• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.523-523
• /
• 2012

As the wafer geometric requirements continuously complicated and minutes in tens of nanometers, the expectation of real-time add-on sensors for in-situ plasma process monitoring is rapidly increasing. Various industry applications, utilizing plasma impedance monitor (PIM) and optical emission spectroscopy (OES), on etch end point detection, etch chemistry investigation, health monitoring, fault detection and classification, and advanced process control are good examples. However, process monitoring in semiconductor manufacturing industry requires non-invasiveness. The hypothesis behind the optical monitoring of plasma induced ion current is for the monitoring of plasma induced charging damage in non-invasive optical way. In plasma dielectric via etching, the bombardment of reactive ions on exposed conductor patterns may induce electrical current. Induced electrical charge can further flow down to device level, and accumulated charges in the consecutive plasma processes during back-end metallization can create plasma induced charging damage to shift the threshold voltage of device. As a preliminary research for the hypothesis, we performed two phases experiment to measure the plasma induced current in etch environmental condition. We fabricated electrical test circuits to convert induced current to flickering frequency of LED output, and the flickering frequency was measured by high speed optical plasma monitoring system (OPMS) in 10 kHz. Current-frequency calibration was done in offline by applying stepwise current increase while LED flickering was measured. Once the performance of the test circuits was evaluated, a metal pad for collecting ion bombardment during plasma etch condition was placed inside etch chamber, and the LED output frequency was measured in real-time. It was successful to acquire high speed optical emission data acquisition in 10 kHz. Offline measurement with the test circuitry was satisfactory, and we are continuously investigating the potential of real-time in-situ plasma induce current measurement via OPMS.

• Journal of Positioning, Navigation, and Timing
• /
• v.4 no.4
• /
• pp.161-171
• /
• 2015

Alternative binary offset carrier (AltBOC) signals can be approximated by four synchronized direct sequence spread spectrum (DSSS) signals, each pair of which is a quadrature phase shift keyed (QPSK) signal at a different frequency. Therefore, depending on the strength of an incoming AltBOC signal, an acquisition technique can reduce the mean acquisition time (MAT) by searching the four DSSS signals asynchronously; the search for each of the four DSSS signals can start at one of the evenly separated hypotheses on the two-dimensional hypothesis space. And detection sensitivity can be improved by multiple levels when different numbers of search results for the same hypothesis are combined. In this paper, we propose a fast AltBOC acquisition technique that has an asynchronous search strategy and efficiently utilizes the output of the four search results to increase the sensitivity level when sensitivity improvement is needed. We provide a complete theoretical analysis and demonstrate with numerous Monte Carlo simulations that the MAT of the proposed technique is much smaller than conventional AltBOC acquisition techniques.

• The Journal of Asian Finance, Economics and Business
• /
• v.7 no.8
• /
• pp.225-231
• /
• 2020

The paper aims to investigate the impact of trade integration on business cycle synchronization for the East Asian countries during 2005- 2017 based on the endogeneity hypothesis of Optimum Currency Area criteria. We test the determinants of business cycles by calculating bilateral trade, financial integration, and business cycle synchronization. Applying the system Generalized Method of Moments for dynamic panel data models, the results show that business cycle synchronization is highly associated with trade and financial integration. These findings confirm the endogeneity hypothesis that more trade integration will mitigate asymmetric shocks, and have a positive impact on the business cycle synchronization. The increased trade intensity and financial linkage lead to more correlated business cycles in East Asia. Apart from trade and financial integration, the trade structure differential, monetary policy similarity also influence the business cycle comovement. The significantly negative impact of trade structure differential on business cycle synchronization suggests that countries with less similar structures are more likely to undergo asymmetric shocks. The results also indicate that monetary policy matters for output comovement. This study recommends that the East Asian countries should focus on bilateral trade as well as financial integration with each other to reap benefits from the integration process.

