• Nuclear Engineering and Technology
• /
• v.51 no.7
• /
• pp.1729-1737
• /
• 2019

This paper presents neutronics design of VVER-1000 fuel assembly using burnable poison particles (BPPs) for controlling excess reactivity and pin-wise power distribution. The advantage of using BPPs is that the thermal conductivity of BPP-dispersed fuel pin could be improved. Numerical calculations have been conducted for optimizing the BPP parameters using the MVP code and the JENDL-3.3 data library. The results show that by using $Gd_2O_3$ particles with the diameter of $60{\mu}m$ and the packing fraction of 5%, the burnup reactivity curve and pin-wise power distribution are obtained approximately that of the reference design. To minimize power peaking factor (PPF), total BP amount has been distributed in a larger number of fuel rods. Optimization has been conducted for the number of BPP-dispersed rods, their distribution, BPP diameter and packing fraction. Two models of assembly consisting of 18 BPP-dispersed rods have been selected. The diameter of $300{\mu}m$ and the packing fraction of 3.33% were determined so that the burnup reactivity curve is approximate that of the reference one, while the PPF can be decreased from 1.167 to 1.105 and 1.113, respectively. Application of BPPs for compensating the reduction of soluble boron content to 50% and 0% is also investigated.

• Nuclear Engineering and Technology
• /
• v.54 no.1
• /
• pp.11-18
• /
• 2022

In this research, curium oxide (CmO₂) is studied as fuel for VVER-1200 reactor to get an attention to its energy value and possibilities. For this purpose, CmO₂ is used in fuel rods or integrated burnable absorber (IBA) rods with and without UO₂ and then compared with the conventional fuel assembly of VVER-1200 reactor. It is burned to 60 GWd/t by using SRAC-2006 code and JENDL-4.0 data library. From these studies, it is found that CmO₂ is competent like UO₂ as a fuel due to higher fission cross-section of ²⁴³Cm and ²⁴⁵Cm isotopes and neutron capture cross-section of ²⁴⁴Cm and ²⁴⁶Cm isotopes. As a result, when some or all of the UO₂ of fuel rods or IBA rods are replaced by CmO₂, we get a similar k-inf like the reference even with lower enrichment UO₂ fuels. These studies show that the use of CmO₂ as IBA rods is more effective than the fuel rods considering the initially loaded amount, power peaking factor (PPF), fuel temperature and void coefficient, and the quality of spent fuel. From a detailed study, 3% CmO₂ with inert material ZrO₂ in IBA rods are recommended for the VVER-1200 reactor assembly from the once through concept.

• Journal of Environmental Science International
• /
• v.30 no.11
• /
• pp.907-914
• /
• 2021

In this study, strawberry cultivation environment in a greenhouse located in Jeonju was monitored and internal environmental parameters were analyzed. Temperature, humidity, RAD, and PPF sensors were installed to monitor environmental conditions in the test greenhouse. Data were collected every 10 minutes during four winter months from sensors placed across the greenhouse to assess its permeability and environmental uniformity. Temperature and humidity inside the greenhouse were relatively uniform with negligible deviations among the center, south, and north; however, it was judged that further analysis of gradients of these parameters from the east to the west of the greenhouse would be needed. Both RAD (Total solar radiation) and PPF (Photosynthetic photon flux) had high values on the south and were low on the north and the reduction rate of these parameters was 54% and 61%, respectively, indicating that a significant amount of light could not be transmitted. This implied a significant decrease in the amount of light entering the greenhouse during winter. Therefore, it is concluded that environmental control devices and auxiliary lighting are needed to achieve uniform greenhouse environment for efficient strawberry cultivation.

