• 한국분무공학회지
• /
• 제19권4호
• /
• pp.182-187
• /
• 2014

As the regulations for Particulate Matter (PM) and Particle Number (PN) emissions from Gasoline Direct Injection (GDI) Vehicle stringent recently, a lot of studies have been made on the emission characteristics of PM and PN. In this study, PM and PN emission characteristics were compared to GDI and Multi Port Injection (MPI) Vehicles using the Condensation Particle Counter (CPC) measurement equipment. And driving mode is divided into normal driving mode (CVS-75, NEDC, NIER 6, NIER 9) and a constant speed driving mode (10 km/h, 35 km/h, 80 km/h, 110 km/h) to evaluate the characteristics in the various operating conditions. In the results, most of the driving mode, PM and PN were emitted from GDI Vehicle more than MPI Vehicle. However, in the constant speed mode of 110 km/h, PM and PN from MPI Vehicle were also a lot of emission. It is determined to cause a difficulty in the fuel injection control of the MPI Vehicle.

• 한국분무공학회지
• /
• 제19권3호
• /
• pp.142-148
• /
• 2014

In this study, characteristics of gaseous pollutants and particulate matter were investigated on the condition of DPF regeneration and normal DPF condition. THC, CO, $CO_2$, NOx, and $CH_4$ were analyzed by MEXA-7200H and CVS-7100 respectively. Particulate Matter (PM) was measured by difference in weight of Membrane filter. Particle Number (PN) was measured by CPC analyzer. And Sulfate, Nitrate, Organic were measured by Aerosol Mass Spectrometer (AMS). As a result, gaseous pollutants and particulate matter were detected in higher concentration during DPF regeneration than normal DPF condition. And the PN increased by 94%, the fuel consumption was reduced by 29% on DPF generation process. Sulfate, Nitrate and Organic were undetectable level during normal DPF condition. But the highest concentration of Sulfate, Nitrate and Organic were measured as $100{\mu}g/m^3$, $20{\mu}g/m^3$ and $15{\mu}g/m^3$ respectively on DPF regeneration condition. VOCs concentrations (Benzene, Toluene, Ethylbenzene, Xylene) were analyzed by using PTR-MS. Benzene and Toluene emission have little or no change depending on DPF regeneration. But the Ethylbenzene and Xylene have comparatively low emissions on DPF regeneration.

• 한국분무공학회지
• /
• 제17권4호
• /
• pp.185-191
• /
• 2012

Particulate matters (PM) that is generated by most diesel engine is regulated by the mass concentration measured by the conventional method it had been. Recently, Europe PMP (Particle Measurement Program) decided to start the regulation of vehicle's nano-sized particle number (PN) from the year of 2011 because of nano-particle's higher degree of harm to the human body. So firstly, the standard level of PN emission is introduced in the Euro 5/6 emissions regulation with a limit of $6{\times}10^{11}$ per km for light duty vehicle. Also KPMP(Korea Particle Measurement Program) was organized to copy quickly international technical trend. In this paper, it was investigated the nano-sized PN measurement characteristics for different particle generators between spray type and soot type. And the difference ratio between particle generators, the characteristic of PN concentration, counting efficiency and linearity was analyzed. Then, we make conclusions as followed. When particle diameter is increased, counting efficiency of two generators is decreased. Also Secondary calibration method is more higher 3% than Primary calibration method. Finally, SOF which is included in soot particles is not totally removed so it have great influence on test result of counting efficiency and linearity.

