• 제목/요약/키워드: Oscillation mode

검색결과 306건 처리시간 0.04초

DFT 알고리즘을 이용한 전력계통 동요모드 확인 (Identification of Power System Oscillation Using DFT Algorithm)

  • 김동준;문영환;金容鶴;윤용범
    • 대한전기학회논문지:전력기술부문A
    • /
    • 제50권5호
    • /
    • pp.218-224
    • /
    • 2001
  • This paper describes the identification of torsional modes and power oscillation modes including the inter-area modes and local modes of KEPCO using the proposed DFT analysis algorithm which is applied to the digitally recorded RMS values of power system variables such as steady-state measured active power, load angle and so on. As a result, the inter-area mode of 0.65Hz and the local modes of the three different generators were identified. In addition the torsional modes of two steam-turbo generators were analyzed by applying the DFT algorithm. Thus, this paper clearly shows the availability of the proposed DFT algorithm that can analyze the digitally recorded effective values measured from the equipment such as PMU of DSM.

  • PDF

무밸브 마이크로 펌프의 유동 특성에 관한 수치해석 (A Numerical Study on the Flow Characteristics of a Valveless Micropump)

  • 진상문;허남건
    • 유체기계공업학회:학술대회논문집
    • /
    • 유체기계공업학회 2004년도 유체기계 연구개발 발표회 논문집
    • /
    • pp.748-753
    • /
    • 2004
  • The performance of a valveless micropump driven by chamber wall oscillation was numerically investigated for various frequency and amplitude of the oscillation. The numerical study was performed in the range of oscillation frequency from 200Hz to 1000Hz and amplitude from $1{\mu}m$ to $15{\mu}m$. And optimal values for the parameters are found. At the oscillation frequency 600Hz, the net flow rate of micropump shows a maximum value. Also the results show good agreement with the experimental results. The total flow rate was increased with the oscillation amplitude. However, the net flow rate was found to be decreased over $7{\mu}m$.

  • PDF

Unstable Operation of Francis Pump-Turbine at Runaway: Rigid and Elastic Water Column Oscillation Modes

  • Nicolet, Christophe;Alligne, Sebastien;Kawkabani, Basile;Simond, Jean-Jacques;Avellan, Francois
    • International Journal of Fluid Machinery and Systems
    • /
    • 제2권4호
    • /
    • pp.324-333
    • /
    • 2009
  • This paper presents a numerical simulation study of the transient behavior of a $2{\times}340MW$ pump-turbine power plant, where the results show an unstable behavior at runaway. First, the modeling of hydraulic components based on equivalent schemes is presented. Then, the 2 pump-turbine test case is presented. The transient behavior of the power plant is simulated for a case of emergency shutdown with servomotor failure on Unit 1. Unstable operation at runaway with a period of 15 seconds is properly simulated using a 1-dimensional approach. The simulation results points out a switch after 200 seconds of the unstable behavior between a period of oscillations initially of 15 seconds to a period of oscillation of 2.16 seconds corresponding to the hydraulic circuit first natural period. The pressure fluctuations related to both the rigid and elastic water column mode are presented for oscillation mode characterization. This phenomenon is described as a switch between a rigid and an elastic water column oscillation mode. The influence of the rotating inertia on the switch phenomenon is investigated through a parametric study.

빠른 응답특성을 갖는 DC/DC 컨버터 하이브리드 전류 모드 제어기 (Hybrid Current Mode Controller with Fast Response Characteristics for DC/DC Converter)

  • 오승민;백승우;김학원;조관열
    • 전력전자학회논문지
    • /
    • 제24권2호
    • /
    • pp.134-137
    • /
    • 2019
  • A wide-bandwidth current controller is required for fast charging/discharging of super capacitor applications. Peak current mode is generally used to accomplish fast charging/discharging because this mode has fast response characteristics. However, the peak current mode control must have a slope compensation function to restrain sub-harmonics oscillation. The slope must be changed accordingly if the controlled output voltage is varied. However, changing the slope for every changed output voltage is not easy. The other solution, selecting the slope as the maximum value, causes a slow response problem to occur. Therefore, we propose a hybrid mode controller that uses a peak current and a newly specified valley current. Through the proposed hybrid mode control, the sub-harmonic oscillation does not occur when the duty is larger than 0.5 because of the fast response.

230mm급 고체 추진기관의 연소불안정 거동 현상 분석 (An Analysis on Combustion Instability in Solid Rocket Motor of 230mm Grade)

  • 권태훈;노태호;서혁
    • 한국추진공학회:학술대회논문집
    • /
    • 한국추진공학회 2009년도 춘계학술대회 논문집
    • /
    • pp.177-180
    • /
    • 2009
  • 직경 대 길이비(L/D)의 값이 큰 고체 추진기관에서는 축방향 연소불안정 현상이 발생할 가능성이 높다. 일반적으로 이러한 현상을 억제하기 위해 추진제에 금속입자를 포함시키거나 그레인 설계시 축방향 압력 진동을 억제할 수 있도록 형상을 고안한다. Slotted-Tube형 그레인을 적용한 고체 추진기관은 연소시 Slot의 영향으로 인해 축방향 압력진동이 억제되나 Slot의 길이가 짧을 경우 연소 중반이후부터 실린더부의 영향으로 축방향 압력진동이 증폭될 수 있다. 본 연구에서는 230mm급 고체 추진기관의 연소 시험 결과 중 압력에 대해 스펙트럼 분석 및 음향모드 해석을 수행하여 축방향 압력 진동 현상을 분석하였다.

