• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.8
• /
• pp.69-75
• /
• 1998

We demonstrate wavelength conversion of 2.5Gb/s optical signals by four-wave mixing (FWM) in a semiconductor optical amplifier (SOA). We investigate the effect of input pump and signal powers on the coversion efficiency, optical signal-to-noise ratio (OSNR) and extinction ratio to be a measure of performance in a wavelength converter. As a result, we show that the maximum bit error rate (BER) performance can be obtained by co promising among high-vonversion efficiency (minimum Pprobe), high-OSNR (maximum Pprobe) and low-cross-gain saturation effects (Pprobe kept at least 6dB weaker than Ppump). In our experiment, we obtain optimum performance at +3 dBm pump power and -6dBm signal power. The power penalty incurred in the wavelength conversion can be minimized by careful selection of the input pump and signal powers. We show that about 0.5dB power penalty for 3.2nm wavelength coversion at 10-10 BER is achievable.

• International Journal of Fluid Machinery and Systems
• /
• v.9 no.4
• /
• pp.300-306
• /
• 2016

A twin unidirectional impulse turbine for wave energy conversion has been suggested in our previous study, and the performance under unsteady flow has been investigated by quasi-steady analysis. In the present study, the performance of twin impulse turbine under unsteady flow condition has been investigated by unsteady analysis of Computational fluid dynamics. As a result, the mean efficiency of twin unidirectional impulse turbine under unsteady flow is lower than the maximum efficiency of unidirectional impulse turbine. Moreover, it is verified that airflow goes backward in the reverse turbine in low flow rates.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.22 no.3
• /
• pp.165-170
• /
• 2010

Experiments have been performed to investigate the key parameters determining the performance of thermoelectric power generation. The experimental results obtained show that the power output significantly increases with the temperature difference between cold and hot sides of thermoelectric generator. However, the effect of the hot side temperature under the identical temperature difference on the overall performance of a thermoelectric generator is meager. The conversion efficiency defined as the ratio of the power generated to the heat absorbed at the hot side increases with the temperature difference. The behavior of the thermoelectric generator is shown to be consistent with the theoretical analysis. The optimum current giving the maximum conversion efficiency and the maximum conversion efficiency are linearly increased with the temperature difference.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.4B
• /
• pp.394-402
• /
• 2009

In this paper, we present a new analytical model for estimating the blocking performance of multi-fiber WDM networt:s with sparse and limited wavelength conversion (SLWC). The proposed model is a reduced-load approximation model that can obtain accurate estimates of blocking probability of such networks. Our model employs three new recurrence formulae to obtain the free wavelength distribution on a multi-fiber link, the free wavelength distribution after limited-range wavelength conversion and the end-to-end blocking probability of a multi-hop path, respectively. From the numerical results on the NSFNET, we demonstrate that the blocking performance of two-fiber NSFNET with three wavelength-convertible nodes, each of which translates an input wavelength to its adjacent output wavelengths, closely approximates the blocking performance of full wavelength conversion.

• Transactions of the Korean hydrogen and new energy society
• /
• v.9 no.3
• /
• pp.93-100
• /
• 1998

The ortho-para $H_2$ catalytic conversion equipment has been developed to reduce the evaporation loss from stored liquid hydrogen. The ortho-para $H_2$ conversion heat is evaluated at liquid nitrogen temperature. This problem is of particular interest in the design of the ortho-para $H_2$ converter in a hydrogen liquefaction system. The ortho-para $H_2$ conversion equipment consists of a catalytic converter, a precooler, and a liquid nitrogen bath. 30-90 cc of $Fe(OH)_3$ are employed as a catalyst in the present converter. The conversion heat and conversion effectiveness are evaluated when mass flow rate of hydrogen is in the range of 0.05-l.6 g/min. It is found that the ortho-para conversion heat is increased while conversion effectiveness is decreased as the mass flow rate of hydrogen is increased. Both the ortho-para conversion heat and conversion effectiveness are increased with an increase in the amount of the catalyst.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.9
• /
• pp.2023-2030
• /
• 2010

In this paper, we present research results of developing high performance scan conversion unit and implementing it on FPGA chip. To increase performance of scan conversion unit, we propose an architecture of scan converter that is a SIMD architecture and uses tile-based traversing method. The proposed scan conversion unit can operate about 124Mhz clock frequency on Xilinx Vertex4 LX100 device. To verify the scan conversion unit, we also develop shader unit, texture mapping unit and $240{\times}320$ color TFT-LCD controller to display outputs of the scan conversion unit on TFT-LCD. Because the scan conversion unit implemented on FPGA has 311Mpixels/sec pixel rate, it is applicable to desktop pc's 3d graphics system as well as mobile 3d graphics system needing high pixel rates.