• 한국가스학회지
• /
• 제20권6호
• /
• pp.9-15
• /
• 2016

가스연료인 LPG와 CNG는 청정 대체연료로서 차량용 연료로 많이 사용되고 있다. 특히 CNG의 경우 저탄소 연료로서 온실가스 배출량 저감에 기여할 수 있다, LPG의 경우 가솔린 차량과 거의 동등한 성능을 가지면서도 연료가격이 저렴하여 택시에 많이 사용되고 있다. 본 연구에서는 동일차량에서 LPG와 CNG를 사용하여 배출가스와 최근 문제가 되고 있는 입자상물질의 배출개수(PN; particle number)에 대하여 비교하였다. 차대동력계를 이용하여 FTP-75와 WLTC 모드에 대하여 시험을 진행하였다. PN은 두 대의 CPC(Condensation Particle Counter)를 이용하여 5 nm 이상과 23 nm 이상의 입자에 대하여 배출 개수를 측정하였다. 배출가스에 있어서는 CO2의 경우 LPG 차량이, 메탄의 경우 CNG 차량이 많이 배출되었다. PN의 경우 두 연료에서 배출되는 PN은 비슷한 수준이었으며, WLTC 에서 고속운전하는 동안 23 nm 이하 크기의 입자 배출 개수가 많았다.

• 청정기술
• /
• 제26권1호
• /
• pp.22-29
• /
• 2020

최근 미세먼지 증가로 인하여 디젤엔진의 배출 규제가 강화됨에 따라 디젤 매연여과장치에 관심이 급증하게 되었으며, 특히 디젤 배기가스 후처리 장치의 고효율화에 대한 기술개발이 더욱 요구되고 있다. 이에 대한 일환으로서 디젤매연여과장치(diesel particulate filter, DPF) 내 배기가스의 유동 균일도를 향상시키고 배압을 낮추어서 배기가스처리 효율을 높이는 연구가 많이 되고 있다. 본 연구에서는 ANSYS Fluent를 이용하여 직경 12"의 DPF와 디젤산화촉매(diesel oxidation catalyst, DOC)를 장착한 디젤 매연여과장치에서의 배기가스의 유속과 온도, DPF IO ratio, Ash와 PM양에 따른 배압에 미치는 영향을 시뮬레이션 하여 배압을 낮추는 최적화 연구를 하였다. 결과로서 배기가스의 온도와 유속이 낮을수록 배압이 낮아졌으며, PM양이 Ash양보다 배압에 더 큰 영향을 주는 것으로 나타냈다. 또한 비대칭 DPF가 대칭 DPF에 비해 배압이 더 낮게 나타냈으나, 유동 균일도의 경우는 다양한 변수에 관계없이 일정하게 나타냈다. european stationary cycle (ESC), european transient cycle (ETC) 조건에서 PM의 정화효율은 비대칭, 대칭 DPF 관계없이 유사하나, particle number (PN)의 정화효율에서는 비대칭 DPF가 대칭 DPF에 비해 높게 나타냈다.

• 한국분무공학회지
• /
• 제24권1호
• /
• pp.21-26
• /
• 2019

In Korea, Medium-duty trucks are classified into GVW (Gross Vehicle Weight) 3.5~10tons. MDTs are mostly used for logistics or delivery between regions. There have been studied on diesel fuel vehicles for SUVs(Sports Utility Vehicle) or light-duty trucks. But MDTs have been not studied. Therefore, this study have been used MDTs for characteristic exhaust emission. Test was carried out using the certification test mode (NEDC, New European Driving cycle) and the NIER mode in chassis dynamometer of the MDTs. And emission gas was analyzed for PN (Particulate Number), PN size distribution and aldehydes, VOCs (Volatile Organic Compounds), PAHs (Polycyclic Aromatic Hydrocarbons). This paper concluded that EURO-IV trucks produced more MSATs than EURO V trucks. Depending on the engine temperature, more MSATs were generated in cold temperature than in the hot start operation. However, the driving speed, the opposite results was obtained.

• 한국분무공학회지
• /
• 제27권2호
• /
• pp.94-100
• /
• 2022

Even in non-road UTV (Utility Terrain Vehicle), spark ignition engines are often used to reduce emissions. In this study, gasoline and LPG (Liquified Petroleum Gas) fuels were applied to UTV engines, and the exhaust gas and combustion stability were compared through engine tests. A 0.8-liter two-cylinder SI engine was used in the experiment. Experiments were conducted while changing the IVO (Intake Valve Open) and EVC (Exhaust Valve Close) at 1500 rpm 14 N·m, 40 N·m, and 3000 rpm 17 N·m, 44 N·m conditions. As a result of the experiment, when the valve overlap increased according to the change of IVO and EVC, combustion stability decreased and THC emission increased, but NOx decreased. Comparing the LPG engine with the gasoline engine, the amount of CO₂ and PN (Particulate Number) generation decreased in the LPG engine, and the combustion stability was good.