  • PDF

이산화탄소로 희석된 메탄-공기 확산화염의 에지화염 불안정성 (Edge Flame Instability of CH4-Air Diffusion Flame Diluted with CO2)

  • 황동진;김정수;길상인;김태권;박정
    • 대한기계학회논문집B
    • /
    • 제30권9호
    • /
    • pp.905-912
    • /
    • 2006
  • Experiments in low strain rate methane-air counterflow diffusion flames diluted with $CO_2$ have been conducted to investigate the flame extinction behavior and edge flame oscillation in which flame length is less than the burner diameter and thus lateral conductive heat loss in addition to radiative loss could be remarkable at low global strain rates. The critical mole fraction at flame extinction is examined in terms of velocity ratio and global strain rate. It is seen that flame length is closely relevant to lateral heat loss, and this sheets flame extinction and edge flame oscillation considerably. Lateral heat loss causes flame oscillation even at fuel Lewis number less than unity. Edge flame oscillations are categorized into three: a growing-, a harmonic- and a decaying-oscillation mode. Onset conditions of the edge flame oscillation and the relevant modes are examined with global strain rate and $CO_2$ mole fraction in fuel stream. A flame stability map based on the flame oscillation modes is also provided at low strain rate flames.

표면연소기의 연소진동음에 관한 연구 (A Study on Combustion-Driven Oscillations in a Surface Burner)

  • 한희갑;권영필
    • 대한기계학회논문집B
    • /
    • 제22권11호
    • /
    • pp.1582-1590
    • /
    • 1998
  • Combustion-driven oscillations in a surface burner have been investigated to clarify their characteristics. A model combustor is made and the oscillation frequencies are measured for various dimensions of the combustor. It is found that there are two modes of oscillations; one is the 'acoustic mode' at high frequencies, associated with the acoustic mode of the combustion system and the other is the 'combustion mode' at low frequencies around 100 Hz, associated with the instability of the flame. Acoustic mode is excited when the surface burner is placed where the phase of particle velocity leads that of acoustic pressure by $90^{\circ}$, for all the combustion conditions. Combustion mode is driven at high combustion rate by the lift of unstable flame near the lower limit of the combustible equivalence ratio. Combustion mode is greatly influenced by the inlet temperature of the premixed gas. When the inlet temperature is very high, the combustion mode does not occur.

AR 코팅된 DFB 레이저에서 격자 위상의 영향 (Effect of Grating Phase in DFB Lasers with an Anti-reflection Coated Mirror)

  • 권기영;기장근;조현묵
    • 문화기술의 융합
    • /
    • 제7권3호
    • /
    • pp.463-468
    • /
    • 2021
  • 본 연구에서는 1.55um의 파장을 갖는 DFB 레이저에서 굴절률 격자와 이득 격자가 동시에 존재할 때, 오른쪽 거울 면에 반사가 일어나지 않도록 유전막 코팅을 하여 𝜌r=0 이 되도록 하였다. 𝛿L>0인 경우일 때, 발진 모드에 대하여, 발진 주파수와 발진 이득의 특성을 해석했다. 좌측 거울면의 격자 위상이 𝜋에서부터 𝜋/2 계속 감소할 때, 각 모드의 그래프 선들이 좌측으로 조금씩 이동한다. 발진 모드의 문턱 이득이 가장 낮은 경우는 𝜅L=10인 경우이고, 이때 모드 선별성은 상대적으로 낮다. 모드 선별성이 우수한 경우는 𝜅L=0.5에서부터 𝜅L=6 정도까지이고, 이 경우 주파수 안정성이 우수하다. 두 개의 벽개면을 갖는 경우와 비교하면, 한 개의 무반사면을 갖는 경우, 발진 모드의 문턱 이득이 증가하지만 모드 선별성은 2배 정도 더 우수해 진다.

광섬유 패브리-페로 파장가변 필터의 공진특성에 기반한 고속 파장가변 모드잠김 레이저의 제작 (Construction of High-Speed Wavelength Swept Mode-Locked Laser Based on Oscillation Characteristics of Fiber Fabry-Perot Tunable Filter)

  • 이응제;김용평
    • 전기학회논문지
    • /
    • 제58권7호
    • /
    • pp.1393-1397
    • /
    • 2009
  • A high-speed wavelength swept laser, which is based on oscillation characteristics of a fiber Fabry-Perot tunable filter, is described. The laser is constructed by using a semiconductor optical amplifier, a fiber Fabry-Perot tunable filter, and 3.348 km fiber ring cavity. The wavelength sweeps are repeatatively generated with the repetition period of 61 kHz which is the first parallel oscillation frequency of the Fabry-Perot tunable filter for the low power consumption. Mode-locking is implemented by 3.348 km fiber ring cavity for matching the fundamental of cavity roundtrip time to the sweep period. The wavelength tuning range of the laser is 87 nm(FWHM) and the average output power is 1.284 mW.

Empirical Mode Decomposition (EMD) and Nonstationary Oscillation Resampling (NSOR): I. their background and model description

  • Lee, Tae-Sam;Ouarda, TahaB.M.J.;Kim, Byung-Soo
    • 한국수자원학회:학술대회논문집
    • /
    • 한국수자원학회 2011년도 학술발표회
    • /
    • pp.90-90
    • /
    • 2011
  • Long-term nonstationary oscillations (NSOs) are commonly observed in hydrological and climatological data series such as low-frequency climate oscillation indices and precipitation dataset. In this work, we present a stochastic model that captures NSOs within a given variable. The model employs a data-adaptive decomposition method named empirical mode decomposition (EMD). Irregular oscillatory processes in a given variable can be extracted into a finite number of intrinsic mode functions with the EMD approach. A unique data-adaptive algorithm is proposed in the present paper in order to study the future evolution of the NSO components extracted from EMD.

  • PDF