• Journal of the Korea Convergence Society
• /
• v.8 no.5
• /
• pp.161-167
• /
• 2017

We have fabricated and characterized $32{\times}32$ photonic quantum ring (PQR) laser arrays uniformly operable with $0.98{\mu}A$ per ring at room temperature. The typical threshold current, threshold current density, and threshold voltage are 20 mA, $0.068A/cm^2$, and 1.38 V. The top surface emitting PQR array contains GaAs multiquantum well active regions and exhibits uniform characteristics for a chip of $1.65{\times}1.65mm^2$. The peak power wavelength is $858.8{\pm}0.35nm$, the relative intensity is $0.3{\pm}0.2$, and the linewidth is $0.2{\pm}0.07nm$. We also report the wavelength division multiplexing system experiment using angle-dependent blue shift characteristics of this laser array. This photonic quantum ring laser has angle-dependent multiple-wavelength radial emission characteristics over about 10 nm tuning range generated from array devices. The array exhibits a free space detection as far as 6 m with a function of the distance.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.30 no.3
• /
• pp.69-81
• /
• 1988

The Repeated Load Triaxial and Oedometer Tests to the weathered granite & silty clay soil have been fulfilled to investigate their dynarnic characteristics. The results obtained are summarized as follows ; 1. In the relation between the repeated triaxial compression and the oedometer test, the recoverable strain of weathered granite soil showed a tendency to decrease by the increase of the repeated loads number(N), and that of silty clay showed approximately constant values while the total strain increased continuously. 2. The changes of plastic strain was dependent to the level of deviator stress which is the most important element in the calculation of soil deformation under repeated load condition. And there was a significance of 10% between the level of stress and plastic strain. 3. When the soil was aimost dried or saturated to 100%, the deformation by the repeated loads was small. However the deformation showed peak around the saturation of 50%. 4. When the deformation was predicted by the repeated triaxial load tests of a laboratory, it is desirable to introduce the threshold stress concept in the calculation of deformation of subgrade of the pavement. 5. The improved design equation (Eq. 16) introducing the modulus of conversion(Fo), which is based on the Boussineq' s theory, is considered to be rational in the design of flexible pavement. From the above results, the deformation to the repeated traffic loads could be predicted by the repeated triaxial tests on the pavement materials or undisturbed soil layers, therefore it is think that the durable and econornic pavement could be constructed by reflecting that to the design.

• The Journal of Korean Physical Therapy
• /
• v.24 no.5
• /
• pp.340-347
• /
• 2012

Purpose: This study was conducted in order to investigate the effect on respiratory function, trunk control, and functional activities of daily living (ADL) through respiratory muscle strength training in patients with chronic stroke. Methods: Eighteen subjects who were six months post stroke participated in this study. The subjects were randomly allocated to two groups: experimental (n=10) and control (n=8). Both groups received physical therapy for five sessions, 30 minutes per week, during a period of six weeks. Subjects in the experimental group participated in an additional respiratory muscle strength training program, in which the threshold PEP device was used for 30 minutes per day, three days per week, during a period of six weeks. Results from pretest-posttest control were evaluated by pulmonary function forced vital capacity (FVC), forced expiratory volume at one second (FEV1), FEV1/FVC, peak expiratory flow (PEF), capacity of cough, trunk control, and functional ADL. Results: Significant improvement in the FEV1, PEF of pulmonary function (p<0.05), cough function (p<0.05), and trunk control (p<0.05) was observed among the groups. Conclusion: Respiratory muscle strength training improves pulmonary function, capacity of cough, and trunk control. These results suggest that respiratory muscle strength training is feasible and suitable for individuals with chronic stroke.

• Journal of information and communication convergence engineering
• /
• v.8 no.1
• /
• pp.51-58
• /
• 2010

This paper proposes an edge adaptive color interpolation for an ultra-small HD-grade complementary metal-oxide semiconductor (CMOS) video sensor in camera phones that can process 720-p/30-fps videos. Recently, proposed methods with great image quality perceptually reconstruct the green component and then estimate the red/blue component using the reconstructed green and neighbor red and blue pixels. However, these methods require the bulky memory line buffers in order to temporally store the reconstructed green components. The edge adaptive color interpolation method uses seven or nine patterns to calculate the six edge directions. At the same time, the threshold values are adaptively adjusted by the sum of the color values of the selected pixels. This method selects the suitable one among the patterns using two flowcharts proposed in this paper, and then interpolates the missing color values. For verification, we calculated the peak-signal-to-noise-ratio (PSNR) in the test images, which were processed by the proposed algorithm, and compared the calculated PSNR of the existing methods. The proposed color interpolation is also fabricated with the 0.18-${\mu}m$ CMOS flash memory process.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.27 no.1
• /
• pp.200-207
• /
• 2003

In this paper, the effect of the compressive residual stresses which were obtained under the various shot velocities of shot balls on the fatigue behaviors of a spring steel, were investigated. The examination of CT specimen test were executed with the materials(JISG SUP9) which are being commonly used for the springs of automotive vehicles. As a result, the optimal shot velocity of shot balls were acquired considering the peak values of the compressive residual stresses on the surface of specimen and effect on the speed of the fatigue crack propagation da/dN in stage II and the threshold stress intensity factor range Δ$K_{th}$ in stage I. Also the material constant C and the crack propagation index m in the formula of paris law da/dN= C $({\Delta}K^m)$ were suggested in this work to estimate the dependency on the shot velocity.

