• 대한전기학회논문지:시스템및제어부문D
• /
• 제52권2호
• /
• pp.107-111
• /
• 2003

In the power-line communication systems, there are many factors of noise and attenuation in the power-line channels, because they were designed for not the communication but the power transmission. Also the transfer function of the channels is highly changed with the topology and the load of the power-lines. To cope with these poor channel situation, channel modeling, one of the many studies in progress, is being studied hard. Channel modeling is essential to apply the active schemes to overcome the bad channel(e.g. modulation technique, channel coding, signal coupling & filtering, etc.) to the power-line communications. In this paper, we have realized the statistical model(this model is suggested as the channel modeling method for the power-line channels) that is combined the transfer function with the various noises. And we have compared and examined the results with the measured data. Also we have studied the plan which can effectively establish the channel data base for the channel information consisted of the parameters that are derived from this modeling, and we have studied the plan to utilize the data base.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집
• /
• pp.185-188
• /
• 2001

Chemical mechanical polishing(CMP) process is widely used for global planarization of inter-metal dielectric (IMD) layer and inter-layer dielectric (ILD) for deep sub-micron technology. However, as the IMD and ILD layer gets thinner, defects such as micro-scratch lead to severe circuit failure, which affect yield. In this paper, for the improvement of CMP Process, deionized water (DIW) pressure, purified $N_2$ (P$N_2$) gas, slurry filter and high spray bar were installed. Our experimental results show that DIW pressure and P$N_2$ gas factors were not related with removal rate, but edge hot-spot of patterned wafer had a serious relation. Also, the filter installation in CMP polisher could reduce defects after CMP process, it is shown that slurry filter plays an important role in determining consumable pad lifetime. The filter lifetime is dominated by the defects. However, the slurry filter is impossible to prevent defect-causing particles perfectly. Thus, we suggest that it is necessary to install the high spray bar of de-ionized water (DIW) with high pressure, to overcome the weak-point of slurry filter. Finally, we could expect the improvements of throughput, yield and stability in the ULSI fabrication process.

• 정보처리학회논문지C
• /
• 제10C권6호
• /
• pp.711-716
• /
• 2003

인터넷상에 분산된 시스템들의 시각동기(time synchronization) SNTP(Simple Network Time Protocol) 의 시각동기모델을 분석하고 안정딘 시각오프셋을 제공할 수 있는 새로운 시각동기모델을 제안한다 SNTP 가 사용면에서는 간다나나 다영한 오류 요소를 구려하지 않으므로 인해 발생하는 안정성 면에서는 단점을 보완하기 위해 SNTP 시각 오프셋 추정식을 분석한다. 분석 결과로 추정된 시각 오프셋이 동적 오류 요소인 송신지연과 수신지연의 차이를 대표적인 오류 요소로 내포하고 있음을 확인하고 송수신 지연차를 적용한 새로운 시각동기 모델로 동적선형모델을 적용한 시각오프셋 추정 모델을 제안한다. 그리고 실측을 통한 송수신 지연차의 특성을 분석 결과로 제시한다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 추계학술대회 논문집 전력기술부문
• /
• pp.251-254
• /
• 2003

A voltage stability assessment consists of the contingency screening, voltage stability analysis, and counter measures. A widely used index for the voltage stability assessment of power system is the reactive power margin. It shows some factors of voluntariness as following the status of power system and load levels for the target analyzing area. Therefore, it has a demerit that the absolute amounts of reactive power margin is not to be applied by the quantized margin criterion. This paper selects a vulnerable area by assigning the voltage instability for the particular contingency for the selection of vulnerable area in the respect of the investigation of reactive power margin or VQVI as an index of V-Q margin sensitivity in order to overcome the demerit. This will be able to grasp the V-Q margin sensitivity for the target analyzing area by presenting the ratio of power margin between the margin before and after contingency as following the calculation of reactive power margin. The presented method is applied to the voltage stability assessment for the Metropolitan area of 2003 KEPCO summer peak system.

• 에너지공학
• /
• 제26권1호
• /
• pp.9-22
• /
• 2017

A combined thermal and flow analysis was carried out to study the behavior and performance of a small, commercial LTD (Low-Temperature-Differential) heat engine. Laminar-flow solutions for annulus and channel flows were employed to estimate the viscous drags on the piston and the displacer and the pressure difference across the displacer. Temperature correction factors were introduced to account for the departure from the ideal heat transfer processes. The analysis results indicate that the work required to overcome the viscous drags on engine moving parts and to move the displacer is much smaller than the moving-boundary work produced by the power piston for temperature differentials in the neighborhood of $20^{\circ}C$ and engine speeds below 10 RPS. A comparison with experimental data reveals large degradations from the ideal heat transfer processes. Thus, heat-transfer devices inside the displacer cylinder are recommended.

