• The Transactions of the Korea Information Processing Society
• /
• v.6 no.5
• /
• pp.1225-1240
• /
• 1999

This paper proposes PASC(PArtitioned SCHeduler) processor architecture that equips with a number of functional unit and an individual scheduler paris. Every scheduler of the PASC processor can determine whether a unit instruction can be issued to the associated functional unit or it is to be waited until next cycle caused by a resource collision or data dependencies. In the PASC processor, only the functional unit with a resource collision or data dependencies waits by executing a NOP(No OPeration) instruction and the other functional units execute their own instructions. Therefore we can expect the code compaction effect on the PASC processor. Thus, the last instruction of a loop at certain iteration and the very first instruction of the loop at the next iteration can be scheduled simultaneously if the two instructions do not incur any resource collision or data dependencies. Therefore, we can expect that such two instructions without any resource collision and data dependencies are packed into the same very long instruction word and thus, the two instructions are executed concurrently at run time. As a result, we can shorten execution cycles of a loop comparing to the execution of the loop on a traditional VLIW or SVLIW processor architecture. Simulation result also promises faster execution of loops on a PASC processor architecture than those on a VLIW and SVLIW processor architecture.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.3
• /
• pp.2321-2327
• /
• 2015

Three coagulants, alum sulfate(alum), poly aluminum chloride(PAC) and poly aluminum silicate chloride (PASC), were used to remove low to high turbidity and TOC in surface and ground blended water. Laboratory experiments and pilot plant experiments were carried out to evaluate the optimal coagulant and its dosage. To determine the optimized coagulant and its dosage, the turbidity, TOC and pH were measured. The experimental results showed the best removal performance using PASC. The optimal dosage of PASC between 3-20 NTU was found to be 15 mg/L in the jar test. In the pilot test, a 15 mg/L PASC dosage was applied and resulted in the efficient removal of turbidity and TOC between 3.6-27 NTU. The removal efficiency of PASC increased with increasing turbidity and TOC.

• The KIPS Transactions:PartB
• /
• v.10B no.2
• /
• pp.151-156
• /
• 2003

The vergence control method is presented for a parallel-axls stereo camera (PASC) using a signal processing technique such as shift, (rotation), and scaling. The PASC is considered as the simplest one of binocular stereo cameras. However, its major limitation lies in the controllability of vergence since its left and right imaging sensors of CCDs are fixed. On the other hand, a horizontal-moving-axis stereo camera (HMASC) with movable imaging sensors is able to control the vergence by moving its CCDs horizontally. In spite of its vergence controllability, there is a major drawback in the implementation because of complicated mechanical structure and the additional cost. To overcome the vergence control problem of the PASC, an operational principle of the HMASC is applied to the PASC. To be specific, without any additional hardware the vergence control problem of the PASC is solved with the signal processing technique. Assuming the virtual displacement between CCD's, a disappearing part of acquired images is removed and the original image site is recovered via interpolation. Experimental results show that the vergence control between stereo images captured by the PASC it possible with an acceptable degradation of the image quality defending on the virtual displacement of CCDs.

• The Monthly Technology and Standards
• /
• s.66
• /
• pp.33-36
• /
• 2007

• Journal of the Korean Society of Radiology
• /
• v.13 no.2
• /
• pp.153-158
• /
• 2019

The purpose of this study is to compare and analyse the differences between a customized small finger made by 3D printing technology, a real small finger, and the other made from plaster of an orthotic company. The areas and the volumes of each cross-section were measured by Computer tomography(CT) and a 3D scanner and analysis of variance was performed to find out the differences of each shape. The areas of the point of 15.69mm, Distal Interphalangel Joints, were measured 30 times respectively using the caliper toll function of Picture Archiving Communication System(PASC) program. The volumes were measured by Configure Units of Meshmixer Program. There was no significant difference in the areas between three of them and there was 0.2 mm gap in the volume, which was more than the significance probability. Therefore, the result of this study shows the availability of finger orthoses made by 3D printing technology in the medical field.

• Advances in materials Research
• /
• v.3 no.4
• /
• pp.233-242
• /
• 2014

Magnetic and conducting aniline sulfide resin cross-linked (ASC-Fe3O4) nanocomposite has been prepared in the presence of aniline sulfide resin (ASR), aniline, $Fe_3O_4$ coated by polyethylene glycol (PEG) and initiator. The magnetic properties of the resulting composites showed ferromagnetic behavior, such as high-saturated magnetization (Ms= 41 emu/g), and coercive force (Hc=1.5 Oe). The saturated magnetization was increased by increasing of $Fe_3O_4$ content and decreased by increasing aniline ratio. The transmission electron micrograph (TEM) and X-ray diffraction proved that nanometer-sized about 20-30 nm $Fe_3O_4$ in the composite. The average size of ASC-$Fe_3O_4$ nanocomposite with core-shell structure was about 50-60 nm, and polydisperse. This approach may also be extended to the synthesis and modification of other polymers. Electrical conductivity of aniline sulfide resin cross-linked (ASC) nanocomposite has been studied by four-point probe method and produced $3.3{\times}10^{-4}S/cm$ conductivity for it. The conductivity of the composites at room temperature depended on the $Fe_3O_4$, aniline ratio and doping degree. The thermogravimetry analysis (TGA) results showed that this resin is thermal resistance near of $500^{\circ}C$. So, It can be used for resistance thermal coating for military applications. $Fe_3O_4$-PASC nanocomposite has been flexible structure with electrical and magnetic properties.