• Analytical Science and Technology
• /
• v.5 no.1
• /
• pp.57-61
• /
• 1992

For the neutron spectrum measurement, $^6Li$ neutron spectrometer system is installed. The characteristic of the $^6Li$ detector are investigated using a $^{137}Cs$ and $^{207}Bi$ point source, and the neutron capture peaks and the pulse height spectrum using an $^{214}Am-Be$ neutron source are measured. Furthermore, the pulse height spectrum for the irradiation time variation from the (214)^Am-Be neutron source, and for the distance variation between detector and source, and the threshold variation of discriminator are measured.

• The Journal of the Korea Contents Association
• /
• v.8 no.3
• /
• pp.41-46
• /
• 2008

Many methods have been developed to overcome the PAPR(peak-to-average power ratio) problem. Selective mapping(SLM), partial transmit sequence(PTS), subblock phase weighting(SPW) and gradient descent(GD) are used widely to reduce the PAPR. In this paper, we present an effective PAPR reduction method that decreases the number of calculations through Radix-2 DIF IFFT procedure and GD method that transmits selected data sequence. The data sequence is constructed by choosing elements that satisfy threshold value as one part of the sequence and the rest elements of each sequence are chosen to have the lower papr operating, which yields performance improvement.

• Geomechanics and Engineering
• /
• v.7 no.3
• /
• pp.297-316
• /
• 2014

This paper presents a detailed study focused on investigating the effects of silt content on the static and dynamic properties of sand-silt mixtures. Specimens with a low-plastic silt content of 0, 15, 30 and 50% by weight were tested in static triaxial, cyclic triaxial, and resonant columns in addition to consolidation tests to determine such parameters as compression index, internal friction angle, cohesion, cyclic stress ratio, maximum shear modulus, normalized shear modulus and damping ratio. The test procedures were performed on specimens of three cases: constant void ratio index, e = 0.582; same peak deviator stress of 290 kPa; and constant relative density, $D_r$ = 30%. The test results obtained for both the constant-void-ratio-index and constant-relative-density specimens showed that as silt content increased, the internal friction angle, cyclic stress ratio and maximum shear modulus decreased, but cohesion increased. In testing of the same deviator stress specimens, both cohesion and internal friction angle were insignificantly altered with the increase in silt content. In addition, as silt content increased, the maximum shear modulus increased. The cyclic stress ratio first decreased as silt content increased to reach the threshold silt content and increased thereafter with further increases in silt content. Furthermore, the damping ratio was investigated based on different silt contents in three types of specimens.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.9A
• /
• pp.710-716
• /
• 2003

OFDM is a very attractive technique for achieving high-bit-rate data transmission and high spectrum efficiency. However one of disadvantages of OFDM signal is the high PAPR characteristic when multicarriers are added up coherently. In this paper, we propose an adaptive PTS scheme using two threshold levels for PAPR reduction and reducing the amount of PAPR calculations with clipping scheme. Simulation results show that it is almost same between average bit error rate performance of the proposed scheme and that of a conventional scheme. Also, we obtain a great performance gain in the amount of calculations compared to the conventional scheme. Therefore, proposed system has a good performance in data processing time in OFDM wireless communication systems.

• IEIE Transactions on Smart Processing and Computing
• /
• v.3 no.4
• /
• pp.221-225
• /
• 2014

Low power RF devices, such as RFID and Zigbee, are important for ubiquitous sensing. These devices, however, are powered by portable energy sources, such as batteries, which limits their use. To mitigate this problem, this study developed RF energy harvesting with W-CDMA for a low power RF device. Diodes are required with a low turn on voltage because the diode threshold is larger than the received peak voltage of the rectifying antenna (rectenna). Therefore, a Schottky diode HSMS-286 was used. A prototype of RF energy harvesting device showed the maximum gain of 5.8dBi for the W-CDMA signal. The 16 patch antennas were manufactured with a 10 dielectric constant PTFT board. In low power RF devices, the transmitter requires a step-up voltage of 2.5~5V with up to 35 mA. To meet this requirement, the Texas Instruments TPS61220 was used as a low input voltage step-up converter. From the evaluated result, the achievable incident power of the rectenna at 926mV to operate Zigbee can be obtained within a distance of 12m.