• Nuclear Engineering and Technology
• /
• v.55 no.10
• /
• pp.3775-3786
• /
• 2023

Mixing Vane Grid (MVG) is one of the most important structures in fuel assembly due to its high performance in mixing the coolant and ultimately increasing Critical Heat Flux (CHF), which avoids the temperature rising suddenly of fuel rods. To evaluate the mixing performance of the MVG, a Total Diffusion Coefficient (TDC) mixing coefficient is defined in the subchannel analysis code. Conventionally, the TDC of the spacer grid is obtained from the combination of experiments and subchannel analysis. However, the processing of obtaining and determine a reasonable TDC is much challenging, it is affected by boundary conditions and MVG geometries. In is difficult to perform all the large and costing rod bundle tests. In this paper, the CFD method was applied in TDC analysis. A typical 5 × 5 MVG was simulated and validated to estimate the mixing performance of the MVG. The subchannel code was used to calculate the TDC. Firstly, the CFD method was validated from the aspect of pressure drop and lateral temperature distribution in the subchannels. Then the effect of boundary conditions including the inlet temperature, inlet velocities, heat flux ratio between hot and cold rods and the arrangement of hot and cold rods on MVG mixing and TDC were studied. The geometric effects on mixing are also carried out in this paper. The effect of vane pattern on mixing was investigated to determine which one is the best to represent the grid's mixing performance.

• The Journal of Information Systems
• /
• v.15 no.2
• /
• pp.173-193
• /
• 2006

This study first conceptualizes and investigates five dimensions of SCM activities, such as organizational capacity, revitalization support collaboration, appraisal and responsibility, and information system activities. Second, this study develops three dimensions of a supply chain structure, and proposes a balanced scorecard (BSC) model in order to measure business performance. And then, this study establishes too research hypotheses as follows: H1. The SCM activities varies with the supply chain structure. H2. The management performance varies with the supply chain structure. In the questionnaire survey for empirical analysis, this study carefully selected 809 of companies in Korea. We conducted a survey by mail and collected 127 data. Out of 127 data we actually used 103 responses for statistical analysis. After conducting statistical analysis, we could find the results as followed: 1) The supply chain structure was classified into three networks through a clustering procedure, such as supply network, conversion network, and distribution network, and these networks were used to testify hypotheses. As a result the effect of SCM activities varies according to three networks and especially, the companies in distribution network were more active than those in supply and conversion networks doing SCM activities. 2) We may conclude that business performance varies with three networks, and distribution network achieves better performance than supply and conversion networks do.

• Journal of the Korean Society of Mechanical Technology
• /
• v.13 no.3
• /
• pp.39-47
• /
• 2011

In a bi-fuel engine using gasoline and LPG fuel, with the current ignition timing for gasoline being used, the optimum performance could not be taken in LPG fuel supply mode. The ignition timing in LPG fuel mode must be advanced much more than that of gasoline mode for the compensation of its higher ignition temperature. The purpose of this study is to investigate how the ignition spark timing conversion influences the engine performance of LPG/Gasoline Bi-Fuel engine. In order to investigate the engine performance during combustion, engine performance are sampled by data acquisition system, for example cylinder pressure, pressure rise rate and heat release rate, while change of the rpm(1500, 2000, 2500) and the ignition timing advance($5^{\circ}$, $10^{\circ}$, $15^{\circ}$, $20^{\circ}$). As the result, between 1500rpm, 2000rpm and 2500rpm, the cylinder pressure and pressure rise rate was increased when the spark ignition was advanced but pressure rise rate at $20^{\circ}$ was smaller value.

• The Journal of Asian Finance, Economics and Business
• /
• v.9 no.6
• /
• pp.297-302
• /
• 2022

The current study examines the relationship between inventory management efficiency and financial performance in Saudi Arabian companies. The study collected data from the companies listed on Tadawul (a Saudi Arabian stock exchange) during the period starting from 2016 and ending in 2020. The study uses pooled regression model by incorporating Return on Assets (ROA) and Inventory Turnover Ratio (ITR) as a performance measurement variable and inventory conversion period as an inventory management variable to report the results. The results show a positive and significant association between inventory management and firms' financial growth measured in terms of Return on Assets (ROA). Further, the study reports a positive and significant association between the inventory conversion period and inventory turnover (ITR). This shows that managing inventory efficiently shall positively impact the firm's performance. The other variables, such as debt ratio and gross profit, are positively related to ROA and negatively correlated with ITR. The firm growth is positively associated with both the dependent variables. The results suggest that the management of inventory in Saudi Arabian firms is efficient. Further, the firm size is positively associated with ROA and ITR. This shows a nexus between inventory management efficiency and firms' financial growth in Saudi Arabian companies.