• 전기의세계
• /
• v.31 no.2
• /
• pp.132-140
• /
• 1982

Designing the capacitor-run motor for balanced operation is accompanied with the excessive capacitor value and low capacitor terminal voltage of condenser. As a solution for this problems, It was reported the design by equal volt-ampere method. The running characteristics of capacitor-run motor by this method due to the balancing point selection, however, has a room to be studied further. This paper deals with the determination of the winding ratio and capacitor value of a permarient-split capacitor motor by balanced operation and equal volt-ampere method at the different load points. The analysis of the running characteristics of a motor and its designing method also presented for both cases. It concluded that the running characteristics due to the equal volt-ampere operation are very close to the balanced operation.

• Journal of Electrical Engineering and Technology
• /
• v.9 no.3
• /
• pp.777-781
• /
• 2014

The current limiting characteristics of the flux-lock type superconducting fault current limiter (SFCL) using series connected two coils with twice triggering operation, which consists of series connected two coils and two superconducting (SC) modules with the inserting resistance, was analyzed. The feature of the suggested SFCL is that it can limit the fault current by triggering either one SC module or two SC modules comprising the SFCL depending on the amplitude of the fault current. To verify the current limiting operation of the suggested SFCL, the short-circuits in the fault location with the different fault currents were tested and its useful operations were described through the analysis on the tested results.

• Journal of Electrical Engineering and Technology
• /
• v.8 no.1
• /
• pp.106-109
• /
• 2013

It is desirable and advantageous to feed parallel propulsion with induction motors by a single voltage source inverter. However, effects of deviation of the wheel diameters on motor current, rotor speed and torque should be also considered for parallel operation. In order to understand the behavior and characteristics, a simple simulation model is developed by using a commercial Matlab Simulink. From the results, it is clear to manage the diameter deviation of the wheels which are connected to traction motors.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2006.05a
• /
• pp.817-820
• /
• 2006

The Tonpilz transducer is one of the essential elements in active sonar application. The characteristics of transducer depend on the piezoelectric ceramics and mechanical elements such as head mass, tail mass, pre-stress rod and so on. One of the important characteristics is electric and mechanical stability of transducer for long term high power transmitting operation. This parer presents the results about long term endurance tests of the underwater acoustic transducer.

• Journal of the Korean Society for Precision Engineering
• /
• v.19 no.12
• /
• pp.70-77
• /
• 2002

Necessity of the tole-operation has been increased in many fields. Since the Internet is inexpensive and available all over the world, it is a strong candidate for the transmission media of the tole-operation. However, the Internet has random time delays that may cause instability in the system especially if the tole -operation is bilateral. In the past few years many attempts have been made to overcome the random time delay, So far, they are still insufficient in terms of performance. The ‘Variable holding time’ is introduced to improve the performance of the ‘Event based tole-operation’ which controls a system with a non-time action reference. By holding each event for proper time, the system can quickly respond and be stabilized. The proper holding time should be selected based on the characteristics of the task that the system performs. The factors that reflect those characteristics are investigated. The fuzzy logic is employed to obtain the proper holding time for each event while the tole-operation system is in operation. The experimental results presented in this paper verify effectiveness of the proposed method.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.4
• /
• pp.539-546
• /
• 2016

With the growing interest of microgrid systems all over the world, many studies on microgrid operation are being carried out. The battery energy storage system(BESS) and the diesel generator are key equipments in the microgrid. In this paper, we analyze the characteristics of fuel consumption according to the power ratio of the diesel generator. Then, the formula to represent the unit cost of generation according to the power ratio of the diesel generator is derived. A new modeling of battery operation is presented considering the lifetime reduction according to increasing the cycles of charge/discharge operation of the battery. The methodology of determining the optimal operation of the battery and the diesel generator is presented by the use of the formula of fuel consumption of the diesel generator and the new modeling of battery operation. It is shown that this optimization methodology can be applied effectively for economical operation of the BESS and the diesel generator of a microgrid by case studies.

• IEMEK Journal of Embedded Systems and Applications
• /
• v.13 no.5
• /
• pp.269-277
• /
• 2018

NAND flash memory has widely been used because of non-volatility, low power consumption and fast access time. However, it suffers from inability to provide update-in-place and the erase cycle is limited. The unit of read/write operation is a page and the unit of erase operation is a block. Moreover erase operation is slower than other operations. We proposed the Adaptive Garbage Collection (called "AGC") policy which focuses on not only reducing garbage collection process time for real-time guarantee but also wear-leveling for a flash memory lifetime. The AGC performs better than Cost-benefit policy and Greedy policy. But the AGC does not consider the operation characteristics. So we proposed the Advanced Adaptive Garbage Collection (called "A-AGC") policy which considers the page write operation count and block erase operation count. The A-AGC reduces the write operations by considering the data update frequency and update data size. Also, it reduces the erase operations by considering the file fragmentation. We implemented the A-AGC policy and measured the performance compared with the AGC policy. Simulation results show that the A-AGC policy performs better than AGC, specially for append operation.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.60 no.4
• /
• pp.220-226
• /
• 2011

This paper proposes a straightforward method of analyzing the operation characteristics for the capacitor run single-phase induction motor from the traditional equivalent circuit based on the revolving field theory. The proposed method consists of five procedures as follows: mechanical loss segregation, iron loss segregation and calculation of the equivalent circuit parameters, recalculation of parameters of the main winding side, calculation of the auxiliary winding magnetizing reactance and effective turn ratio, and analyzing the operation characteristics for this motor. When the characteristics are analyzed, the segregated mechanical and iron losses are considered as a loss resistance across input terminals of the equivalent circuit for the analysis. The validity of the proposed method is verified from the comparison between the computed results and the experimental ones for the operation characteristics.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.7
• /
• pp.1135-1140
• /
• 2008

Superconducting fault current limiters (SFCL) have been progressing due to the development of superconducting technology. The resistor type SFCL is one of the promising current limiting devices in power system for its effective operation. For proper application and operation of a SFCL, the prior investigation of fundamental characteristics and its effects to the distribution systems are needed. The most important current limiting behavior of a SFCL is dominated by quenching and recovery characteristics. In this paper, the resistive type SFCL was developed by using EMTP/ATPDraw and MODELS language. The operating characteristics and current limiting behaviors of the SFCL in distribution systems have been simulated and investigated.

• Speech Sciences
• /
• v.7 no.3
• /
• pp.285-294
• /
• 2000

In this paper the acoustic characteristics of pathological voice, which are measured before and after surgical operation, are compared. This experiment is conducted for the purpose of predicting patients' speech after operation. The voices are recorded from the same patients. Jitter, shimmer and other parameters are. computed and their statistical characteristics are compared. Also spectral changes, such as formant frequency shift and spectral slope change, are compared. From the experimental results, it is verified that not only source characteristics but also vocal tract components vary. And this indicates that the modification of source parameters are not enough for the prediction. Also the result indicates that the operation causes change to both the physical shape of vocal folds and the manner of articulation.