• 한국산업융합학회 논문집
• /
• 제21권3호
• /
• pp.109-115
• /
• 2018

This paper proposes the method to develop the fuel of suljigemi pellet using agricultural by-products the occurred during the manufacturing of alcohol. The goal of the development of suljigemi using biomass is to make the pellet fuel of high calorie. The suljigemi pellet is difficult to recycle waste in the manufacture company of alcohol. suljigemi pellet has the effect of zero emission as the soil conditioner using ash after burning. Also suljigemi pellet has the reduction effect of carriage fee, fuel economy and low-cost high-efficiency effects, environmentally clean fuel as CO2 emissions savings. So the technologies of the suljigemi fuel pellet are developing low carbon, green growth renewable energy fuel through futuristic energy system will be. In experiments, suljigemi pellets confirmed the calories by about 10% higher than wood pellets with the same conditions.

• Advances in concrete construction
• /
• 제5권3호
• /
• pp.183-199
• /
• 2017

This paper reports an experimental study into the rheological behaviour of Smart Dynamic Concrete (SDC). The investigation is aimed at quantifying the effect of the varying amount of mineral admixtures on the rheology, setting time and compressive strength of SDC containing natural sand and crushed sand. Ordinary Portland cement (OPC) in conjunction with the mineral admixtures was used in different replacement ratio keeping the mix paste volume (35%) and water binder ratio (0.4) constant at controlled laboratory atmospheric temperature ($33^{\circ}C$ to $35^{\circ}C$). The results show that the properties and amount of fine aggregate have a strong influence on the admixture demand for similar initial workability, i.e., flow. The large amounts of fines and lower value of fineness modulus (FM) of natural sand primarily increases the yield stress of the SDC. The mineral admixtures at various replacement ratios strongly contribute to the yield stress and plastic viscosity of SDC due to inter particle friction and cohesion.

• 한국농공학회지
• /
• 제38권4호
• /
• pp.137-146
• /
• 1996

This paper presents the results of field experience from an experimental pavement construction on a low volume road using recycled concrete. The recycled concrete was prepared by replacing a half of coarse aggregate with recycled aggregate. Virgin natural sand was used as fine aggregate together a plasticizer and a fly ash (0.8% and 5% by wt. of cement, respectively). The load bearing capacity of the subbase made of recycled aggregate was acceptable. The length, thickness and width of the pavement were l00m, 20cm and 3m, respectively. From construction experience, it was found that workability and finishability of the recycled concrete mixture were relatively poor, but strengths were satisfactory. Flexural strength, compressive strength and elastic modulus at 28 days were 54Kg/$cm^2$, over 250Kg/$cm^2$, and 220,OOOKg/$cm^2$, respectively. The construction could be performed by hand without much difficulty. The surface was finished smoothly by wet fabric and only minor cracks were found on the surface.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1999년도 봄 학술발표회 논문집(I)
• /
• pp.475-480
• /
• 1999

Recently domestic building market in the face of 3D, in addition to construction cost increase, materials lack problems and opening a building market to foreign countries, is trying to find out the efficient ways of overcoming these problems. So the necessity to study the permanent form is urgent to escape the problems of constructing human power economy, cost down, noises problem, environmental prevention and efficacy of form work to technical improvement will contribute a practical permanent form in field through economic evaluation of permanent form. In this paper, we compared wood form cost with permanent form cost(made form polymer or fly ash) for frame work

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2006년도 춘계 학술발표회 논문집(II)
• /
• pp.521-524
• /
• 2006

In this paper, admixture factors affecting the properties of lightweight foamed concrete incorporating cement kiln dust(CKD) and fly ash(FA), respectively are discussed. Increase in CKD contents resulted in loss of fluidity and decrease in settlement of concrete noticeably. Moreover, the higher the unit weight is, the smaller the settlement depth is. The use of CKD resulted in slight decrease in compressive strength and tensile strength compared to that with other admixture. However, all mixtures met the requirement of strength prescribed in Korean Industrial Standards.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2006년도 춘계 학술발표회 논문집(II)
• /
• pp.529-532
• /
• 2006

This paper presents results from creep and shrinkage tests performed on different High Strength Concrete (HSC) mixes (with compressive strengths up to 90 MPa). Results were compared with those from various Code prediction models. The effects of pozzolanic materials on the creep and shrinkage were also investigated. Results show that while fly ash increases the compressive creep of concrete, silica fume decreases it. Moreover, current creep and shrinkage prediction models need to be revised for the HSC mixture.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2006년도 춘계 학술발표회 논문집(II)
• /
• pp.205-208
• /
• 2006

Damage of hydraulic concrete structures by the abrasion and erosion process is very severe and it indicates that the necessity of considering the influence of this process while designing concrete mixtures. Abrasion wear of concrete in hydraulic structures is caused by the movement of particles, water-borne debris. The resistance against erosion for high-strength self-consolidating concrete(SCC) was examined in this paper. A newly designed testing method is presented in order to quantitatively estimate the erosion of concrete. It was shown that loss of volume in abraded concrete can be explained as function of material parameters such as the amount of fly ash and blast furnace slag. Those admixtures have been widely used to reduce heat of hydration and improve resistance against sulfate attack. The results of current study can be used as a guideline in selecting the composition of concrete exposed to abrasion-wear.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2005년도 추계 학술발표회 제17권2호
• /
• pp.711-714
• /
• 2005

This paper focused on development of geopolymer for wood wool ceramic board. Geopolymer can substitude ordinary portland cement and its accelerator of wood wool cement board as inorganic polymer. In this study, what we would obtain geopolymer's properties such as initial setting time(KS L 5108), flow(KS L 5102) and compressive strength of 3days aged(KS L 5105), was less than 1 hour, more than $110\%$, more than 40Mpa. Geopolymer have three essential materials called filler, hardener and geopolymer liquor. So, We applied filler by quartz, hardener by blast furnace slag powder, metakaoline and fly ash, geopolymer liquor by NaOH, KOH and sodium silicate solution. As result of this experiment, what we could obtain best fitted geopolymer's properties such as initial setting time, flow and compressive strength of 3days aged, was 45min, $116\%$ and 43.6Mpa. This result can be applicable to commercial wood wool ceramic board.

• KIEAE Journal
• /
• 제6권1호
• /
• pp.11-16
• /
• 2006

This paper deals with the experimental for manufacturing the lightweight buildng materials with portland cement, fly ash, slag, lime, gypsum, and aluminum powder system. Aluminum powder was added an aerating agent. Specific gravity range of lightweight concrete specimens were 0.6~0.9g/cm3. These specimens properties studied by means of specific gravity, compressive strength, absorption coefficient, transmission loss and scanning electron microscopy. Cellular concrete with maximum compressive strength was 41kgf/cm2 by obtained Al=0.05wt.%. Moreover, the aeration lightweight concrete showed excellent sound absorption properties.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2003년도 가을 학술발표회 논문집
• /
• pp.58-61
• /
• 2003

This paper investigated the chloride invasion resistance properties of concrete containing mineral admixtures(pozzolanic materials such as fly-ash, ground granulated blast-furnace slage, silica fume and meta kaolin) for each replacement ratios under W/B ratios ranged from 40% to 55%. For the electrical migration test, Tang and Nilsson's method was used to estimate the migration coefficient of chloride ion. As a result, the migration coefficients of chloride ion of concrete containing mineral admixtures were shown reducing with the use of mineral admixtures, and the compressive strength was shown related to the migration coefficient. From the correlation between compressive strengths and migration coefficients, the kind and replacement ratio of mineral admixtures have a great effect on migration coefficients below 50㎫.