• 한국초전도학회:학술대회논문집
• /
• v.10
• /
• pp.41-44
• /
• 2000

The mixed-state Hall angle has been measured in Hg-based superconducting thin films as functions of magnetic fields (H) up to 18 T. The temperature dependence of the Hall angle shows a peak (T$^{\ast}$) at low temperature, which is consistent with a crossover point from the thermally activated flux flow (TAFF) to a critical region (CR). At low fields below 10 T, T$^{\ast}$ shifts to low temperature with increasing fields. Interestingly, however, we found that T$^{\ast}$ is independent of fields above 10 T, suggesting unusual vortex state. A physical implication of H - T$^{\ast}$ line will be discussed.

• Progress in Superconductivity
• /
• v.2 no.1
• /
• pp.39-42
• /
• 2000

The mixed-state Hall angle has been measured in Hg-based superconducting thin films as functions of magnetic fields (H) up to 18 T. The temperature dependence of the Hall angle shows a peak (T*) at low temperature, which is consistent with a crossover point from the thermally activated flux flow (TAFF) to a critical region (CR). At low fields below 10 T, T* shifts to low temperature with increasing fields. Interestingly, however, we found that T* is independent of fields above 10 T, suggesting unusual vortex state. A physical implication of H-T* line will be discussed.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.9 no.4
• /
• pp.424-431
• /
• 1999

The reproducibility of successive growth of $Bi_{12}TiO_{20}$ (BTO) single crystlas using a top-seeded solution growth (TSSG) pulling method was evalutated by measuring the lattice constants and their standard deviations. A substantial phase diagram in the region close to the stoichiometric BTO was established expermentally for this purpose, and the existence of a retrograde solid solution close to a BTO was clarified. It was emphasized that a starting solution, with a 10.0~10.1 mol% $TiO_{2}$ concentration, results in large single crystals with a highly homogeneous lattice constant of within ${\pm}1{\times}10^{-4}\AA$, when the solidified fraction of the grown crystal is less than about 45 %. A wavelength dispersion of refractive index was measrued for the first time, and it was verified that the refractive index of BTO is larger than that of BSO($Bi_{12}TiO_{20}$), allowing the voltage sensitivity of EOS higher than the case with BSO as a probe head.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2008.05a
• /
• pp.66-69
• /
• 2008

In this paper, The author present a load current feed-forward compensator by method that improve voltage controller of Step-down Chopper to get stable output voltage to sudden change of load current. To confirm the characteristicsof a presented load current feed -forward compensator compared each transfer function of whole system that load current feed-forward compensator is added with transfer function of whole system that existent voltage controller is included using Mason gains formula in Root locus and Bode diagram. As a result the pole of system is improved, extreme point of the wave and system improves, and size of peak value and phase margin of break frequency in resonance frequency confirmed that is good. Therefore, presented control technique could confirm that reduce influence by perturbation and improves stationary state and dynamic characteristics in output of Step-down Chopper.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.07a
• /
• pp.256-258
• /
• 2003

Two Si wafers are bonded with indium-silver alloy using diffusion bonding method. When silver and indium thin films are contacted, they diffuse into each other and form inter-metallic compounds like $AgIn_2$, $Ag_2In$, $Ag_3In$ etc. These compounds are determined by ratio of two metals. From phase diagram of Ag-In alloy, we can get the ratio of $Ag_2In$, that has high melting point about 700$^{\circ}C$, approximately 2:1. This ratio was made by controlling of film thickness. And bonding was executed by annealing and adding pressures at a time. The joint of these wafers had been observed by SEM. And we had also seen the EDS (Energy Dispersive Spectroscopy) data to analysis the component of samples.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2003.11a
• /
• pp.498-503
• /
• 2003

Dynamic analysis of a plate with non-linearity due to large deformation is performed in the study. There have been many researches about the non-linear dynamic behavior of plates examining by means of theoretical or numerical analyses. But it is important how exactly model the actual system. In this respect, the Continuous-Time system identification technique is used to generate non-linear models, for stiffness and damping terms, to explain the observed behaviors with single mode assumptions for the simplicity after comparing the experimental results with the numerical results of a linear plate model.