• Journal of Advanced Marine Engineering and Technology
• /
• v.19 no.3
• /
• pp.77-83
• /
• 1995

Recently, in the field of industrial servo-systems, several methods have been proposed for tracking the reference input fastly and finely without overshoot. These methods, however, are established under hypothesis that structure and parameters of the plant are known accurately and they are time invariant. In practice, it is difficult to obtain the values of plant's parameters accurately and usually plants change with time and operation conditions. In this paper a method to construct the nominal model tracking adaptive control system is proposed. The system is composed of the nomial model which produces a ideal response and the model tracking system with the fuzzy adaptive controller. If the actual plant is equal to the controlled object in the nominal model, the output of the plant is the same as that of the nominal model and the fuzzy adaptive controller becomes idle. However, when the plant changes, the fuzzy adaptive controller of the tracking system operates in order for the output of the plant to track the ideal response. Through the computer simulations under various conditions, it is confirmed that the proposed model tracking system is very effective.

• Journal of Dental Anesthesia and Pain Medicine
• /
• v.20 no.3
• /
• pp.129-135
• /
• 2020

Background: Postoperative fluid retention is a factor that causes delay in recovery and unexpected adverse events. It is important to prevent intraoperative fluid retention, which is putatively caused by intraoperative release of stress hormones, such as ADH (anti-diuretic hormone) or others. We hypothesized that intraoperative analgesia may prevent pathological fluid retention. We retrospectively explored the relationship between analgesics and in-out balance in surgical patients from anesthesia records. Methods: Anesthetic records of 80 patients who had undergone orthognathic surgery were checked in this study. Patients were anesthetized with either TIVA (propofol and remifentanil) or inhalational anesthesia (sevoflurane and remifentanil). During surgery, acetated Ringer's solution was infused for maintenance at a rate of 3-5 ml/kg/h at the discretion of the anesthetist. The perioperative parameters, including the amount of crystalloid and colloid infused, and the amount of urine and bleeding were checked. Furthermore, we checked the amount and administration rate of remifentanil during the surgical procedure. The correlation coefficient between the remifentanil dose and the in-out balance or the urinary output was analyzed using the Pearson correlation coefficient. The contributing factor to fluid retention, including urinary output, was statistically examined by means of multivariate logistic regression analysis. Results: A significant positive correlation was found between remifentanil dose and urinary output. Urinary output less than 0.04 ml/kg/min was suggested to cause positive fluid balance. Although in-out balance approaches zero balance with increase in remifentanil administration rate, no contributing factor for near-zero fluid balance was statistically picked up. The remifentanil administration rate was statistically picked up as the significant factor for higher urinary output (> 0.04 ml/kg/min) (OR, 2,644; 95% CI, 3.2-2.2 × 10⁶) among perioperative parameters. Conclusions: In conclusion, remifentanil contributes in maintaining the urinary output during general anesthesia. Although further prospective study is needed to confirm this hypothesis, it was suggested that fluid retention could be avoided through suppressing intraoperative stress response by means of appropriate maintenance of remifentanil infusion rate.

• IEMEK Journal of Embedded Systems and Applications
• /
• v.8 no.4
• /
• pp.185-194
• /
• 2013

Abstract- In distant-talking environments, speech recognition performance degrades significantly due to noise and reverberation. Recent work of Michael L. Selzer shows that in microphone array speech recognition, the word error rate can be significantly reduced by adapting the beamformer weights to generate a sequence of features which maximizes the likelihood of the correct hypothesis. In this approach, called Likelihood Maximizing Beamforming algorithm (Limabeam), one of the method to implement this Limabeam is an UnSupervised Limabeam(USL) that can improve recognition performance in any situation of environment. From our investigation for this USL, we could see that because the performance of optimization depends strongly on the transcription output of the first recognition step, the output become unstable and this may lead lower performance. In order to improve recognition performance of USL, some post-filter techniques can be employed to obtain more correct transcription output of the first step. In this work, as a post-filtering technique for first recognition step of USL, we propose to add a Wiener-Filter combined with Feature Weighted Malahanobis Distance to improve recognition performance. We also suggest an alternative way to implement Limabeam algorithm for Hidden Markov Network (HM-Net) speech recognizer for efficient implementation. Speech recognition experiments performed in real distant-talking environment confirm the efficacy of Limabeam algorithm in HM-Net speech recognition system and also confirm the improved performance by the proposed method.