• Journal of Microbiology and Biotechnology
• /
• v.20 no.2
• /
• pp.265-270
• /
• 2010

Two major endoglucanase genes (cel7B and cel5A) were cloned from Penicillium decumbens 114-2 using the method of modified thermal asymmetric interlaced polymerase chain reaction (TAIL-PCR). The result of Southern blotting suggested that P. decumbens has a single copy of the cel5A gene and a single copy of the cel7B gene in its chromosomal DNA. The expression levels of cel5A and cel7B were determined by means of real-time quantitative PCR, suggesting that the two genes were coordinately expressed, and repressed by glucose and induced by cellulose. Both endoglucanase genes were expressed in Saccharomyces cerevisiae and the recombinant proteins were purified. The recombinant Cel7B and Cel5A were both optimally active at $60^{\circ}C$ and pH 4.0. The recombinant Cel7B showed more than 8-fold, 30-fold, and 5-fold higher enzyme activities toward carboxymethyl cellulose, barley $\beta$-glucan, and PASC, respectively, in comparison with that of Cel5A. However, their activities toward pNPC and Avicel showed minor differences. The results suggested that Cel7B is a strict endoglucanase, whereas Cel5A showed processivity because of its relative higher ability to hydrolyze the crystal cellulose.

• Korean Journal of Digital Imaging in Medicine
• /
• v.9 no.1
• /
• pp.31-35
• /
• 2007

외부 데이터가 진료병원 Server에 저장됨에 있어서 판독을 의뢰하지 않을 경우, 대부분의 병원이 무상으로 이루어 지고 있는 상황이며 이에 외부 데이터 단순 import의 효율적인 관리를 위한 수가 적용 여부를 검토하였다. 2007년 3월부터 4월까지 서울 경기 지역의 PACS가 도입 된지 1년 이상, 병상 수 500Bed 이상의 종합 대학병원 25곳에 근무하는 각 병원의 PACS 운영실 및 PACS 관리자를 대상으로 하였다. 외부 데이터에 관한 10가지 항목의 설문지를 작성하여 각 병원의 PASC 담당자 및 관리자를 대상으로 E-mail을 이용한 자기 기입 방식, 전화를 통한 질의응답 방식으로 조사하였다. 조사된 25개의 종합 대학병원의 96%이상이 외부 데이터 단순 import를 지원하고 있었으며, 그 중 92%의 병원은 무상으로 이루어지고 있었다. 이와 같이 진행 되는 부분에 대하여 각 병원의 PACS 담당자 70% 이상이 단순 import에 대한 수가 적용의 필요성을 느끼고 있으며, 현재 많은 병원에서 단순 import의 무상 지원으로 인한 문제점을 인식하고 있었다. K병원을 기준으로 단순 import에 년간 H/W 소요 비용은 336만원이고, 년간 인건비 소요비용은 421만원이다. 또한 단순 import 한 건당 평균 데이터 size는 48MB 정도로 조사되었다. 환자 입장에서 진료에 참고자료로 사용 될 외부 데이터의 정확한 저장과 정당한 PACS 사용을 위해서는 그에 상응하는 수가가 적용 되어야 할 것이다. 보험심사평가원 급여기준에 따라 수가적용이 인정되어 의료영상 디지털화로 인한 초기의 고액 투자비용 보장과 회수를 위해 단순 Import의 수가 적용이 반드시 필요하다고 사료 된다.

• Journal of Microbiology and Biotechnology
• /
• v.31 no.10
• /
• pp.1446-1454
• /
• 2021

Herein, we cloned and expressed an endo-β-1,4-glucanase gene (celA1805) from Bacillus subtilis B111 in Escherichia coli. The recombinant celA1805 contains a glycosyl hydrolase (GH) family 8 domain and shared 76.8% identity with endo-1,4-β-glucanase from Bacillus sp. KSM-330. Results showed that the optimal pH and temperature of celA1805 were 6.0 and 50℃, respectively, and it was stable at pH 3-9 and temperature ≤50℃. Metal ions slightly affected enzyme activity, but chemical agents generally inhibited enzyme activity. Moreover, celA1805 showed a wide substrate specificity to CMC, barley β-glucan, lichenin, chitosan, PASC and avicel. The K_m and V_max values of celA1805 were 1.78 mg/ml and 50.09 µmol/min/mg. When incubated with cellooligosaccharides ranging from cellotriose to cellopentose, celA1805 mainly hydrolyzed cellotetrose (G4) and cellopentose (G5) to cellose (G2) and cellotriose (G3), but hardly hydrolyzed cellotriose. The concentrations of reducing sugars saccharified by celA1805 from wheat straw, rape straw, rice straw, peanut straw, and corn straw were increased by 0.21, 0.51, 0.26, 0.36, and 0.66 mg/ml, respectively. The results obtained in this study suggest potential applications of celA1805 in biomass saccharification.