• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.6
• /
• pp.39-47
• /
• 2009

This paper presents implementation of two types of the 802.11 MAC engine for the next generation WLAN, 802.11n. The first version of MAC engine consists of hardwired logic and embedded firmware. Hardwired logic includes Tx block, Rx block, Backoff block, and ChannelManage block. Embedded firmware contains Protocol Control block, MLME block, and MSDU processing block. The first version has a time-critical fault during the atomic transmission caused by software overhead, so it can not be applied to 802.11n MAC. For that reason, the second version has additional blocks with hardwired logic modules to reduce software overhead of the first version. This enhanced version has 73Mbps throughput and it is expected to be further improved up to 129 Mbps with frame aggregation which is one of the key additional features of 802.11n. As a result, the second version of MAC engine can be applied to 802.11n MAC.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.45 no.1
• /
• pp.70-77
• /
• 2008

On the wireless sensor network MAC protocols, one of main issues is energy enciency. Since several asynchronous wireless sensor network MAC protocols with short preamble sampling scheme can be operated without setting the timing synchronization among neighbor nodes, it consumes a little energy for maintaining protocols. However, each node encounters either preamble or data overhearing problem, because each node wakes up in a different time and must check whether the frame is being sent to itself or not. To solve this overhearing problem, we newly propose B-MAC++ that can reduce the overhearing energy consumption by using short preambles with destination address and payload length. from simulation results, we show that the proposed B-MAC++ has advantageous in terms of power consumption efficiency over other asynchronous wireless sensor network MAC protocols.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.15 no.1
• /
• pp.16-27
• /
• 2012

In multi-interface multi-channel(MIMC) based tactical ad hoc networks, QoS support for required operational capacity is one of the main challenging issues for multi-hop transmissions. To support QoS in such a harsh environment, we propose a novel MAC scheme to minimize multi-hop as well as per-hop delay. The current IEEE 802.11 MAC protocols should contend to reserve the channel resource at every hop by each sender. The every-hop channel contention results in a degradation of end-to-end delay for multi-hop transmissions. The basic idea of our scheme is to make a "multi-hop reservation" at the MAC layer by using the modified RTS frame. It contains additional information such as destination information, packet priority, and hop count, etc. In addition, we differentiate the contention window area according to the packet priority and the number of hops to deliver packets in the predefined allowed latency. Our scheme can minimize the multi-hop delay and support the QoS of the critical data in real time(i.e., VoIP, sensing video data, Video conference between commanders). Our simulation study and numerical analysis show that the proposed scheme outperforms the IEEE 802.11 MAC.

• Journal of Communications and Networks
• /
• v.18 no.1
• /
• pp.75-83
• /
• 2016

In this paper, we propose a multi-channel medium access control (MAC) protocol, named underwater multi-channel MAC protocol (UMMAC), for underwater acoustic networks (UANs). UMMAC is a split phase and reservation based multi-channel MAC protocol which enables hosts to utilize multiple channels via a channel allocation and power control algorithm (CAPC). In UMMAC, channel information of neighboring nodes is gathered via exchange of control packets. With such information, UMMAC allows for as many parallel transmissions as possible while avoiding using extra time slot for channel negotiation. By running CAPC algorithm, which aims at maximizing the network's capacity, users can allocate their transmission power and channels in a distributed way. The advantages of the proposed protocol are threefold: 1) Only one transceiver is needed for each node; 2) based on CAPC, hosts are coordinated to negotiate the channels and control power in a distributed way; 3) comparing with existing RTS/CTS MAC protocols, UMMAC do not introduce new overhead for channel negotiation. Simulation results show that UMMAC outperforms Slotted floor acquisition multiple access (FAMA) and multi-channel MAC (MMAC) in terms of network goodput (50% and 17% respectively in a certain scenario). Furthermore, UMMAC can lower the end-to-end delay and achieves a lower energy consumption compared to Slotted FAMA and MMAC.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.4
• /
• pp.855-860
• /
• 2017

One of the most important issues in Wireless Sensor Networks is to save energy of the sensor node. But transmission latency is also the problem to solve for some applications such as military surveillance, object tracking. In these applications sensor node needs to send lots of data in limited time when an even such as object appearance occurs. So a delay efficient data transmission method is required. In this paper we propose a MAC protocol adequate for those applications. This paper proposed a low delay data transmission mechanism for military surveillance in wireless sensor networks. In the MAC protocol, a receiver node sends another beacon frame to sender node after receiving data packet. Using this second beacon frame, fast hop-to-hop transmission can be performed. Results have shown that the proposed MAC control mechanism outperformed RI-MAC protocol in the terms of latency.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37C no.11
• /
• pp.1162-1169
• /
• 2012