• Journal of Technology Innovation
• /
• v.16 no.2
• /
• pp.65-94
• /
• 2008

There has been rapid diffusion of digital innovation technology(DIT) such as 3 D CAD, CAE, simulation software which enable firms to see the future results of intended product designs through 3 D diagram and simulated results. This technology helps firms to reduce trial and error process by solving later stage problems in earlier stages. The DIT being the technology reflecting the real world, as a tool representing the simplified form of the real world, the degree of reflecting the real world(fidelity) is important in utilizing the DIT. This study is an exploratory research examining the process of reviewing the fidelity of the DITs and developing the complementary process necessary for utilizing the DIT with 'not good enough' fidelity. This study could draw out, from its case study, an exploratory hypothesis about the process of developing the complementary process. In the process, there is an analysis of the corresponding relationship between the actual data and the output data of the DIT, e.g. simulated result. Then the input data or output data are adjusted on the basis of the analysis of the corresponding relationship so that the discrepancy between the actual data and the expected interpretation of the output data, through the adjustment, of the DIT, can be reduced. This process is sometimes accompanied by the process of generating experimental data, which reflect the unique situation of the product development process of a company, to be put to the data base of DIT. The complementary process is the process requiring knowledge sharing and adjustment activities across different divisions. This study draw outs implications for effective management of the fidelity of DIT tools.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.63 no.11
• /
• pp.1545-1550
• /
• 2014

Fault detection and diagnosis (FDD) of photovoltaic (PV) power systems is one of significant techniques for reducing economic loss due to abnormality occurred in PV modules. This paper presents a new FDD method against PV power systems by using statistical comparison. This comparative approach includes deviation signals between the outputs of two neighboring PV modules. We first define a binary hypothesis testing under such deviation and make use of a generalized likelihood ratio testing (GLRT) theory to derive its FDD algorithm. Additionally, a recursive computational mechanism for our proposed FDD algorithm is presented for improving a computational effectiveness in practice. We carry out a real-time experiment to test reliability of the proposed FDD algorithm by utilizing a lab based PV test-bed system.

• The Korean Journal of Physiology
• /
• v.30 no.1
• /
• pp.117-124
• /
• 1996

This study evaluated the hypothesis that motoneuron collaterals modulate the excitability of ventral spinocerebellar tract neurons. In acute cats, 128 ventral cerebellar tract cells were studied extracellularly to determine the effects of ventral root stimuli. The majority of the cells responded to ventral root stimulation with either short or long latency increases in spike discharge. In many cells with sufficient spontaneous activity ventral root stimulation also evoked a long lasting reduction in activity. In preparations with the dorsal root ganglion removed VSCT neurons had similar response properties. In some cells contralateral ventral root stimulation also evoked excitatory responses. These findings indicate the VSCT can provide the cerebellum with information regarding activity in the final output neurons of the motor system, the alpha motoneurons.

• Journal of Families and Better Life
• /
• v.10 no.2
• /
• pp.163-178
• /
• 1992

This study is focused on causual relationship analysis among the components of family resource management system based on a theory of Deacon and Firebaugh. The system of family resource management is consisted for the component of input like on objective resource and level of resource perception, the component of throughput like a behavior pattern of the family resource management, and the component of output like a degree of the family life satisfaction. The instrument for resource perception level, behavior pattern of family resource management and degree of life satisfaction were developed for this study, and main investigation was executed through 1st and 2nd pre-test. The 800 questionnaire were distributed by cluster sampling to the homemakers in Seoul. The final data used in this study were 703, and analyzed by Cronback's coefficient, factor analysis. frequency. percentage, regression analysis and path analysis, and teated with SAS PC+. Consequently , the findings of this study were accepted hypothesis I, II, II, IV.