• Journal of the Korean Society for Precision Engineering
• /
• v.14 no.10
• /
• pp.127-134
• /
• 1997

열가소성 복합재료는 고상 성형법에 의해 저렴한 가격으로 부피가 튼 제품의 제조에 널리 사용될 수 있어 아주 좋은 전망을 가지고 있다. 그러나, 이러한 재료의 성형성에 대해선 아직 잘 알려지지 않았다. 본 연구의 첫번때 주안점은 2축 인장성형시 성형성에 대한 연구에 두었다. 실험에 사용된 재료는 임의의 방향으로 위치한 유리 섬유를 중량비로 20, 35, 40% 함유한 폴리프로필렌이다. 성형시험은 75 .deg. C 에서 150 .deg. C 사이의 온도에서 행했으며, 펀치 속도는 0.01cm/sec 와 1cm/sec 에서 행했다. 2축 인장성형에서 측정된 한계 변형률(Limiting Strain)은 Marciniak 불완전성 (Imperfection) 이론에 근거한 예견치외 비교되었다. 이론치와 실험치가 잘 일치함을 보였으며, 성형한계선도(Forming Limit Diagram) 로써 결과들을 요약하였다. 성형한계 변형률은 성형온도와 성형속도에 의해 크게 영향을 받는다는 것을 보인다. 이러한 결과들은 적절한 성형조건이 선택된다면 열가소성 복합재료의 인장성형은 실제 상업적으로 이용하기에 충분한 성형성을 갖는다는 것을 보인다.

• Progress in Superconductivity and Cryogenics
• /
• v.16 no.3
• /
• pp.1-3
• /
• 2014

We have synthesized La doped $CaFe_2As_2$ single crystals with Sn flux in an evacuated quartz ampule. Doping and pressure effects on the magnetic and superconducting properties of the under-doped $Ca_{1-x}La_xFe_2As_2$ (x=0.08, 0.1) were studied by measuring electrical resistivity under quasi-hydrostatic pressure up to 21 kbar. Magnetic transition temperatures for all studied concentrations were sharply suppressed with slight amplitude of pressure, less than 3 kbar, while superconducting transition temperatures were robust against pressure. In this communication, we report temperature-pressure phase diagram for the La-doped $CaFe_2As_2$ single crystals.

• Bulletin of the Society of Naval Architects of Korea
• /
• v.19 no.1
• /
• pp.15-22
• /
• 1982

The effects of the forebody geometry of ships on the response function of wave loads are investigated by numerical calculations based on a strip method. For the vertical wave loads both shearing forces and bending moments, the V-shaped bow gives greater responses than the U-shaped one in regular oblique waves. These results have been clarified by the vector diagram of all static and dynamic components contributing to the resultant wave bending moment. In the present evaluation the phase relation among the components plays an important role. And the effect of the forebody geometry on lateral wave loads seems to be negligible from the result of the present investigation.

• Journal of the Korean Applied Science and Technology
• /
• v.6 no.1
• /
• pp.59-66
• /
• 1989

Inclusion complex formation of octyldimethyl p-aminobenzoate with ${\beta}-cyclodextrin$in aqueous solution and in the solid state was studied by the solubility method, spectroscopic (UV, FT-IR) and X-ray diffractornetry. The solid complex of octyldimethyl p-aminobenzoate with ${\beta}-cyclodextrin$ was obtained in molar ratio of 1:2 (guest/host). A spatial relationship between host and guest molecule was clearly reflected in the magnitude of the apparent stability constant (K') and in the stoichiometry of the inclusion complex. Furthermore, a typical type Bs phase-solubility diagram was obtained for octyldimethyl p-aminobenzoate and ${\beta}-cyclodextrin$ in water at $25^{\circ}C$. The results indicated that the solubility of the guest molecule was higher by the formation of ${\beta}-cyclodextrin$ inclusion complex.