• Restorative Dentistry and Endodontics
• /
• 제35권2호
• /
• pp.65-68
• /
• 2010

복합레진의 개발 및 환자의 심미적 욕구로 인해 기존의 아말감을 복합레진 수복이 빠른 속도로 대체하고 있다. 하지만 복합레진의 경우 술식의 어려움, 중합수축으로 인한 응력의 발생, 재료의 파절, 이차우식등의 문제를 가지고 있으며 아직까지 복합레진 수복을 위해서는 치과용 접착제의 사용이 필수적이다. 이에 본 글에서는 현재 복합레진이 가지고 있는 문제점을 극복하기 위해 복합레진 수복의 가장 많은 실패 원인으로 알려진 이차우식을 억제할 수 있는 재광화 물질을 방출할 수 있는 복합레진의 개발이 어디까지 이루어지고 있는지 살펴보고 앞으로의 임상적용 가능성에 대해 생각해보고자 한다.

• Journal of Electrical Engineering and Technology
• /
• 제2권2호
• /
• pp.178-187
• /
• 2007

One important issue in power systems is dynamic instability due to loosing balance relation between electrical generation and a varying load demand that justifies the necessity of stabilization. Moreover, Power System Stabilizer (PSS) must have capability of producing appropriate stabilizing signals over a wide range of operating conditions and disturbances. To overcome these drawbacks, this paper proposes a new method for robust design of PSS by using an auto-tuning fuzzy control in combination with Real-Coded Genetic Algorithm (RCGA). This method includes two fuzzy controllers; internal fuzzy controller and supervisor fuzzy controller. The supervisor controller tunes the internal one by on-line applying of nonlinear scaling factors to inputs and outputs. The RCGA-based method is used for off-line training of this supervisor controller. The proposed PSS is tested in three operational conditions; nominal load, heavy load, and in the case of fault occurrence in transmission line. The simulation results are provided to compare the proposed PSS with conventional fuzzy PSS and conventional PSS. By evaluating the simulation results, it is shown that the performance and robustness of proposed PSS in different operating conditions is more acceptable

• 농촌계획
• /
• 제22권2호
• /
• pp.9-18
• /
• 2016

In this research, we reappraise saemaul project which is a leading role of rural development in a present perspectives and deduct social and political implications for rural development. For deducting problems and implications, related documents and previous researches are reviewed. Administration statistics are also gathered and analyzed for monitoring detailed projects propulsion progress and results. Samaul project is reappraised based on previous researches such as rural development, regional agricultural production system improvement, agricultural distribution system improvement, leader breeding, income improvement, and governance. Saemaul project has basically positive characteristics because of decreasing growth gap of urban and rural area by empowering cooperation of rural residents, instilling leadership, making village fund, constricting networks of government and urban area for administrative and financial assistant. In conclusion, there are implications that continues interests of most powerful sovereignty and comprehensive assistant of government are needed for overcome agricultural and rural crisis. Saemaulundong is a united and systematic approach in village level. In south korea where most of farms are small size, village or regional level assistants started in saemaulundong are still needed. In regional development, we can infer that will and ability development of participated residents are most basic and important factors for successful project propulsion in saemaul project.

• 대한방사성의약품학회지
• /
• 제2권1호
• /
• pp.43-50
• /
• 2016

$^{89}Zr$ with the favorable nuclear decay kinetics and chemical properties is an appealing radiometal for its application in immuno-PET using radiolabeled monoclonal antibodies. Rising demand of ultrahigh purity and high-specific activity $^{89}Zr$ has propelled the radiochemist worldwide to develop an overall efficacious method for its promising separation from the target matrix $^{89}Y$. The requirement of elevated radiochemical purity (${\geq}$ 99.99%) has accelerated the efforts since last two decades to achieve higher decontamination and separation factors of carrier free $^{89}Zr$ over $^{89}Y$ using several suitable separation techniques. However, each of the technique has its own pros and cons which prior to its actual medical application needs to be optimized and thoroughly scrutinized to avoid further complications during radiolabelling of the pharmaceuticals. In this short review article we will specifically consider as well focus on the historical development and the recent advances on the radiochemical separation of $^{89}Zr$ from $^{89}Y$ which will be helpful for the separation scientist involved in this area to understand the existing available means and plan the strategy to investigate and develop the novel techniques to overcome the problems involved in the present methods.

• International Journal of Industrial Entomology and Biomaterials
• /
• 제32권2호
• /
• pp.49-53
• /
• 2016

Bone morphogenetic proteins (BMPs) are essential growth factors for bone formation, skeletal development and bone regeneration. The BMP-2/7 heterodimer is known to have remarkable effects on osteogenic induction that are even stronger than the BMP-2 or BMP-7 homodimers. We designed a recombinant human BMP-2/7 (rhBMP-2/7) heterodimer protein with four glycine residues between BMP-2 and BMP-7 protein to facilitate free bond rotation of domains. The Baculovirus Expression Vector System (BEVS) is routinely used to produce recombinant proteins in the milligram scale. In this study, the BEVS was used to express the rhBMP-2/7 protein whrer the recombinant baculovirus was recovered in the host Sf9 cells. To confirm the biological activity of rhBMP-2/7 protein secreted from the BEVS as an osteogenic differentiation and induction factor, we measured the BMP-induced ALP activity. rhBMP-2/7 could be used as an alternative to BMPs to overcome limitations like short half-life and requirement for high concentrations. Furthermore, rhBMP-2/7 may be an efficient tool for various application studies such as bone regeneration and skeletal development.