One of the important operational requirements for mission critical Ethernet networked system is having the fault tolerant capability. Such capability can be obtained by equipping multiport Network Interface Card (NIC) in each node in the system. Conventional NIC uses two or more Media Access Controls (MACs) and a co-processor for the MAC switching whenever an active port fails. Since firmware is needed for the co-processor, longer fail-over switching and degraded throughput can be generally expected. Furthermore the system upgrading requiring the firmware revision in each tactical node demands high cost. In this paper we propose a novel single MAC based NIC that does not use a co-processor, but just use general discrete building blocks such as MAC chip and switching chip, which results in better performances than conventional method. Experimental results validate our scheme.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.12B
• /
• pp.1028-1036
• /
• 2006

Energy conservation is an important issue in wireless networks, especially for self-organized, low power, low data-rate impulse-radio ultra-wideband (IR-UWB) networks, where every node is a battery-driven device. To conserve energy, it is necessary to turn node into sleep state when no data exist. This paper addresses the energy consumption analysis of Direct-Sequence (DS) versus Time-Hopping (TH) multiple accesses and two kinds of sleeping protocols (slotted and unslotted) in PHY-MAC for Un networks. We introduce an analytical model for energy consumption or a node in both TH and DS multiple accesses and evaluate the energy consumption comparison between them and also the performance of the proposed sleeping protocols. Simulation results show that the energy consumption per packet of DS case is less than TH case and for slotted sleeping is less than that of unslotted one for bursty load case, but with respect to the load access delay unslotted one consumes less energy, that maximize node lifetime.

• Journal of information and communication convergence engineering
• /
• v.11 no.3
• /
• pp.153-166
• /
• 2013

A hierarchical time division multiple access (HTDMA) medium access control (MAC) protocol is proposed for clustered mobile underwater acoustic networks. HTDMA consists of two TDMA scheduling protocols (i.e., TDMA1 and TDMA2) in order to accommodate mobile underwater nodes (UNs). TDMA1 is executed among surface stations (e.g., buoys) using terrestrial wireless communication in order to share mobility information obtained from UNs which move cluster to cluster. TDMA2 is executed among UNs, which send data to their surface station as a cluster head in one cluster. By sharing mobility information, a surface station can instantaneously determine the number of time slots in a TDMA2 frame up to as many as the number of UNs which is currently residing in its cluster. This can enhance delay and channel utilization performance by avoiding the occurrence of idle time slots. We analytically investigate the delay of HTDMA, and compare it with that of wellknown contention-free and contention-based MAC protocols, which are TDMA and Slotted-ALOHA, respectively. It is shown that HTDMA remarkably decreases delay, compared with TDMA and Slotted-ALOHA.

• Journal of the Korea Society of Computer and Information
• /
• v.10 no.4 s.36
• /
• pp.229-237
• /
• 2005

One of the important issues of in this research is effective usage of energy to increase life time of nodes which form a network. Existing LEEM protocol causes unnecessary active time due to small packets with shorter transfer time than active interval period of node and packets with transfer time of more than twice of active interval period of node. In this paper, we propose Energy-Efficient MAC by Reservation (EEMR) protocol which can increase energy effectiveness in wireless sensor network environment by reducing unnecessary active time using a method that reserves next-hop depend upon the size of packet. We evaluated effectiveness of our proposed method through experiments. The result showed that using EEMR protocol had better energy effectiveness than existing LEEM protocol by 15%.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.40 no.7
• /
• pp.261-272
• /
• 2003

An Ethernet PON(Passive Optical Network) is an economical and efficient access network that has received significant research attention in recent years. A MAC(Media Access Control) protocol of PON , the next generation access network, is based on TDMA(Time Division Multiple Access) basically and can classify this protocol into a fixed length slot assignment method suitable for leased line supporting QoS(Quality of Service) and a variable length slot assignment method suitable for LAN/MAN with the best effort. For analyzing the performance of these protocols, we design an Ethernet PON model using OPNET tool. To establish the maximum efficiency of a network, we verify a MAC protocol and determine the optimal number of ONUs(Optical Network Unit) that can be accepted by one OLT(Optical Line Terminal) and propose the suitable buffer size of ONU based on analyzing the end-to-end Ethernet delay, queuing delay, throughput, and utilization.