and effective means of predicting the occurrence of rainfall-induced slope failures.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.4 no.1
• /
• pp.83-92
• /
• 2001

In this paper, the monopulse channel receiver which can be matched between channels through a wide bandwidth has been proposed. The effects of the gain and phase imbalance between channels on the slope of monopulse error signal were analyzed. Also, the matching method between channels in a wide bandwidth was proposed, by which monopulse slope could be stabilized. Using the implemented monopulse radar system the monopulse slope was measured in the anechoic chamber which include the moving horn antenna and the target signal generator. The results show that the wide band matching method is useful and applicable to various channel receivers

• Journal of Advanced Navigation Technology
• /
• v.17 no.2
• /
• pp.208-217
• /
• 2013

The optimal residual dispersion per span (RDPS) slope is induced through the analyses of the compensation characteristics of the wavelength division multiplexed (WDM) channels depending on RDPS slope in the optical links with a dispersion management (DM) and an optical phase conjugation. The simulation results show that the effective launch power of WDM is more increased and the performance difference between the channels is more decreased as RDPS slope is more increased. The simulation results also show that the effective net residual dispersion (NRD) range is more increased as RDPS slope is more increased, and consequently, it is more advantageous to use the large RDPS slope for implementing the flexible optical links.

• Proceedings of the KIEE Conference
• /
• 2006.10c
• /
• pp.530-532
• /
• 2006

In this paper, we propose stable walking algorithm using ZMP for the biped robot in the slope-way. At first, we define discrete state variables that classified stable area and unstable area by center of mass from ZMP during slope-way walking. For the stable walking gait, the discrete state controller for determining the high-level and low-level decision making are designed. The high-level decision making is composed of the discrete state variables; left foot support phase, right foot support phase, flat-way, and slope-way. Then the continuous state controller is implemented for the low-level decision making using ZMP.

• Korean Journal of Optics and Photonics
• /
• v.15 no.6
• /
• pp.485-489
• /
• 2004

We demonstrated numerically that both the chromatic dispersion and the dispersion slope could be compensated by using purely phase-sampled superstructure fiber Bragg gratings provided with chirp of coupling coefficient along the wavelength axis. Also, we propose a purely phase-sampled Bragg grating for dispersion and dispersion slope compensation by introducing a chirp in coupling coefficient and sampling function. The bandwidth of all reflected channels can be equalized.