• Archives of Plastic Surgery
• /
• v.50 no.2
• /
• pp.194-199
• /
• 2023

Moderate soft-tissue defects need stable coverage, ideally with tissue of similar characteristics and low donor site morbidity. We propose a simple technique for the coverage of moderate skin defects in the limbs. It allows intraoperative transformation of a propeller perforator flap (PPF) into a keystone design perforator flap (KDPF) in cases of unsatisfying perforator vessel or in cases of unpredictable intraoperative events. Between March 2013 and July 2019, nine patients with moderate soft-tissue defects (mean defect size 4.5 × 7.6 cm) in the limbs (two on the upper limbs and seven on the lower limbs) were covered using this technique. We performed four PPFs and five KDPFs. The mean follow-up was 5 months. There was one complication, partial distal tip necrosis in a PPF located in the leg, which healed by secondary intention within 3 weeks. The donor site was closed directly in all cases. No functional impairments were noted regardless of the perforator flap utilized. This technique enables us to employ flexible surgical strategies and allows us to make adjustments based on the patient's vascular anatomy.

• Horticultural Science & Technology
• /
• v.29 no.3
• /
• pp.187-194
• /
• 2011

The objective of this study was to determine the effects of light intensity and electrical conductivity (EC) of nutrient solution on the growth and nutrient uptake of potted kalanchoe plants (Kalanchoe blossfeldiana 'Marlene') with growth stage in ebb and flow subirrigation systems. The plants were grown at four ECs of 0.5, 1.0, 1.5, and 2.0 $dS{\cdot}m^{-1}$ for seedling stage and four ECs of 1.0, 1.5, 2.0, and 3.0 $dS{\cdot}m^{-1}$ for short day stage under three daily photosynthetic photon flux (PPF) of 6.5, 10.3, 18.2 $mol{\cdot}m^{-2}{\cdot}d^{-1}$. At seedling stage, plant height was the longest under the lowest light intensity, and particularly dry weights and leaf areas were the highest at PPF 10.3 $mol{\cdot}m^{-2}{\cdot}d^{-1}$. Dry weights and leaf areas were the highest at EC 1.5 $dS{\cdot}m^{-1}$ regardless of light intensity. At short day exposure, plant height was the longest under the lowest light intensity. Dry weights, leaf areas, and number of pedicels of the plants significantly increased as light intensity increased. Under all light intensity conditions, dry weights, leaf areas, and number of pedicles increased until EC becomes to 1.0 - 2.0 $dS{\cdot}m^{-1}$. And after reached the highest at EC 2.0 $dS{\cdot}m^{-1}$, they decreased at EC 3.0 $dS{\cdot}m^{-1}$. By comparing the ion uptakes at EC 1.5 $dS{\cdot}m^{-1}$ of seedling stage and EC 2.0 $dS{\cdot}m^{-1}$ of short day stage in which the plants grew better, we confirmed that ion balance of nutrient solution among $NO_3{^-}$-N, $H_2PO_4{^-}$, $K^+$, $Ca^{2+}$, and $Mg^{2+}$ were significantly changed at short day stage compared to seedling stage. For better growth of the plants, both ion balance and EC of nutrient solution should be considered under different light intensities at short day stage while control of EC is enough at seedling stage.

• Journal of Bio-Environment Control
• /
• v.22 no.3
• /
• pp.270-278
• /
• 2013

The objective of the present study is to provide data needed to decide covering method to be able to increase the thermal insulation and light transmittance efficiency of commercial greenhouse. The thermal insulation effect, PPF transmittance and quantity of condensation water were estimated in experimental tomato greenhouses covered with three types of coverings of single layer, air inflated and conventional double layers covering. The overall heat flow of air inflated double layers greenhouse was similar to that of conventional double layers greenhouse, but the temperature between covering material and thermal screen in air inflated double layers greenhouse was lower than that in conventional double layers greenhouse at the same outside temperature condition due to air leakage through the gap of roof vent. The overall heat transfer coefficients acquired by experiment that was performed in single layer and conventional double layers greenhouses were close to those obtained from model experiment. Even though the PPF transmittance of air inflated double layers greenhouse was lower than that of single layer greenhouse, which was greater than that of conventional double layers greenhouse. The quantity of condensation water on covering surface of single layer greenhouse was greater than that of air inflated double layers greenhouse due to lower covering surface temperature.

