• 한국화재소방학회논문지
• /
• 제25권2호
• /
• pp.132-137
• /
• 2011

부속실 단독가압의 제연설비 구역에서 계단실 출입문의 크기 변화가 개방 및 폐쇄조건에 미치는 영향을 분석하기 위해서 자동폐쇄장치의 구조와 저항모멘트의 관계를 정리하였으며, 부속실 출입문의 크기 변화를 고려하여 개방력과 폐쇄력을 측정하였다. 그 결과 부속실 출입문의 크기가 증가할수록 개방 및 폐쇄조건에 도달하기 위한 힘의 크기는 증가하였으며, 폐쇄시간, 회전속도, 회전각도와 힘의 관계, 자동폐쇄장치의 효율을 고려한 부속실 출입문의 설계범위가 존재함을 확인하였다.

• 한국융합학회논문지
• /
• 제11권2호
• /
• pp.155-160
• /
• 2020

본 연구에서는 자동차 창문의 개폐에 따라 공기의 내부 유동 해석을 통하여 여름철에 운전자와 동승자의 쾌적한 운전환경을 고찰하였다. 실제 운전 환경을 고려하여, 자동차 창문 개폐 상태로서의 에어컨 입구 조건들을 유동 해석에 적용하였다. 자동차 에어컨 토출구, 시트 그리고 실내를 모델링하였고, 차 내부에서의 공기유동을 해석하여 공기의 유동형상과 내부의 온도분포를 확인하였다. 본 해석에서는 공기 유입부와 배출구를 정하고 자동차 내부를 단열상태로 가정하고 내부공기와 창문 개폐의 영향만을 고려해서 결과를 보았다. 각 조건들의 해석을 고찰해보면 본 연구 모델들이 쾌적한 환경이 유지됨을 알 수 있었다. 차량 창문 개폐에 따른 내부에서의 유동에 대한 본 해석 결과는 디자인 분야에 융합하여 적용될 수 있다고 보인다.

• 한국생산제조학회지
• /
• 제20권5호
• /
• pp.528-534
• /
• 2011

This study analyzes thermal stress and durability fatigue on the modelling of EGR valve. In case of 10% opening at its inlet, the minimum temperature gets cool as 3 times as inlet temperature. The maximum equivalent stress becomes lowest as the value of $2.6274{\times}109$ Pa and fatigue life becomes highest as 23.657 Cycle. But the minimum temperature gets cool as 2.2 times as inlet temperature in case of 50% opening at its inlet. The equivalent stress becomes higher and fatigue life becomes lower than in case of 10% opening. In case of 100% opening at its inlet, the minimum temperature gets cool as 0.2 times as inlet temperature. The equivalent stress becomes lower and fatigue life becomes higher than in case of 50% opening. Maximum equivalent stress and total deformation are shown at the closing of EGR valve by the pressure of inflow gas. The structural analysis result of this study can be effectively utilized with the design of EGR valve by investigating prevention and durability against its damage.

• 한국토양비료학회지
• /
• 제45권6호
• /
• pp.1179-1186
• /
• 2012

For better understanding of carbon cycle dynamics of an agro-ecosystem, an accurate assessment of seasonal and daily $CO_2$ flux is essential to understand the relationship between various environmental factors and crop productivity. We developed the automatic sliding canopy chamber (ASCC) system that measured continuous net ecosystem productivity (NEP) over whole growing season under the natural meteorological rhythm. The ASCC was composed of two main parts which were sliding part for measuring NEP, and automatic opening and closing chamber (AOCC) for measuring soil respiration (SR) on the soil surface. The ASCC was developed by using open flow method for measuring soil $CO_2$ efflux. The disturbance of natural meteorological condition was minimized by opening the base frames. In the field test with barley (Hordeum vulgare L.), NEP was calculated at $140mg\;CO_2\;m^{-2}h^{-1}$ on a clear day using continuous data and eliminated the possibility of overestimate about 16% using one hour data during the day time. Unlike other small scale chamber system, installation on cropping-field made it possible to take any modifications which might be caused by natural environmental condition.

• 대한기계학회논문집
• /
• 제15권6호
• /
• pp.1839-1851
• /
• 1991

Fatigue crack behavior is studied through the two-level rotary bending test with the deep non-through radial holed notch specimens of low carbon steels(SM22C). The main factors investigated are the effects of the damage zone size around crack tip and phenomena of closing or opening of the crack tip. Obtained results are summarized as follows. Fatigue crack behavior in second level stressing slightly lower than fatigue limit is closely related to the size of damage zone produced by the first level stress higher than fatigue limit and to the phenomena of crack closing and opening for the second level stress. The non-propagating crack limit condition depends upon the crack length l$_{1}$ propagated under the first level stress and the magnitude of second level stress .sigma.$_{2}$ lower than the fatigue limit. The non-propagating crack limit condition is expressed by following eq. $\sigma_2^{6.1}{\times}l_{1}=7.35{\times}10^{6}[(kg_{f}mm^{6.1}(mm)]$