• 대한기계학회논문집B
• /
• 제39권4호
• /
• pp.351-358
• /
• 2015

세계적인 배출가스 규제의 강화와 함께 화석 연료의 매장량 감소와 유가 상승은 새로운 엔진 기술 개발을 촉진시켰다. 가솔린 직접 분사(GDI; Gasoline Direct Injection) 엔진은 연료를 직접 연소실에 공급하고 정밀한 연소제어를 통해 공연비가 희박한 혼합 상태에서도 연소가 가능하게 하였는데, 이러한 방식은 기존 포트 분사 엔진보다 연비와 출력을 모두 향상시킬 수 있다. 하지만 GDI엔진은 디젤 엔진의 경우와 마찬가지로 soot 발생률이 높아짐에 따라 입자상 물질의 배출이 증대되는 문제를 안고 있다. 이러한 문제를 해소하고자 본 연구에서는 가솔린 입자상 물질 필터(GPF; Gasoline Particulate Filter)를 개발하여 입자상 물질의 배출정도를 저감시키고자 하였다. 필터의 설계 효율에 따라 3가지의 Metal foam 필터와 단일 Metal fiber 필터를 실험에 적용하여 PM과 PN의 저감률을 비교하였다.

• 동력기계공학회지
• /
• 제18권6호
• /
• pp.77-83
• /
• 2014

As the interest on the air pollution is gradually risen up at home and abroad, their vehicle emission regulations have been reinforcing by steps. PM regulation was also reinforced 4times for the last 13years and has been applied to SI vehicles after EURO 5. Additionally, knowing that small particles of PM can easily penetrate deep into lungs PM number was added on the regulation from EURO5+ and is applied to CI vehicles. Also, PN regulation is going to be applied to SI vehicles. But, because the regulation is appled to only a general test mode of each countries that is performed at $25{\pm}5^{\circ}C$, it is unclear whether the regulation can work on the other ambient temperature conditions or not. In this paper, to know that exhaust emission characteristics at the special conditions CI vehicles(CRDi w, w/o DPF) were tested using 5-cycle mode, NEDC mode at 5-ambient temperatures (35, 25, 0, -7 and -15) and the exhaust emission test results were discussed. The results show that the vehicle with DPF emits much low PM(and PM number) on all of the test mode. However, NOx of the other mode was emitted higher than regulation mode. Also. NOx was sharply increased according to decreasing Ambient Temperature.

• 에너지공학
• /
• 제25권4호
• /
• pp.159-169
• /
• 2016

본 연구에서는 함산소기재 중 MTBE를 휘발유에 첨가하여 산소함량(0, 1.0, 2.3 및 2.7 wt %)의 변화에 따라 MPI 및 GDi 차량에서 배출되는 유해한 배출가스와 연비를 분석하였다. 국내 및 미국의 연비시험방법인 FTP-75 mode와 HWFET mode를 적용하였다. CO, NMHC, NOx 배출량은 산소함량의 변화에 따라 미미한 차이는 있었지만 상관관계는 없었다. FTP-75 mode에서 CO2 배출량은 산소함량의 변화에 따라 증감의 경향성은 없었다. 하지만 차량이 예열된 상태이고 고속 운전영역이 포함된 FTP-75 mode의 phase-3와 HWFET mode에서는 산소를 함유한 연료의 CO2 배출량이 적었다. 입자개수 배출량은 산소함량과 음의 상관관계를 보였으며 산소함량 2.3 wt %에서 가장 적었다. 카본발란스법에 의해 계산된 연비는 산소를 함유한 연료가 높았으며 2.3 wt %에서 가장 높았다.