• Korean Journal of Agricultural Science
• /
• v.40 no.4
• /
• pp.325-331
• /
• 2013

This experiment has been carried out to determine optimal culture conditions for the production of cut flowers and tubers of Calla (Zantedeschia 'Golden Affair' and 'Black Magic') in highlands. Treatments consisted of various levels of root zone environments, Results are as follows: Calla 'Golden Affair' were grown with different mulching materials such as Non-mulching, Black film, reflective film, Rice hull. Mulching materials resulted in no difference in the number of cut flowers but flower length was highest in reflective film. Calla 'Black Magic' were treated with various soil water content, soil type and watering time. Number of cut flowers and flower quality were greatest when the plants were watered at -80 kPa soil water content. No symptoms of soft rot (Erwinia carotovora) was observed at this soil water content. The occurrence of soft rot was observed with similar percentage according to soil type and the soil water content. When Calla 'Black Magic' were watered at the time of soil surface drying, growth was greater compared to others. Air temperature and PPF affected plant growth and photosynthesis. Photosynthetic rate was greatest at $25^{\circ}C$ and PPF $200{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$, while lowest at $28^{\circ}C$ and PPF $800{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$. Soft rot did not occur without regard to dipping treatment (0, 5, 10, 24, 48 hours) when the day and night temperature were maintained at $25^{\circ}C$ and $20^{\circ}C$, respectively.

• Horticultural Science & Technology
• /
• v.29 no.3
• /
• pp.273-277
• /
• 2011

Fusarium oxysporum f. sp. fragariae (Fof), the causal agent of crown and root rot in strawberry, is the most serious soilborne disease of nursery plants in Korea. The possibility of infection by Fof through runner propagation from infected mother plants of strawberry cv. 'Kumhyang' was assessed in stolons and daughter plants hanging from raised beds. The number of daughter plants from an infected mother plant in plastic house and photosynthetic photon flux (PPF) system, 280 ${\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$ was 2.7 and 3.8 plants after 58 days, respectively. However, healthy mother plants produced 6.5 and 8.4 daughter plants, respectively. The pathogen was detected in the uppermost portion of the stolon after 58 days, but was not detected further down the stolon. After 90 days, it was detected in all portions of the stolon between mother and $1^{st}$ daughter plant and in 60% of all $1^{st}$ daughter plants. The pathogen was not detected in the corresponding portions of the non-infected controls. These results show that infected mother plants can transmit Fof to their daughter plants without passing through the soil and $1^{st}$ daughter was used as mother plant in PPF system for propagating healthy plants.

• Journal of Bio-Environment Control
• /
• v.12 no.3
• /
• pp.147-152
• /
• 2003

This study was conducted to analyze the energy balance in closed transplants production system (CTPS) for the production of high quality transplants. Potato (Solanum tuberosum L. cv. Dejima) plug seedlings were grown for 15 days at air temperature of 20$^{\circ}C$, relative humidity of 70%, photoperiod of 16/8 h, and photosynthetic photon flux (PPF) of 200 ${\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$ following 5 days of tooting in CTPS. Electric energy consumption was 46% for lighting, 35% for cooling, 16% for heating, 2% for air circulation, and 1% for humidifying. The electric energy utilization efficiency and the short-wave energy utilization efficiency were 0.5% and 5.4%, respectively. These results suggest that CTPS has the feasibility for the commercial production of potato plug seedlings if the electric energy consumption in CTPS is reduced and the electric energy utilization efficiency is increased.

• Journal of Bio-Environment Control
• /
• v.20 no.4
• /
• pp.253-257
• /
• 2011

This study was carried out to investigate the effect of different light emitting diode (LED) irradiation on the growth of paprika (Capsicum annuum 'Cupra'). The plants were irradiated by red (660 nm), blue (460 nm) and red + blue (4 : 1) light emitting diodes above 50 cm for 5 hours after sunset. Photosynthetic photon flux (PPF) irradiated by red, blue and red + blue LED were $79{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$, $75{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$ and $102{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$ respectively. Leaf temperature of paprika grown under blue LED irradiation was the highest of $18.6^{\circ}C$. Fruit temperature was the highest under in the control (no irradiation) but it was lower than leaf temperature. There was influence of LED irradiation on the paprika plants height; under blue irradiation the plant height was the shortest, while under in the control plant height was the highest. The leaf size of under different LED irradiation was bigger than that of in the control. Mean fruit weight under different LED irradiation was significantly increased; however number of fruits and marketable yield per plant were significantly decreased as compared to the control.