• 대한방사선기술학회지:방사선기술과학
• /
• 제42권6호
• /
• pp.477-482
• /
• 2019

Recently, due to the increased use of medical radiation, the radiation exposure of radiation workers should be considered as well as medical exposure of patients. And it is recommended to close the door during radiography. however, In this study, when the door was inevitably opened for radiography, the proposed method was to install the shield as a method of reducing the exposure dose. And its efficiency was analyzed. In simple chest radiography, the measurement point was changed according to the measurement location. Dose rate were measured 10 times for each condition using a dosimeter. And the average value was derived. Using this, the change of dose according to the opening and closing of the door and the installation of the shield was analyzed. Using this, we compared and analyzed the dose change according to the door opening and closing and the installation of the shield, and significance was verified through the SPSS ver. 24. Depending on whether the door was opened or closed, 11,215.35%, 159.0%, 101.9% increased in front of the door in the consol room, behind the wall and behind the lead glass. Depending on the installing of the shield, the 49.2%, 29.6%, 19.9%, 30.6% decrease in front of the door in the examination and consol room, behind the wall and lead glass. In addition, statistical analysis was showed that there were significant differences in both the results according to whether the door was opened or closed and shielding(p<.05). Close the door during radiography. However, when the door should be opened, it was confirmed that the dose rate were reduced by installing the shield. Therefore, to optimize radiation protection, it is recommended to install shields when opening the door.

• 대한가정학회지
• /
• 제41권10호
• /
• pp.199-209
• /
• 2003

The purpose of this study was to investigate the causes of bankruptcy in small apparel stores. Data were collected from 153 apparel retail store owners who experienced failure in small apparel stores in Busan. The results showed as follows; The internal factors that caused bankruptcy in small apparel stores were the problems related with employees, capital, investment, weak marketing strategies, inadequate management, and characteristics of store owners. The external factors were economic condition, unexpected incidents, and the condition of market. There were significant differences in the perception of factors which caused the store bankruptcy according to prior business experience before opening apparel stores, the level of education, and the period between store opening and closing.

• 한국전자통신학회논문지
• /
• 제8권4호
• /
• pp.619-629
• /
• 2013

이 연구는 20대 여대생들을 대상으로 세 가지 균형조절 훈련(Aqua, Bio-feedback, Trampolin)이 정적 균형 능력과 시각, 전정각, 고유수용감각 등의 감각요소에 미치는 효과를 비교하기 위해 아쿠아 훈련군(10명), 바이오피드백 훈련군(10명), 트램폴린 훈련군(9명)으로 무작위 할당한 후 각 군별로 주 3회, 회당 30분간의 운동 프로그램을 6주간 진행하면서 3주후, 6주후에 Tetrax portable multiple system을 이용하여 안정성지수를 측정하고, 근전도 중앙주파수값을 이용하여 산출한 근전도 균형점수를 반복측정된 자료의 분산분석 및 Wilcoxon의 부호순위 검정 등을 이용하여 비교 분석한 결과를 종합해 볼 때, 바이오피드백 훈련은 세 가지 감각기능을 고루 향상시키며 아울러 감각기능 간의 협응성 또한 향상시키는 것으로 판단되며, 아쿠아 훈련은 전정기능을 집중적으로 강화시키는 것으로 보인다.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2007년도 추계 학술대회논문집
• /
• pp.272-276
• /
• 2007

In this paper, we researched a parametric study in flow control system using louver with numerical method. Generally, for the large fans with constant rotational speed, the louver can be used to control the flow rate. The opening and closing of louver can make a some change of flow properties generated by a large fan. To develope the relation between the opening angle of louver and flow rate(or pressure difference), we simulated the flow past the modelled louver installed in a virtual wind tunnel. For the various angles, the mean flow properties are investigated and parameterized with a given boundary condition. The research result can be used directly to design the flow control system of large constant-speed fans, which are often applied to petrolic refinery system.

• 대한한의학원전학회지
• /
• 제13권1호
• /
• pp.74-101
• /
• 2000

Geungyul(根結) means roots and nodes of meridians. If human body gets damaged by energy which each seasons has, the meridians get some troubles. Healing for symptom, meridians consist of root, stay, follow, inpouring and node of acupuncture points should be in harmony. 1. This chapter explain roots and node parts of each meridian, acupuncture points name and root, stay, follow, inpouring of acupuncture points which in arm and leg of three Yin and Yang. 2. The opening, closing, axis function, the symptom, and the needling of both meridians of Yin and Yang are explained. 3. The method that predicts the rise-and-fall of visceral energy and the time of death by using an order of pulse and intermittent pulse is explained. 4. It is explained that since the physical condition of the rich and the poor are different, the method using a needling for each person to be healed, such as the deep-and-shallow and the quick-and-slow, are different. 5. It is explained that the excess and the deficiency in the energy of shape should be considered when a acupuncture is given.